Hydrophilic/underwater superoleophobic graphene oxide membrane intercalated by TiO2 nanotubes for oil/water separation

GO/TiO₂ membrane was prepared by assembling GO nanosheets and TiO₂ nanotubes. The intercalation of TiO₂ nanotubes enlarged the space of GO interlayers and modified the surface morphology. Hydrophilic/underwater superoleophobic property of GO/TiO₂ membrane was obtained. Water permeability, hydrophilicity, oleophobicity and antifouling ability of GO-based membrane were all enhanced by intercalating TiO₂ nontubes. Membrane technology for oil/water separation has received increasing attention in recent years. In this study, the hydrophilic/underwater superoleophobic membrane with enhanced water permeability and antifouling ability were fabricated by synergistically assembling graphene oxide(GO) nanosheets and titanium dioxide (TiO₂) nanotubes for oil/water separation. GO/TiO₂ membrane exhibits hydrophilic and underwater superoleophobic properties with water contact angle of 62° and under water oil contact angle of 162.8°. GO/TiO₂ membrane shows greater water permeability with the water flux up to 531 L/(m²·h·bar), which was more than 5 times that of the pristine GO membrane. Moreover, GO/TiO₂membrane had excellent oil/water separation efficiency and anti-oil-fouling capability, as oil residual in filtrate after separation was below 5 mg/L and flux recovery ratios were over 80%.The results indicate that the intercalation of TiO₂ nanotubes into adjacent GO nanosheets enlarged the channel structure and modified surface topography of the obtained GO/TiO₂ membranes, which improved the hydrophilicity, permeability and anti-oil-fouling ability of the membranes, enlightening the great prospects of GO/TiO₂ membrane in oil-water treatment.     

原子吸收法测定废水中的铬（Ⅵ）

在pH<1的溶液中,用甲基异丁酮(MIBK)与磷酸三丁酯(TBP)混合作为萃取剂,萃取废水中的铬时,六价铬的分配比为108.6,而三价铬几乎不被萃取。用原子吸收分光光度计测定有机相中的六价铬具有很好的选择性,且干扰少,灵敏度高。工作曲线的最佳浓度范围是:0.04～4.00mg/L。     

超滤膜分离性能的影响因素研究

以水通量，化学需氧量和细菌截留率为主要考核指标，考察了超滤膜分离性污泥混合液的影响因素，结果表明：ＰＥＳ膜适宜污水膜生物工艺使用：一定程度下，膜的截留分子量大，有利于水通量增加；膜的水通量随污泥浓度和滤纸过滤液ＣＯＤ浓度的提高面减少；滤纸过滤液ＣＯＤ浓度对膜水通量影响大于活性污泥浓度；截留分子量小的膜，水通量随压力的提高而上升。     

污泥低氧消化-膜分离工艺运行条件对膜通量的影响

应用低氧消化－膜分离工艺对活性污泥进行低氧消化处理，考察了运行条件对膜通理的影响，结果表明，操作压力和膜组件底部的曝气强度是本工艺膜分离过程中的2个重要的操作条件；操作压力对膜通量的影响与膜污染程度有关，膜污染越严重，临界压力越小；底部曝气对膜通量的影响程度受到操作压力的制约，操作压力越高，底部曝气的强度对膜通量的影响越大。     

铜在日本青鳉体内的累积特征及其对肝脏组织结构的影响

为了解水体铜(Cu(Ⅱ))在日本青鳉(Oryzias latipes)脑、鳃、肝脏、性腺和肌肉组织中的累积特征,以及Cu(Ⅱ)对肝脏组织结构的影响,本文采用生态学单因子梯度实验,进行20 d的日本青鳉毒性暴露试验。结果显示,日本青鳉各个组织对Cu(Ⅱ)的累积量随着浓度的升高而增多,但不同组织对Cu(Ⅱ)的累积量有较大的差异,铜累积量由大到小依次为:肝脏脑鳃性腺肌肉。铜暴露后的日本青鳉肝细胞出现肿大、大小不一、排列混乱,静脉扩张淤血,部分肝细胞固缩和坏疽等现象。肝脏是日本青鳉蓄积铜的主要器官之一,实验发现高浓度的Cu(Ⅱ)对肝脏组织结构造成了明显的损伤,进而严重影响日本青鳉的存活率。     

典型平原河网区水体富营养化特征、成因分析及控制对策研究

本文以嘉兴市北部湖荡区为典型研究区域,通过现场调研、来源分析等,揭示了平原河网区水体富营养化状态,明确了水污染主要成因,并提出控制对策.研究结果显示,北部湖荡区总磷、高锰酸盐指数、五日生化需氧量、化学需氧量、总氮、氨氮等各污染物含量呈现显著的时空分布特征,西部片区水质较东部片区差,5月水质较9月差(总磷除外);富营养化...     

Speciation and sources of atmospheric aerosols in a highly industrialised emerging mega-city in central China

Monitoring air quality in large urban agglomerations is the key to the prevention of air pollution-related problems in emerging mega-cities. The city of Wuhan is a highly industrialised city with >9 million inhabitants in Central China. Simultaneous PM10 sampling was performed during 1 year at one urban and one industrial site. Mean PM10 daily levels (156 microg m(-3) at the urban site and 197 microg m(-3) at the industrial hotspot) exceed the US-EPA or EU annual limit values by 3-4 times. A detailed study of daily speciation showed that the mean chemical composition of PM10 presents minimal differences between peak and low PM episodes. This implies that PM10 aerosols in the study area result from local emissions, and air quality management and abatement strategies in Wuhan should thus focus on local anthropogenic sources. The levels of some elements of environmental concern are relatively high (409-615 ngPb m(-3), 66-70 ngAs m(-3), 116-227 ngMn m(-3), 10-12 ngCd m(-3)) due to industrial, but also urban emissions. Principal component analysis identified a mineral source (probably cement and steel manufacture) and smelting as the main contributors to PM10 levels at the industrial site (34%), followed by a coal fired power plant (20%) and the anthropogenic regional background (16%). At the urban site the major PM10 source is a mixed coal combustion source (31%), followed by the anthropogenic regional background (28%) and traffic (16%).     

不同升温速率下城市污水污泥热解特性及动力学研究

利用差热-热重分析法和Coats-Redfern积分法,对杭州某污水处理厂污泥在不同升温速率下的热解特性及反应动力学特征进行研究。实验结果表明,热解温度从室温升至900℃时,污泥热解过程可分为4个失重阶段;升温速率对污泥热解转化率、挥发分析出温度以及最大失重率等热解特性参数都有显著影响。升温速率越高污泥最大失重率越大;而较低的升温速率延迟了污泥热解反应时间,导致污泥失重量相对较大。根据Coats-Redfern积分法计算结果,污泥在氮气氛围下的热解反应为二级反应模式。提高升温速率可显著增加污泥热解的表观活化能和频率因子。     

膜-生物反应器处理餐饮废水过程中溶解性有机物的迁移变化特性研究

借助于凝胶过滤色谱(GFC)分子量测定技术和三维荧光(EEM)光谱技术,对膜一生物反应器(MBR)处理餐饮废水过程中溶解性有机物(DOM)的迁移变化特性进行了研究.结果表明,GFC分析中,在析出的前12 min,除了调节池出水,其他各工艺阶段(原水、气浮池出水、MBR出水)水样中均有大分子有机物(分子量＞400 ku)...     

A~2/O工艺重新启动试验的污泥活性恢复研究

以处理实际城市污水的小试规模A2/O工艺为研究对象,在处理工艺稳定运行的基础上关停装置60 d,进行了"饥饿"期内不同关停模式下系统重新启动后污泥活性恢复的研究.结果表明,循环模式、厌氧模式和微曝模式3种不同关停模式下,系统重启第4天,污泥硝化性能及反硝化性能基本恢复甚至超过关停前水平,而脱碳性能和除磷性能的恢复速度则较缓慢,重新启动后系统呈现较好的反硝化除磷能力;重启第12天后3种关停模式出水水质良好,基本满足<城镇污水处理厂污染物排放标准>(GB 18918-2002)一级B标准.不同关停模式下,系统污泥活性恢复速率及出水水质对比显示,污水处理厂故障检修期间将搅拌、曝气等动力设备完全关闭的厌氧模式下系统污泥活性恢复较快,而且能耗最低.