Metabolic uncoupler, 3,3′,4′,5-tetrachlorosalicylanilide addition for sludge reduction and fouling control in a gravity-driven membrane bioreactor

• Effects of metabolic uncoupler TCS on the performances of GDMBR were evaluated. • Sludge EPS reduced and transformed into dissolved SMP when TCS was added. • Appropriate TCS increased the permeability and reduced cake layer fouling. • High dosage aggravated fouling due to compact cake layer with low bio-activity. The gravity-driven membrane bioreactor (MBR)system is promising for decentralized sewage treatment because of its low energy consumption and maintenance requirements. However, the growing sludge not only increases membrane fouling, but also augments operational complexities (sludge discharge). We added the metabolic uncoupler 3,3′,4′,5-tetrachlorosalicylanilide (TCS) to the system to deal with the mentioned issues. Based on the results, TCS addition effectively decreased sludge ATP and sludge yield (reduced by 50%). Extracellular polymeric substances (EPS; proteins and polysaccharides) decreased with the addition of TCS and were transformed into dissolved soluble microbial products (SMPs) in the bulk solution, leading to the break of sludge flocs into small fragments. Permeability was increased by more than two times, reaching 60–70 L/m²/h bar when 10–30 mg/L TCS were added, because of the reduced suspended sludge and the formation of a thin cake layer with low EPS levels. Resistance analyses confirmed that appropriate dosages of TCS primarily decreased the cake layer and hydraulically reversible resistances. Permeability decreased at high dosage (50 mg/L) due to the release of excess sludge fragments and SMP into the supernatant, with a thin but more compact fouling layer with low bioactivity developing on the membrane surface, causing higher cake layer and pore blocking resistances. Our study provides a fundamental understanding of how a metabolic uncoupler affects the sludge and bio-fouling layers at different dosages, with practical relevance for in situ sludge reduction and membrane fouling alleviation in MBR systems.     

Monitoring land cover change detection with NOAA-AVHRR and MODIS remotely sensed data in the North and West of Africa from 1982 to 2015

Environmental Science and Pollution Research - Mapping land cover changes (LCC) cover three decades over North and West Africa regions provides critical insights for the climate research that...     

Manganese-modified biochar for highly efficient sorption of cadmium

Environmental Science and Pollution Research - In this study, corn stalk was modified by manganese (Mn) before (MBC1) and after (MBC2) pyrolysis at different temperatures (400~600 °C)...     

T酸一次洗水初步处理的研究

采用重氮化－偶合－混凝沉淀和重氮化－混凝沉淀两种方法对Ｔ酸一次洗水的初步处理进步了研究。Ｔ酸一次洗水经两种方法处理后,ＣＯＤ去除率分别为６１．３％、５０．５％,色度去除率分别为７４．６％、７１％。     

石膏浆液旋流器的分离性能实验研究

通过理论分析及工程经验对石灰石/石膏法烟气脱硫工艺中石膏浆液脱水系统的旋流器进行优化设计,在与工业实际相近的操作条件下,优选出了一根综合性能较好的旋流器。考察了该旋流器的压力、流量与分离效率之间相互关系,与常规石膏浆液旋流器的分级效率进行了比较,确定了最佳操作条件。结果表明,旋流器的进口流量随着进出口压力差的增大而增大,分离效率随着流量增加先上升后下降。在进口硫石膏颗粒平均粒径为24μm,流量为11.8~14.8 m3/h时,分离效率在85%以上,底流出口10μm、15μm以下的颗粒分别占底流出口颗粒总体积的1%、10%左右,起到了很明显的分级浓缩作用,分离性能也优于常规使用的石膏浆液旋流器。     

TiO_2光催化对微滤去除腐殖酸的膜污染控制研究

着重研究了不同紫外灯光源和照射时间条件下,TiO_2光催化(PCO)对微滤去除腐殖酸过程中的膜污染控制,并探讨了膜污染的控制机理。研究结果表明,TiO_2光催化能有效提高微滤对腐殖酸的去除,同时降低膜通量的下降,起到有效控制膜污染的作用。进一步的实验分析表明,TiO_2光催化控制膜污染的主要机理在于将腐殖酸降解为易于被TiO_2吸附的小分子量物质,吸附腐殖酸降解产物后的TiO_2聚合颗粒粒径增大,易于在膜表面形成更为松散的沉积层,并使膜污染从以膜孔堵塞和沉积层污染为主转化为以沉积层污染为主的可逆性污染。     

非水相硝基苯在含水层中的迁移释放规律

通过室内模拟实验,探讨了在非水相硝基苯污染含水层的条件下,其在含水层中的迁移及释放规律。迁移规律表明,非水相硝基苯并非在含水层中直接进行垂向迁移,而是一方面在自身重力作用下向含水层下部迁移,另一方面在地下水流的作用下随地下水同向运移,整体表现为随地下水流的侧向运移,并最终迁移至含水层底部。释放规律表明,非水相硝基苯在含水层迁移的过程中会向地下水大量释放,释放出的硝基苯在水流的作用下随地下水同向运移,污染源及迁移至含水层底部的非水相硝基苯均存在再次释放。     

高锰酸盐复合药剂强化混凝改善再生水景观湖水质研究

实验通过投加助凝剂以强化混凝沉淀过程,从而达到去除再生水景观水中的藻类。以PAC为混凝剂,高锰酸盐复合药剂(PPC)为预氧化助凝剂,通过烧杯实验确定PPC、PAC同时投加,最佳投量分别为1 mg/L、60 mg/L。生产性实验中,机械加速澄清池强化混凝对TP、叶绿素、藻密度的去除率分别为54%、32.3%和35.4%,湖水中TP、TN逐渐降低分别由4.9 mg/L、23 mg/L降至0.72 mg/L、10.3 mg/L。PPC提高了混凝沉淀对藻类的去除效果,改善了再生水景观湖水质,降低水中氮磷营养盐的含量。     

用废变压器油吸收废气中的二甲苯

以废变压器油作为吸收剂对二甲苯废气进行吸收处理,考察了影响二甲苯气体去除率的因素。实验结果表明:二甲苯废气流量为350 L/h、废变压器油喷淋量为40 L/h、进口二甲苯废气平日质量浓度为935 mg/m~3、吸收温度为18℃、吸收时间为50 min时,出口二甲苯气体质量浓度为35 mg/m~3,二甲苯去除率高达96.3%,小于GB16297—1996《大气污染物综合排放标准》中二甲苯质量浓度90 mg/m~3的排放标准。     

脉冲放电降解实际空气流中甲苯的实验研究

研制了一种喷射式线-筒放电反应器,在室温条件下进行了降解实际空气流中甲苯的实验研究。结果表明,该反应器能够有效降解甲苯,但不同的通气方式对甲苯降解率有显著影响,验证了该反应器设计的合理性。同时证明,通过流场控制可以提高甲苯降解率。电场方向与气流方向一致则强化降解,两者方向相反则弱化降解。当电压为34kV时,正脉冲和负脉冲的甲苯降解率相差高达42.5%。当电压小于火花放电电压时,甲苯降解率随着电压的增大而升高;当电压过大时,电极间发生火花放电,甲苯降解率不升反降。小电压时,小电容放电的甲苯降解率较高;但随着电压的增大,大电容的优势得以体现。甲苯降解率随气流中甲苯初始浓度的升高而降低;随气体流量的增大而降低;环境湿度过大时,甲苯降解率下降,并且甲苯氧化不完全,有CO生成。