长江口徐六泾颗粒态正构烷烃的月变化组成特征及来源解析

2003年6月到2005年12月之间,在长江口徐六泾站位按月际采集表层水样用于颗粒态正构烷烃的测定。徐六泾颗粒态样品总正构烷烃含量在0.3~3.8 μg·L^-1范围内,高值多集中在每年4月到8月。正构烷烃的碳数范围在C₁₅ 到 C₃₆之间,主峰碳主要为C₂₇、C₂₉和C₃₁。徐六泾颗粒态正构烷烃分布可分陆源输入优势型、陆源和水生生物混合优势型及石油污染型等3种类型,其中陆源输入为主,少部分冬、春季样品的分析结果显示为陆源与水生生物共同作用类型,可能与低悬浮颗粒物浓度和海水倒灌的影响有关。UCM结果显示徐六泾石油烃污染主要分布范围为C₂₈-C₃₃,与推测的船只燃料油污染相吻合。     

黄龙钙华水体藻多样性及分布规律研究

对黄龙钙华水体藻种类、分布规律及多样性进行了研究,共鉴定出23属53种淡水藻类,分属5门。黄龙钙华水体藻类以硅藻占绝对优势,绿藻、黄藻门、蓝藻门次之,裸藻门、金藻门最少。从季节交替变化来看,春季小球藻最多,夏秋季节硅藻最多;从分布规律来看,夏季以海拔最高的泉眼处藻类最多,沿海拔降低藻类数量递减;秋季以钙华滩流群处藻类最盛。多样性分析结果表明,黄龙水体钙华藻类的物种丰富度指数dmar在0.083⁰.667之间,多样性指数H在0.1910.667之间,多样性指数H在0.191¹.99之间,均匀度e在0.2761.99之间,均匀度e在0.276¹.000之间。结果表明黄龙钙华水体藻类受到季节、温度、水量等环境因数和海拔、钙华滩、彩池等地理因素影响表现出现种群的周期演替。     

石化污水处理场挥发性污染物分布特征研究

采用大气预浓缩系统-气相色谱-质谱联用方法对石化企业污水处理场排放的挥发性污染物分布特征进行了定性、定量和半定量分析。结果表明,在污水处理场4个监测位点均检出多种挥发性有机污染物,以芳烃和直链烃类化合物为主,其中苯系物浓度和检出率最高,甲苯和二甲苯占污染区采样点检出成分总量的10%以上。4个监测点中污水总进口上方大气污染最为严重。对大气预浓缩系统-气相色谱-质谱联用方法分析挥发性硫化物进行了方法验证,结果表明,该系统对硫化氢、甲硫醇和乙硫醇3种化合物存在一定的吸附作用,标准曲线斜率与起始浓度显著相关,采用该系统对低浓度、高活性的硫化物进行分析和绝对定量时应谨慎对待。污泥贮存池是硫化物恶臭类物质控制的重点区域。     

黄河水质监测的分析方法研究

随着对黄河水的治理工作的逐渐深入,关于黄河水质的监测事业都取得了快速的发展并有着不小的进步,当然仍然存在着一些问题,比如监测的条件较为单一且技术落后、监测的断面也不够多、资料信息缺乏等.随着时代的发展,现有的一些关于水质监测的方法已经不能满足监测的要求,所以本文对于黄河水质监测的分析方法做了一定得研究,希望对于水质监测方面有一定的帮助.     

基于厌氧氨氧化的含氨废气原位处理

采用部分亚硝化-厌氧氨氧化一体化反应器研究了含氨废气原位脱氮处理的可行性.结果表明,在控制低溶解氧(0.2~1 mg·L~(-1)),pH为7.9~8.2,中温(30~35℃)条件下,经过60 d的运行,成功地实现部分亚硝化-厌氧氨氧化一体化反应器的启动,总氮去除率达到88%,氮去除速率由0.05 kg·(m~3·d)~(-1)上升并稳定在0.7 kg·(m~3·d)~(-1).在含氨废气处理研究中,当含氨废气浓度低于2.59%,废气中原有的氧过量,导致硝态氮大量累积;当含氨废气体积分数为2.59%~4.2%时,废气中氧满足反应器脱氮的需求;当含氨废气体积分数高于4.2%,需要额外通入空气,补充反应器内的氧需求.经过60 d的运行,氨气的去除率达100%,总氮去除率达90.06%,总氮去除负荷为0.51 kg·(m~3·d)~(-1).说明基于厌氧氨氧化反应的一体化反应器可实现含氨废气稳定去除.     

Decolorization of Methyl Orange by a new clay-supported nanoscale zero-valent iron: Synergetic effect, efficiency optimization and mechanism

In this study, a novel nanoscale zero-valent iron (nZVI) composite material was successfully synthesized using a low-cost natural clay, “Hangjin 2^# clay” (HJ clay) as the support and tested for the decolorization of the azo dye Methyl Orange (MO) in aqueous solution by nZVI particles. According to the characterization and MO decolorization experiments, the sample with 5:1 HJ clay-supported nZVI (HJ/nZVI) mass ratio (HJ-nZVI5) showed the best dispersion and reactivity and the highest MO decolorization efficiency. With the same equivalent Fe⁰ dosage, the HJ-nZVI1 and HJ-nZVI5 samples demonstrated a synergetic effect for the decolorization of MO: their decolorization efficiencies were much higher than that achieved by physical mixing of HJ clay and nZVIs, or the sum of HJ clay and nZVIs alone. The synergetic effect was primarily due to the improved dispersion and more effective utilization of the nZVI particles on/in the composite materials. Higher decolorization efficiency of MO was obtained at larger HJ-nZVI dosage, higher temperature and under N₂ atmosphere, while the MO initial concentration and pH were negatively correlated to the efficiency. HJ clay not only works as a carrier for nZVI nanoparticles, but also contributes to the decolorization through an “adsorption-enhanced reduction” mechanism. The high efficiency of HJ-nZVI for decontamination gives it great potential for use in a variety of remediation applications.     

Novel cationic polyamidine: Synthesis, characterization, and sludge dewatering performance

In this study, a new and facile route was employed for synthesis of polyamidine with abundant cations and attractive five-membered ringlike structural unit. N-vinylformamide and acrylonitrile copolymerized firstly to form intermediates, and the intermediates were processed with hydrochloric acid to produce polyamidine. A series of polymerization conditions (e.g. polymerization time, temperature and dosage of initiator) were optimized through productivity, viscosity and cationic degree as evaluation. SEM analysis illustrated that the amidinization process could reduce the size of spaces between molecular and created compact structure, which would contribute to good flocculation performance and high viscosity. FT-IR, XPS and NMR spectra presented a rather clear structure of polyamidine. 34.3% of sludge was sedimentated through the flocculation of polyamidine in the early stages. In contrast, only 6.8% of sludge was sedimentated by polyacrylamide. The moisture content in dehydrated floc could be reduced to 77.7% when 60 mg/L polyamidine was added. These results demonstrated that the polyamidine showed a great potential in the practical application of sludge dewatering.     

天津分公司加氢裂化装置HAZOP分析

通过对180×10~4t/a加氢裂化装置的HAZOP分析实例,详细阐述了HAZOP分析方法的实际应用,找出装置需要改进的针对性建议措施,总结了HAZOP分析过程中常见的问题以及经验。     

淀山湖沉积物-水界面氮磷通量及其生态环境效应研究

底泥营养盐释放对淀山湖湖区造成的内源污染不容忽视.采用室外采样和室内模拟实验方法,对春夏两季淀山湖沉积物-水界面氮磷释放速率进行了研究.结果表明春季氨氮、硝态氮、可溶磷的的通量变化范围分别为-692.79~315.82 mg/(m2?h)、-19.04~5.29 mg/(m2?h)和-1.35~2.31 mg/(m2?h),平均值分别为76.65 mg/(m2?h)、-3.29 mg/(m2?h)和0.64 mg/(m2?h).夏季三者变化范围分别为-74.15~91.91 mg/(m2?h)、-70.71 mg/(m2?h)~8.65 mg/(m2?h)和-10.02~18.86 mg/(m2?h),平均值为4.85 mg/(m2?h)、-42.16 mg/(m2?h)和9.47 mg/(m2?h).淀山湖区春夏两季总氮(TN)、总磷(TP)的交换总量分别为-1769.22 t,1539.40 t,淀山湖底泥可以有效去除上覆水体氮负荷,但却是水体磷的释放源.     

不同回用用途下典型城市污水再生处理工艺的生命周期评价分析

对3种典型城市污水再生处理工艺(微絮凝+砂滤+消毒(MSD)、混凝+转盘过滤+消毒(CRD)和混凝沉淀+超滤+消毒(CUD))进行生命周期环境影响定量评价,探讨了不同工艺在不同回用用途下的环境表现。结果表明:MSD工艺在富营养化(EP)方面的影响略高,归一化结果为9.32E-15,其他方面环境影响均小于CRD和CUD工艺;不同回用用途的污水再生可在某些方面抵消原需水产生的环境影响,有一定环境效益,不同出水用途的替代抵消作用可影响环境表现。以砂滤为主的典型城市污水再生处理工艺在出水用于工业冷却水时,归一化加权结果为其他两种工艺的25%和7.5%,具有较好的应用前景。