液氮冻融破碎生物污泥制备生物絮凝剂

利用城市剩余生物污泥,采用液氮冻融破碎、提取液提取的方法制备了生物污泥絮凝剂。对絮凝剂的制备条件及其絮凝性能进行了研究,结果表明:采用液氮冻融破碎,pH为1.0的稀盐酸溶液作为提取液提取所制备的絮凝剂,对高岭土悬浮液的絮凝效率可达98.5%。液氮冻融破碎的次数对絮凝剂制备没有明显影响。同时考察了絮凝剂投加量以及絮凝体系的pH对絮凝剂絮凝活性的影响。     

聚硅酸铝铁-壳聚糖复合絮凝剂的制备与应用

采用聚硅酸铝铁与壳聚糖复合,制备低成本、高絮凝性能的新型无机-有机复合絮凝剂。结果表明:最佳复合条件为pH值1.4～2.0、原料配比(质量比)1:1、最佳温度70～80℃、反应时间16h。并将该絮凝剂用于造纸废水的处理实验,在投加量每500mL为5mL时,其对废水浊度、色度和COD的去除率分别为94.5%,61.5%和78.7%。     

模糊综合评判法在水质评价中的应用——以松花江流域为例

社会的快速发展在给人类带来经济效益的同时,也给环境尤其是水环境造成极大的压力,水质问题是当今社会亟待解决的重大难题之一。水质是诸多因素影响的结果,具有一定程度的不确定性,所以在水质评价中需要综合考虑模糊因素。本文采用模糊综合评判法对松花江流域八个断面水质进行评价,引入数学隶属度的概念,针对多种评价因子指标值大小表示的污染程度不同,采用两种隶属度计算公式,且客观定量地确定各污染因子的权重,从而确定水质类别。     

有机磷农药降解方法及应用研究新进展

现代农业的发展和有机磷农药的使用密切相关,所造成的严重的农产品和环境污染是农业发展有待解决的关键问题之一。介绍了超声波技术、吸附、洗涤和辐照等物理方法,微生物、降解酶和工程菌等生物方法,水解、氧化分解和光化学降解等化学方法对有机磷农药的降解作用及其相关的应用研究。     

DNA Heat Treatment for Improving qPCR Analysis of Human Adenovirus in Wastewater

PCR inhibitory substances in complex sample matrices can cause false negatives or under-estimation of target concentration. This study assessed DNA heat treatment for reducing inhibition during qPCR analysis of human adenovirus (HAdV) in wastewater samples. Inhibition was reduced by heat treating DNA, where mean HAdV concentration was increased by 0.71 log₁₀ GC/L (and up to 3.04 log₁₀ GC/L in one case), and replicate variability and false negatives were reduced. DNA heat treatment should be further investigated for improving reliability of HAdV concentration estimates in water, which can support more accurate assessment of health risks associated with viral pathogen exposure.     

地铁环境振动预测方法浅析

简要介绍了国内外关于地铁环境振动预测方法的研究概况,在作者研究分析地铁振动传播途径和主要影响参数基础上,给出了简单定量预测地铁环境振动程度之方法,应用该方法所得到的预测值,与现场实测值误差在±2dB范围内.     

Nanoencapsulation of hexavalent chromium with nanoscale zero-valent iron: High resolution chemical mapping of the passivation layer

Solid phase reactions of Cr(Ⅵ) with Fe(0) were investigated with spherical-aberration-corrected scanning transmission electron microscopy(Cs-STEM) integrated with X-ray energy-dispersive spectroscopy(XEDS). Near-atomic resolution elemental mappings of Cr(Ⅵ)–Fe(0) reactions were acquired. Experimental results show that rate and extent of Cr(Ⅵ) encapsulation are strongly dependent on the initial concentration of Cr(Ⅵ) in solution. Low Cr loading in nZⅥ(1.0 wt%) promotes the electrochemical oxidation and continuous corrosion of n ZⅥ while high Cr loading(1.0 wt%) can quickly shut down the Cr uptake. With the progress of iron oxidation and dissolution, elements of Cr and O counter-diffuse into the nanoparticles and accumulate in the core region at low levels of Cr(Ⅵ)(e.g., 10 mg/L). Whereas the reacted n ZⅥ is quickly coated with a newly-formed layer of 2–4 nm in the presence of concentrated Cr(Ⅵ)(e.g., 100 mg/L). The passivation structure is stable over a wide range of pH unless pH is low enough to dissolve the passivation layer. X-ray photoelectron spectroscopy(XPS) depth profiling reconfirms that the composition of the newly-formed surface layer consists of Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxides with Cr(Ⅵ) adsorbed on the outside surface. The insoluble and insulating Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxide layer can completely cover the n ZⅥ surface above the critical Cr loading and shield the electron transfer. Thus, the fast passivation of nZⅥ in high Cr(Ⅵ) solution is detrimental to the performance of nZⅥ for Cr(Ⅵ) treatment and remediation.     

Observation and analysis of atmospheric volatile organic compounds in a typical petrochemical area in Yangtze River Delta, China

Volatile organic compounds (VOCs) are a kind of important precursors for ozone photochemical formation. In this study, VOCs were measured from November 5th, 2013 to January 6th, 2014 at the Second Jinshan Industrial Area, Shanghai, China. The results showed that the measured VOCs were dominated by alkanes (41.8%), followed by aromatics (20.1%), alkenes (17.9%), and halo-hydrocarbons (12.5%). The daily trend of the VOC concentration showed a bimodal feature due to the rush-hour traffic in the morning and at nightfall. Based on the VOC concentration, a receptor model of Positive Matrix Factorization (PMF) coupled with the information related to VOC sources was applied to identify the major VOC emissions. The result showed five major VOC sources: solvent use and industrial processes were responsible for about 30% of the ambient VOCs, followed by rubber chemical industrial emissions (23%), refinery and petrochemical industrial emissions (21%), fuel evaporations (13%) and vehicular emissions (13%). The contribution of generalized industrial emissions was about 74% and significantly higher than that made by vehicle exhaust. Using a propylene-equivalent method, alkenes displayed the highest concentration, followed by aromatics and alkanes. Based on a maximum incremental reactivity (MIR) method, the average hourly ozone formation potential (OFP) of VOCs is 220.49?ppbv. The most significant source for ozone chemical formation was identified to be rubber chemical industrial emissions, following one by vehicular emission. The data shown herein may provide useful information to develop effective VOC pollution control strategies in industrialized area.     

上海市大气中非甲烷烃与机动车尾气排放研究

采用特征性化合物法和统计法相结合的方法,对上海市大气中非甲烷烃(NMHC)与作为机动车尾气特征性化合物的CO与Pb进行了相关性分析。结果发现,NMHC与Pb在显著性水平0.01下显著性相关,相关系数达到0.593(n=18);NMHC与CO小时均值相关系数达到0.495(n=2329),日均值相关系数达到0.581(n=114)。从而判断机动车尾气排放已经逐渐成为上海市大气中NMHC的主要贡献者。     

Analysis and Modeling on the Spatial Structure of Urban Land Use: A Case of Jinan, China

Based on the data of urban land use obtained by remote sensing interpretation from aero images in 1986 and 2004, the spatial structure of Jinan is studied in this paper with the method of Geographic Information System (GIS). According to the proportion of land for residence, industry and commerce, the urban district can be distinguished into three rings. Compared with the traditional theory of the ring structure in Western coun- tries, they have many distinctive characteristics. The main func- tions of the inner ring include residence, business and banking, but the proportion of residential land (more than 50%) is considerably higher than that of the cities in Western countries. The land proportion for residence and industry in the intermediate ring is equal on the whole. The main land of the outside ring is for industrial use. From 1986 to 2004, great changes have taken place on the land proportion of different types of use. In the inner ring, the land for residential and industrial use has shrunk much while the land for commercial use has increased. In the intermediate ring, the changes of the three types of land use were not very much and the temporal variation was relatively stable. On the contrary, the structure in the outside ring varies acutely. Though most of it is also for industrial use, the proportion of residential land has in- creased much. The three rings can also be divided into several sectors respectively, according to the function of land use clusters. New trends and mechanisms of the changes of land use impacting the urban structure were proposed in the end of the paper.