PCB and dioxin-like PCB in indoor air of public buildings contaminated with different PCB sources--deriving toxicity equivalent concentrations from standard PCB congeners

Data on dioxin-like PCB in indoor air of buildings with PCB-containing materials and on possible correlation between toxicity equivalent concentrations (TEQ) and levels of non-dioxin-like standard PCB is sparse. As part of a larger survey on indoor-air contamination with PCB, the connection between the concentration of standard PCB congeners and the dioxin-like toxicity expressed as TEQ was investigated. Indoor air samples (n=8) were collected in four public buildings with known PCB sources and total PCB levels in the range from 715 to 2250 ng/m3 and analyzed for the six non-dioxin-like standard PCB (congeners 28, 52, 101, 138, 153, 180), the twelve dioxin-like PCB congeners according to WHO and the 17 2,3,7,8-substituted PCDD/PCDF congeners. In three buildings where PCB were used as flame retardant coatings of acoustic ceiling tiles, PCB 101 had the maximum level among the six standard PCB, while in the building with permanent elastic sealants as PCB source, congeners 28 and 52 dominated the pattern by far. In the case of permanent elastic sealants as PCB source (n=3) a total PCB concentration of 1000 ng/m3 corresponded to a total TEQ level of 0.3-0.6 pg/m3. In contrast, in rooms with acoustic ceiling tiles as PCB source, 1.8-4.7 pg TEQ/m3 per 1000 ng total PCB/m3 were found. Linear regression analysis between PCB and TEQ indicated that PCB 118 might be used to calculate the total TEQ of dioxin-like PCB and PCDD/PCDF. By means of such a correlation it is possible to estimate TEQ by extrapolation from the results of less sophisticated analytical methods. It is tentatively recommended to use PCB 118 for screening purposes or re-evaluation of standard PCB indoor-air measurements. If only the six non-dioxin-like PCB standard congeners are available, a regression algorithm using the sum of PCB 101, 138, 153 and 180 might be used instead.     

Which meteorological conditions produce worst-case odors from area sources?

Two competing meteorological factors influence atmospheric concentrations of pollutants from open liquid area sources such as wastewater treatment plant units: temperature and stability. High temperatures in summer produce greater emissions from liquid area sources because of increased compound volatility; however, these emissions tend to disperse more readily because of frequent occurrence of unstable conditions. An opposite scenario occurs in winter, with lesser emissions due to lower temperatures, but also frequently less dispersion, due to stable atmospheric conditions. The primary objective of this modeling study was thus to determine whether higher atmospheric concentrations from open liquid area sources occur more frequently in summer, when emissions are greater but so is dispersion, or in winter, when emissions are lesser but so is dispersion. The study utilized a rectangular clarifier emitting hydrogen sulfide as a sample open liquid area source. Dispersion modeling runs were conducted using ISCST3 and AERMOD, encompassing 5 yr of hourly meteorological data divided by season. Emission rates were varied hourly on the basis of a curve-fit developed from previously collected field data. Model output for each season was used to determine (1) maximum 2-min average concentrations, (2) the number of odor events (2-min average concentrations greater than odor detection thresholds), and (3) areas of impact. On the basis of these 3 types of output, it was found that the worst-case odors were associated with summer, considering impacts of meteorology upon both emissions and dispersion. Not accounting for the impact of meteorology on emissions (using a constant worst-case emission rate) caused concentrations to be overpredicted compared with a variable emission rate case. The highest concentrations occurred during stability classes D, E, and F, as anticipated. A comparison of ISCST3 and AERMOD found that for the area source modeled, ISCST3 predicted higher concentrations and more odor events for all seasons.     

Characterization of spatially homogeneous regions based on temporal patterns of fine particulate matter in the continental United States

Statistical analyses of time-series or spatial data have been widely used to investigate the behavior of ambient air pollutants. Because air pollution data are generally collected in a wide area of interest over a relatively long period, such analyses should take into account both spatial and temporal characteristics. The objective of this study is 2-fold: (1) to identify an efficient way to characterize the spatial variations of fine particulate matter (PM2.5) concentrations based solely upon their temporal patterns, and (2) to analyze the temporal and seasonal patterns of PM2.5 concentrations in spatially homogenous regions. This study used 24-hr average PM2.5 concentrations measured every third day during a period between 2001 and 2005 at 522 monitoring sites in the continental United States. A k-means clustering algorithm using the correlation distance was used to investigate the similarity in patterns between temporal profiles observed at the monitoring sites. A k-means clustering analysis produced six clusters of sites with distinct temporal patterns that were able to identify and characterize spatially homogeneous regions of the United States. The study also presents a rotated principal component analysis (RPCA) that has been used for characterizing spatial patterns of air pollution and discusses the difference between the clustering algorithm and RPCA.     

Mercury speciation in Pacific coastal rainwater,Monterey Bay,California

We measured mercury speciation in coastal rainwater samples from Monterey Bay, California in 2007–2008 to investigate the source of monomethylmercury (MMHg) in rainwater and determine the relative importance of wet atmospheric deposition of MMHg to coastal waters compared to other sources on the central Pacific coast. Total mercury (HgT) ranged from 10 to 88 pM, with a sample mean ± standard deviation of 33 ± 22 pM (volume-weighted average 29 pM). MMHg concentrations ranged from 0.12 to 2.3 pM with a sample mean of 0.7 ± 0.5 pM (volume-weighted average 0.68 pM). Reactive mercury (HgR) concentrations ranged from 0.87 to 47 pM, sample mean 7.8 ± 8.3 pM (volume-weighted average 6.1 pM). Acetate concentration in rainwater, measured in a subset of samples, ranged from 0.34 to 3.1 μM, and averaged 1.6 ± 0.9 μM (volume-weighted average 1.3 μM). Dimethylmercury (DMHg) concentrations were below the limit of detection in air (<0.01 ng m^?3) and rainwater (<0.05 pM). Despite previous suggestions that DMHg in upwelled ocean waters is a potential source of MMHg in coastal rainwater, MMHg in rain was not related to coastal upwelling seasons or surface water DMHg concentrations. Instead, a multiple linear regression analysis demonstrated that MMHg concentrations were positively and significantly correlated (p = 0.002, adjusted R² = 0.88) with those of acetate and HgR. These data appear to support previous suggestions that the aqueous phase methylation of Hg(II) by acetate may be the source of MMHg in rainwater, but imply that acetate concentrations in rainwater play a more important role relative to HgR than previously hypothesized. However, the calculated chemical speciation of Hg(II) in rainwater and the minimal predicted complexation of Hg(II) by acetate suggest that the aqueous phase methylation of Hg(II) by acetate is unlikely to account for the MMHg found in precipitation, or that the mechanism of this reaction in the atmosphere differs from that previously reported (Gardfeldt et al., 2003).     

Risk estimation and annual fluxes of emerging contaminants from a Scottish priority catchment to the estuary and North Sea

Environmental Geochemistry and Health - Emerging contaminants (ECs) such as endocrine-disrupting chemicals (EDCs) and pharmaceuticals and personal care products (PPCPs) attracted global concern...     

Removal of carbonyl sulfide using activated carbon adsorption

Wastewater treatment plant odors are caused by compounds such as hydrogen sulfide (H2S), methyl mercaptans, and carbonyl sulfide (COS). One of the most efficient odor control processes is activated carbon adsorption; however, very few studies have been conducted on COS adsorption. COS is not only an odor causing compound but is also listed in the Clean Air Act as a hazardous air pollutant. Objectives of this study were to determine the following: (1) the adsorption capacity of 3 different carbons for COS removal; (2) the impact of relative humidity (RH) on COS adsorption; (3) the extent of competitive adsorption of COS in the presence of H2S; and (4) whether ammonia injection would increase COS adsorption capacity. Vapor phase react (VPR; reactivated), BPL (bituminous coal-based), and Centaur (physically modified to enhance H2S adsorption) carbons manufactured by Calgon Carbon Corp. were tested in three laboratory-scale columns, 6 in. in depth and 1 in. in diameter. Inlet COS concentrations varied from 35 to 49 ppmv (86-120 mg/m3). RHs of 17%, 30%, 50%, and 90% were tested. For competitive adsorption studies, H2S was tested at 60 ppmv, with COS at 30 ppmv. COS, RH, H2S, and ammonia concentrations were measured using an International Sensor Technology Model IQ-350 solid state sensor, Cole-Parmer humidity stick, Interscan Corp. 1000 series portable analyzer, and Drager Accuro ammonia sensor, respectively. It was found that the adsorption capacity of Centaur carbon for COS was higher than the other two carbons, regardless of RH. As humidity increased, the percentage of decrease in adsorption capacity of Centaur carbon, however, was greater than the other two carbons. The carbon adsorption capacity for COS decreased in proportion to the percentage of H2S in the gas stream. More adsorption sites appear to be available to H2S, a smaller molecule. Ammonia, which has been found to increase H2S adsorption capacity, did not increase the capacity for COS.     

Determination of sterols, estrogens and inorganic ions in waste water and size-segregated aerosol particles emitted from waste water treatment

Concentrations of steroids and inorganic ions were measured in waste water of an aerated sand trap as well as in aerosol particles emitted from this tank at the waste water treatment plant (WWTP) of Bayreuth, Germany, in January and February 2003. The investigations comprised seven sterols, two estrogens, and several inorganic ions. Since an appropriate method for the determination of sterols in waste water was not available, a new method based on solid phase extraction was developed. The concentrations of the sterols coprostanol and cholesterol amounted to 30-180 microg l(-1) in waste water and to 400-5000 pg m(-3) in aerosol particles. All other sterols were present in markedly lower concentrations. The mean concentrations of the two estrogens estrone and 17beta-estradiol were about 165 pg m(-3) in aerosol particles. The steroid concentrations in both waste water and aerosol particles varied greatly over time, however with the exception of coprostanol, no clear correlation was detected between concentrations in waste water and aerosol particles.     

Advancing objectives-based,integrated ocean management through marine spatial planning: current and future directions on the Scotian Shelf off Nova Scotia,Canada

The national legislative and policy context for integrated ocean management in Canada is provided by the Oceans Act (1996) and the supporting policy statement, Canada’s Oceans Strategy. Under the Oceans Act, Fisheries and Oceans Canada (DFO) is the lead federal authority for ocean affairs and is charged with leading and facilitating the development and implementation of integrated management plans for all marine waters. Integrated management efforts in Canada are being undertaken through an area-based approach that enables marine planning, management and decision making to occur at appropriate spatial scales, from regional to site-specific. This article focuses on the Eastern Scotian Shelf Integrated Management (ESSIM) process, an offshore-focused effort to develop an integrated ocean management plan for a large portion of the Scotian Shelf, off Nova Scotia. The resulting Eastern Scotian Shelf Integrated Ocean Management Plan (the ESSIM plan) has been developed through a collaborative process involving all interested and affected government departments and ocean stakeholders, and provides an objectives-based approach to ocean management. The ESSIM plan contains a set of long-term, overarching goals for collaborative governance and integrated management, sustainable human use, and healthy ecosystems. These goals are supported by more specific objectives that express desired outcomes and conditions for the marine region. The objectives-based approach seeks to ensure that interrelationships among ecosystem and human use objectives are recognized and reflected in the identification of management strategies and supporting actions. This article considers the role of marine spatial planning within the context of the integrated ocean management process underway for the Scotian Shelf. The policy and management context for integrated ocean management in Canada is briefly described and a summary of the ESSIM plan is provided. The current and potential role for marine spatial planning in implementing the objectives and strategies of the ESSIM plan is highlighted using examples related to multiple ocean use and marine conservation and protected area planning. The article concludes by drawing out key lessons learned to date through the ESSIM process for marine spatial planning and looks to the future in terms of the development of tools and approaches for this integral aspect of integrated ocean management.     

Bioluminescent yeast estrogen assay (BLYES) as a sensitive tool to monitor surface and drinking water for estrogenicity

Estrogenic Endocrine Disrupting Chemicals (EDCs) are a concern due to their ubiquity and recognized adverse effects to humans and wildlife. Methods to assess exposure to and associated risks of their presence in aquatic environment are still under development. The aim of this work is to assess estrogenicity of raw and treated waters with different degrees of pollution. Chemical analyses of selected EDCs were performed by liquid chromatography-tandem mass spectrometry, and estrogenic activity was evaluated using in vitro bioluminescent yeast estrogen assay (BLYES). Most raw water samples (18/20) presented at least one EDC and 16 rendered positive in BLYES. When EDCs were detected, the bioassay usually provided a positive response, except when only bisphenol A was detected at low concentrations. The highest values of estrogenic activity were detected in the most polluted sites. The maximum estrogenic activity observed was 8.7 ng equiv. of E2 L(-1). We compared potencies observed in the bioassay to the relative potency of target compounds and their concentrations failed to fully explain the biological response. This indicates that bioassay is more sensitive than the chemical approach either detecting estrogenic target compounds at lower concentrations, other non-target compounds or even synergistic effects, which should be considered on further investigations. We have not detected either estrogenic activity or estrogenic compounds in drinking water. BLYES showed good sensitivity with a detection limit of 0.1 ng equiv. E2 L(-1) and it seems to be a suitable tool for water monitoring.