Sulfur Control In Coal Fired Power Plants: A Probabilistic Approach to Policy Analysis

The optimum level of sulfur pollution control for a coal fired power plant is the point where the sum of societal costs, due to pollution, and control costs is minimized. This basic microeconomic concept has been of limited practical value due to considerable uncertainty in estimating both costs. A probabilistic approach is used to characterize these uncertainties quantitatively for a hypothetical 1000 Mw_e plant located near Pittsburgh, Pennsylvania. Only mortality effects within a distance of 80 km of the plant have been included. The results allow explicit consideration of attitude toward risk and appropriate level of investment to prevent deaths. Limitations of the findings are discussed. Implications are described for policy based on alternative sets of values and assumptions.     

Development of a low-cost air sensor package and indoor air quality monitoring in a California middle school: Detection of a distant wildfire

A low-cost air sensor package was used to monitor indoor air quality (IAQ) in a classroom at the Albany Middle School in the San Francisco Bay Area of California. A rapid increase in carbon dioxide (CO₂) was observed in the classroom as soon as it is occupied. When the classroom is unoccupied, the CO₂ levels decay slowly toward the outdoor background level. All high CO₂ concentrations observed inside the classroom, above the outdoor background, was due to exhaling of the occupants. The CO₂ concentrations generally exceed the recommended level of 1000 ppb towards the end of the school day. The exceedances and slow decay may suggest that the ventilation rate in this school is not sufficient. The particulate level in the classroom was low until a distant wildfire advected large amount of particulate matter to the San Francisco Bay Area. Very high (10–15 times compared to the background) particle numbers (per m³ of particles with diameter >0.3 µm) were observed in the classroom during the wildfire. These particles were relatively small (0.3–1.0 µm) and the filters (MERV 8) of the ventilation system were unable to filter them out. Therefore, the measurements made by low-cost particle counters can inform the school administrators of adverse IAQ during future wildfire (or other combustion) events. The particle number was independent of the occupation before and during the wildfire suggesting that all observed particles were infiltrated into the classroom from outside. Consistent with previous studies, no appreciable increase in the local ambient CO₂ background was observed during this distant wildfire event.

Implications: Low-cost air sensors are effective in monitoring indoor air quality in classrooms. The CO₂ levels in classrooms are mainly generated indoors due to exhalation of occupants. Concentration of CO₂ generally exceed the recommended level of 1000 ppb towards the end of the school day. In contrast, the particulate matter mostly comes from outdoors and small particles penetrate though the filters normally used at schools. Distant wildfires do not increase the local CO₂ background appreciably, but significantly increase the particulate matter concentrations both indoors and outdoors. Further investigations are needed to assure that ventilation rates in classrooms are sufficiently health protective.     

Methods to determine response factors for infrared gas imagers used as quantitative measurement devices

Response factors (RF) can be used to characterize relative sensitivity of one compound vs. another compound for the same measurement instrument. Use of RF allows the analysts/operators to calibrate the instrument with one compound and make measurement for a large number of compounds. This method is adopted for Flame Ionization Detector (FID) based survey instruments used in the Leak Detection and Repair (LDAR) practice for control of fugitive emissions of volatile organic compounds. Gas detecting Infrared (IR) cameras have been used for leak detection. However, the RF for IR cameras has not been well established despite some attempt to develop a method for IR camera RF. In addition to a method proposed earlier (Method 1), two new methods for IR camera RF are proposed in this paper: Method 2 based on theoretical approach and Method 3 based on experimental approach. All three methods are examined and compared. Both Methods 2 and 3 have shown the ability to characterize the behavior of RF for various compounds and substantially higher accuracy than Method 1. Method 2 provides a mechanism to generate RF for a large number of compounds without conducting experiments, and is recommended for implementation. The RF derived from this method can be used both in the emerging field of Quantitative Optical Gas Imaging (QOGI) and to answer the most common question that IR camera users ask—whether a particular compound can be imaged by a particular IR camera.Implications: Infrared imager is an efficient tool for detecting gas leaks from process equipment and has been used in leak detection and repair (LDAR) programs for control of fugitive emissions. However, the information regarding which chemical compounds can be imaged and how sensitive a given infrared imager is for various compounds is limited. A theoretical method is presented in this paper that can answer these questions without conducting resource-intensive experiment. The results of this theoretical method has good agreement with experimental data. The method has been used to predict relative sensitivity for 398 compounds.     

Nonvolatile,semivolatile, or volatile: Redefining volatile for volatile organic compounds

Although widely used in air quality regulatory frameworks, the term “volatile organic compound” (VOC) is poorly defined. Numerous standardized tests are currently used in regulations to determine VOC content (and thus volatility), but in many cases the tests do not agree with each other, nor do they always accurately represent actual evaporation rates under ambient conditions. The parameters (time, temperature, reference material, column polarity, etc.) used in the definitions and the associated test methods were created without a significant evaluation of volatilization characteristics in real world settings. Not only do these differences lead to varying VOC content results, but occasionally they conflict with one another. An ambient evaporation study of selected compounds and a few formulated products was conducted and the results were compared to several current VOC test methodologies: SCAQMD Method 313 (M313), ASTM Standard Test Method E 1868-10 (E1868), and U.S. EPA Reference Method 24 (M24). The ambient evaporation study showed a definite distinction between nonvolatile, semivolatile, and volatile compounds. Some low vapor pressure (LVP) solvents, currently considered exempt as VOCs by some methods, volatilize at ambient conditions nearly as rapidly as the traditional high-volatility solvents they are meant to replace. Conversely, bio-based and heavy hydrocarbons did not readily volatilize, though they often are calculated as VOCs in some traditional test methods. The study suggests that regulatory standards should be reevaluated to more accurately reflect real-world emission from the use of VOC containing products.

Implications:The definition of VOC in current test methods may lead to regulations that exclude otherwise viable alternatives or allow substitutions of chemicals that may limit the environmental benefits sought in the regulation. A study was conducted to examine volatility of several compounds and a few formulated products under several current VOC test methodologies and ambient evaporation. This paper provides ample evidence to warrant a reevaluation of regulatory standards and provides a framework for progressive developments based on reasonable and scientifically justifiable definitions of VOCs.     

Effects of seagrasses and algae of the Caulerpa family on hydrodynamics and particle-trapping rates

The widespread decline of seagrass beds within the Mediterranean often results in the replacement of seagrasses by opportunistic green algae of the Caulerpa family. Because Caulerpa beds have a different height, stiffness and density compared to seagrasses, these changes in habitat type modify the interaction of the seafloor with hydrodynamics, influencing key processes such as sediment resuspension and particle trapping. Here, we compare the effects on hydrodynamics and particle trapping of Caulerpa taxifolia, C. racemosa, and C. prolifera with the Mediterranean seagrasses Cymodocea nodosa and Posidonia oceanica. All macrophyte canopies reduced near-bed volumetric flow rates compared to bare sediment, vertical profiles of turbulent kinetic energy revealed peak values around the top of the canopies, and maximum values of Reynolds stress increased by a factor of between 1.4 (C. nodosa) and 324.1 (P. oceanica) when vegetation was present. All canopies enhanced particle retention rates compared to bare sediment. The experimental C. prolifera canopy was the most effective at particle retention (m² habitat); however, C. racemosa had the largest particle retention capacity per structure surface area. Hence, in terms of enhancing particle trapping and reducing hydrodynamic forces at the sediment surface, Caulerpa beds provided a similar or enhanced function compared to P.oceanica and C. nodosa. However, strong seasonality in the leaf area index of C. racemosa and C. taxifolia within the Mediterranean, combined with a weak rhizome structure, suggests that sediments maybe unprotected during winter storms, when most erosion occurs. Hence, replacement of seagrass beds with Caulerpa is likely to have a major influence on annual sediment dynamics at ecosystem scales.     

Public acceptance of large-scale wind energy generation for export from Ireland to the UK: evidence from Ireland

Although international trade in energy may offer a flexible and cost effective means by which European countries could meet their renewable energy targets, developers in the exporting nation can face local opposition for reasons which are not always clear. Using focus groups and a public survey, we contrast perspectives between local stakeholders and wind farm operators and investigate the community impacts associated with large-scale wind energy for domestic use and export from Ireland to the UK. Although the export of renewable energy from Ireland to the UK is currently on hold, our findings suggest that significant investment is required by the state and wind farm operators in better information provision, trust building, effective instruments to internalise wind farm externalities and co-management arrangements before Ireland can fully capture the benefits of wind exports to the UK.     

Summer Ozone Concentrations in Southern Ontario in Relation to Photochemical Aspects and Vegetation Damage

In the summers of 1960 and 1961, groups from the Canada Department of Agriculture, the Meteorological Service of Canada, and the Canada Department of National Health and Welfare conducted a joint study in a tobacco-growing area along the north shore of Lake Erie. The purpose of the study was to determine the causal agent for weather fleck damage to tobacco crops. A number of air pollutants were monitored and the results correlated with extensive observations of meteorological phenomena and effects on rate of growth and fleck damage to leaves of tobacco plants in experimental plots. Ozone concentrations followed a diurnal cycle, rising a few hours after sunrise, peaking in early afternoon at about 5 pphm, and dropping to a minimum of less than 1 pphm during the night. Other measurements indicated the presence of NO₂ in the order of 1 pphm, aldehydes about 0.2 pphm or lower, and negligible concentrations of SO₂. Cracking of stretched rubber strips followed the ozone values although, in general, the cracking index was greater than could be attributed to ozone (by oxidized KI) alone. The maximum ozone value recorded during the two growing seasons was IS pphm. A dosage of 20 pphm-hr was found sufficient to cause weather fleck or ozone damage to susceptible tobacco leaves. In addition meteorological data could be used to predict weather fleck attacks one to four days in advance.     

Methyl 2-(methylthio)benzoate: the unique sulfur-containing sex pheromone of<Emphasis Type="Italic"> Phyllophaga crinita</Emphasis>

The female-produced sex pheromone of Phyllophaga crinita (Burmeister) (Coleoptera: Scarabaeidae: Melolonthinae; the adult has no common name) is identified as methyl 2-(methylthio)benzoate. This is the first identification of a sulfur-containing, long-distance, female-produced sex attractant from any insect taxa. The root-feeding larvae of this species are serious pests in many crops in Texas and Mexico. In field tests, many P. crinita males were captured in traps baited with the authentic compound. Interestingly, a heteroatom analog, methyl 2-methoxybenzoate, also captured P. crinita males, but only at a dose 10,000 times higher than the lowest tested dose of the authentic pheromone.In memory of M.G. Villani, who died on 15 May 2001. His enthusiasm for soil-dwelling scarab beetles and contributions to their research are greatly missed.     

Amniotic alpha-fetoprotein in the prenatal diagnosis of congenital nephrotic syndrome of the finnish type

Congenital nephrosis of the Finnish type (CNF) is rare outside Finland, where the incidence may be as high as 1 in 2000 live births. Neonates with the disorder develop renal failure within the first months of life and without renal transplantation, the prognosis is extremely poor. This case report describes a woman's three pregnancies, two of which were affected with CNF.