Polycyclic aromatic hydrocarbons in the ambient air of Greek towns in relation to other atmospheric pollutants

Polycyclic aromatic hydrocarbons (PAHs) were determined in the ambient air of six towns in N. Greece. This paper presents the variability of the particle-bound PAHs concentrations and the particle PAH content during the cold and the warm months. Correlations of total PAHs with other atmospheric pollutants were largely different among towns indicating that the relative contribution of emission sources is different in each location. In the warm months PAHs were significantly correlated with vehicular pollutants thus suggesting traffic as the major PAH emmitting source. The same was also deduced from the comparison of the ambient PAH profiles to the profiles of particular sources. The contribution of residential heating was significant in most towns during winter. Principal component analysis of the data did not result in a clear distinction between towns thus suggesting that all are influenced by similar source types. Finally, the risk associated with the inhallation of carcinogenic PAHs in each town was estimated and compared to the risk from more urbanized/industrialized sites in N. Greece.     

Distribution in Portugal of some pollutants in the lichen Parmelia sulcata

During the months of July and August 1993 a lichen (Parmelia sulcata Taylor) collection campaign was held in Portugal where samples were obtained from olive tree bark at 228 sites, following a grid of 10 x 10 km along the Atlantic coast and 50 x 50 km in the interior of the country. The samples were analysed by instrumental neutron activation analysis and proton induced X-ray emission techniques. Concentration data patterns for the pollutants As, Cr, Hg, Ni, Pb, S, Sb, Se, and V were obtained for the whole country surface by making use of an extinction rule of 1/r(3), preventing any cut-off distance from being artificially introduced. Some pollution sources were identified: (1) oil-powered plants on the Lisbon-Setúbal axis (V, Ni), (2) coal-power plants in Porto and Sines (S, Se), (3) traffic in the northern area and the Lisbon-Setúbal axis (Pb), (4) a chemical industry south of Porto (Hg, As), and (5) soil influence (Cr, Sb). Arsenic and chromium results largely exceed, in a few areas, the concentrations acceptable to plants, and in a few spots also Hg, Ni, and Pb data.     

Tracing sources of atmospheric sulphur using epiphytic lichens

The overall objective of this work was to measure the spatial variation of sulphur isotopic composition of lichens across the island of Newfoundland in order to assess the degree to which the atmosphere is being affected by long-range transport of anthropogenic sulphur from eastern North America, and/or local pollution sources. A contour map (based on over 80 composite samples of the lichen Alectoria sarmentosa) illustrates the spatial distribution of sulphur isotopic composition of the Newfoundland atmosphere. It shows a gradient of delta(34)S of sulphur in lichen, decreasing from the coast to the interior of the island. It also shows local anomalies corresponding to the city of St. John's, the Come-By-Chance Oil Refinery, mining areas and fossil-fuel powered pulp and paper mills in central and western Newfoundland. The study strongly suggests that the isotopic composition of sulphur in the Newfoundland atmosphere is influenced more by the ocean (sea salt sulphate) and local anthropogenic activities in the province, than by long-range transport of continental North American sulphate.     

The variability and intrinsic remediation of a BTEX plume in anaerobic sulphate-rich groundwater

Data from long-term groundwater sampling, limited coring, and associated studies are synthesised to assess the variability and intrinsic remediation/natural attenuation of a dissolved hydrocarbon plume in sulphate-rich anaerobic groundwater. Fine vertical scale (0.25- and 0.5-m depth intervals) and horizontal plume-scale (>400 m) characteristics of the plume were mapped over a 5-year period from 1991 to 1996. The plume of dissolved BTEX (benzene, toluene, ethylbenzene, xylene) and other organic compounds originated from leakage of gasoline from a subsurface fuel storage tank. The plume was up to 420 m long, less than 50 m wide and 3 m thick. In the first few years of monitoring, BTEX concentrations near the point of leakage were in approximate equilibrium with non-aqueous phase liquid (NAPL) gasoline. NAPL composition of core material and long-term trends in ratios of BTEX concentrations in groundwater indicated significant depletion (water washing, volatilisation and possibly biodegradation) of benzene from residual NAPL after 1992. Large fluctuations in BTEX concentrations in individual boreholes were shown to be largely attributable to seasonal groundwater flow variations. A combination of temporal and spatial groundwater quality data was required to adequately assess the stationarity of plumes, so as to allow inference of intrinsic remediation. Contoured concentration data for the period 1991 to 1996 indicated that plumes of toluene and o-xylene were, at best, only partially steady state (pseudo-steady state) due to seasonal groundwater flow changes. From this analysis, it was inferred that significant remediation by natural biodegradation was occurring for BTEX component plumes such as toluene and o-xylene, but provided no conclusive evidence of benzene biodegradation. Issues associated with field quantification of intrinsic remediation from groundwater sampling are highlighted. Preferential intrinsic biodegradation of selected organic compounds within the BTEX plume was shown to be occurring, in parallel with sulphate reduction and bicarbonate production. Ratios of average hydrocarbon concentrations to benzene for the period 1991 to 1992 were used to estimate degradation rates (half-lives) at various distances along the plume. The estimates varied with distance, the narrowest range being, for toluene, 110 to 260 days. These estimates were comparable to rates determined previously from an in situ tracer test and from plume-scale modelling.     

Measurements of peroxyacyl nitrates (PANS) in Mexico City: implications for megacity air quality impacts on regional scales

Peroxyacyl nitrates (PANs) were measured using gas chromatography with electron capture detection (GC/ECD) in north central Mexico City during February–March of 1997. Peroxyacetyl nitrate (PAN) was observed to exceed 30 ppb during five days of the study, with peroxypropionyl nitrate (PPN) and peroxybutryl nitrate (PBN) reaching 6 and 1 ppb maximum, respectively. Levels of total PANs typically exceeded 10 ppb during the period of measurement and showed a very strong diurnal variation with PANs maximum during the early afternoon and falling to less than 0.1 ppb during the evening hours. These levels of PANs are the highest reported values in North America (and the world) for an urban center, since levels of approximately 30 ppb were reported during the late 1970s in the Los Angeles area (South Coast Air Basin, Tuazon et al., 1978). Hydrocarbon measurements indicate that the levels of olefins, specifically butenes are significant in Mexico City. A time series taken of source indicator hydrocarbons taken before and during a Mexican National Holiday with reduced automobile traffic clearly show that mobile sources of butenes are as important as liquefied petroleum gas. Observations of 10–40 ppb C methyl-t-butyl ether (MTBE) are consistent with MTBE/gasoline fuel usage as a source of isobutene and formaldehyde. Both these reactive species can lead to increased oxidant and PAN formation. The strong diurnal profiles of PANs are consistent with regional clearing of the Mexico City air basin on a daily basis. Estimates are given using a simple box model calculation for a number of key primary and secondary pollutant emissions from this megacity on an annual basis. These calculations indicate that megacities can be important sources of both primary and secondary pollutants, and that PANs produced in megacity environments are likely to contribute strongly to regional scale ozone and aerosol productions during long range transport.     

Ozone patterns for three metropolitan statistical areas in North Carolina, USA

As part of an effort by the state of North Carolina to develop a State Implementation Plan (SIP) for 1-h peak ozone control, a network of ozone stations was established to monitor surface ozone concentrations across the state. Between 19 and 23 ozone stations made continuous surface measurements between 1993 and 1995 surrounding three major metropolitan statistical areas (MSAs): Raleigh/Durham (RDU), Charlotte/Mecklenburg (CLT), and Greensboro/High Point/Winston-Salem (GSO). Statistical averages of the meteorological and ozone data were performed at each Metropolitan Statistical Area (MSA) to study trends and/or relationships on high ozone days (days in which one of the MSA sites measured an hourly ozone concentration90.0 ppbv). County emission maps of precursor gases, wind roses, total area averages of ozone, total downwind averages of ozone deviations, upwind averages of ozone, and a modified delta ozone analysis were all obtained and analyzed. The results of this study show a reduction in the delta ozone relative to an earlier study at RDU, but no average significant change at CLT (no comparison can be made for GSO). The statistical data analyses in this study are used to quantify the importance of local contributions and regional transport, to ozone air pollution in the MSAs.     

Adsorbent selection for endosulfan removal from water environment

In the present study, an attempt was made to select a low cost adsorbing material for the removal of endosulfan [C,C'-(1,4,5,6,7,7-hexachloro-8,9,10- trinorborn-5-en-2,3-ylene)(dimethylsulphite)] from water. Various low cost adsorbents like wood charcoal, kimberlite tailings, silica, macro fungi sojar caju were tried with activated charcoal as reference material. The above materials were selected from various sources encompassing organic, inorganic, clayey, and biological sources. For the selection of suitable adsorbent for endosulfan uptake, maximum adsorption capacity (Qmax) was chosen as the parameter. Kinetic profiles of removal were generated for all the materials to assess the equilibrium time. Equilibrium studies were carried out for all materials to assess the adsorption equilibrium model that they followed. The model that gave the best correlation coefficient by linear regression analysis, was adopted for the calculation of Qmax of the corresponding adsorbent material. Using linearised forms of equilibrium models like Langmuir, BET, and Freundlich, maximum adsorptive capacities were determined. Activated charcoal showed the best adsorptive capacity with Qmax of 2.145 mg/g followed by wood charcoal 1.773 mg/g, sojar caju 1.575 mg/g, kimberlite tailings 0.8821 mg/g, and silica 0.3231 mg/g. Albeit activated charcoal gave better performance, it was not considered as a candidate material because of its high cost. Wood charcoal was the next best adsorbent with Qmax 1.773 mg/g. Therefore, wood charcoal was chosen as the best material for endosulfan removal. The study of physical and chemical characteristics of wood charcoal revealed that it is a potential adsorbent and can even be improved further.     

Organochlorine pesticide residues in human milk in Punjab, India

Human milk samples collected from areas having intensive cotton cultivation and sparse cotton cultivation in Punjab (India) were analysed for organochlorine insecticides. Both DDT and HCH were detected in almost all the samples analysed. The average levels of Sigma-DDT and Sigma-HCH residues in samples from cotton-growing areas were significantly higher than in those from areas where cotton is sparsely grown. Residues of Sigma-DDT mainly comprised p,p'-DDT and p,p'-DDE, while those of Sigma-HCH residues were mainly in the form of its beta-isomer. Median values of 0.52 microg g(-1) of Sigma-DDT and 0.19 microg g(-1) of Sigma-HCH in samples of human milk from cotton-growing areas of Punjab (India) were higher than those reported from most other countries in the World.     

Petroleum hydrocarbons in the nearshore marine sediments of the United Arab Emirates

The concentrations of total petroleum hydrocarbons (TPH) were determined in nearshore sediment samples collected from 28 sampling sites along the United Arab Emirates shorelines on the Arabian Gulf, the Gulf of Oman and seven major creeks (khors) extending from them. Concentrations were highly variable and ranged between <0.4 and 212 microg g(-1) dry weight, and the highest values obtained were in the top sediment (1 cm) layer near a fuel filling station and port areas. Locally high levels of TPH were found in Dubai, Sharjah and Ajman semi-enclosed creeks where boat activities and land-based wastewater discharges are most common. Data support the premise that port activities, fuel filling stations and land-based wastewater discharges are major sources of pollution in the study area. Correlations with sediment grain size, total organic carbon (TOC) and distance from pollution sources are discussed.     

Algal-bacterial interactions in metal contaminated floodplain sediments

The aim of the present study was to investigate algal-bacterial interactions in a gradient of metal contaminated natural sediments. By means of multivariate techniques, we related the genetic structure (denaturing gradient gel electrophoresis, DGGE) and the physiological structure (community-level physiological profiling, CLPP) of the bacterial communities to the species composition of the algal communities and to the abiotic environmental variables, including metal contamination. The results revealed that genetic and physiological structure of the bacterial communities correlated with the species composition of the algal community, but hardly to the level of metal pollution. This must be interpreted as an indication for a strong and species-specific linkage of algal and bacterial species in floodplain sediments. Metals were, however, not proven to affect either the algal or the bacterial communities of the Dutch river floodplains.