Three-Dimensional Numerical Simulation of Air Pollutant Dispersion in Street Canyons

The PHOENICS Computational Fluid Dynamics (CFD) software package has been used with a standard k- turbulence model to simulate the three-dimensional dispersion of air pollutants in an urban street canyon. In all cases, a vortex was formed within the street canyon, characterized by updrafts near the upwind buildings and down-drafts near the downwind buildings. Contours of pollutant concentrations over a transverse vertical plane at mid-canyon show pollutants circulating within the vortex, with higher concentrations at the leeward face than at the windward faces, and higher concentrations above downwind buildings than above upwind buildings. Longitudinal distributions of pollutant concentrations at leeward and windward faces are characterized by higher concentrations at mid-block and lower concentrations at the ends. These results agree qualitatively with previous wind tunnel findings such as those of Hoydysh and Dabberdt (1988) and Wedding et al. (1977). The results also suggest that the k- turbulence model is satisfactory for simulating the effect of turbulence on dispersion of pollutants in street canyons     

Recovery of nickel oxide from spent catalyst

This study investigates the possibility of recovering nickel from the spent catalyst (NiO/Al2O3) resulting from the steam reforming process to produce water gas (H2/H2O) in many industries. In the extraction process, nickel is recovered as sulfate using sulfuric acid as a solvent. The considered parameters affecting nickel recovery were acid concentration, temperature and time of digestion solid:liquid ratio, particle size and stirring rate. Nickel was to be directly recovered as a sulfate salt by direct crystallization method. The conversion was 99% at 50% sulfuric acid concentration, solid: liquid ratio (1:12) by weight, particle size less than 500 micron for more than 5 h and 800 rpm at 100 degrees C.     

Ziziphus spina-christi leaf extract attenuates mercuric chloride-induced liver injury in male rats via inhibition of oxidative damage

Environmental Science and Pollution Research - Heavy metal contamination including mercury (Hg) has become one of the most serious environmental problems facing humans and other living organisms....     

Modeling trihalomethane formation for Jabal Amman water supply in Jordan

A mathematical model that expresses Total trihalomethane (TTHM) concentration in terms of initial chlorine concentration, total organic carbon, bromide ion concentration, contact time, and pH is developed for Zai water treatment plant which supplies water to Jabal Amman. The developed mathematical model is for constant temperature of 20°C. To adjust model calculated TTHM concentrations for temperatures other than 20°C, another mathematical model that expresses TTHM growth rate as function of temperature is also developed. To test the ability of the two developed models in predicting TTHM concentrations throughout water supplies, a sampling program that aimed at measuring TTHM concentrations in addition to the predictors in the two developed mathematical models namely; chlorine concentration, bromide ion concentration, total organic carbon, temperature and pH throughout Jabal Amman water supply was conducted. The two developed mathematical models and WaterCad, which was used to determine water age, were used to predict TTHM concentrations throughout Jabal Amman water supply. Predicted TTHM concentrations were compared to actual TTHM concentrations measured during the sampling program. Results showed that there is good agreement between measured and, calculated TTHM concentrations, which means that the method presented in this paper, can be used to obtain good estimates of TTHM concentrations throughout networks.     

Residues of carbofuran and its two carbamate metabolites in field‐treated rutabaga 1

Abstract

Carbofuran was applied over seeded rutabaga cv. York and residues (corrected for recovery) of carbofuran, 3‐hydroxy‐ and 3‐ketocarbofuran in the harvested roots averaged 0.15, 0.23 and 0.07 ppm in peel and 0.09, 0.14 and 0.05 ppm in pulp, respectively. Samples were extracted by hot acid digestion, partitioned in methylene chloride and cleaned up on Florisil. The 3‐hydroxy‐carbofuran was ethoxylated and the compounds were converted into their dinitrophenyl ethers and analysed by electron capture gas chromatography using 3% OV‐3 column.     

Aluminum interaction with human brain tau protein phosphorylation by various Kinases

Abstract

Phosphorylation is an indispensable process for energy and signal transduction in biological systems. AlCl₃ at 10 nM to 10 uM range activated in‐vitro [γ‐³²P)ATP phosphorylation of the brain (tau) T protein in both normal human or E.coli expressed T forms; in the presence of the kinases P34, PKP, and PKC. However, higher concentrations of ALCl₃ inhibited the T phosphorylation with P34, PKP, and PKC to a maximum at 1 mM level. AlCl₃ at 100 uM to 500 uM range induced non‐enzymatic phosphorylation of T with γ‐ATP, γ‐GTP, and α‐GTP. AlCl₃ activated histone phosphorylation by P34 in a similar pattern. The hyperphosphorylation of T by Al³⁺ was accompanied by molecular shift and mobility retardation in SDS‐PAGE. This may demonstrate the mechanism of the longterm neurological effect of Al³⁺ in human brain leading to the formation of the neurofibrillary tangles related to Alzeheimer's disease.     

Runoff and leaching of atrazine and alachlor on a sandy soil as affected by application in sprinkler irrigation

Abstract

Rainfall simulation was used with small packed boxes of soil to compare runoff of herbicides applied by conventional spray and injection into sprinkler‐irrigation (chemigation), under severe rainfall conditions. It was hypothesized that the larger water volumes used in chemigation would leach some of the chemicals out of the soil surface rainfall interaction zone, and thus reduce the amounts of herbicides available for runoff. A 47‐mm rain falling in a 2‐hour event 24 hours after application of alachlor (2‐chloro‐N‐(2,6‐diethylphenyl)‐N‐(methoxymethyl)‐acetamide) and atrazine (6‐chloro‐N‐ethyl‐N‐(1‐methylethyl)‐1,3,5‐triazine‐2,4‐diamine) was simulated. The design of the boxes allowed a measurement of pesticide concentrations in splash water throughout the rainfall event. Initial atrazine concentrations exceeding its’ solubility were observed. When the herbicides were applied in 64000 L/ha of water (simulating chemigation in 6.4 mm irrigation water) to the surface of a Tifton loamy sand, subsequent herbicide losses in runoff water were decreased by 90% for atrazine and 91% for alachlor, as compared to losses from applications in typical carrier water volumes of 187 L/ha. However, this difference was not due to an herbicide leaching effect but to a 96% decrease in the amount of runoff from the chemigated plots. Only 0.3 mm of runoff occurred from the chemigated boxes while 7.4 mm runoff occurred from the conventionally‐treated boxes, even though antecedent moisture was higher in the former. Two possible explanations for this unexpected result are (a) increased aggregate stability in the more moist condition, leading to less surface sealing during subsequent rainfall, or (b) a hydrophobic effect in the drier boxes. In the majority of these pans herbicide loss was much less in runoff than in leachate water. Thus, in this soil, application of these herbicides by chemigation would decrease their potential for pollution only in situations where runoff is a greater potential threat than leaching.     

Considerable hazards produced by heavy fuel oil in operating thermal power plant in Assiut, Egypt

Heavy fuel oil and ash samples were collected from the Assiut thermal power plant in Egypt and subjected to gamma spectrometry analysis for natural radioactivity contents. Considerable results were observed where the ash contains nearly 1,000 times natural radionuclides more than raw oil. The results were confirmed by measuring the samples via using different devices in different institutions. All ash samples had radium equivalent activities and external hazard index values more than 370 Bq/kg and unity respectively. The mean absorbed dose rate was10,650 nGy/h which is nearly 190 times higher than the global average value of 55 nGy/h. The corresponding annual external effective dose is estimated to be 13 mSv/year, which is nearly 30 times higher than that in areas of natural background radiation (0.46 mSv/year).     

Application of cleaner production technology in chemical industry: a near zero emission

The main objective of this study is to investigate and evaluate opportunities for implementation of pollution prevention and waste minimization in a chemical industrial company producing poly sulfonated naphthalene formaldehyde which is used as a super plasticizer for concrete. Environmental problems encountered were mainly the highly polluted wastewater and a semi-solid cake containing considerable amount of the final product. Possible modules for remedial measures and their cost estimation were investigated. The proposed remedial modules included recycling of retained water discharge in filter press, recycling of washing water of reaction vessels (reactors), closed circuit cooling system for high-pressure pump, good housekeeping through control of leakage of raw material, products and water and finally utilization of retained residual product from the solid waste. The implemented pollution control measures proved to be cost effective and have short payback periods. Also, minimization of the hydraulic and organic loads in the final effluent was achieved.     

Sustainable Development and Environmental Impact Assessment in Egypt: Historical Assessment

The achievement of sustainable development demands the integration of environment and development. To achieve sustainable development requires a close collaboration and cooperation between environmentalists and the decision-makers. The evidence is that in developing countries (Egypt, as an example) the gap is widening rather than closing. Intensive research programs are needed, for instance in the field of sustainable development and urban environmental management, to narrow that gap. Environmental Impact Assessment (EIA) has become a management tool for achieving acceptable forms of environmentally sound development and sustainability; at best it is proving nothing more than a permit to move a project ahead.It is recommended that indicators for sustainable development and their progress be fully monitored. Performance indicators should always be established, not only for project implementation, but also during and after the implementation process to make sure that all mitigation measures are satisfactorily implemented. This can be achieved by linking the license granting authority for action to the actual implementation of these measures. To secure the environmental sustainability of an environmental project, it is also important to have the EIA document as an integral part of the license application document, and to make it available to inspectors during their necessarily frequent inspection visits.