Monitoring the impact of urban effluents on mineral contents of water and sediments of four sites of the river Ravi, Lahore

We assessed the impact of urban effluents on the concentrations of selected minerals (Cd, Cr, Cu, Fe, Pb, Zn, Mn, Ni, and Hg) in river Ravi before and after its passage through Lahore city. Water and sediment samples were collected from three lowly to highly polluted downstream sites (Shahdera (B), Sunder (C), and Balloki (D)) alongside the least polluted upstream site (Siphon (A)) during high and low river flow seasons. All the mineral concentrations increased up to site C but stabilized at site D, showing some recovery as compared to the third sampling site. The trend of mean mineral concentration was significantly higher during the low than the high flow season at all the sites. The mean Hg concentrations approached 0.14 and 0.12 mg/l at site A which increased (%) up to 107 and 25 % at site B, 1,700 and 1,317 % at site C, and 1,185 and 1,177 % at site D during low and high river flows, respectively. All mineral concentrations were much higher in the sediment than the water samples. Mean Cd (917 %), Cr (461 %), Cu (300 %), Fe (254 %), Pb (179 %), Zn (170 %), Mn (723 %), Ni (853 %), and Hg (1,699 %) concentrations were higher in riverbed sediments sampled from site C in comparison with the sample collected at site A during low flow season. The domestic and industrial discharges from Lahore city have created undesirable water qualities during the low river flow season. As majority of the mineral levels in the river Ravi were higher than the permissible and safe levels, this is of immediate concern for riverine fish consumers and the users of water for recreation and even irrigation. The use of these waters may pose health risks, and therefore, urgent intervention strategies are needed to minimize river water pollution and its impact on fish-consuming communities of this study area and beyond.     

Impact of anthropogenic activities on physico-chemical parameters of water and mineral uptake in Catla catla from river Ravi, Pakistan

The river Ravi, while passing through Lahore, the second largest city of Pakistan, gets highly polluted owning heavy loads of untreated municipal sewage and industrial effluents of diverse kinds. The fish, Catla catla sampled in two different seasons from three downstream polluted sites were compared with the samples of the same fish from an upstream, a less polluted site, for their physico-chemical parameters. The data were statistically analysed to study the effect of sites, seasons and their interaction on the physico-chemical parameters of waters and mineral uptake in fish muscles. Significant differences (P?<?0.001) among the sampling sites and seasons were observed. The river appeared to be polluted as indicated by the high values of total suspended solids (909 mg/l) and sulphate (964 mg/l) in comparison to the respective values of 150 and 600 mg/l being suggested as the safer values of drinking water of the National Environmental Quality Standards. Most trace and macro elements in fish muscles were increased with the increasing pollution loads from the upstream to the downstream sites of this river. The remarkable increases in the levels of all the investigated minerals in fish muscles from the polluted sites raise concerns about the long-term health of the river Ravi ecosystem and consequently the fish and its consumer’s health. The results contradict the opinion of the local population that the riverine fish are natural, more health-promoting and precious than the pond fish. Therefore, we strongly argue for the utilization of an effect-based monitoring approach to alleviate the detrimental effects of anthropogenic activities on fish and the fish consumers’ health.     

Cytotoxicity,genotoxicity and oxidative stress of malachite green on the kidney and gill cell lines of freshwater air breathing fish Channa striata

The cytotoxicity, genotoxicity and oxidative stress of malachite green (MG) was investigated using the fish Channa striata kidney (CSK) and Channa striata gill (CSG) cell lines. Five concentrations ranging from 0.001 to 10 μg mL^?1 were tested in three independent experiments. Cytotoxicity was assessed by 3-(4, 5-dimethylthiazol-2-yl)-2,5-diphenyltetrazolium bromide (MTT) assay, Rhodamine 123 and Alamar Blue. The mitochondrial changes and apoptosis of MG-exposed cells were observed by Rhodamine 123 and acridine orange/ethidium bromide (AO/EB) staining, respectively. In vitro potential DNA damaging effect of MG was tested using comet assay. Mitochondrial damage, apoptosis and DNA fragmentation increased in a concentration-dependent manner. Additionally, DNA electrophoretic mobility experiments were carried out to study the binding effect of MG to double-stranded DNA (dsDNA) of cells. DNA shift mobility experiments showed that MG is capable of strongly binding to linear dsDNA causing its degradation. Biochemical parameters such as lipid peroxidation (MDA), catalase (CAT) activity and reduced glutathione (GSH) levels were evaluated after exposure to MG. In CSK and CSG cell lines exposed to MG for 48 h, a significant increase in lipid peroxidation, which might be associated with decreased levels of reduced glutathione and catalase activity in these cell lines (p?相似文献   

Incidence of metal and antibiotic resistance in Pseudomonas spp. from the river water, agricultural soil irrigated with wastewater and groundwater

A total of 144 isolates of Pseudomonas spp. (48 each from the Yamuna River water, wastewater irrigated soil and groundwater irrigated soil) were tested for their resistance against certain heavy metals and antibiotics. Minimum inhibitory concentrations (MICs) of Hg^2?+?, Cd^2?+?, Cu^2?+?, Zn^2?+?, Ni^2?+?, Pb^2?+?, Cr^3?+? and Cr^6?+? for each isolate were also determined. A maximum MIC of 200 ??g/ml for mercury and 3,200 ??g/ml for other metals were observed. The incidences of metal resistance and MICs of metals for Pseudomonas isolates from the Yamuna water and wastewater irrigated soil were significantly different to those of groundwater irrigated soil. A high level of resistance against tetracycline and polymyxin B (81.2%) was observed in river water isolates. However, 87.5% of Pseudomonas isolates from soil irrigated with wastewater showed resistance to sulphadiazine, whereas 79.1% were resistant to both ampicillin and erythromycin. Isolates from soil irrigated with groundwater exhibited less resistance towards heavy metals and antibiotics as compared to those of river water and wastewater irrigated soil. Majority of the Pseudomonas isolates from water and soil exhibited resistance to multiple metals and antibiotics. Resistance was transferable to recipient Escherichia coli AB2200 strains by conjugation. Plasmids were cured with the curing agent ethidium bromide and acridine orange at sub-MIC concentration.     

Cost efficiency analysis and emission reduction by implementation of energy efficiency standards for electric motors

The industrial sector is the biggest electricity consumer in Malaysia. Electric motors account for more than 45% of the electricity consumption in the industrial sector in the country. Therefore, it is very important to implement energy efficiency standards for electric motors to reduce energy consumption growth in this sector. This paper attempts to calculate the cost efficiency analysis and emission reduction by implementing energy efficiency standards for electric motor in Malaysia. The energy efficiency standards are proposed based on the efficiency of electric motors from survey data. The study examines the potential energy, economical and environmental impacts of the implementation of energy efficiency standards for electric motors in three scenarios i.e. 0.5%, 1.0% and 1.5% of standards efficiency improvement. Standards also enable consumers to reduce their electricity bill and contribute to a positive environmental impact.     

Nitrite pre-treatment of dewatered sludge for microbial fuel cell application

The effect of pre-treatment of dewatered sludge using different nitrite concentrations and pH for microbial fuel cell (MFC) application was investigated. The results show that the addition of nitrite was feasible to increase the solubilization rate of the sludge and may reduce mass transfer limitation at the anode. This helped the MFC to reach higher voltage and to generate more power. The higher free nitrous acid (FNA) concentration under the acidic condition helped to increase sludge solubilization. However, under an alkaline condition, during which the FNA concentration was relatively low, the solubilization of the sludge was higher. The highest voltage and power density produced was 390?mV and 153?mW/m², respectively, with the addition of nitrite at 100?mg-N/L and pH?9. Furthermore, it was found that elevated levels of FNA could inhibit electrogenic bacteria thus reducing power generation.     

Kinetic of formation for single carbon dioxide and mixed carbon dioxide and tetrahydrofuran hydrates in water and sodium chloride aqueous solution

A laboratory-scale reactor system is built and operated to measure the kinetic of formation for single and mixed carbon dioxide–tetrahydrofuran hydrates. The T-cycle method, which is used to collect the kinetic data, is briefly discussed. For single carbon dioxide hydrate, the induction time decreases with the increase of the initial carbon dioxide pressure up to 2.96 MPa. Beyond this pressure, the induction time is becoming relatively constant with the increase of initial carbon dioxide pressure indicating that the liquid phase is completely supersaturated with carbon dioxide. Experimental results show that the inclusion of tetrahydrofuran reduces the induction time required for hydrate formation. These observations indicate hydrate nucleation process and onset growth are more readily to occur in the presence of tetrahydrofuran. In contrast, the presence of sodium chloride prolongs the induction time due to clustering of water molecules with the ions and the salting-out effects. It is also shown that the degree of subcooling required for hydrate formation is affected by the presence of tetrahydrofuran and sodium chloride in the hydrate forming system. The presence of tetrahydrofuran in the hydrate system significantly reduces the amount of carbon dioxide uptake. The apparent rate constant, k, for those systems are reported.     

Groundwater vulnerability assessment for the Banyas Catchment of the Syrian coastal area using GIS and the RISKE method

Vulnerability assessment to delineate areas that are more susceptible to contamination from anthropogenic sources has become an important element for sensible resource management and landuse planning. This contribution aims at estimating aquifer vulnerability by applying the RISKE model in Banyas Catchment Area (BCA), Tartous Prefecture, west Syria. An additional objective is to demonstrate the combined use of the RISKE model and a geographical information system (GIS) as an effective method for groundwater pollution risk assessment. The RISKE model uses five environmental parameters (Rock of aquifer media, Infiltration, Soil media, Karst, and Epikarst) to characterize the hydro-geological setting and evaluate aquifer vulnerability. The elevated eastern and low western part of the study area was dominated by high vulnerability classes, while the middle part was characterized by moderate vulnerability classes. Based on the vulnerability analysis, it was found that 2% and 39% of BCA is under low and high vulnerability to groundwater contamination, respectively, while more than 52% and 5% of the area of BCA can be designated as an area of moderate and very high vulnerability to groundwater contamination, respectively. The GIS technique has provided an efficient environment for analyses and high capabilities of handling a large amount of spatial data.     

A comprehensive review of the energy efficiency on nano coated fin and tube condenser

The condenser is a piece of equipment used to effectively transfer heat from water to the environment. The fin and tube condenser is the most commonly used in commercial applications. The improved performance of heat transfer in the fin and tube condenser is a significant area of study all over the world because optimizing the efficiency of heat transfer in the condenser will contribute to enhancing the effectiveness of system performance. The vapor deposition, plasma spray, and thermal spray techniques are being used, and it is determined that a heat transfer enhancing coating improves condenser performance. This review discusses the nanomaterial coating over the fin and tube condenser in detail. The various nanomaterial coatings with various propositions and coating methods had been discussed with the evidence of previous researchers. At a 50-degree inclination angle on the condensate plate, the condensate over the coating surface increases by more than 30%. The thermal properties of the working fluid are improved over the condenser, and the overall effectiveness of the condenser is increased by approximately 40% over the non-coated condenser. A 1% volumetric concentration of Nanoparticles in the coated material achieves a maximum efficiency increase of 78.7%.     

Climate variability,water levels,and fish catch in the Upper East Region of Ghana

The aim of the research was to investigate the effects of climate variability on selected water bodies in the Upper East Region of Ghana using time series decomposition and simple linear regression analyses. Data on temperature and rainfall (1960–2015), annual total fish catch (1996–2016), and the recorded water levels (1987–2015) of a major reservoir, the Tono, were used. Time series decomposition analyses were performed on the rainfall, temperature, and water level data to identify their trends. While temperature was increasing, rainfall was decreasing and resulted in a decrease in the water level in the Tono Reservoir. The decreasing water level in the reservoir made fish catch easier, which led to overfishing. Out of the other 39 dugouts studied, 8 (21%) were silted. Also, rainfall was decreasing at 4.4% per decade and minimum and maximum temperatures were increasing at 2.5% and 0.03% per decade, respectively. The minimum, maximum, and mean water levels of the Tono Reservoir were 3.7, 8.0, and 4.9 meters (m), respectively. The water level of the Tono Reservoir was decreasing by ?0.08 m per year. It is concluded that the water level in the Tono Reservoir was continually decreasing as a result of decreasing rainfall and increasing maximum and minimum temperatures. To maintain a much more stable microclimate and decrease the siltation rate of the reservoirs, farmers are advised to stop farming along the banks of water bodies and avoid clearing vegetation. Fishermen are also encouraged to adopt fish farming in enclosed areas within the reservoir to meet the growing protein demands in the Upper East Region of Ghana.