非点源污染河流的水环境容量估算和分配

通过河流相应集水区内氮磷的各污染源分析(包括农地、畜禽养殖和生活排污等),利用输出系数模型估算各非点源的氮磷投(排)放量和入河量;采用河段氮磷输入-输出平衡关系分析方法,估算河流对氮磷的每月自净量.以此为基础,参照水功能区划所要求的水质目标,提出了水质未超标河段相应集水区的氮磷剩余水环境容量按月估算模型,和水质超标河段相应集水区内氮磷投放削减量的按月估算模型,及其在各污染源之间的分配方案.结果表明,长乐江的总氮和总磷自净量分别达到775.9 t·a^-1和30.9 t·a^-1,自净率分别为28.8%和51.2%.河流对氮磷的自净量不仅受水文生态条件的影响而表现出较大的季节性变化,而且随着污染负荷量本身的增加而提高.按照水功能区划中Ⅲ类水的水质要求,长乐江总氮含量全年超标;各非点源的总氮投(排)放量均须不同程度的削减,削减总量应达到1 581.0　t;氮源削减量分配结果表明,化肥是应削减的最大氮源,要求在河流相应集水区内的化肥氮投放削减量为1 047.4 t·a^-1;而与各种氮源的投排放现状相比,要求削减比例最高的是畜禽养殖的氮排放量,达32.4%.长乐江流域尚有一定的总磷剩余水环境容量(2 335.7 t·a^-1).根据目标水质要求,平水期是各污染源总氮投放需要削减的量最大的时期,丰水期则是总磷剩余水环境容量最小的时期.     

上海市PM2.5的物理化学特征及其生物活性研究

采集了上海市区和郊区春季和夏季的大气PM2.5样品,分析了市区和郊区春夏2季PM2.5质量浓度变化的规律,使用PIXE(Proton Induced X-ray Emission)分析技术获得S、K、Ca、Ti、Cr、Mn、Fe、Ni、Cu、Zn、As、Se、Br、Sr、Pb等15种元素的质量浓度.结果表明,上海PM2.5中化学元素的质量浓度在春季(5038.6ng·m-3)比在夏季(3810.6ng·m-3)高,春季郊区(2528.9ng·m-3)和市区(2509.7ng·m-3)PM2.5中化学元素的质量浓度相当,夏季市区样品(1674.2ng·m-3)中化学元素质量浓度的总量比郊区(2136.3 ng·m-3)的低,但来自人为污染的化学元素(Cr、Mn、Ti、Ni、Cu、Zn、As、Br、Sr、Pb)在市区PM2.5中的含量较高;场发射扫描电镜(FESEM)分析显示,上海PM2.5主要由烟尘集合体、燃煤飞灰、矿物颗粒、生物质颗粒和不明物质组成,质粒DNA评价揭示上海市区PM2.5比郊区的具有更强的生物活性,主要原因可能在于市区样品中含有较高的重金属元素和较多的烟尘集合体.     

The analysis of human health risk with a detailed procedure operating in a GIS environment

An approach for quantifying the human health risk caused by industrial sources, which, daily or accidentally, emit dangerous pollutants able to impact on different environmental media, is introduced. The approach is performed by the HHRA-GIS tool which employs an integrated, multimedia, multi-exposure pathways and multi-receptors risk assessment model able to manage all the steps of the analysis in a georeferenced structure. Upper-bound excess lifetime cancer risk and noncarcinogenic hazards are the risk measures, the spatial distribution of which is calculated and mapped on the involved territory, once all the pathways and receptors of the study area are identified. A sensitivity analysis completes the calculations allowing to understand how risk estimates are dependent on variability in the factors contributing to risk. The last part of the paper makes use of a case study concerning a working industrial site to put in evidence in which way the designed tool can help local authorities and policy makers in managing risks and planning remedial and reduction actions. The considered geographical area is a hypothetical territory characterized by residential, agricultural and industrial zones. The presence of two sources of contamination, a municipal waste incinerator (MWI) and a contaminated site, are evaluated by the tool application. Various typologies of receptors have been taken into account, each of them characterized by different anatomical and dietary properties. The achieved results are analyzed, compared with acceptable and background values and alternatives of minor environmental impact calculated.     

Long-term study of environmental levels of dioxins and furans in the vicinity of a municipal solid waste incinerator

From 1975 to 2004, a municipal solid waste incinerator (MSWI) was operating in Montcada (Barcelona, Catalonia, Spain). Because of the potential health risks derived from emission of pollutants by the facility, especially polychlorinated dibenzo-p-dioxins (PCDDs) and dibenzofurans (PCDFs), a long-term monitoring program focused on measuring the environmental levels of PCDD/Fs near the facility, and to assess the health risks for the population living in the neighborhood, was established between 1996 and 2002. A total number of 111 soil and 121 herbage samples were analyzed for PCDD/Fs during this period. Human health risks for the individuals living near the MSWI (500 and 1,000 m) were also assessed before (1998) and after modernization (2000) of the facility. It included PCDD/F inhalation, dermal contact, soil and dust ingestion, and food intake. All these data are here summarized. The environmental levels of PCDD/Fs showed that the MSWI was not the main responsible of the atmospheric pollution by these compounds. In turn, human health risks for the population living in the vicinity of the facility after introduction of a modern technology were negligible in comparison with the dietary PCDD/F exposure.     

Decolorization of Remazol Black-B using a thermotolerant yeast, Kluyveromyces marxianus IMB3

The ability of Kluyveromyces marxianus IMB3 to decolorize Remazol Black-B dye was investigated. The effect of environmental conditions, such as pH and temperature were examined. No noticeable effects on decolorization were observed when pH varied from 3.0-5.5. Maximum colour removal, 98%, was achieved at 37 degrees C. Little or no colour removal was detected when K. marxianus IMB3 was incubated under anaerobic conditions. Further investigation, in which decolorization was monitored under extreme temperatures and low pH (to inhibit growth) and using ten fold dense inoculum, revealed that decolorization was due to biosorption to the yeast cells and not due to a metabolic reaction.     

Retention of estrogenic steroid hormones by selected New Zealand soils

We performed batch sorption experiments for 17beta-estradiol (E2) and 17alpha-ethynylestradiol (EE2) on selected soils collected from dairy farming regions of New Zealand. Isotherms were constructed by measuring the liquid phase concentration and extracting the solid phase with dichloromethane, followed by an exchange step, and analysis by HPLC and UV detection. The corresponding metabolite estrone, (E1) formed during equilibration of E2 with soil was taken into account to estimate the total percentage recoveries for the compounds, which ranged from 47-105% (E2 and E1) and 83-102% (EE2). Measured isotherms were linear, although some deviation from linearity was observed in a few soils, which was attributed to the finer textured particles and/or the allophanic nature of the soils having high surface area. There was a marked difference in K(d)(eff) (effective distribution coefficient) values for E2 and EE2 among the soils, consistent with the soils organic carbon content and ranged from 14-170 L kg(-1) (E2), and 12-40 L kg(-1) (EE2) in the soils common for both compounds. The sorption affinity of hormones in the soils followed an order: EE2相似文献   

The Use of Natural Taraxacum officinale Wigg. Populations for Assessing the State of Technogenically Disturbed Areas

Russian Journal of Ecology -     

Methods for integrated assessment

Integrated assessment is an approach that seeks to involve all disciplines in policy-relevant assessment. The process aims to encompass environmental science, technology and policy problems. The aim is to establish an overview of the environmental issue in question that attempts to avoid the mistakes of the past associated with narrow, one-sided or unidimensional approaches. A number of methods are available for such assessments. However, they are also subject to a number of limitations, difficulties and dilemmas. Integrated methods are inherently complicated and the tradition is that only experts are involved. New more inclusionary procedures have to be devised in order to involve all stakeholders. They have to be involved in the framing of the issue and in the value judgements associated with the approach. The dilemmas cannot be solved by integrated approaches, but they can be mitigated via proper identification, analysis and evaluation of the gains and losses involved. In structuring the analysis the existence of ignorance has to be accounted for and communicated to the managers and the political decision makers. The ignorance/uncertainty aspects can be partially accommodated for via an intensification of feasible monitoring and research so as to minimise the risks of unpleasant surprises. Electronic Publication     

Thallium: a review of public health and environmental concerns

Thallium (Tl) is a rare but widely dispersed element. All forms of thallium are soluble enough to be toxic to living organisms. Thallium is more toxic to humans than mercury, cadmium, lead, copper or zinc and has been responsible for many accidental, occupational, deliberate, and therapeutic poisonings since its discovery in 1861. Its chemical behavior resembles the heavy metals (lead, gold and silver) on the one hand and the alkali metals (K, Rb, Cs) on the other. It occurs almost exclusively in natural waters as monovalent thallous cation. The solubility of thallous compounds is relatively high so that monovalent thallium is readily transported through aqueous routes into the environment. Tl can be transferred from soils to crops readily and accrues in food crops. The fascinating chemistry and high toxicity potential make thallium and its compounds of particular scientific interest and environmental concern. Thallium was detected in base-metal mining effluents. The conventional removal of heavy metals from wastewater has little effect on thallium. In this review, various treatment options and removal technologies are enumerated in order to protect the environment from thallium toxicity.