Towards optimal sampling schedules for integral pumping tests

Ethanol use as a gasoline additive is increasing, as are the chances of groundwater contamination caused by gasoline releases involving ethanol. To evaluate the impact of ethanol on dissolved hydrocarbon plumes, a field test was performed in which three gasoline residual sources with different ethanol fractions (E0: no ethanol, E10: 10% ethanol and E95: 95% ethanol) were emplaced below the water table. Using the numerical model BIONAPL/3D, the mass discharge rates of benzene, toluene, ethylbenzene, xylenes, trimethylbenzenes and naphthalene were simulated and results compared to those obtained from sampling transects of multilevel samplers. It was shown that ethanol dissolved rapidly and migrated downgradient as a short slug. Mass discharge of the hydrocarbons from the E0 and E10 sources suggested similar first-order hydrocarbon decay rates, indicating that ethanol from E10 had no impact on hydrocarbon degradation. In contrast, the estimated hydrocarbon decay rates were significantly lower when the source was E95. For the E0 and E10 cases, the aquifer did not have enough oxygen to support complete mineralization of the hydrocarbon compounds to the extent suggested by the field-based mass discharge. Introducing a heterogeneous distribution of hydraulic conductivity did little to overcome this discrepancy. A better match between the numerical model and the field data was obtained assuming partial degradation of the hydrocarbons to intermediate compounds. Besides depending on the ethanol concentration, the impact of ethanol on hydrocarbon degradation appears to be highly dependent on the availability of electron acceptors.     

Identification of perfluoroalkyl acid sources in Swiss surface waters with the help of the artificial sweetener acesulfame

Anthropogenic perfluorinated compounds (PFCs), especially the perfluoroalkyl acids (PFAAs) are ubiquitously found in surface waters around the globe. Emissions from households, industries and also atmospheric transport/deposition are discussed as the possible sources. In this study, these sources are evaluated using Switzerland as the study area. Forty-four surface water locations in different rivers and an Alpine lake were investigated for 14 PFAAs, four precursors and acesulfame, an artificial sweetener used as a population marker. Concentrations of individual PFAAs were generally low, between 0.02 and 10 ng/L. Correlation analysis showed that some PFAAs concentrations correlated well with population and less with catchment area, indicating that emissions from population, i.e., from consumer products, is the most important source to surface waters in Switzerland. The correlation with the population marker acesulfame confirmed this observation but highlighted also a few elevated PFAA levels, some of which could be attributed to industrial emissions.     

Arsenic strongly associates with ferrihydrite colloids formed in a soil effluent

Arsenic mobility may increase in liquid phase due to association with colloidal Fe oxides. We studied the association of As with Fe oxide colloids in the effluent from water-saturated soil columns run under anoxic conditions. Upon exfiltration, the solutions, which contained Fe²⁺, were re-aerated and ferrihydrite colloids precipitated. The entire amount of effluent As was associated with the ferrihydrite colloids, although PO₄³⁻, SiO₄⁴⁻, CO₃²⁻ and dissolved organic matter were present in the effluent during ferrihydrite colloid formation. Furthermore, no subsequent release of As from the ferrihydrite colloids was observed despite the presence of these (in)organic species known to compete with As for adsorption on Fe oxides. Arsenic was bound via inner-sphere complexation on the ferrihydrite surface. FTIR spectroscopy also revealed adsorption of PO₄³⁻ and polymerized silica. However, these species could not impede the quantitative association of As with colloidal ferrihydrite in the soil effluents.     

Hexachlorocyclohexane (HCH) as new Stockholm Convention POPs��a global perspective on the management of Lindane and its waste isomers

Purpose

Hexachlorocyclohexane (HCH) isomers (??-, ??- and ??- (Lindane)) were recently included as new persistent organic pollutants (POPs) in the Stockholm Convention, and therefore, the legacy of HCH and Lindane production became a contemporary topic of global relevance. This article wants to briefly summarise the outcomes of the Stockholm Convention process and make an estimation of the amount of HCH waste generated and dumped in the former Lindane/HCH-producing countries.

Results

In a preliminary assessment, the countries and the respective amount of HCH residues stored and deposited from Lindane production are estimated. Between 4 and 7 million tonnes of wastes of toxic, persistent and bioaccumulative residues (largely consisting of alpha- (approx. 80%) and beta-HCH) are estimated to have been produced and discarded around the globe during 60 years of Lindane production. For approximately 1.9 million tonnes, information is available regarding deposition. Countries are: Austria, Brazil, China, Czech Republic, France, Germany, Hungary, India, Italy, Japan, Macedonia, Nigeria, Poland, Romania, Slovakia, South Africa, Spain, Switzerland, Turkey, The Netherlands, UK, USA, and former USSR. The paper highlights the environmental relevance of deposited HCH wastes and the related POPs?? contaminated sites and provides suggestions for further steps to address the challenge of the legacy of HCH/Lindane production.

Conclusion

It can be expected that most locations where HCH waste was discarded/stockpiled are not secured and that critical environmental impacts are resulting from leaching and volatilisation. As parties to the Stockholm Convention are legally required to take action to stop further POPs pollution, identification and evaluation of such sites are necessary.     

Nutritionally relevant elements in staple foods: influence of arable site versus choice of variety

Eighteen representative sites for the Austrian grain-growing and eight for the potato-growing zones (soils and crops) were investigated. On each site, total element contents (B, Ba, Ca, Cd, Co, Cu, Fe, K, Li, Mg, Mn, Mo, Na, P, Sr and Zn) were determined in 4–12 varieties of winter wheat (n = 136), 6 varieties of spring durum wheat (n = 30), 5 varieties of winter durum wheat (n = 15), 7 varieties of rye (n = 49), 5 varieties of spring barley (n = 30) and 5 varieties of potatoes (n = 40). Element accumulations in grain species and potato tubers varied significantly with site conditions, with the main exceptions for B in potatoes and wheat as well as for Zn, Cu and Co in durum wheat. On average, across all investigated sites, differences in varieties occurred concerning the elements Ca, Cd, Ba, Sr and Zn (except Zn in potatoes and winter durum). A rough estimation revealed that an average Austrian consumer of wheat, rye and potatoes meets more than 50% of the needs of daily element intake for K, P and Mg, between 36 and 72% for Fe, Zn and Cu, and more than 100% for Co, Mo and Mn. In particular, the elements Ca and Na have to be added from other sources.     

Distribution,fate and formation of non-extractable residues of a nonylphenol isomer in soil with special emphasis on soil derived organo-clay complexes

Anthropogenic contaminants like nonylphenols (NP) are added to soil, for instance if sewage-sludge is used as fertilizer in agriculture. A commercial mixture of NP consists of more than 20 isomers. For our study, we used one of the predominate isomers of NP mixtures, 4-(3,5-dimethylhept-3-yl)phenol, as a representative compound. The aim was to investigate the fate and distribution of the isomer within soil and soil derived organo-clay complexes. Therefore, ¹⁴C- and ¹³C-labeled NP was added to soil samples and incubated up to 180 days. Mineralization was measured and soil samples were fractionated into sand, silt and clay; the clay fraction was further separated in humic acids, fulvic acids and humin. The organo-clay complexes pre-incubated for 90 or 180 days were re-incubated with fresh soil for 180 days, to study the potential of re-mobilization of incorporated residues. The predominate incorporation sites of the nonylphenol isomer in soil were the organo-clay complexes. After 180 days of incubation, 22 % of the applied ¹⁴C was mineralized. The bioavailable, water extractable portion was low (9 % of applied ¹⁴C) and remained constant during the entire incubation period, which could be explained by an incorporation/release equilibrium. Separation of organo-clay complexes, after extraction with solvents to release weakly incorporated, bioaccessible portions, showed that non-extractable residues (NER) were preferentially located in the humic acid fraction, which was regarded as an effect of the chemical composition of this fraction. Generally, 27 % of applied ¹⁴C was incorporated into organo-clay complexes as NER, whereas 9 % of applied ¹⁴C was bioaccessible after 180 days of incubation. The re-mobilization experiments showed on the one hand, a decrease of the bioavailability of the nonylphenol residues due to stronger incorporation, when the pre-incubation period was increased from 90 to 180 days. On the other hand, a shift of these residues from the clay fraction to other soil fractions was observed, implying a dynamic behavior of incorporated residues, which may result in bioaccessibility of the NER of nonylphenol.     

Biomonitoring of heavy metals in the feathers of House crow (Corvus splendens) from some metropolitans of Asia and Africa

Environmental Science and Pollution Research - Urban-dwelling birds can be useful biomonitors to assess the impact of the urbanisation on both public and wildlife health. Widely distributed urban...     

Multicriteria evaluation of simulated logging scenarios in a tropical rain forest

Forest growth models are useful tools for investigating the long-term impacts of logging. In this paper, the results of the rain forest growth model FORMIND were assessed by a multicriteria decision analysis. The main processes covered by FORMIND include tree growth, mortality, regeneration and competition. Tree growth is calculated based on a carbon balance approach. Trees compete for light and space; dying large trees fall down and create gaps in the forest. Sixty-four different logging scenarios for an initially undisturbed forest stand at Deramakot (Malaysia) were simulated. The scenarios differ regarding the logging cycle, logging method, cutting limit and logging intensity. We characterise the impacts with four criteria describing the yield, canopy opening and changes in species composition. Multicriteria decision analysis was used for the first time to evaluate the scenarios and identify the efficient ones. Our results plainly show that reduced-impact logging scenarios are more 'efficient' than the others, since in these scenarios forest damage is minimised without significantly reducing yield. Nevertheless, there is a trade-off between yield and achieving a desired ecological state of logged forest; the ecological state of the logged forests can only be improved by reducing yields and enlarging the logging cycles. Our study also demonstrates that high cutting limits or low logging intensities cannot compensate for the high level of damage caused by conventional logging techniques.     

Heavy metal release from contaminated soils: comparison of column leaching and batch extraction results

Heavy metals in soils may adversely affect environmental quality. In this study, we investigated the release of Zn, Cd, Pb, and Cu from four contaminated soils by column leaching and single and sequential batch extractions. Homogeneously packed soil columns were leached with 67 mL/g 10(-2) M CaCl2 to investigate the exchangeable metal pool and subsequently with 1400 mL/g 10(-2) M CaCl2 adjusted to pH 3 to study the potential of metal release in response to soil acidification. In two noncalcareous soils (pH 5.7 and 5.1), exchange by Ca resulted in pronounced release peaks for Zn and Cd that were coupled to the exchange of Mg by Ca, and 40 to 70% of total Zn and Cd contents were rapidly mobilized. These amounts compared well with exchangeable pools determined in single and sequential batch extractions. In two soils with near-neutral pH, the effluent concentrations of Zn and Cd were several orders of magnitude lower and no pronounced elution peaks were observed. This behavior was also observed for Cu and Pb in all four soils. When the soils were leached at pH 3, the column effluent patterns reflected the coupling of CaCO3 dissolution (if present) and other proton buffering reactions, proton-induced metal release, and metal-specific readsorption within the soil column. Varying the flow rate by a factor of five had only minor effects on the release patterns. Overall, Ca exchange and subsequent acidification to pH 3 removed between 65 and 90% of total Zn, Cd, Pb, and Cu from the four contaminated soils.