Use of treated bark for the removal of lipids from water

Raw, biologically treated bark and bark impregnated with transition metal ions were used to retain the lipids from synthetic emulsions. Several experimental parameters affecting the lipid removal efficiency (RE) were studied (initial concentration of lipids, temperature, time, pH, carboxylic acid chain length, etc.). Saturated bark was characterized using Fourier transform infrared (FTIR) spectroscopy and light microscopy, and the treated bark wetting index was determined. Results show that lipid removal can exceed 95% of the initial concentration at a pH lower than 7. The uptake of lipids by these sorbents varied from 0.2 to 2.5 g/g of dry bark. Trials for regenerating the sorbent saturated by lipids allowed the recovery of approximately 95% of lipids. The calorific value of the saturated bark was approximately 79% that of domestic fuel and can be considered as an energy source, thus avoiding its waste disposal. These results may upgrade the treatment of wastewater generated by several industrial sectors, such as the food industry, surface treatment, and so on.     

Potentially toxic elements (PTEs) in soils from the surroundings of the Trans-Amazonian Highway,Brazil

The Trans-Amazonian Highway (TAH) is located in the northern region of Brazil, comprising a border region where agricultural, mining, and logging activities are the main activities responsible for fostering economic development, in addition to large hydroelectric plants. Such activities lead to environmental contamination by potentially toxic elements (PTEs). Environmental monitoring is only possible through the determination of element contents under natural conditions. Many extraction methods have been proposed to determine PTEs’ bioavailability in the soil; however, there is no consensus about which extractor is most suitable. In this study, we determined the contents of PTEs in soils in the surroundings of TAH after mineral extraction with diethylenetriaminepentaacetic acid-triethanolamine (DTPA-TEA), Mehlich I, and Mehlich III solutions. Soil samples were collected in areas of natural vegetation in the vicinity of TAH in the state of Pará, Brazil. Chemical attributes and particle size were determined, besides concentrations of Fe, Al, Mn, and Ti by sulfuric acid digestion, Si after alkaline solution attack, and poorly crystalline Fe, Al, and “free” Fe oxides. Mehlich III solution extracted greater contents from Fe, Al, and Pb as compared to Mehlich I and DTPA-TEA and similar contents from Cd, Mn, Zn, and Cu. Significant correlations were found between concentrations of PTEs and the contents of Fe and Mn oxides as well as organic carbon and soil cation exchange capacity. Contents of Cu, Mn, Fe, and Zn by the three methods were positively correlated.     

Atrazine Transport Within a Coastal Zone in Southeastern Puerto Rico: a Sensitivity Analysis of an Agricultural Field Model and Riparian Zone Management Model

Agrichemical runoff from farmland may adversely impact coastal water quality. Two models, the Agricultural Policy/Environmental eXtender (APEX) and the Riparian Ecosystem Management Model (REMM), were used to evaluate the movement of the herbicide atrazine to the Jobos Bay National Estuarine Research Reserve from adjacent fields. The reserve is located on Puerto Rico’s southeast coast. Edge-of-field atrazine outputs simulated with the APEX were routed through a grass-forest buffer using the REMM. Atrazine DT₅₀ (half-life) values measured in both field and buffer soils indicated that accelerated degradation conditions had developed in the field soil due to repeated atrazine application. APEX simulations examined both the measured field and buffer soil atrazine DT₅₀ and the model’s default value. The use of the measured field soil atrazine degradation rate in the APEX resulted in 33 % lower atrazine transport from the field. REMM simulations indicated that the buffer system had the potential to reduce dissolved atrazine transport in surface runoff by 77 % during non-tropical storm events by increasing infiltration, slowing transport, and increasing time for pesticide degradation. During a large runoff event due to a tropical storm that occurred close to the time of an atrazine application, the REMM simulated only a 37 % reduction in atrazine transport. The results indicate that large storm events soon after herbicide application likely dominate herbicide transport to coastal waters in the region. These results agree with water quality measurements in the reserve. This study demonstrated the sensitivity of these models to variations in DT₅₀ values in evaluating atrazine fate and transport in the region and emphasizes that the use of measured DT₅₀ values can improve model accuracy.     

Influence of the presence of ruthenium on the activity and stability of Co–Mg–Al-based catalysts in CO2 reforming of methane for syngas production

Environmental Science and Pollution Research - Hydrogen production by methane dry reforming is an important yet challenging process. A performing catalyst will favor the thermodynamic equilibrium...     

Hydrogen production from food wastes and gas post-treatment by CO2 adsorption

The production of H₂ by biological means, although still far from being a commercially viable proposition, offers great promise for the future. Purification of the biogas obtained may lead to the production of highly concentrated H₂ streams appropriate for industrial application. This research work evaluates the dark fermentation of food wastes and assesses the possibility of adsorbing CO₂ from the gas stream by means of a low cost biomass-based adsorbent. The reactor used was a completely stirred tank reactor run at different hydraulic retention times (HRTs) while the concentration of solids of the feeding stream was kept constant. The results obtained demonstrate that the H₂ yields from the fermentation of food wastes were affected by modifications in the hydraulic retention time (HRT) due to incomplete hydrolysis. The decrease in the duration of fermentation had a negative effect on the conversion of the substrate into soluble products. This resulted in a lower amount of soluble substrate being available for metabolisation by H₂ producing microflora leading to a reduction in specific H₂ production.Adsorption of CO₂ from a gas stream generated from the dark fermentation process was successfully carried out. The data obtained demonstrate that the column filled with biomass-derived activated carbon resulted in a high degree of hydrogen purification. Co-adsorption of H₂S onto the activated carbon also took place, there being no evidence of H₂S present in the bio-H₂ exiting the column. Nevertheless, the concentration of H₂S was very low, and this co-adsorption did not affect the CO₂ capture capacity of the activated carbon.     

Dry-thermophilic anaerobic digestion of organic fraction of municipal solid waste: methane production modeling

The influence of particle size and organic matter content of organic fraction of municipal solid waste (OFMSW) in the overall kinetics of dry (30% total solids) thermophilic (55 °C) anaerobic digestion have been studied in a semi-continuous stirred tank reactor (SSTR). Two types of wastes were used: synthetic OFMSW (average particle size of 1 mm; 0.71 g Volatile Solids/g waste), and OFMSW coming from a composting full scale plant (average particle size of 30 mm; 0.16 g Volatile Solids/g waste).A modification of a widely-validated product-generation kinetic model has been proposed. Results obtained from the modified-model parameterization at steady-state (that include new kinetic parameters as K, Y_pMAX and θ_MIN) indicate that the features of the feedstock strongly influence the kinetics of the process. The overall specific growth rate of microorganisms (μ_max) with synthetic OFMSW is 43% higher compared to OFMSW coming from a composting full scale plant: 0.238 d⁻¹ (K = 1.391 d⁻¹; Y_pMAX = 1.167 L CH₄/gDOC_c; θ_MIN = 7.924 days) vs. 0.135 d⁻¹ (K = 1.282 d⁻¹; Y_pMAX = 1.150 L CH₄/gDOC_c; θ_MIN = 9.997 days) respectively.Finally, it could be emphasized that the validation of proposed modified-model has been performed successfully by means of the simulation of non-steady state data for the different SRTs tested with each waste.     

Co-digestion of cattle manure with food waste and sludge to increase biogas production

Anaerobic co-digestion strategies are needed to enhance biogas production, especially when treating certain residues such as cattle/pig manure. This paper presents a study of co-digestion of cattle manure with food waste and sewage sludge. With the aim of maximising biogas yields, a series of experiments were carried out under mesophilic and thermophilic conditions using continuously stirred-tank reactors, operating at different hydraulic residence times. Pretreatment with ultrasound was also applied to compare the results with those obtained with non-pretreated waste. Specific methane production decreases when increasing the OLR and decreasing HRT. The maximum value obtained was 603 LCH(4)/kg VS(feed) for the co-digestion of a mixture of 70% manure, 20% food waste and 10% sewage sludge (total solid concentration around 4%) at 36°C, for an OLR of 1.2g VS/Lday. Increasing the OLR to 1.5g VS/Lday led to a decrease of around 20-28% in SMP. Lower methane yields were obtained when operating at 55°C. The increase in methane production when applying ultrasound to the feed mixtures does not compensate for the energy spent in this pretreatment.     

Recycling of extruded polystyrene wastes by dissolution and supercritical CO2 technology

Polystyrene (PS) is currently used as packaging, insulating and storing material in various industrial or domestic fields. As a result, a large quantity of PS wastes is produced. Plastic wastes are not usually biodegradable, so it is necessary to suggest a technology to recycle them. Landfills and incineration are reasonably cheap methods but are not environmentally acceptable, therefore, alternative methods for polymer recycling are required. The general purpose of PS foam recycling is to recover a more compact polymeric material without degradation. Dissolution with terpenic solvents is presented here as an efficient and cheap alternative that is developed at room temperature; among the oils studied, limonene was selected because of its intermediate solubility and its abundance. The solvent removal is possible thanks to supercritical technology that provides a high solubility in limonene and almost a complete PS insolubility at moderated pressures (77?bar) and low temperatures (30?°C). Thus, based on the results of thermogravimetric and chromatographic analysis, we propose that.supercritical antisolvent precipitation is an ideal technique for carrying out the separation of PS and limonene, providing a recycled polymer with a reduced volume, almost completely free of solvent and without degradation of the polymeric chains.     

Safety culture: analysis of the causal relationships between its key dimensions

INTRODUCTION: Several fields are showing increasing interest in safety culture as a means of reducing accidents in the workplace. The literature shows that safety culture is a multidimensional concept. However, considerable confusion surrounds this concept, about which little consensus has been reached. METHOD: This study proposes a model for a positive safety culture and tests this on a sample of 455 Spanish companies, using the structural equation modeling statistical technique. RESULTS: Results show the important role of managers in the promotion of employees' safe behavior, both directly, through their attitudes and behaviors, and indirectly, by developing a safety management system. IMPACT ON INDUSTRY: This paper identifies the key dimensions of safety culture. In addition, a measurement scale for the safety management system is validated. This will assist organizations in defining areas where they need to progress if they wish to improve their safety. Also, we stress that managers need to be wholly committed to and personally involved in safety activities, thereby conveying the importance the firm attaches to these issues.