秦皇岛市天然矿泉水水质特征及开发利用前景研究

秦皇岛市天然矿泉水主要赋存在早太古代的花岗岩和变质岩的构造裂隙与风化裂隙之中,有锶、偏硅酸、锶及偏硅酸、锶溴及偏硅酸等4种类型。矿泉水水源地数量较多,水质优良,但开采程度较低,开发利用前景广阔。     

纳米零价铁的制备及其去除水中对氯硝基苯的研究

通过FeSO4与KBH4反应,利用液相还原法制备纳米零价铁颗粒(NZVI),用XRD、SEM和BET对其性能进行表征。在常温常压下利用纳米铁还原废水中的对氯硝基苯(p-CNB),探讨了反应条件对还原率的影响。结果表明,制备过程中碱性物质(NaOH)的添加可以明显减小颗粒粒径,增大比表面积,提高纳米铁还原反应的效率。NZVI对于对氯硝基苯有很好的去除效果,NZVI用量、p-CNB初始浓度和pH值均对其去除效率产生影响。在纳米铁投加量为1 g/L,pH=2的条件下,添加NaOH的纳米铁能在120 min内将质量浓度为50 mg/L的对氯硝基苯基本完全降解,降解率为98.8%。此外,还对NZVI还原对氯硝基苯的机理进行了初步探讨。     

麻质活性炭的制备及其对Cu~(2+)的吸附研究

以废麻为原料,KOH为活化剂制备粉状活性炭,通过静态吸附实验研究了活性炭对Cu2+的吸附性能,探讨了溶液起始pH值、活性炭投加量、吸附时间、起始Cu2+质量浓度等对Cu2+吸附效果的影响。结果表明,溶液pH和活性炭投加量对吸附效果有较大影响,活性炭对Cu2+的吸附率在60 min内超过50%,初始浓度在10~50 mg/L时,活性炭对Cu2+的吸附量与起始浓度近似成正比。采用Langmuir、Freundlich吸附等温式对吸附平衡数据进行了拟合,结果表明吸附等温线符合Frenudlich模型。采用傅立叶红外光谱法(FT-IR)分析了活性炭的表面官能团,分析表明活性炭表面酸性官能团可能是吸附Cu2+的活性中心。     

利用城市污泥堆肥及建筑弃土种植麦冬研究

将污泥堆肥产品分别与建筑弃土按0%、10%、20%、30%、40%和50%(湿重)的比例配制营养土,以麦冬为例进行180 d的栽培实验,分析了营养土对麦冬生长特性、植物体内及栽培土壤中营养学指标和重金属含量的变化规律,并通过模糊综合评价方法选择营养土较佳配制方案。实验结果表明:堆肥比例在50%时麦冬生物量增加率、新生芽数及地表部分比重为最大值,在30%时纺锤体肉质数减少率为最大值;随着营养土中堆肥比例增加,麦冬体内养分含量、重金属积累量随之增加,均在50%时达到最大值;栽培土壤养分越多损失量越多,各指残留率越低,同时全磷、全氮及K含量降低率较有效磷、碱解氮小得多,Cr降低率在5.20%～8.34%之间,Zn降低率在3.27%～17.35%之间;堆肥比例在40%以上的营养土对麦冬生长效果好,但较佳配制方案为堆肥产品占20%。     

微生物燃料电池法测BOD影响因素研究

以双室无介体微生物燃料电池构建了BOD检测系统,研究了阴极流量、有机物浓度(BOD)及阳极流量的变化对系统响应信号(电池电压)的影响,并考察了系统响应信号与BOD浓度的对应关系。结果表明:阴极流量在1.5～5mL/min时,阴极流量变化对响应信号具有显著的影响,且响应信号随阴极流量增大而增大;当阴极流量由5 mL/min增加到10 mL/min时,阴极流量变化对响应信号影响不显著。BOD浓度在10～150 mg/L时,响应信号随底物浓度增加而升高,而BOD浓度大于150 mg/L时,BOD浓度变化对响应信号没有显著影响。当BOD浓度较高时,阳极流量变化对响应信号影响不大,但当BOD浓度较低时,阳极流量变化对响应信号有显著影响,且响应信号随阳极流量增大而增加。电池稳态电压与BOD浓度在10～150 mg/L范围内成指数衰减关系,而电池电压的初始变化速率与BOD浓度在50～200 mg/L范围有线性响应。     

Distribution of radionuclides in the guano sediments of Xisha Islands, South China Sea and its implication

Several natural and anthropogenic radionuclides (²¹⁰Pb, ²²⁶Ra and ¹³⁷Cs) in guano-phosphatic coral sediments and pure guano particles collected from Ganquan, Guangjin, Jinqing and Jinyin Islands of the Xisha archipelago, South China Sea, were analyzed. The Constant Initial Concentration (CIC) model and the Constant Rate of Supply (CRS) model were applied for age calculation. The average supply rate of ²¹⁰Pb was 126 Bq m⁻² a⁻¹, very close to the flux of northern hemisphere average (125 Bq m⁻² a⁻¹). The activities of anthropogenic radionuclides in the sediments were very low, indicating that human nuclear tests did not notably impact this region. The main source of radionuclides in the sediments was from atmospheric precipitation, and the organic matter derived from plant and produced by nutrient-rich guano could further enhance them.     

Joint action and lethal levels of toluene, ethylbenzene, and xylene on midge (Chironomus plumosus) larvae

Aquatic ecosystems are vulnerable to the exposure with petrochemicals such as toluene, ethylbenzene, and xylene (o-, m-, and p-xylene) (TEX) and their adverse effects. Considering the widespread use, occurrence, and high toxicity of TEX, the aim of this work was to investigate the differential toxicity of TEX against midge (Chironomus plumosus) larvae and reveal the joint action of binary and ternary mixtures of TEX using the predictive concentration addition model. More importantly, this research can afford the basic toxicity data and scientific reference for the establishment of water quality criteria or benchmark, water pollution control, and aquatic risk assessment. Single and joint toxic effects of TEX on C. plumosus larvae were investigated using a semi-static bioassay, and the type of joint effects of TEX was ascertained. In the single toxicant experiments, the toxicity of the three pollutants could be sequenced as ethylbenzene > xylene > toluene. Specifically, LC_50s of T, E, and X after a 48-h exposure were 64.9, 37.8, and 42.0 mg/L, respectively. In the binary mixture experiments, the interaction between toluene and ethylbenzene, ethylbenzene and xylene, and toluene and xylene was largely in conformity with partial additive or additive effect as determined by isobologram representation and toxic unit models. In the ternary mixture experiments, the interaction was basically dependent on the use of additive index and mixture toxicity index methods. However, the antagonistic and synergistic actions were not significant. Thus, the tertiary mixture interaction could be regarded as additive action. The concentration addition model could successfully predict the joint action of TEX mixtures on C. plumosus larvae. Particularly, the additive action of TEX on C. plumosus larvae can be further recommended to evaluate water quality criteria of TEX.     

Cadmium tolerance in six poplar species

Selection of poplar species with greater Cd tolerance and exploiting the physiological mechanisms involved in Cd tolerance are crucial for application of these species to phyto-remediation. The aim of this study is to investigate variation in Cd tolerance among the six poplar species and its underlying physiological mechanisms. Cuttings of six Populus species were cultivated for 10 weeks before exposure to either 0 or 200 μM CdSO₄ for 20 days. Gas exchange in mature leaves was determined by a portable photosynthesis system. Cd concentrations in tissues were analyzed by a flame atomic absorbance spectrometry. Subsequently, Cd amount per plant, bio-concentration factor (BCF) and translocation factor (T _f) were calculated. Nonenzymatic compounds and activities of antioxidative enzymes in tissues were analyzed spectrophotometrically. Cd exposure caused decline in photosynthesis in four poplar species including Populus cathayana (zhonghua 1). Among the six species, P. cathayana (zhonghua 1) displayed the highest Cd concentrations in tissues, the largest Cd amount in aerial parts, the highest BCF in aerial parts and T _f under Cd exposure. Under Cd stress, increases in total soluble sugars in roots but decreases in starch in roots, wood, and leaves of P. cathayana (zhonghua 1) were found. Induced O ₂ ^?? and H₂O₂ production in roots and leaves, and increases in free proline, soluble phenolics, and activities of antioxidative enzymes were observed in P. cathayana (zhonghua 1). Based on results of this pot experiment, it is concluded that P. cathayana (zhonghua 1) is superior to other five species for Cd phyto-remediation, and its well-coordinated physiological changes under Cd exposure confer the great Cd tolerance of this species.     

Synthesis of hybrid carbon nanotubes using Brassica juncea L. application to photodegradation of bisphenol A

Hyperaccumulators contain tubular cellulose and heavy metals, which can be used as the sources of carbon and metals to synthesize nanomaterials. In this paper, carbon nanotubes (CNTs), Cu_0.05Zn_0.95O nanoparticles, and CNTs/Cu_0.05Zn_0.95O nanocomposites were synthesized using Brassica juncea L. plants, and the ultraviolet (UV)-light-driven photocatalytic degradations of bisphenol A (BPA) using them as photocatalysts were studied. It was found that the outer diameter of CNTs was around 50 nm and there were a few defects in the crystal lattice. The synthesized Cu_0.05Zn_0.95O nanocomposites had a diameter of around 40 nm. Cu_0.05Zn_0.95O nanocomposites have grown on the surface of the CNTs and the outer diameter of them was around 100 nm. The synthesized hybrid carbon nanotubes using B. juncea could enhance the efficiency of photocatalytic degradation on BPA. The complete equilibration time of adsorption/desorption of BPA onto the surface of CNTs, Cu_0.05Zn_0.95O nanoparticles, and CNTs/Cu_0.05Zn_0.95O nanocomposites was within 30, 20, and 30 min, and approximately 14.9, 8.7, and 17.4 % BPA was adsorbed by them, respectively. The combination of UV light irradiation (90 min) with CNTs, Cu_0.05Zn_0.95O nanoparticles, and CNTs/Cu_0.05Zn_0.95O nanocomposites could lead to 48.3, 75.7, and 92.6 % decomposition yields of BPA, respectively. These findings constitute a new insight for synthesizing nanocatalyst by reusing hyperaccumulators.     

Occurrence and distribution of heavy metals and tetracyclines in agricultural soils after typical land use change in east China

Land use in east China tends to change from paddy rice to vegetables or other high-value cash crops, resulting in high input rates of organic manures and increased risk of contamination with both heavy metals (HMs) and antibiotics. This investigation was conducted to determine the accumulation, distribution and risks of HMs and tetracyclines (TCs) in surface soils and profiles receiving different amounts of farmyard manure. Soil samples collected from suburbs of Hangzhou city, Zhejiang province were introduced to represent three types of land use change from paddy rice to asparagus production, vineyards and field mustard cultivation, and divided into two portions, one of which was air-dried and sieved through 2-, 0.3- and 0.149-mm nylon mesh for determination of pH and heavy metals. The other portion was frozen at ?20 °C, freeze-dried and sieved through a 0.3-mm nylon mesh for tetracyline determination. HM and TC concentrations in surface soils of 14-year-old mustard fields were the highest with total Cu, Zn, Cd and ∑TCs of 50.5, 196, 1.03 mg?kg^?1 and 22.9 μg?kg^?1, respectively, on average. The total Cu sequence was field mustard?>?vineyards?>?asparagus when duration of land use change was considered; oxytetracycline (OTC) and doxycycline were dominant in soils used for asparagus production; OTC was dominant in vineyards and chlortetracycline (CTC) was dominant in mustard soils. There were positive pollution relationships among Cu, Zn and ∑TCs, especially between Cu and Zn or Cu and ∑TCs. Repeated and excessive application of manures from intensive farming systems may produce combined contamination with HMs and TCs which were found in the top 20 cm of the arable soil profiles and also extended to 20–40 cm depth. Increasing manure application rate and cultivation time led to continuing increases in residue concentrations and movement down the soil profile.