Matrine and oxymatrine in corroborant plant extracts and fertilizers: HPLC/MS-MS method development and single-laboratory validation

A reversed phase high-performance liquid chromatographic method (HPLC/MS-MS) has been developed and validated for detection of alkaloids matrine and oxymatrine in fertilizer with labeled enhancer plant defense activities. The analytical method was validated statistically. The results show a strong matrix effect, requiring quantification by standard addition method. The regression lines showed r² > 0.994. Recoveries ranging from 97 to 104% were obtained for the fortification level of 0.01% wt wt^?1 and the relative standard deviations ranged from 3 to 4% (n = 10). The limits of detection were below 0.0001% wt wt^?1, while the limits of quantification did not exceed 0.0004% wt wt^?1. The method is currently applied in ICQRF Laboratory of Catania on fertilized and corroborant plant extract collected in the Italian market in the frame of MIPAAF institutional quality control activity, with the aim to dectect these unpermitted active substances.     

Precision and Accuracy in the Determination of Sulfur Oxides,Fluoride, and Spherical Aluminosilicate Fly Ash Particles in Project MOHAVE

The precision and accuracy of the determination of particu-late sulfate and fluoride, and gas phase SO₂ and HF are estimated from the results obtained from collocated replicate samples and from collocated comparison samples for high-and low-volume filter pack and annular diffusion denuder samplers. The results of replicate analysis of collocated samples and replicate analyses of a given sample for the determination of spherical aluminosilicate fly ash particles have also been compared. Each of these species is being used in the chemical mass balance source apportionment of sulfur oxides in the Grand Canyon region as part of Project MOHAVE, and the precision and accuracy analyses given in this paper provide input to that analysis. The precision of the various measurements reported here is ±1.8 nmol/m³ and ±2.5 nmol/m³ for the determination of SO₂ and sulfate, respectively, with an annular denuder. The precision is ±0.5 nmol/m³ and ±2.0 nmol/m³ for the determination of the same species with a high-volume or low-volume filter pack. The precision for the determination of the sum of HF(g) and fine particulate fluoride is ±0.3 nmol/m³. The precision for the determination of aluminosilicate fly ash particles is ±100 particles/m³. At high concentrations of the various species, reproducibility of the various measurements is ±10% to ±14% of the measured concentration. The concentrations of sulfate determined using filter pack samplers are frequently higher than those determined using diffusion denuder sampling systems. The magnitude of the difference (e.g., 2-10 nmol sulfate/m³) is small, but important relative to the precision of the data and the concentrations of particulate sul-fate present (typically 5-20 nmol sulfate/m³). The concentrations of SO₂(g) determined using a high-volume cascade impactor filter pack sampler are correspondingly lower than those obtained with diffusion denuder samplers. The concentrations of SO_x (SO₂(g) plus particulate sulfate) determined using the two samplers during Project MOHAVE at the Spirit Mountain, NV, and Hopi Point, AZ, sampling sites were in agreement. However, for samples collected at Painted Desert, AZ, and Meadview, AZ, the concentrations of SO_x and SO₂(g) determined with a high-volume cascade impactor filter pack sampler were frequently lower than those determined using a diffusion denuder sampling system. These two sites had very low ambient relative humidity, an average of 25%. Possible causes of observed differences in the SO₂(g) and sulfate results obtained from different types of samplers are given.     

The adaptive response of lichens to mercury exposure involves changes in the photosynthetic machinery

Lichens are an excellent model to study the bioaccumulation of heavy metals but limited information is available on the molecular mechanisms occurring during bioaccumulation. We investigated the changes of the lichen proteome during exposure to constant concentrations of mercury. We found that most of changes involves proteins of the photosynthetic pathway, such as the chloroplastic photosystem I reaction center subunit II, the oxygen-evolving protein and the chloroplastic ATP synthase β-subunit. This suggests that photosynthesis is a target of the toxic effects of mercury. These findings are also supported by changes in the content of photosynthetic pigments (chlorophyll a and b, and β-carotene). Alterations to the photosynthetic machinery also reflect on the structure of thylakoid membranes of algal cells. Response of lichens to mercury also involves stress-related proteins (such as Hsp70) but not cytoskeletal proteins. Results suggest that lichens adapt to mercury exposure by changing the metabolic production of energy.     

Enhanced retention of linuron, alachlor and metalaxyl in sandy soil columns intercalated with wood barriers

A study has been made of the effect a reactive barrier made of pine (softwood) or oak (hardwood) wood intercalated in a sandy soil column has on the retention of linuron, alachlor and metalaxyl (pesticides with contrasting physicochemical characteristics). The leaching of pesticides has been carried out under a saturated flow regime and breakthrough curves (BTCs) have been obtained at flow rates of 1 mL min⁻¹ (all pesticides) and 3 mL min⁻¹ (linuron). The cumulative curves in the unmodified soil indicate a leaching of pesticides >80% of the total amount of compound added. After barrier intercalation, linuron leaching decreases significantly and a modification of the leaching kinetics of alachlor and metalaxyl has been observed. The theoretical R factors increased ∼2.6-3.3, 1.2-1.6-fold, and 1.4-1.7-fold and the concentration of the maximum peak decreased ∼6-12-fold, 2-4-fold and 1.2-2-fold for linuron, alachlor and metalaxyl, respectively. When considering the three pesticides, significant correlations have been found between the theoretical retardation factor (R) and the pore volume corresponding to the maximum peaks of the BTCs (r = 0.77; p < 0.05) or the total volume leached (r = −0.78; p < 0.05). The results reveal the efficacy of reactive wood barriers to decrease the leaching of pesticides from point sources of pollution depends on the type of wood, the hydrophobicity of the pesticide and the adopted water flow rate. Pine was more effective than oak in decreasing the leaching of hydrophobic pesticide linuron or in decreasing the maximum peak concentration of the less hydrophobic pesticides in soils. Efficacy of these wood barriers was limited for the least hydrophobic pesticide metalaxyl.     

Material and energy recovery in integrated waste management systems. An evaluation based on life cycle assessment

This paper reports the environmental results, integrated with those arising from mass and energy balances, of a research project on the comparative analysis of strategies for material and energy recovery from waste, funded by the Italian Ministry of Education, University and Research. The project, involving the cooperation of five University research groups, was devoted to the optimisation of material and energy recovery activities within integrated municipal solid waste (MSW) management systems. Four scenarios of separate collection (overall value of 35%, 50% without the collection of food waste, 50% including the collection of food waste, 65%) were defined for the implementation of energetic, environmental and economic balances. Two sizes of integrated MSW management system (IWMS) were considered: a metropolitan area, with a gross MSW production of 750,000 t/year and an average province, with a gross MSW production of 150,000 t/year. The environmental analysis was conducted using Life Cycle Assessment methodology (LCA), for both material and energy recovery activities. In order to avoid allocation we have used the technique of the expansion of the system boundaries. This means taking into consideration the impact on the environment related to the waste management activities in comparison with the avoided impacts related to the saving of raw materials and primary energy. Under the hypotheses of the study, both for the large and for the small IWMS, the energetic and environmental benefits are higher than the energetic and environmental impacts for all the scenarios analysed in terms of all the indicators considered: the scenario with 50% separate collection in a drop-off scheme excluding food waste shows the most promising perspectives, mainly arising from the highest collection (and recycling) of all the packaging materials, which is the activity giving the biggest energetic and environmental benefits. Main conclusions of the study in the general field of the assessment of the environmental performance of any integrated waste management scheme address the importance of properly defining, beyond the design value assumed for the separate collection as a whole, also the yields of each material recovered; particular significance is finally related to the amount of residues deriving from material recovery activities, resulting on average in the order of 20% of the collected materials.     

Spatial variability of precipitation in Spain

The spatial variability of annual and seasonal precipitation in the conterminous land of Spain has been evaluated by using correlation decay distance analysis (CDD). The CDD analysis essentially explores how the correlation between neighbouring stations varies according to distance. We analysed CDD independently for the decades 1956–1965, 1966–1975, 1976–1985, 1986–1995, and 1996–2005 using only those stations with no missing values for each decade. To this end, 972, 1,174, 1,242, 773 and 695 complete series were used for each decade, respectively. In particular, for each station and decade, we calculated the threshold distance at which the common variance between target (i) and neighbour series is higher than 50 % (r ²  = 0.5) to evaluate whether current density of the climate data set captures the spatial variability of precipitation within the study area. Results indicate that, at an annual scale, neighbouring stations with 50 % of common variance are restricted on average to about 105 km, but this distance can vary from 28 to 251 km within the study area. The lowest variability is located to the SW and in winter, while the higher spatial variability is found to the north, in the Cantabrian area, and to the east, in the Mediterranean and Pyrenees, during summer. Our results suggest that current density of climate stations (those operating in 2005) is good enough to study precipitation variability at an annual scale for winter, spring and autumn, but not enough for summer.     

Heavy metal distribution and speciation in the Northern Adriatic Sea

In the present study the concentrations of cobalt, copper, iron, manganese, zinc were analysed and the speciation of copper and zinc performed, with a summer and winter sampling, for two areas in the Northern Adriatic Sea and crossing at the farthest zones of the Po river-sea water interface. Results show that when salinity increases the concentrations of all investigated metals (with the exception of cobalt) present some degree of biogeochemical cycling. Copper is the element whose dissolved phase has the highest importance in metal transport across the salinity gradient. Results of speciation analysis demonstrate that the presence of excess amounts (5-8 fold) of unbound ligands confers a buffering capacity for potential inputs of dissolved metals into the Northern Adriatic Sea. The speciation of both copper and zinc in the dissolved phase was dominated by organic complexation.