Layers of Antarctic krill, Euphausia superba : are they just long krill swarms?

Antarctic krill, Euphausia superba Dana, a major component in the southern ocean food web, typically occur in aggregations that range from small, discrete swarms and schools through to layers and superswarms that extend horizontally for several kilometres. A large Longhurst–Hardy plankton recorder has been used to obtain high-resolution serial samples from within two layers (up to 4 km in length) that were found near Elephant Island, north of the Antarctic Peninsula. Krill length, sex and maturity stage, net and acoustic estimates of number density are shown to vary significantly within these large layers. The variation occurring within a single layer is comparable with that occurring in a set of 38 swarms sampled contemporaneously with the layers. Thus, unlike a krill swarm, a whole krill layer may account for a substantial amount of the variation in the local krill population, although individual parts of the layer cannot be considered in this way. The layers play an important role in the ecology of the krill within the area. Firstly, these large layers may contain a significant proportion of the biomass within an area. Secondly, the structure of the layers gives some insight into the ways in which krill swarm formation and dispersal may be occurring. Received: 28 March 1997 / Accepted: 3 December 1997     

CHANGE IN LAKE TROPHIC STATE AND INTERNAL PHOSPHORUS RELEASE AFTER ALUMINUM SULFATE APPLICATION1

ABSTRACT: Recovery of eutrophic lakes after nutrient diversion may be delayed if the lake experiences significant internal phosphorus (p) loading to the water column. A maximum dose of aluminum sulfate, defined herein, was applied to the anaerobic sediments of the hypolimnia of two dimictic Ohio lakes following septic tank diversion, with the objective of attaining long term control of the release of phosphorus to the water column from these sediments. The results were compared to a similar, downstream, untreated lake. Total phosphorus concentration declined sharply after treatment and has remained so through 1980 for both lakes, a period of 5 and 6 years of control, respectively. Internal P loading from anaerobic, hypolimnetic sediments was partially controlled by the treatment but there are other important sources, perhaps in the littoral zone, in these lakes. Algal biomass is Smaller and water transparency has increased. Both lakes became mesotrophic after treatment, as described by the Carlson (1977) trophic state index, and remain in that improved condition to date. No deleterious side effects were observed, although one lake experienced a significant decrease in diversity of planktonic microcrustacea and a lakeward extension of the macrophyte community. This method appears to be an effective and lasting means of accelerating the recovery of a eutrophic lake following nutrient diversion.     

ENVIRONMENTAL IMPACTS OF APPLYING MANURE,FERTILIZER, AND SEWAGE BIOSOLIDS ON A DAIRY FARM1

ABSTRACT: Farms that once spread only manures are now also applying sewage biosolids (sludge) and/or other wastes such as those from food processing. The objective of this study was to monitor environmental impacts at a dairy farm applying these materials. Fields were selected representing recent waste applications of manure (M1, M2), sewage biosolids (B1, B2), or fertilizer only control (F1, F2), although most fields had historical biosolids applications. Fields representing each treatment were not experimental replicates because of varying applications and soil characteristics. Septage and food processing wastes were also applied. Soil percolates were collected with wick lysimeters. Runoff was sampled at seven stream sites. Test field soils and alfalfa (Medicago sativa) were analyzed for trace elements. Cumulative trace metal loadings were low, at most only 1 percent of USEPA Part 503 limits. Surface soil enrichment was most evident for Mo, P, and S. Alfalfa tissue showed no trends of concern. The B2 site had the greatest percolate concentrations for 6 of 13 elements. Percolate Cu was somewhat elevated at Sites M1, M2, B2, and Fl. Percolate sodium was elevated on all M and B fields and sulfur was greatest at M2, B1, and B2. Soluble orthophosphate correlated with stream discharge during intensive monitoring of Stream Sites S1 (fertilizer) and S2 (biosolids). Peaks in S2 streamwater Mo lagged large runoff events by five days. Total streamwater export of Cu, Na, Mo, and soluble P were greater from the S2 biosolids subwatershed than from the S1 fertilizer subwatershed. Percolate concentrations exceeded corresponding streamwater concentrations in most cases.     

Using a physiologically based pharmacokinetic model to link urinary biomarker concentrations to dietary exposure of perchlorate

Exposure to perchlorate is widespread in the United States and many studies have attempted to character the perchlorate exposure by estimating the average daily intakes of perchlorate. These approaches provided population-based estimates, but did not provide individual-level exposure estimates. Until recently, exposure activity database such as CSFII, TDS and NHANES become available and provide opportunities to evaluate the individual-level exposure to chemical using exposure surveillance dataset. In this study, we use perchlorate as an example to investigate the usefulness of urinary biomarker data for predicting exposures at the individual level. Specifically, two analyses were conducted: (1) using data from a controlled human study to examine the ability of a physiologically based pharmacokinetic (PBPK) model to predict perchlorate concentrations in single-spot and cumulative urine samples; and (2) using biomarker data from a population-based study and a PBPK model to demonstrate the challenges in linking urinary biomarker concentrations to intake doses for individuals. Results showed that the modeling approach was able to characterize the distribution of biomarker concentrations at the population level, but predicting the exposure-biomarker relationship for individuals was much more difficult. The type of information needed to reduce the uncertainty in estimating intake doses, for individuals, based on biomarker measurements is discussed.     

Modelling the dissipation kinetics of six commonly used pesticides in two contrasting soils of New Zealand

We used three non-linear bi-phasic models, bi-exponential (BEXP), first-order double exponential decay (FODED), and first-order two-compartment (FOTC), to fit the measured degradation data for six commonly used pesticides (atrazine, terbuthylazine, bromacil, diazinon, hexazinone and procymidone) in two New Zealand soils. Corresponding DT₅₀ and DT₉₀ values for each compound were numerically obtained and compared against those estimated by simple first-order kinetic (SFOK) model. All 3 non-linear models gave good fit of the measured data under both soil depths and were well supported by the values obtained for the respective statistical indices (RMSE, CRM and r ²). The FOTC model gave by far the best fit for most compounds, followed by the FODED and BEXP models. Overall, DT₅₀ values derived by non-linear models for the six compounds in soils from both sites were lower than the values obtained by the SFOK model. Differences in the SFOK and the three non-linear models derived DT₉₀were, however, an order of magnitude higher for some compounds, while for others differences were very small. Although all three non-linear models described most data by giving excellent fits, in a few instances > 5–10% asymptotes hindered the estimation of DT₉₀ values. This work shows that when degradation deviates from first-order kinetic, application of non-linear decay models to describe the kinetics of degradation becomes important in order to derive the true end-points for pesticides in soil.     

Variably saturated flow and multicomponent biogeochemical reactive transport modeling of a uranium bioremediation field experiment

Three-dimensional, coupled variably saturated flow and biogeochemical reactive transport modeling of a 2008 in situ uranium bioremediation field experiment is used to better understand the interplay of transport and biogeochemical reactions controlling uranium behavior under pulsed acetate amendment, seasonal water table variation, spatially variable physical (hydraulic conductivity, porosity) and geochemical (reactive surface area) material properties. While the simulation of the 2008 Big Rusty acetate biostimulation field experiment in Rifle, Colorado was generally consistent with behaviors identified in previous field experiments at the Rifle IFRC site, the additional process and property detail provided several new insights. A principal conclusion from this work is that uranium bioreduction is most effective when acetate, in excess of the sulfate-reducing bacteria demand, is available to the metal-reducing bacteria. The inclusion of an initially small population of slow growing sulfate-reducing bacteria identified in proteomic analyses led to an additional source of Fe(II) from the dissolution of Fe(III) minerals promoted by biogenic sulfide. The falling water table during the experiment significantly reduced the saturated thickness of the aquifer and resulted in reactants and products, as well as unmitigated uranium, in the newly unsaturated vadose zone. High permeability sandy gravel structures resulted in locally high flow rates in the vicinity of injection wells that increased acetate dilution. In downgradient locations, these structures created preferential flow paths for acetate delivery that enhanced local zones of TEAP reactivity and subsidiary reactions. Conversely, smaller transport rates associated with the lower permeability lithofacies (e.g., fine) and vadose zone were shown to limit acetate access and reaction. Once accessed by acetate, however, these same zones limited subsequent acetate dilution and provided longer residence times that resulted in higher concentrations of TEAP reaction products when terminal electron donors and acceptors were not limiting. Finally, facies-based porosity and reactive surface area variations were shown to affect aqueous uranium concentration distributions with localized effects of the fine lithofacies having the largest impact on U(VI) surface complexation. The ability to model the comprehensive biogeochemical reaction network, and spatially and temporally variable processes, properties, and conditions controlling uranium behavior during engineered bioremediation in the naturally complex Rifle IFRC subsurface system required a subsurface simulator that could use the large memory and computational performance of a massively parallel computer. In this case, the eSTOMP simulator, operating on 128 processor cores for 12h, was used to simulate the 110-day field experiment and 50 days of post-biostimulation behavior.     

Effects of sulfur dioxide pollution on the translocation and accumulation of heavy metals in soybean grain

Background  

Open-top chambers were used to study the impact of simultaneous exposure to atmospheric SO₂ pollution and heavy metal contamination in soils on the metal contents and productivity of soybean plant.     

Growth and elemental accumulation by canola on soil amended with coal fly ash

To explore the agronomic potential of an Australian coal fly ash, we conducted two glasshouse experiments in which we measured chlorophyll fluorescence, CO2 assimilation (A), transpiration, stomatal conductance, biomass accumulation, seed yield, and elemental uptake for canola (Brassica napus) grown on soil amended with an alkaline fly ash. In Experiment 1, application of up to 25 Mg/ha of fly ash increased A and plant weight early in the season before flowering and seed yield by up to 21%. However, at larger rates of ash application A, plant growth, chlorophyll concentration, and yield were all reduced. Increases in early vigor and seed yield were associated with enhanced uptake of phosphorus (P) by the plants treated with fly ash. Fly ash application did not influence accumulation of B, Cu, Mo, or Zn in the stems at any stage of plant growth or in the seed at harvest, except Mo concentration, which was elevated in the seed. Accumulation of these elements was mostly in the leaves, where concentrations of Cu and Mo increased with any amount of ash applied while that of B occurred only with ash applied at 625 Mg/ha. In Experiment 2, fly ash applied at 500 Mg/ha and mixed into the whole 30 cm soil core was detrimental to growth and yield of canola, compared with restricting mixing to 5 or 15 cm depth. In contrast, application of ash at 250 Mg/ha with increasing depth of mixing increased A and seed yield. We concluded that fly ash applied at not more than 25 Mg/ha and mixed into the top 10 to 15 cm of soil is sufficient to obtain yield benefits.