Mixed response in bacterial and biochemical variables to simulated sand mining in placer-rich beach sediments,Ratnagiri, West coast of India

We investigated the influence on bacterial community and biochemical variables through mechanical disturbance of sediment-akin to small-scale mining in Kalbadevi beach, Ratnagiri, a placer-rich beach ecosystem which is a potential mining site. Changes were investigated by comparing three periods, namely phase I before disturbance, phase II just after disturbance, and phase III 24 h after disturbance as the bacterial generation time is ≤7 h. Cores from dune, berm, high-, mid-, and low-tide were examined for changes in distribution of total bacterial abundance, total direct viability (counts under aerobic and anaerobic conditions), culturability and biochemical parameters up to 40 cm depth. Results showed that bacterial abundance decreased by an order from 10⁶ cells g^− 1 sediment, while, viability reduced marginally. Culturability on different-strength nutrient broth increased by 155% during phase II. Changes in sedimentary proteins, carbohydrates, and lipids were marked at berm and dune and masked at other levels by tidal influence. Sedimentary ATP reduced drastically. During phase III, Pearson’s correlation between these variables evolved from non-significant to significant level. Thus, simulated disturbance had a mixed effect on bacterial and biochemical variables of the sediments. It had a negative impact on bacterial abundance, viability and ATP but positive impact on culturability. Viability, culturability, and ATP could act as important indicators reflecting the disturbance in the system at short time intervals. Culturability, which improved by an order, could perhaps be a fraction that contributes to restoration of the system at bacterial level. This baseline information about the potential mining site could help in developing rational approach towards sustainable harnessing of resources with minimum damage to the ecosystem.     

Influence of a portable air treatment unit on health-related quality indicators of indoor air in a classroom

During periods of two weeks in February and June 2010 the performance of portable air treatment units (PATUs) was evaluated in a primary school classroom using indicators of indoor air quality. Air samples were collected in an undisturbed setting on weekend days and in an occupied setting during teaching hours. In the first week PATUs were turned off and in the second week they were turned on. On weekend days PATUs reduced indoor levels of PM-10 by 87% in February and by 70% in June compared to weekend days when PATUs were turned off. On schooldays, indoor PM-10 was increased by 6% in February and reduced by 42% in June. For PM-2.5 reductions on weekend days were 89% in February and 80% in June. On school days PM-2.5 was increased by 15% in February and reduced by 83% in June. Turning on the PATUs reduced total VOC by 80% on weekend days and by 57% on school days (but not in June). No influence on formaldehyde, NO(2), O(3) and molds was observed. PATUs appeared to be less effective in removal of air pollutants when used in an occupied classroom compared to an unoccupied setting. Our study suggests that such devices should be tested in real-life settings to evaluate their influence on indoor air quality.     

Workplace aerosol mass concentration measurement using optical particle counters

Direct-reading aerosol measurement usually uses the optical properties of airborne particles to detect and measure particle concentration. In the case of occupational hygiene, mass concentration measurement is often required. Two aerosol monitoring methods are based on the principle of light scattering: optical particle counting (OPC) and photometry. The former analyses the light scattered by a single particle, the latter by a cloud of particles. Both methods need calibration to transform the quantity of scattered light detected into particle concentration. Photometers are simpler to use and can be directly calibrated to measure mass concentration. However, their response varies not only with aerosol concentration but also with particle size distribution, which frequently contributes to biased measurement. Optical particle counters directly measure the particle number concentration and particle size that allows assessment of the particle mass provided the particles are spherical and of known density. An integrating algorithm is used to calculate the mass concentration of any conventional health-related aerosol fraction. The concentrations calculated thus have been compared with simultaneous measurements by conventional gravimetric sampling to check the possibility of field OPC calibration with real workplace aerosols with a view to further monitoring particle mass concentration. Aerosol concentrations were measured in the food industry using the OPC GRIMM? 1.108 and the CIP 10-Inhalable and CIP 10-Respirable (ARELCO?) aerosol samplers while meat sausages were being brushed and coated with calcium carbonate. Previously, the original OPC inlet had been adapted to sample inhalable aerosol. A mixed aerosol of calcium carbonate and fungi spores was present in the workplace. The OPC particle-size distribution and an estimated average particle density of both aerosol components were used to calculate the mass concentration. The inhalable and respirable aerosol fractions calculated from the OPC data are closely correlated with the results of the particle size-selective sampling using the CIP 10. Furthermore, the OPC data allow calculation of the thoracic fraction of workplace aerosol (not measured by sampling), which is interesting in the presence of allergenic particles like fungi spores. The results also show that the modified COP inlet adequately samples inhalable aerosol in the range of workplace particle-size distribution.     

Multivariate analysis of potentially toxic metals in sediments of a tropical coastal lagoon

Surface sediments collected from the Lagos Lagoon, Nigeria, and three adjoining rivers were analysed for their physicochemical properties and pseudo-total concentration of the potentially toxic metals (PTM) Cd, Cr, Cu, Pb and Zn. The concentration of the PTM varied seasonally and spatially. Odo-Iyaalaro was observed to be the most polluted river, with highest concentrations of 42.1 mg kg^?1, 102 mg kg^?1, 185 mg kg^?1, 154 mg kg^?1 and 1040 mg kg^?1 of Cd, Cr, Cu, Pb and Zn, respectively, while Ibeshe River was the least contaminated, apart from a site affected by Cu from the textile industry. Some of the sediments were found to be above the consensus-based probable effect concentrations and Dutch sediment guideline for metals. Overall metal concentrations were similar to those reported for other tropical lagoon and estuarine systems affected by anthropogenic inputs as a result of rapid urbanisation. Due to the large number of samples, principal component analysis was used to examine relationships within the data set. Generally, sediments collected during the dry season were observed to have higher concentration of PTM than those collected during the rainy season. This means that PTM could accumulate over a prolonged period and then be released relatively rapidly, on an annual basis, into tropical lagoon systems.     

Particulate matter concentration in ambient air and its effects on lung functions among residents in the National Capital Region, India

The World Health Organization has estimated that air pollution is responsible for 1.4 % of all deaths and 0.8 % of disability-adjusted life years. NOIDA, located at the National Capital Region, India, was declared as one of the critically air-polluted areas by the Central Pollution Control Board of the Government of India. Studies on the relationship of reduction in lung functions of residents living in areas with higher concentrations of particulate matter (PM) in ambient air were inconclusive since the subjects of most of the studies are hospital admission cases. Very few studies, including one from India, have shown the relationship of PM concentration and its effects of lung functions in the same location. Hence, a cross-sectional study was undertaken to study the effect of particulate matter concentration in ambient air on the lung functions of residents living in a critically air-polluted area in India. PM concentrations in ambient air (PM_1, PM_2.5) were monitored at residential locations and identified locations with higher (NOIDA) and lower concentrations (Gurgaon). Lung function tests (FEV₁, PEFR) were conducted using a spirometer in 757 residents. Both air monitoring and lung function tests were conducted on the same day. Significant negative linear relationship exists between higher concentrations of PM₁ with reduced FEV₁ and increased concentrations of PM_2.5 with reduced PEFR and FEV₁. The study shows that reductions in lung functions (PEFR and FEV₁) can be attributed to higher particulate matter concentrations in ambient air. Decline in airflow obstruction in subjects exposed to high PM concentrations can be attributed to the fibrogenic response and associated airway wall remodeling. The study suggests the intervention of policy makers and stake holders to take necessary steps to reduce the emissions of PM concentrations, especially PM_1, PM_2.5, which can lead to serious respiratory health concerns in residents.     

Long-term dispersion and availability of metals from submarine mine tailing disposal in a fjord in Arctic Norway

Mining of Cu took place in Kvalsund in the Arctic part of Norway in the 1970s, and mine tailings were discharged to the inner part of the fjord, Repparfjorden. Metal speciation analysis was used to assess the historical dispersion of metals as well as their potential bioavailability from the area of the mine tailing disposal. It was revealed that the dispersion of Ba, Cr, Ni, Pb and Zn from the mine tailings has been limited. Dispersion of Cu to the outer fjord has, however, occurred; the amounts released and dispersed from the mine tailing disposal area quantified to be 2.5–10 t, less than 5% of Cu in the original mine tailings. An estimated 80–390 t of Cu still remains in the disposal area from the surface to a depth of 16 cm. Metal partitioning showed that 56–95% of the Cu is bound in the potential bioavailable fractions (exchangeable, reducible and oxidisable) of the sediments, totalling approximately 70–340 t, with potential for continuous release to the pore water and re-precipitation in over- and underlying sediments. Surface sediments in the deposit area were affected by elevated Cu concentrations just above the probable effect level according to the Norwegian sediment quality criteria, with 50–80% Cu bound in the exchangeable, reducible and oxidisable fractions, potentially available for release to the water column and/or for uptake in benthic organisms.     

Carbon and nitrogen mineralization in Vertisol as mediated by type and placement method of residue

Selection of appropriate residue application method is essential for better use of biomass for soil and environmental health improvement. A laboratory incubation experiment was conducted for 75 days to investigate C and N mineralization of residues of soybean (Glycine max L.), chickpea (Cicer arietinum L.), maize (Zea mays L.), and wheat (Triticum aestivum L.) placed on the soil surface and incorporated into the soil. The residue of soybean and chickpea had a greater decomposition rate than that of maize and wheat, despite of their placements. Higher rate of decomposition of the residue of soybean and chickpea was recorded when it was kept on the soil surface while soil incorporation of residue of wheat and maize resulted in faster decomposition. Therefore, these findings could be used as guidelines for management of crop residue application in farmland to improve soil and environmental quality.     

Monitoring of meteorological and hydrological droughts in the Vistula basin (Poland)

The article presents the course of meteorological droughts in Vistula subcatchments in years 1981–2010 and their influence on the occurrence of hydrological droughts. Using the Standardized Precipitation Index (SPI) as an indicator of meteorological drought on the one hand and the Standardized Water-level Index (SWI) and Standardized Runoff Index (SRI) as indicators of hydrological drought on the other, the mutual relationships between precipitation conditions and hydrological conditions were evaluated, as well as the relationships between the two drought types. Studies were conducted for three cumulative periods of these indices, of 12, 24, and 48 months. It was determined that meteorological droughts occurred earliest in the north-western and central part of the basin, and latest in areas lying above 300 m a.s.l. and in the south of Poland. Total duration, depending on the cumulative period, for SPI comprised from 38 to 41% of the analyzed period and for SWI (35–47%) and SRI (24–51%). The strongest relationships were identified in the central part of the Vistula (0.8?<?r?<?0.85), while the weakest relationships were recorded in the foothill region (r?<?0.5). There were also indicated non-climate-related factors influencing those relationships (underground reservoirs, diverse Vistula water resource usage for municipal and industrial intake).     

An automated (novel) algorithm for estimating green vegetation cover fraction from digital image: UIP-MGMEP

Green vegetation cover fraction (VCF) is an important indicator of vegetation status in ecology and agronomy. Digital image analysis (DIA) has been widely accepted as a new VCF measurement technique. In this study, we present a novel fully automatic threshold segmentation algorithm for VCF measurements, which is named as upper inflection point plus mean gradient magnitude of edge pixels (UIP-MGMEP). The algorithm performs VCF estimation upon the vegetation index Excess Green (EXG). UIP-MGMEP optimizes the EXG threshold by searching the upper inflection point (UIP) of the M-Et curve (mean gradient magnitude of edge pixels (MGMEP) vs. EXG threshold), based on the assumption that EXG variance of the boundary pixels between vegetation and background is larger than the variance of the background. Five typical sample images are used to illustrate how ground complexity reduces the distinctness of the UIP. Three controlled experiments are illustrated to test the robustness of UIP-MGMEP to resolution, exposure, and ground complexity. The results show that UIP-MGMEP is a promising algorithm for automatic VCF estimation upon digital images. Compared to broad-leaved grass, narrow-leaved grass is more sensitive to resolution and exposure. To reduce ground complexity, smaller footprint size while more images to cover the same area may be better than one image with large footprint size. UIP-MGMEP is fully automatic, making it promising for batch processing of VCF measurements that is very difficult in any wide-range field survey in the past. UIP-MGMEP algorithm can only extract green vegetation and is not suitable for non-green (even grayish-green) vegetation, due to the limits of vegetation index EXG. In addition, UIP-MGMEP is not recommended for images with VCF less than 0.5% or greater than 99.5%.