A new organic-rich soil reference material certified for its EDTA- and acetic acid- extractable contents of Cd, Cr, Cu, Ni, Pb and Zn, following collaboratively tested and harmonised procedures

There is an increasing requirement for assessment of the bioavailable metal fraction and the mobility of trace elements in soils upon disposal. One of the approaches is the use of leaching procedures, but the results obtained are operationally defined; therefore, their significance is highly dependent on the extraction protocol performed. So, for this type of study, there is a need for reference materials that allow the quality of measurements to be controlled. This paper describes the steps involved in the certification of an organic-rich soil reference material, BCR-700, for the EDTA- and acetic acid-extractable contents of some trace elements, following collaboratively tested and harmonised extraction procedures. Details are given for the preparation of the soil, homogeneity and stability testing, analytical procedures and the statistical selection of data to be included in the certification.     

The changing nature of the 206Pb/207Pb isotopic ratio of lead in rainwater, atmospheric particulates, pine needles and leaded petrol in Scotland, 1982-1998

The inductively coupled plasma-mass spectrometry (ICP-MS)-determined 206Pb/207Pb ratio of 145 samples of rainwater collected at 25 locations around Scotland during December 1997 and January 1998 and at three longterm monitoring stations in the northeast, central belt and southeast of the country from November 1997 to December 1998 averaged 1.144+/-0.017 (1 s). This represents a significant increase from the mean value of 1.120+/-0.016 recorded for the long-term sites in 1989 1991, only partly attributable to a concomitant increase in the 206Pb/207Pb ratio of leaded petrol from 1.075+/-0.013 to 1.088+/-0.007. The rainwater 206Pb/207Pb data for the late 1990s also contrast markedly with the lower 206Pb/207Pb ratios found for pine needle and atmospheric particulate samples from Scotland (e.g. Glasgow: 1.085+/-0.012 in 1985-1986, 1.099+/-0.007 in 1991-1992), England and Western Europe in this study for the period 1982-1992 when emissions of lead to the atmosphere from petrol-engined vehicles in the UK were approximately 2-9 times higher. The observed change in the lead isotopic signature of rainwater predominantly reflects the impact of measures, such as the introduction and growing uptake of unleaded petrol, to reduce car exhaust emissions of lead to the atmosphere in the UK. Based on the rainwater data, source apportionment calculations suggest a general decline in the contribution of leaded petrol to atmospheric lead in Scotland from 53-61% in 1989-1991 to 32-45% in 1997-1998, with a corresponding decline in the urban environment from 84-86% to 48-58%.     

Lead in grass in the Scottish uplands: deposition or uptake?

If it is assumed that the Pb collected in grass samples is derived mainly from atmospheric deposition then grass samples can be used as a convenient and easily analysed monitor for Pb deposition, in particular to establish the isotopic composition of current deposition in remote locations. As some studies have demonstrated a strong correlation between soil and grass Pb concentrations, it was considered important to establish the proportion of soil Pb in the grasses used to monitor atmospheric deposition at upland locations in Scotland. Consideration of earlier studies provided evidence that very little, if any, Pb in grass was derived from soil. Lead isotope analysis, by thermal ionisation mass spectrometry, of grasses grown on soils spiked with enriched (207)Pb in the field situation allowed the relative contribution of atmospheric deposition and soil to the grass Pb to be calculated. In most cases, >80% of Pb in grass was derived from atmospheric deposition and in recent years this value was >90%. Recalculation of the (206)Pb/(207)Pb ratio in grass samples showed that there was very little error in the results, published previously, which were based on the assumption that all the Pb collected with grass was derived from the atmosphere. The trends established by measuring the (206)Pb/(207)Pb ratio in grasses were confirmed and remain valid.     

Modelling the spatial distribution of ammonia emissions from seabirds in the UK

Knowledge of the sources and distribution of ammonia (NH3) emissions underpins our understanding of the nitrogen budget. Research has focused on quantifying NH3 emissions from anthropogenic sources, whilst those from natural sources have received little attention internationally. Seabirds excrete large quantities of nitrogen, making seabird colonies a major natural source of NH3. Ammonia emissions from each UK seabird species were estimated and combined with population distribution data to model their spatial distribution. Total NH3 emissions from UK seabirds were estimated at 2.7 kt per year. Seabird emissions are concentrated in remote parts of the UK where anthropogenic emissions are small, so that seabirds often represent the main source of NH3 emissions in these areas. Seabird NH3 emissions were found to have increased by 34% since the 1970s. This corresponds to population changes which may be influenced by human activities, showing that even this natural source can be anthropogenically modified.     

生态气象监测评估业务平台的设计与应用

 针对目前生态气象监测轨道业务的特点,结合工作的实际需要,运用C和C++语言建立了生态气象监测评估业务平台。在程序设计中,采用了生成中间交换文件的结构组织,能够对各模块的输出结果进行详尽直观的分析,并提供了等值线色斑图与区域填充等多种图形绘制方式。该系统可处理AVHRR和EOS/MODIS卫星遥感资料,对气象观测报文进行解译、数据分类管理和质量控制,统计计算水体密度指数、湿润指数、植被覆盖指数、土地退化指数、灾害指数和生态质量综合评价指标,以图形、图像的形式输出生态气象监测评估产品,实现了卫星遥感与生态气象地面监测数据的有效组织和智能化管理。将系统应用于湖南省生态质量气象评价,业务化运行的结果表明,该系统具有较好的业务实用性。〖HJ1〗〖HJ〗
〖HT5”H〗     

Belief network models of land manager decisions and land use change

A two-stage model of land use change is described, which is driven by the types of decisions that land managers make when changing their broad styles of use. The first stage uses decision modelling techniques to assess if a manager is currently satisfied with the present situation, when compared to various potential alternatives. If this evaluation indicates satisfaction, it is assumed that the present land use will continue. However, if it indicates dissatisfaction, Belief Network techniques are used to estimate, in more detail, both how dissatisfied the manager is and whether the costs of changing, from the present use to a potentially better one, will be out-weighed by the anticipated benefits. The proposed models can use a variety of cost and benefit criteria (e.g. financial, social and ecological). The approach is illustrated with a case-study of the factors that might influence changes from farming to forestry in marginal upland areas of the UK.     

ASSESSING POTENTIAL SOURCES OF ASBESTOS FIBERS IN WATER SUPPLIES OF S. E. QUEBEC1

ABSTRACT: A comparative study of the concentration of asbestos fibers in drinking water supplies of southeastern Quebec was undertaken to assess the relative contributions of fibers by asbestos-bearing railway ballast and naturally occurring asbestos deposits. Water samples were taken from areas where one or the other potential sources or neither potential source was present. In addition, rainwater samples were taken to assess the importance of atmospheric contributions. The sampling design accounted for potential variations in fiber counts due to the season, location and analytical procedures. Fiber concentrations were estimated from counts made on a JEOL 100CX scanning transmission electron microscope and statistically compared among areas. These levels were then compared with levels found in other areas of Canada and the United States. The results indicate that the rail ballast could be contributing statistically (albeit marginally) significant quantities of fibers to water supplies during the summer but not in the spring. Estimated concentrations in water supplies ranged between 1.7 × 10⁶fibers/liter and 147.8 × 10⁶fibers/liter. Fiber levels in samples taken during the spring were significantly higher and more variable than those taken during the summer. The presence of fibers in rainwater samples at concentrations of 1.9 × 10⁶fibers/liter, 18.3 × 10⁶fibers/liter and 23.7 × 10⁶fibers/liter suggests that atmospheric transport may play an important role in contributing fibers to regional systems. Fiber levels found in these systems are not unique when compared to levels observed elsewhere in North America.     

Freeze/thaw durability of concrete with recycled demolition aggregate compared to virgin aggregate concrete

An increasing trend towards the use of sustainable processes has led to recycled materials being incorporated into concrete. It is generally recognised that crushed recycled construction aggregate material produces concrete of a lower compressive strength, when used as an aggregate replacement due to deleterious materials within the aggregate.It is generally accepted that in the UK, freeze/thaw attack is, after chloride-induced corrosion, the most common cause of concrete deterioration. This paper addresses the freeze/thaw durability of recycled aggregate concrete using a paired comparison test based upon weight loss and final compressive strength.Recycled aggregate concrete was found to be of at least equal durability to concrete manufactured with virgin aggregates. This was due to careful selection of the replacement aggregate and treatment prior to batching.Durability is an important material property and recycled aggregates need to be widely tested to gain confidence for use within the industry and this work shows future possibilities.     

Characterization of environmental water samples using strontium and lead stable isotope compositions

A simple procedure using both cation and anion exchange chromatography has been applied in the study of lead and strontium isotope composition in rain and stream water samples from remote catchments in Scotland. Whereas the soil released strontium to stream waters, lead was removed from rain water and the concentrations in stream waters were very low. Highly precise analysis by thermal ionisation mass spectrometry proved necessary in the determination of strontium isotope composition. The ⁸⁷Sr/⁸⁶Sr ratio in rain water was close to that of marine strontium but the ratios in stream waters were constant and highly characteristic for the stream. In the case of the stream at the Sourhope site, the ratio (0.70798 ± 0.00005) was less than that in rain water and probably resulted from the weathering of one specific mineral. The results suggested that the ⁸⁷Sr/⁸⁶Sr ratios could be used as a stable isotope tracer of waters and to provide information on the weathering processes. Two major anthropogenic components of lead were identified in water samples. One had its origin in petrol additives whereas the other was probably of industrial origin. The low ²⁰⁶Pb/²⁰⁷Pb ratios observed in stream waters confirmed the lead as being of anthropogenic origin and the data suggested that there was a movement, albeit very small, of lead from the soil to waters.     

Application of a modified BCR sequential extraction (three-step) procedure for the determination of extractable trace metal contents in a sewage sludge amended soil reference material (CRM 483), complemented by a three-year stability study of acetic acid and EDTA extractable metal content

This paper provides additional data on a sewage sludge amended soil certified reference material, CRM 483, which was certified in 1997 for its EDTA and acetic acid extractable contents of some trace metals, following standardised extraction procedures. The additional work aimed to test the long-term stability of the material and the applicability of an improved version of the BCR three-step sequential extraction procedure on the sewage sludge amended soil (CRM 483). The paper demonstrates the CRM 483 long-term stability for EDTA and acetic acid extractable contents of Cd, Cr, Cu, Ni, Pb and Zn and gives the results (obtained in the framework of an interlaboratory study) for the extractable contents of the same elements in the CRM 483, following the BCR three-step sequential extraction scheme. The aqua regia extractable contents following the ISO 11466 Standard are also given. The data are given as indicative (not certified) values.