Assessment of pesticide residues in freshwater areas affected by rice paddy effluents in Southern Japan

Pesticide residues in five freshwater areas that are directly affected by rice paddy effluents in southern Japan were measured to determine their maximum concentrations and temporal variations. Water samples were collected every week during the 2005 rice planting season in Kagoshima Prefecture and stations were established in Amori River, Sudo River, Nagaida River (that drains into the bigger Kotsuki River), rice paddy drainage canal, and wastewater reservoir (that collects effluents from rice paddy fields). Of the 14 target pesticides examined, a total of 11 were detected in all stations. Mefenacet, fenobucarb, and flutolanil were the three pesticides with the highest maximum concentrations and were also detected frequently. Analysis of temporal variations of pesticides showed that herbicides had relatively higher concentrations in the earlier stages of the rice planting season, while insecticides and fungicides had relatively higher concentrations at the later stages. There was no significant difference among stations with regards to the temporal patterns of the top three pesticides. The calculated toxic units were less than 1 in all stations, implying low or negligible environmental risk of pesticides detected to freshwater organisms.     

Estimation of pollutant partition in sandy soils with different water contents

The objectives of this work were: (1) to identify an isotherm model to relate the contaminant contents in the gas phase with those in the solid and non-aqueous liquid phases; (2) to develop a methodology for the estimation of the contaminant distribution in the different phases of the soil; and (3) to evaluate the influence of soil water content on the contaminant distribution in soil. For sandy soils with negligible contents of clay and natural organic matter, contaminated with benzene, toluene, ethylbenzene, xylene, trichloroethylene (TCE), and perchloroethylene (PCE), it was concluded that: (1) Freundlich’s model showed to be adequate to relate the contaminant contents in the gas phase with those in the solid and non-aqueous liquid phases; (2) the distribution of the contaminants in the different phases present in the soil could be estimated with differences lower than 10% for 83% of the cases; and (3) an increase of the soil water content led to a decrease of the amount of contaminant in the solid and non-aqueous liquid phases, increasing the amount in the other phases.     

Mullet and gudgeon liver histopathology and macroinvertebrate indexes and metrics upstream and downstream from a wastewater treatment plant (Febros River—Portugal)

The increased pollution in ecosystems reinforces the importance of both chemical monitoring and biological monitoring of streams and rivers, as an effective water quality-based approach to assess aquatic ecosystem health. In this study, gudgeon (Gobio gobio) and mullet (Mugil cephalus) liver histopathology (biomarker) and some macroinvertebrate community indexes and metrics (bioindicator) were used to evaluate the effect of the wastewater treatment plant (WWTP) of Febros (Avintes) in Febros River water quality and ecosystem health. Regarding macroinvertebrate communities, the Belgian Biotic Index (BBI) and Iberian Biological Monitoring Working Party (IBMWP) indexes suggested that Febros water was slightly polluted, even though the worst situation was found downstream the WWTP discharge. Concerning community metrics, upstream percent of individuals in five numerically dominant taxa (80%) was slightly more superior than the downstream (78%). The presence of intolerant or sensible individuals, determined by percent of Ephemeroptera, Plecoptera, and Trichoptera individuals and number of Ephemeroptera, Plecoptera, and Trichoptera families metrics, was higher upstream WWTP, reflecting a better water quality. The histopathology shows the presence of hepatic lesions in gudgeon and mullet. The statistical analysis of the lesion gradation showed that only necrosis was significantly higher in gudgeon captured downstream the WWTP, while differences were not observed for mullet. The multivariate analysis of data confirmed the existence of differences in hepatic lesions between gudgeon and mullet and between sampling sites. Regarding macroinvertebrate community, this analysis showed that the organic contamination reflected by the BBI and IBMWP indexes values was a determinant factor in the spatial distribution of macroinvertebrates. This work showed that the study of different biological organization levels can be used for a better assessment of ecosystem ecological integrity and can be used as a tool to reveal anthropogenic activity effects in macroinvertebrate diversity and in fish liver pathology from Febros River.     

Management of MSW in Spain and recovery of packaging steel scrap

Packaging steel is more advantageously recovered and recycled than other packaging material due to its magnetic properties. The steel used for packaging is of high quality, and post-consumer waste therefore produces high-grade ferrous scrap. Recycling is thus an important issue for reducing raw material consumption, including iron ore, coal and energy. Household refuse management consists of collection/disposal, transport, and processing and treatment - incineration and composting being the most widely used methods in Spain. Total Spanish MSW production exceeds 21 million tons per year, of which 28.1% and 6.2% are treated in compost and incineration plants, respectively. This paper presents a comprehensive study of incineration and compost plants in Spain, including a review of the different processes and technologies employed and the characteristics and quality of the recovered ferrous scrap. Of the total amount of packaging steel scrap recovered from MSW, 38% comes from compost plants and 14% from incineration plants. Ferrous scrap from incineration plants presents a high degree of chemical alteration as a consequence of the thermal process to which the MSW is subjected, particularly the conditions in which the slag is cooled, and accordingly its quality diminishes. Fragmentation and magnetic separation processes produce an enhancement of the scrap quality. Ferrous scrap from compost plants has a high tin content, which negatively affects its recycling. Cleaning and detinning processes are required prior to recycling.     

Growth, photosynthetic and respiratory responses to sub-lethal copper concentrations in Scenedesmus incrassatulus (Chlorophyceae)

In the present paper we investigated the effects of sub-lethal concentrations of Cu²⁺ in the growth and metabolism of Scenedesmus incrassatulus. We found that the effect of Cu²⁺ on growth, photosynthetic pigments (chlorophylls and carotenoids) and metabolism do not follow the same pattern. Photosynthesis was more sensitive than respiration. The analysis of chlorophyll a fluorescence transient shows that the effect of sub-lethal Cu²⁺ concentration in vivo, causes a reduction of the active PSII reaction centers and the primary charge separation, decreasing the quantum yield of PSII, the electron transport rate and the photosynthetic O₂ evolution. The order of sensitivity found was: Growth > photosynthetic pigments content = photosynthetic O₂ evolution > photosynthetic electron transport > respiration. The uncoupled relationship between growth and metabolism is discussed.     

Oxidation of trichloroethene over metal oxide catalysts: kinetic studies and correlation with adsorption properties

The performance of bulk chromium oxide is compared with that of a Mn commercial catalyst for the deep oxidation of trichloroethene (1000-2500ppmv, 55h(-1) space velocity) in air, in dry and wet (20000ppm of H(2)O) conditions, in terms of activity, selectivity and stability. Chromium oxide was found to be more active (on a catalyst weight basis), however its activity decreases continuously with time on stream. The presence of water increases its stability, the Mn catalyst showing the opposite behaviour. The effect of water on the Cr catalyst can be explained according to the Deacon equilibrium, as the presence of water tends to decrease the Cl(2) concentration, assumed to be responsible of the catalyst deactivation. Regarding to the selectivity, the Mn catalyst yields C(2)Cl(4), CCl(4) and CHCl(3) as organochlorinated by-products, whereas chromium oxide produces only trace amounts of CCl(4). Simple power-law kinetics expressions (first-order for Mn and zero-order for Cr) provide fairly good fits for the evolution of the conversion with the temperature. Furthermore, the kinetic behaviour of chromium oxide can be represented with a Langmuir-Hinshelwood model taking into account the chlorine inhibitory effect.     

A field trial for an ex-situ bioremediation of a drilling mud-polluted site

The remediation of drilling mud-polluted sites in the Southeast of Mexico is a top priority for Mexican oil industry. The objective of this work was to find a technology to remediate these sites. A field trial was performed by composting in biopiles, where four 1ton soil-biopiles were established, one treatment in triplicate and one unamended biopile. Amended biopiles were added with nutrients to get a C/N/P ratio of 100/3/0.5 plus a bulking agent (straw) at a soil/straw ratio of 97/3. Moisture content was maintained around 30-35%. Results showed that, after 180 d, total petroleum hydrocarbon (TPH) concentrations decreased from 99300+/-23000mgTPHkg(-1) soil to 5500+/-770mgTPHkg(-1) for amended biopiles and to 22900+/-7800mgTPHkg(-1) for unamended biopile. An undisturbed soil control showed no change in TPH concentrations. Gas chromatographic analysis showed residual alkyl dibenzothiophene type compounds. Highest bacterial counts were observed during the first 30 d which correlated with highest TPH removal, whereas fungal count increased at the end of the experimentation period. Results suggested an important role of the straw, nutrient addition and water content in stimulating aerobic microbial activity and thus hydrocarbon removal. This finding opens an opportunity to remediate old polluted sites with recalcitrant and high TPH concentration.     

Polychlorinated biphenyls and DDT in swordfish (Xiphias gladius) and blue shark (Prionace glauca) from Brazilian coast

The polychlorinated biphenyls (PCBs) and DDT may bioaccumulate in the aquatic food web and have been of great concern due to their toxic effects on wildlife and human health. There is evidence showing that fish in the human diet contributes at a significant proportion to the total intake of PCBs and other organochlorine compounds, particularly fish with higher fat levels. This study investigated the concentration of PCBs and DDTs in muscle tissues of samples of the blue shark (Prionace glauca) and a swordfish (Xiphias gladius) from east Brazilian coast and estimate the human exposure to total DDTs through the consumption of both the species. Samples of the each species were caught between August and September 2001. The mean concentration for summation operator PCBs in P. glauca was 3.15 ng/g w.w. and the summation operator DDTs was 0.93 ng/g w.w. The mean concentration of summation operator PCBs in X. gladius was 6.50 ng/g and the mean of summation operator DDTs was 2.47 ng/g. The estimated daily intake of summation operator DDT through X. gladius or P. glauca consumption can be considered safe since it contributes to less than 0.1% of the limit of acceptable daily intake (ADI) of summation operator DDT proposed by WHO.     

Persistent organic pollutants in atmospheric deposition and biomonitoring with Tillandsia usneoides (L.) in an industrialized area in Rio de Janeiro state, southeast Brazil--Part II: PCB and PAH

Monitoring of immission of persistent organic pollutants in the industrialized area of Volta Redonda (V.R.) and in the National Park of Itatiaia (PNI) in southeast Brazil was performed using an endemic bromeliad species as biomonitor and measuring bulk deposition rates of polychlorinated biphenyls (PCB) and polycyclic aromatic hydrocarbons (PAH). For the sum of PCB, overall deposition rates were between 17 and 314 ng/(m2 day) in winter and between 43 and 81 ng/(m2 day) in summer, respectively. Deposition rates of dioxin-like PCBs ranged from 0.14 to 2.8 pg WHO-TEQ/(m2 day) in winter and from 0.90 to 4.3 pg WHO-TEQ/(m2 day) in summer. PCB deposition rates (total PCB and WHO-TEQ) were in the same range in winter in V.R. and PNI. In summer, contamination levels in V.R. were 6-10-folds higher than in PNI. PCB concentrations in biomonitor samples from V.R. and PNI were in the same range in summer and in winter. Concentrations of total PCB ranged from 14 to 95 microg/kg dry matter (d.m.) in winter and from 18 to 27 microg/kg d.m. in summer, respectively. The TEQ values were between 1.7 and 4.1 ng WHO-TEQ/kg d.m. in winter and between 1.9 and 2.9 ng WHO-TEQ/kg d.m. in summer. PCB concentrations of di-ortho PCB but not of non-ortho PCB were a factor of 2-4 lower in summer in both areas. PCB congener profiles resembled those from technical formulations. The profiles shifted to the higher chlorinated congeners in summer, probable due to revolatilisation of the lighter components at higher temperatures. PCB profiles in biomonitor resembled those from deposition samples and the shift to the heavier congeners in summer was even more pronounced. PAH deposition rates were in a similar range in both areas (131-2415 ng/(m2 day)). PAH levels in biomonitor samples from V.R. were about one order of magnitude higher than in samples from PNI indicating the impact of local sources. PAH profiles revealed stationary thermal processes as main source of contamination in V.R. whereas in PNI, biomass burning seems to be the main contamination source.     

Advanced oxidation processes for the treatment of olive-oil mills wastewater

In this work, the treatment of an actual industrial waste with three advanced oxidation processes (AOP) has been studied: conductive-diamond electrooxidation (CDEO), ozonation and Fenton oxidation. The wastewater comes from olive-oil mills (OMW) and contains a COD of nearly 3000 mg dm(-3). CDEO allowed achieving the complete mineralization of the waste with high current efficiencies. Likewise, both ozonation and Fenton oxidation were able to treat the wastes, but they obtained very different results in terms of efficiency and mineralization. The accumulation of oxidation-refractory compounds as final products excludes the use of ozonation and Fenton oxidation as a sole treatment technology. This confirms that besides the hydroxyl-radical mediated oxidation, CDEO combines other important oxidation processes such as the direct electro-oxidation on the diamond surface and the oxidation mediated by other electrochemically formed compounds generated on this electrode.