Guided group discussion and attitude change: The roles of normative and informational influence

Kurt Lewin and others have showed that group discussion effectively changed attitudes and behaviors compared to individually targeted messages. This study examines the roles of normative and informational social influence in this effect. High school students heard a message about replacing toxic products with nontoxic alternatives; classes were randomly assigned to hear the message delivered as a lecture or via guided group discussion. For female students (N=250 in 26 classes), HLM mediation analyses suggested normative influence predominated: Discussion was more effective than lecture and this effect was fully mediated by students’ perceptions that other students endorsed nontoxics. Content analyses of students’ comments indicated that three kinds of remarks led female students to this perception: (1) sharing knowledge about nontoxics; (2) asking questions about nontoxics; and (3) little praise for toxic products. For male students in separate HLM analyses (N=107 in 19 of the same classes), informational influence was most apparent: Postmeeting attitudes were higher after discussion than lecture, and this effect was partially mediated by cognitive elaboration about the message (but not perceptions others endorsed the message). In addition, males’ quiz grades were higher after discussion, and students’ comments fully mediated the discussion to quiz grades relationship. Results support the importance of hearing others’ promessage comments for changing socially motivated behaviors, although the routes of influence appear to differ for these samples of male and female students.     

Analysis of Wind Farm Output: Estimation of Volatility Using High-Frequency Data

In the financial year 2011–2012, wind farms supplied 26 % of South Australia’s electricity demand according to the Australian Energy Market Operator’s report. This contribution has risen from zero in 2003. The operation of the electricity grid depends heavily on knowledge of the variability of supply. Wind farm output displays similar conditional volatility as financial market variables. In this paper, a new method of estimating wind farm output volatility on a 5-min time scale is developed through the use of higher-frequency wind farm output data. First, an autoregressive model for the high-frequency data is developed, and it is used to derive a volatility measure for 5-min data. The results are also true in certain general situations when the high-frequency data follow an autoregressive moving average process or exhibits long memory features. The methods described here are analogous to realised volatility measures used in financial series, except that wind farm output data are measured at uniform intervals, unlike random trading times for financial transactions.     

Emission of volatile organic compounds from religious and ritual activities in India

Worshipping activity is a customary practice related with many religions and cultures in various Asian countries, including India. Smoke from incense burning in religious and ritual places produces a large number of health-damaging and carcinogenic air pollutants include volatile organic compounds (VOCs) such as formaldehyde, benzene, 1,3 butadiene, styrene, etc. This study evaluates real-world VOCs emission conditions in contrast to other studies that examined emissions from specific types of incense or biomass material. Sampling was conducted at four different religious places in Raipur City, District Raipur, Chhattisgarh, India: (1) Hindu temples, (2) Muslim graveyards (holy shrines), (3) Buddhist temples, and (4) marriage ceremony. Concentrations of selected VOCs, respirable particulate matter (aerodynamic diameter, <5 μm), carbon dioxide, and carbon monoxide were sampled from the smoke plumes. Benzene has shown highest emission factor (EF) among selected volatile organic compounds in all places. All the selected religious and ritual venues have shown different pattern of VOC EFs compared to laboratory-based controlled chamber studies.     

Heavy metals: their pathway from the ground,groundwater and springs to Lake Góreckie (Poland)

The migration pathways of heavy metals derived from an area previously in agricultural use was investigated in the Wielkopolski National Park (mid-western Poland). The heavy metals involved (Cd, Cu, Cr, Pb, Ni and Zn) were determined in groundwater, the springs that feed Lake Góreckie and the lake itself. In order to show how the heavy metals may be set free and what is their biological availability, soil and sediment samples were subjected to single-stage extraction, using 0.01 M CaCl₂, 0.02 M EDTA, 0.005 M DTPA, 0.1 M HCl, 1 M HCl and de-ionised water. Varying metal concentrations were recorded in the water samples during the study period (from November 2009 to July 2010), usually with higher values in winter and lower ones in summer. The seasonal changes may be ascribed to natural processes taking place in the ground- and surface waters of Lake Góreckie. On the other hand, the concentration levels (mostly of Cd, Pb and Cr) are indicative of anthropogenic activity. It should be mentioned in this context that the highest metal concentrations were found in the soil layer. The concentrations were also found to exceed both the Polish and the World Health Organization water-quality standards. It appears that the soils are highly contaminated, mostly with cadmium. The long-lasting effect of acid precipitation in the area makes it possible for immobile forms to become mobile, thus facilitating further migration into the environment.     

In situ measurements of volatile aromatic hydrocarbon biodegradation rates in groundwater

Benzene and alkylbenzene biodegradation rates and patterns were measured using an in situ microcosm in a crude-oil contaminated aquifer near Bemidji, Minnesota. Benzene-D6, toluene, ethylbenzene, o-, m- and p-xylenes and four pairs of C₃- and C₄-benzenes were added to an in situ microcosm and studied over a 3-year period. The microcosm allowed for a mass-balance approach and quantification of hydrocarbon biodegradation rates within a well-defined iron-reducing zone of the anoxic plume. Among the BTEX compounds, the apparent order of persistence is ethylbenzene > benzene > m,p-xylenes > o-xylene ≥ toluene. Threshold concentrations were observed for several compounds in the in situ microcosm, below which degradation was not observed, even after hundreds of days. In addition, long lag times were observed before the onset of degradation of benzene or ethylbenzene. The isomer-specific degradation patterns were compared to observations from a multi-year study conducted using data collected from monitoring wells along a flowpath in the contaminant plume. The data were fit with both first-order and Michaelis-Menten models. First-order kinetics provided a good fit for hydrocarbons with starting concentrations below 1 mg/L and Michaelis-Menten kinetics were a better fit when starting concentrations were above 1 mg/L, as was the case for benzene. The biodegradation rate data from this study were also compared to rates from other investigations reported in the literature.     

Quantification of self pollution from two diesel school buses using three independent methods

We monitored two Seattle school buses to quantify the buses’ self pollution using the dual tracers (DT), lead vehicle (LV), and chemical mass balance (CMB) methods. Each bus drove along a residential route simulating stops, with windows closed or open. Particulate matter (PM) and its constituents were monitored in the bus and from a LV. We collected source samples from the tailpipe and crankcase emissions using an on-board dilution tunnel. Concentrations of PM₁, ultrafine particle counts, elemental and organic carbon (EC/OC) were higher on the bus than the LV. The DT method estimated that the tailpipe and the crankcase emissions contributed 1.1 and 6.8 μg m^?3 of PM_2.5 inside the bus, respectively, with significantly higher crankcase self pollution (SP) when windows were closed. Approximately two-thirds of in-cabin PM_2.5 originated from background sources. Using the LV approach, SP estimates from the EC and the active personal DataRAM (pDR) measurements correlated well with the DT estimates for tailpipe and crankcase emissions, respectively, although both measurements need further calibration for accurate quantification. CMB results overestimated SP from the DT method but confirmed crankcase emissions as the major SP source. We confirmed buses’ SP using three independent methods and quantified crankcase emissions as the dominant contributor.     

Phytoremediation and long-term site management of soil contaminated with pentachlorophenol (PCP) and heavy metals

Pentachlorophenol (PCP) is a persistent organic pollutant (POP) previously used as a timber treatment chemical to prevent sap stain and wood rot. Commonly used in wood treatment industries for the last 50 years, there are now many sites worldwide that are contaminated with PCP. Although persistent, PCP is a mobile contaminant and therefore has a propensity to leach and contaminate surrounding environments. Both willow (Salix sp., 'Tangoio') and poplar (Populus sp. 'Kawa') growing in an open-ended plastic greenhouse were found to tolerate soil PCP concentrations of 250 mg kg(-1) or less and both species stimulated a significant increase in soil microbial activity when compared to unplanted controls. Both poplar and willow could not survive PCP concentrations above 250 mg kg(-1) in soil. Pentachlorophenol degradation occurred in both planted and unplanted pots, but a higher rate of degradation was observed in the planted pots. Soil contaminated by wood-treatment activities often contains co-contaminants such as B, Cr, Cu and As, that are also used as timber preservatives. An additional column leaching experiment, done along side the potted trial, found that PCP, B, Cr, Cu and As were all present in the column leachate. This indicates that although Cu, Cr and As are generally considered immobile in the soil, they were mobilised under our column conditions. If a contaminated site were to be hydraulically 'sealed' using plants, a reticulation irrigation system should be installed to capture any contaminant leachate resulting from heavy rains. This captured leachate can either be independently treated, or reapplied to the site. Our data demonstrate a reduction in soil hydraulic conductivity with repeated application of leachate containing PCP and metal compounds but the soil did not become anaerobic. This would need to be considered in site remediation design.     

Modelling Wetland Bird Response to Water Level Changes in the Lake Ontario – St. Lawrence River Hydrosystem

Lake Ontario and St. Lawrence River (LOSL) wetland bird abundance and diversity are greatly influenced by lake and river hydrology. Our study used an interdisciplinary ecosystem approach, blending avian and plant ecology, ecohydraulic, statistical ecology and modelling to evaluate potential impacts of water level fluctuations on indicator species representative of the wetland breeding bird assemblages in the entire LOSL freshwater system. Multi-year (2000–2003) bird surveys captured bird distribution and density in wetland habitats under varying degrees of water inandation, depth and fluctuation. Analyses revealed strong associations between estimated breeding pair densities and plant communities, water depth, and degree of water level fluctuation during the breeding season for a suite of wetland bird species using marsh, wet meadow, shrub swamp and treed swamp habitats. These quantitative associations were used to develop wetland bird performance indicators for use in a LOSL water regulation review study. Several bird species also nest at or near the water surface and are thus vulnerable to nest flooding or stranding. Changes to the seasonal hydrology of Lake Ontario and St. Lawrence River that result in an increased frequency or magnitude of these nest failure events may have a significant impact on regional population sustainability. Long term nest record databases were analyzed to create nesting flooding and stranding probability equations based on water level increases and decreases during the breeding season. These species-specific nesting relationships were incorporated into a reproduction index.Many breeding bird species were strongly associated with specific wetland plant communities. Predicted habitat suitability, as measured by estimated breeding pair density, can also change significantly within a specific wetland plant community based solely on changes in water depth during the breeding season. Three indicator species, Black Tern, Least Bittern and Virginia Rail were selected as key environmental performance indicators for alternate regulation plan comparisons.Water regulation criteria should be such that the long term diversity and abundance of wetland plant communities and frequency of spring flooding in marsh habitats during breeding are not reduced. Magnitude and frequency of water level change during the nesting season (May–July) can also adversely impact reproductive success of many wetland bird species. As such, regulation criteria that increase the seasonal magnitude and frequency of water level change may be detrimental to the long term viability of certain regional breeding bird populations.     

A thermodynamic approach to the hydration of sulphate-resisting Portland cement

A thermodynamic approach is used to model changes in the hydrate assemblage and the composition of the pore solution during the hydration of calcite-free and calcite-containing sulphate-resisting Portland cement CEM I 52.5 N HTS. Modelling is based on thermodynamic data for the hydration products and calculated hydration rates for the individual clinker phases, which are used as time-dependent input parameters. Model predictions compare well with the composition of the hydrate assemblage as observed by TGA and semi-quantitative XRD and with the experimentally determined compositions of the pore solutions. The calculations show that in the presence of small amounts of calcite typically associated with Portland cement, C-S-H, portlandite, ettringite and calcium monocarbonate are the main hydration products. In the absence of calcite in the cement, however, siliceous hydrogarnet instead of calcium monocarbonate is observed to precipitate. The use of a higher water-to-cement ratio for the preparation of a calcite-containing cement paste has a minor effect on the composition of the hydrate assemblage, while it significantly changes the composition of the pore solution. In particular, lower pH value and higher Ca concentrations appear that could potentially influence the solubility and uptake of heavy metals and anions by cementitious materials.