Antibacterial behavior of silver-modified clinoptilolite-heulandite rich tuff on coliform microorganisms from wastewater in a column system

The water disinfecting behavior of silver-modified clinoptilolite–heulandite rich tuff (ZSAg) as an antibacterial agent against coliform microorganisms from water in a continuous mode was investigated. Silver recovery from the disinfected effluents by the sodium-modified clinoptilolite–heulandite rich tuff (ZSNa) was also considered. Escherichia coli (ATCC 8739) and total coliform microorganisms, as indicators of microbiological contamination of water, were chosen to achieve the disinfection of synthetic wastewater or municipal wastewater. Ammonium (NH₄⁺) and chloride (Cl⁻) ions were added to the synthetic wastewater as an interfering chemical species on the disinfection processes. The antibacterial activity of the ZSAg as a bactericide was measured by the coliform concentration as evaluated by the APHA method. The amount of silver in the disinfected effluents was determined using atomic absorption spectroscopy. The inactivation of the ZSAg was calculated from the breakthrough curves based on the model reported by Gupta et al. It was found that when the silver concentration in the effluent is less than 0.6 μg/mL, the bacterial survival percentage increased and the volume of disinfected water diminished. The total silver amounts found in the effluent at the end of the disinfection processes varied depending on the water treated (synthetic or municipal wastewater). The presence of NH₄⁺ ions in synthetic wastewater influent notably improved the disinfected water volume (zero NVC/100 mL), in comparison to the disinfection of the same influent without NH₄⁺ ions. A contrary water disinfection behavior was observed in the presence of Cl⁻ ions. The silver recovery does not depend on the mass of the sodium zeolitic bed according with the wastewater to be treated (synthetic or municipal wastewater) and the presence of NH₄⁺ or Cl⁻ ions in the influent also influenced the silver recovery from wastewater. The ZSNa did not have antibacterial activity. Therefore the amount of bactericide agent (silver-modified natural zeolite), coliform microorganisms from water (E. coli or consort of coliform microorganisms) as well as the water quality (synthetic wastewater or municipal wastewater) influenced both the disinfection process and the silver recovery in a column system.     

Inverse modeling of multicomponent reactive transport through single and dual porosity media

Compacted bentonite is foreseen as buffer material for high-level radioactive waste in deep geological repositories because it provides hydraulic isolation, chemical stability, and radionuclide sorption. A wide range of laboratory tests were performed within the framework of FEBEX (Full-scale Engineered Barrier EXperiment) project to characterize buffer properties and develop numerical models for FEBEX bentonite. Here we present inverse single and dual-continuum multicomponent reactive transport models of a long-term permeation test performed on a 2.5 cm long sample of FEBEX bentonite. Initial saline bentonite porewater was flushed with 5.5 pore volumes of fresh granitic water. Water flux and chemical composition of effluent waters were monitored during almost 4 years. The model accounts for solute advection and diffusion and geochemical reactions such as aqueous complexation, acid-base, cation exchange, protonation/deprotonation by surface complexation and dissolution/precipitation of calcite, chalcedony and gypsum. All of these processes are assumed at local equilibrium. Similar to previous studies of bentonite porewater chemistry on batch systems which attest the relevance of protonation/deprotonation on buffering pH, our results confirm that protonation/deprotonation is a key process in maintaining a stable pH under dynamic transport conditions. Breakthrough curves of reactive species are more sensitive to initial porewater concentration than to effective diffusion coefficient. Optimum estimates of initial porewater chemistry of saturated compacted FEBEX bentonite are obtained by solving the inverse problem of multicomponent reactive transport. While the single-continuum model reproduces the trends of measured data for most chemical species, it fails to match properly the long tails of most breakthrough curves. Such limitation is overcome by resorting to a dual-continuum reactive transport model.     

Chemosensory discrimination of familiar and unfamiliar conspecifics by lizards: implications of field spatial relationships between males

The ability of territorial lizards to discriminate between scents of neighbors and non-neighbors might contribute to decreasing the costs of aggressive interactions. To test this hypothesis, we conducted a field study to analyze the spatial relationships between male Iberian rock-lizards, Lacerta monticola. We then used the same individuals in a laboratory experiment to test whether male lizards can use chemical cues to discriminate between familiar conspecific males (those whose home ranges overlapped) and unfamiliar conspecific males (those whose home ranges did not overlap, and whose home range centers were at least 50 m apart). Differences in tongue-flick rates in the presence of chemical cues suggested that male L. monticola discriminated between odors of familiar and unfamiliar males. The behavioral responses were also dependent on relative differences in body size between the responding male and the unfamiliar male that donated the scent: There was a significant negative correlation between tongue-flick rates emitted in cages of unfamiliar males and the body size differences between males. In contrast, when the donor of the scent was a familiar male, the tongue-flick rate was not dependent on body size differences. These results are compatible with individual discrimination through chemical cues in male L. monticola.     

Improve Compliance with Limited Resources by a Three-Group Inspection Regime

Frequent monitoring and relatively high fines are usually necessary to bring about improvements in environmental quality, but more challenging for many countries with limited human, material, and financial resources is to put them into practice. This paper developed a three-group model of a state-dependent enforcement in a repeated game to improve the policy implementation under limited inspection capacities. A certain number of firms are grouped (group 1, group 2, group 3) for different supervision intensity (e.g., the order of inspection probability corresponding to each group is p ₁?<?p ₂?<?p ₃) based on their environmental performance. The optimal policy parameters, such as inspection probability of each group and the probability that a firm found in compliance is moved to a better reputation group, were obtained as the basis for regulator’s policy making. Numerical simulations indicated that the three-group inspection regime can significantly increase compliance rate as compared with static enforcement with the same monitoring probability. Among the number of firms in each group under steady state conditions, group 2 had the most, group 1 was the second, and group 3 had the smallest. Analysis and prediction of a three-group reputation example provided a good experiment for the model. The results give a practical reference for the policy makers with inspection capacity constraints to achieve higher compliance rate.     

Particulate matter levels in a South American megacity: the metropolitan area of Lima-Callao,Peru

The temporal and spatial trends in the variability of PM₁₀ and PM_2.5 from 2010 to 2015 in the metropolitan area of Lima-Callao, Peru, are studied and interpreted in this work. The mean annual concentrations of PM₁₀ and PM_2.5 have ranges (averages) of 133–45 μg m^?3 (84 μg m^?3) and 35–16 μg m^?3 (26 μg m^?3) for the monitoring sites under study. In general, the highest annual concentrations are observed in the eastern part of the city, which is a result of the pattern of persistent local winds entering from the coast in a south-southwest direction. Seasonal fluctuations in the particulate matter (PM) concentrations are observed; these can be explained by subsidence thermal inversion. There is also a daytime pattern that corresponds to the peak traffic of a total of 9 million trips a day. The PM_2.5 value is approximately 40% of the PM₁₀ value. This proportion can be explained by PM₁₀ re-suspension due to weather conditions. The long-term trends based on the Theil-Sen estimator reveal decreasing PM₁₀ concentrations on the order of ?4.3 and ?5.3% year^?1 at two stations. For the other stations, no significant trend is observed. The metropolitan area of Lima-Callao is ranked 12th and 16th in terms of PM₁₀ and PM_2.5, respectively, out of 39 megacities. The annual World Health Organization thresholds and national air quality standards are exceeded. A large fraction of the Lima population is exposed to PM concentrations that exceed protection thresholds. Hence, the development of pollution control and reduction measures is paramount.     

Modeling of Cr contamination in the agricultural lands of three villages near the leather industry in Kasur,Pakistan, using statistical and GIS techniques

Kasur is one of the hubs of leather industry in the Punjab, Pakistan, where chrome tanning method of leather processing is extensively being used. Chromium (Cr) accumulation levels in the irrigation water, soil, and seasonal vegetables were studied in three villages located in the vicinity of wastewater treatment plant and solid waste dumping site operated by the Kasur Tanneries Waste Management Agency (KTWMA). The data was interpreted using analysis of variance (ANOVA), clustering analysis (CA), and principal component analysis (PCA). Interpolated surface maps for Cr were generated using the actual data obtained for the 30 sampling sites in each of the three villages for irrigation water, soil, and seasonal vegetables. The level of contamination in the three villages was directly proportional to their distance from KTWMA wastewater treatment plant and the direction of water runoff. The highest level of Cr contamination in soil (mg kg^?1) was observed at Faqeeria Wala (37.67), intermediate at Dollay Wala (30.33), and the least in Maan (25.16). A gradational variation in Cr accumulation was observed in the three villages from contaminated wastewater having the least contamination level (2.02–4.40 mg L^?1), to soil (25.16–37.67 mg kg^?1), and ultimately in the seasonal vegetable crops (156.67–248.33 mg kg^?1) cultivated in the region, having the highest level of Cr contamination above the permissible limit. The model used not only predicted the current situation of Cr contamination in the three villages but also indicated the trend of magnification of Cr contamination from irrigation water to soil and to the base of the food chain. Among the multiple causes of Cr contamination of vegetables, soil irrigation with contaminated groundwater was observed to be the dominant one.     

A Novel Formulation for Designing a Monitoring Strategy: Application to the Design of a River Quality Monitoring System

In this work, we propose a technique to automatically optimize the monitoring of any distributed indicator (concentration of a substance along a river, blood pressure of a patient over time, etc.) for which a reliable estimate is previously available. From a mathematical point of view, the problem is based on obtaining a reliable estimate of the chosen indicator (e.g., by numerical simulation), and then solving a multi-objective optimization problem (with mixed real and integer variables) whose solution must provide an efficient and satisfactory monitoring strategy. As an illustrative case, we show the steps to follow in order to implement that strategy when designing a system for monitoring water quality in a river. Finally, we present and analyze the results when applying the proposed technique to study a real case in the Neuse River (North Carolina, USA).     

A moving target—incorporating knowledge of the spatial ecology of fish into the assessment and management of freshwater fish populations

Freshwater fish move vertically and horizontally through the aquatic landscape for a variety of reasons, such as to find and exploit patchy resources or to locate essential habitats (e.g., for spawning). Inherent challenges exist with the assessment of fish populations because they are moving targets. We submit that quantifying and describing the spatial ecology of fish and their habitat is an important component of freshwater fishery assessment and management. With a growing number of tools available for studying the spatial ecology of fishes (e.g., telemetry, population genetics, hydroacoustics, otolith microchemistry, stable isotope analysis), new knowledge can now be generated and incorporated into biological assessment and fishery management. For example, knowing when, where, and how to deploy assessment gears is essential to inform, refine, or calibrate assessment protocols. Such information is also useful for quantifying or avoiding bycatch of imperiled species. Knowledge of habitat connectivity and usage can identify critically important migration corridors and habitats and can be used to improve our understanding of variables that influence spatial structuring of fish populations. Similarly, demographic processes are partly driven by the behavior of fish and mediated by environmental drivers. Information on these processes is critical to the development and application of realistic population dynamics models. Collectively, biological assessment, when informed by knowledge of spatial ecology, can provide managers with the ability to understand how and when fish and their habitats may be exposed to different threats. Naturally, this knowledge helps to better evaluate or develop strategies to protect the long-term viability of fishery production. Failure to understand the spatial ecology of fishes and to incorporate spatiotemporal data can bias population assessments and forecasts and potentially lead to ineffective or counterproductive management actions.