Atmospheric particulate matter and polycyclic aromatic hydrocarbons for PM10 and size-segregated samples in Bangkok

Air samples of particulate matter (PM) with an aerodynamic diameter less than 10 microm (PM10) were collected from six sites in Bangkok, Thailand, using high-volume air samplers. Daily samples were taken at intervals of 12 days from November 1999 to November 2000. Size-selected sampling using a multislit Andersen size-fractionated cascade impactor was undertaken at one site in central Bangkok to identify particulate size distribution. The annual average PM10 concentration at all six sites exceeded the Thailand National Ambient Air Quality Standard (NAAQS) of 50 microg/m3. The daily PM10 concentrations at heavy traffic roadside areas ranged between 30 and 160 microg/m3. The highest PM10 level occurred during the winter period (November-February), which is the dry season. From our results, which are based on a 1-yr survey, it can be observed that the particulate concentrations are associated with traffic volumes and seasonal factors (temperature and rainfall). The relative importance of size fractions in contributing to PM load is presented and discussed. Twenty polycyclic aromatic hydrocarbons (PAHs) associated with PM have been identified and quantified. The summed PAHs based on the 20 species had an average concentration of 60 ng/m3. Benzo(e)pyrene, indeno(123cd)pyrene, and benzo(ghi)perylene were the major compounds with average concentrations of 8, 10, and 13 ng/m3, respectively. Results indicate that more than 97% of PAHs were found in the small particulate size range of <0.95 microm.     

The design of child restraint system (CRS) labels and warnings affects overall CRS usability

A study was conducted that assessed the effectiveness of different child restraint system (CRS) label/warning designs on users' installation performance. Forty-eight paid participants installed a convertible CRS in a vehicle, and two child test dummies in a CRS, using one of four label conditions. The label conditions were: (1) no labels, (2) the manufacturer's labels that were already affixed to the CRS ("Current"), (3) labels that were designed according to a combination of the current U.S. regulations concerning CRS labels and recently proposed changes to these regulations ("Proposed"), and (4) labels that were designed according to human factors principles and guidelines, and that were based on a hierarchical behavioral task analysis ("Optimal"). Results demonstrated that, overall, the Optimal labels resulted in higher usability ratings and better task performance. This indicates that labels designed using human factors and task analyses that identify critical task information requirements for label features will result in increased user compliance with instructions, higher usability, and improved task performance. Surprisingly, having no labels on the CRS resulted in better installation performance than when either the Current or the Proposed label conditions were used. This indicates that label design can decrease task performance; the actual physical design of a CRS may be just as critical as label content in the installation choices provided to the user. Collectively, results suggest that implementation of the proposed changes to the U.S. regulations concerning CRS labeling would likely not result in increased performance or usability compared to existing manufacturer labels that follow the current guidelines. In order to achieve significantly better ease-of-use and task performance, it would be necessary to implement features of the Optimal label condition.     

CHANNEL NETWORK EXTENSION BY LOGGING ROADS IN TWO BASINS,WESTERN CASCADES,OREGON1

ABSTRACT: Based on field surveys and analysis of road networks using a geographic information system (GIS), we assessed the hydrologic integration of an extensive logging-road network with the stream network in two adjacent 62 and 119 km² basins in the western Cascades of Oregon. Detailed surveys of road drainage for 20 percent of the 350 km road network revealed two hydrologic flow paths that link roads to stream channels: roadside ditches draining to streams (35 percent of the 436 culverts examined), and roadside ditches draining to culverts with gullies incised below their outlets (23 percent of culverts). Gully incision is significantly more likely below culverts on steep (< 40 percent) slopes with longer than average contributing ditch length. Fifty-seven percent of the surveyed road length is connected to the stream network by these surface flowpaths, increasing drainage density by 21 to 50 percent, depending on which road segments are assumed to be connected to streams. We propose a conceptual model to describe the hydrologic function of roads based on two effects: (1) a volumetric effect, increasing the volume of water available for quickflow and (2) a timing effect, altering flow-routing efficiency through extensions to the drainage network. This study examines the second of these two effects. Future work must quantify discharge along road segments connected to the stream network in order to more fully explain road impacts on basin hydrology.     

The interaction of temperature and sucrose concentration on foraging preferences in bumblebees

Several authors have found that flowers that are warmer than their surrounding environment have an advantage in attracting pollinators. Bumblebees will forage preferentially on warmer flowers, even if equal nutritional reward is available in cooler flowers. This raises the question of whether warmth and sucrose concentration are processed independently by bees, or whether sweetness detectors respond to higher sugar concentration as well as higher temperature. We find that bumblebees can use lower temperature as a cue to higher sucrose reward, showing that bees appear to process the two parameters strictly independently. Moreover, we demonstrate that sucrose concentration takes precedence over warmth, so that when there is a difference in sucrose concentration, bees will typically choose the sweeter feeder, even if the less sweet feeder is several degrees warmer.     

Design and Verification of a Programmable Gas Dispensing System for Exposing Plants to Dynamic Concentrations of Air Pollutants

Abstract

Landfills represent a source of distributed emissions source over an irregular and heterogeneous surface. In the method termed “Other Test Method-10” (OTM-10), the U.S. Environmental Protection Agency (EPA) has proposed a method to quantify emissions from such sources by the use of vertical radial plume mapping (VRPM) techniques combined with measurement of wind speed to determine the average emission flux per unit area per time from nonpoint sources. In such application, the VRPM is used as a tool to estimate the mass of the gas of interest crossing a vertical plane. This estimation is done by fitting the field-measured concentration spatial data to a Gaussian or some other distribution to define a plume crossing the vertical plane. When this technique is applied to landfill surfaces, the VRPM plane may be within the emitting source area itself. The objective of this study was to investigate uncertainties associated with using OTM-10 for landfills. The spatial variability of emission in the emitting domain can lead to uncertainties of –34 to 190% in the measured flux value when idealistic scenarios were simulated. The level of uncertainty might be higher when the number and locations of emitting sources are not known (typical field conditions). The level of uncertainty can be reduced by improving the layout of the VRPM plane in the field in accordance with an initial survey of the emission patterns. The change in wind direction during an OTM-10 testing setup can introduce an uncertainty of 20% of the measured flux value. This study also provides estimates of the area contributing to flux (ACF) to be used in conjunction with OTM-10 procedures. The estimate of ACF is a function of the atmospheric stability class and has an uncertainty of 10–30%.     

Our battle with hexachlorobenzene: citizen perspectives on toxic waste in Botany

The perspectives of residents are brought together in this assembly of statements concerning the management of hexachlorobenzene waste in Botany, a southeastern suburb of Sydney. The paper indicates how residents have responded as participants in public participation exercises, and the contribution made by lay experts in the search for a negotiated solution to the problems of legacy wastes. Resident comments on the role of independent scientific experts, on legal liability, and on the State Government sponsored Commission of Inquiry, indicate the deficit of resources faced by the local community. The paper provides insights into the status of citizen knowledge in environmental controversies and the pitfalls of participatory processes.     

Types of packaging waste from secondary sources (supermarkets)--the situation in the UK

Packaging waste is a contributing factor to the large quantity of waste that is sent to landfill in the UK. This research focuses on waste from the secondary packaging sector in the UK. In particular, supermarkets were investigated as they supply a large section of consumers with their grocery and other requirements and generate high quantities of packaging waste due to the high turnover within the store. In general, supermarkets use either metal cages or wooden pallets to transport products from depot to store. Investigation shows that packaging waste produced when using the wooden pallets is greater than for metal cages but the use of wooden pallets allows for greater versatility when in the store. The type of transit packaging used depends on what the products are initially packaged in and how the supermarket supply chain works. All cardboard and high-grade plastic is recycled but, depending on the facilities at the stores, the low-grade plastic can be recycled as well. This paper details types of packaging used within the supermarket secondary packaging sector and how waste can be reduced. To reduce the amount of packaging waste produced by the supermarkets, the products will have to be wrapped differently by the producers so that less packaging is needed in transit.     

Phenotypic analysis of fetal blood leucocytes: Potential for prenatal diagnosis of immunodeficiency disorders

Recent technological advances allow the detection and quantitation of subsets of leucocytes using monoclonal antibodies. We have taken advantage of this to study the ontogeny of fetal blood leucocytes, using very small blood samples obtained at fetoscopy. By 14 weeks gestation T cells represent 35 per cent or more of fetal leucocytes and the distribution of the helper/inducer and suppressor/cytotoxic subsets is similar to that of adults. B lymphocytes before 161/2 weeks are low (4–20 per cent), but rise to a mean of 28 per cent in 17–26 week fetuses. Granulocytic cells, many of which are phenotypically immature, represent 18–34 per cent of total leucocytes. The methodology employed is very reliable and offers the opportunity for the prenatal diagnosis of some immunodeficiency disorders, since using the same reagents we have diagnosed children with severe combined immunodeficiency shortly after birth.     

White birch (Betula papyrifera Marshall) foliar litter decomposition in relation to trace metal atmospheric inputs at metal-contaminated and uncontaminated sites near Sudbury, Ontario and Rouyn-Noranda, Quebec, Canada

Decomposition of white birch (Betula papyrifera Marshall) foliar litter was examined at metal-contaminated and uncontaminated sites established along gradients of soil Cu, Ni, Pb and Zn concentrations near Sudbury, Ontario and Rouyn-Noranda, Quebec. Over an 18-month study period, a significantly lower rate of litter mass loss was observed at the Sudbury contaminated site (S1) than at the uncontaminated site (S2). This result was not duplicated at corresponding sites (RN1, RN2) in Rouyn-Noranda, despite similar levels of soil metal contaminants and atmospheric inputs. Concentrations of metals in litter increased at all sites with time. However, the greatest litter Cu and Ni concentrations were observed at S1 (188 and 192 microg/g, respectively), a result of substantial net gains of these elements from atmospheric inputs. On a per hectare basis, Cu accumulation in litter at S1 approached recommended application rates of Cu as copper sulphate for control of fungal diseases in agricultural operations, indicating that the current rate of Cu smelter emissions in Sudbury may cause the observed impairment of decomposition.