冷冻胁迫对芦荟叶肉细胞原生质体中Ca2+、Na+分布的影响

低温和冻害是造成巨大农业损失和植物死亡的主要逆境因子。为揭示冷冻胁迫对植物细胞中离子分布的影响,选择芦荟细胞原生质体为受试材料,使用离子选择性微电极检测了经冷冻处理后的芦荟原生质体在低渗液中破裂时产生的Ca~(2+)浓度脉冲信号,并同时检测Na~+浓度脉冲信号作为对比。研究了冷冻温度、解冻时间和ZnO NPs处理等因素对冷冻胁迫下芦荟原生质体中Ca~(2+)分布的影响。结果表明,与未经冷冻处理的原生质体相对比,经过冷冻处理的原生质体破裂后,其Ca~(2+)脉冲信号前沿处发生明显的"凹陷",这说明,原生质体中Ca~(2+)分布出现分层现象,靠近细胞中心浓度较高而细胞膜附近浓度较低。这一分层现象在温度为-7℃时开始出现,原生质体解冻5 h后仍未消失。经过ZnO NPs预处理后再进行冷冻的原生质体,其Ca~(2+)脉冲凹陷深度明显减小。而当用ZnO NPs处理解冻后的原生质体时,其Ca~(2+)分层现象消失。冷冻胁迫下芦荟原生质体内Ca~(2+)分布发生显著变化,表明原生质体内Ca~(2+)分布变化与其抗寒反应存在一定关系。与Ca~(2+)相反,Na~+的分布几乎不受冷冻因素的影响。ZnO NPs处理对冷冻芦荟原生质体中Ca~(2+)浓度分布分层有明显的缓解作用,表明一定浓度范围的ZnO NPs在缓解冷冻造成的Ca~(2+)流动性下降,维持细胞Ca~(2+)分布的调控能力方面,具有一定的积极影响。     

Sub-cooled and flashing liquid jets and droplet dispersion I. Overview and model implementation/validation

Many accidents involve two-phase releases of hazardous chemicals into the atmosphere. This paper describes the results of a third phase of a Joint Industry Project (JIP) on liquid jets and two-phase droplet dispersion. The aim of the project is to increase the understanding of the behaviour of sub-cooled non-flashing and superheated flashing liquid jets, and to improve the prediction of initial droplet size, droplet dispersion and rainout.Phase III of the JIP first included scaled experiments for materials with a range of volatilities (water, cyclohexane, butane, propane and gasoline). These experiments were carried out by Cardiff University including measurements of flow rate and initial droplet size across the full relevant range of superheats. See the companion paper II for further details of these experiments and the derivation of new refined correlations for droplet size distribution and Sauter Mean Diameter. Furthermore large-scale butane experiments were carried out by INERIS (France) to ensure that for more realistic scenarios the derived droplet size correlations are accurate.Model validation and model improvements were carried out by DNV Software, including validation of release rate and initial droplet size against the above scaled and large-scale experiments. New correlations for droplet size distribution and Sauter Mean Diameter (SMD) were implemented into the Phast discharge model. These were compared against a range of other droplet size and rainout correlations published in the literature, in conjunction with validation against an extensive set of experiments. It was shown that the new droplet size correlation agrees better against experimental data than the existing Phast correlation. To further improve the rainout prediction, the Phast dispersion model (UDM) was also extended to allow simultaneous modelling of a range of droplet sizes and distributed rainout (rather than rainout at one point).     

Sub-cooled and flashing liquid jets and droplet dispersion II. Scaled experiments and derivation of droplet size correlations

This paper describes the results of the first stage of Phase III of a Joint Industry Project (JIP) on liquid jets and two-phase droplet dispersion. This stage included scaled experiments for water, gasoline, and cyclohexane for a range of superheats and nozzles with different aspect ratios. Additional experiments for butane and propane were conducted as a validation exercise and are discussed in the companion paper. Moreover this paper provides recommendations for atomisation correlations in the regimes of mechanical break-up, transition to flashing, and fully flashing. The objectives of this scaled experimental programme are to : (i) provide confidence in the previously proposed modelling methodology (Phase II) across a broad range of initial conditions (ii) update the models’ correlations to generalise further its applicability (iii) recommend further model improvements. Development of new correlations for Sauter Mean Droplet diameter (SMD) and droplet size distribution is based on a best fit of the current scaled experimental data. The new data endorses the previous tri-functional Phase II approach including regimes for mechanical break-up, transition to flashing, and fully flashing, which is hence updated in the new Phase III SMD model. Considerable effort is devoted to capturing the full droplet size range under low-superheat conditions. Also, new enhancements in PDA technology were adopted to enable better quality data under high-superheat conditions. The priority recommendation for further model improvement is better characterisation of the poor quality releases under low-superheat conditions, where this work indicates that extremely broad droplet size distributions are likely. A companion paper (Part I) presents a more general overview of the dispersion problem, implementation of the correlations and subsequent performance against both the current scaled experiments and additional large-scale butane experiments.     

五老峰隧道岩爆声发射参数特征研究

为研究岩爆事件的声发射特征,为岩爆灾害的进一步监测预警提供依据,对五老峰隧道掌子面附近区域岩爆事件进行声发射监测,以RA均值作为主要参数,研究岩爆发生前后的参数变化规律,并通过与b值等参数分析结果的相互印证,对比岩爆信号与爆破震动信号之间的区别。试验结果表明:不同传感器因为布设位置、耦合程度的差异,接收到的声发射信号数量与参数分布范围存在较大差异;RA均值作为参数分析依据,能够较好地反映岩爆事件的孕育发展过程,且能够一定程度上消除传感器接收信号数量差异的影响,更稳定地反映岩爆事件的信号特征;岩爆事件发生前RA均值与事件密度不断升高,峰值后则都迅速降低,而爆破产生的声发射信号则在RA值上存在一定突变性,且峰值后仍保持较高水平。本次监测中,共发生1次微型岩爆,而在左洞爆破后,声发射信号明显增多,但并未产生显著破裂事件。     

花岗岩蠕变特性及分数阶黏弹塑性模型研究

为了解花岗岩蠕变特性,采用全自动岩石三轴伺服仪对其开展试验研究,在常规三轴压缩试验基础上进行多级加载蠕变试验,系统分析花岗岩蠕变过程中整体蠕变规律和同围压不同应力水平下的轴向及环向蠕变变形量、蠕变速率随时间的变化规律。基于分数阶微积分算子及损伤力学理论,在Scott Blair黏壶基础上,考虑蠕变参数的非定常性,建立花岗岩黏弹塑性蠕变本构模型,并推导出其在恒应力情况下的三维黏弹塑性蠕变本构模型。结合花岗岩室内多级加载蠕变试验结果,采用Quasi Newton（BFGS）法对三维蠕变模型参数反演。结果表明,提出的模型与试验数据拟合较好并克服Nishihara模型不能描述蠕变非线性加速特征的不足,能够很好地反映花岗岩三阶段蠕变过程。     

A review of the impact of outdoor and indoor environmental factors on human health in China

Environmental Science and Pollution Research - The Intergovernmental Panel on Climate Change (IPCC) reported that global climate change has led to the increased occurrence of extreme weather...     

Diurnal and Weekday Variations in the Source Contributions of Ozone Precursors in California’s South Coast Air Basin

Abstract

For at least 30 years, ozone (O₃) levels on weekends in parts of California’s South Coast (Los Angeles) Air Basin (SoCAB) have been as high as or higher than on weekdays, even though ambient levels of O₃ precursors are lower on weekends than on weekdays. A field study was conducted in the Los Angeles area during fall 2000 to test whether proposed relationships between emission sources and ambient nonmethane hydrocarbon (NMHC) and oxides of nitrogen (NO_x) levels can account for observed diurnal and day-of-week variations in the concentration and proportions of precursor pollutants that may affect the efficiency and rate of O₃ formation. The contributions to ambient NMHC by motor vehicle exhaust and evaporative emissions, estimated using chemical mass balance (CMB) receptor modeling, ranged from 65 to 85% with minimal day-of-week variation. Ratios of ambient NO_x associated with black carbon (BC) to NO_x associated with carbon monoxide (CO) were approximately 1.25 ± 0.22 during weekdays and 0.76 ± 0.07 and 0.52 ± 0.07 on Saturday and Sunday, respectively. These results demonstrate that lower NO_x emissions from diesel exhaust can be a major factor causing lower NO_x mixing ratios and higher NMHC/NO_x ratios on weekends. Nonmobile sources showed no significant day-of-week variations in their contributions to NMHC. Greater amounts of gasoline emissions are carried over on Friday and Saturday evenings but are, at most, a minor factor contributing to higher NMHC/NO_x ratios on weekend mornings.     

Air Quality Measurements from the Fresno Supersite

ABSTRACT

The Fresno Supersite intends to 1) evaluate non-routine monitoring methods, establishing their comparability with existing methods and their applicability to air quality planning, exposure assessment, and health effects studies; 2) provide a better understanding of aerosol characteristics, behavior, and sources to assist regulatory agencies in developing standards and strategies that protect public health; and 3) support studies that evaluate relationships between aerosol properties, co-factors, and observed health end-points. Supersite observables include in-situ, continuous, short-duration measurements of 1) PM_2.5, PM₁₀, and coarse (PM₁₀ minus PM_2.5) mass; 2) PM_2.5 SO₄ ^-2, NO₃ ^-, carbon, light absorption, and light extinction; 3) numbers of particles in discrete size bins ranging from 0.01 to ~10μm; 4) criteria pollutant gases (O₃, CO, NO_x); 5) reactive gases (NO₂, NO_y, HNO₃, peroxyacetyl nitrate [PAN], NH₃); and 6) single particle characterization by time-of-flight mass spectrometry. Field sampling and laboratory analysis are applied for gaseous and particulate organic compounds (light hydrocarbons, heavy hydrocarbons, carbonyls, polycyclic aromatic hydrocarbons [PAH], and other semi-volatiles), and PM_2.5 mass, elements, ions, and carbon. Observables common to other Supersites are 1) daily PM_2.5 24-hr average mass with Federal Reference Method (FRM) samplers; 2) continuous hourly and 5-min average PM_2.5 and PM₁₀ mass with beta attenuation monitors (BAM) and tapered element oscillating microbalances (TEOM); 3) PM_2.5 chemical specia-tion with a U.S. Environmental Protection Agency (EPA) speciation monitor and protocol; 4) coarse particle mass by dichotomous sampler and difference between PM₁₀ and PM_2.5 BAM and TEOM measurements; 5) coarse particle chemical composition; and 6) high sensitivity and time resolution scalar and vector wind speed, wind direction, temperature, relative humidity, barometric pressure, and solar radiation. The Fresno Supersite is coordinated with health and toxicological studies that will use these data in establishing relationships with asthma, other respiratory disease, and cardiovascular changes in human and animal subjects.