Comparison of two reference black carbons using a planar PCB as a model sorbate

In studies assessing sorption of hydrophobic organic compounds (HOCs) in natural systems, the choice of an appropriate reference black carbon, which can represent environmental black carbon (BC), is essential. This study compared isotherms of two commonly available and distinct reference BCs (n-hexane soot (BCRM) and diesel particulate matter (SRM 2975)) and a natural sediment from a source with little black carbon (Lake Hartwell, SC) using 3,3',4-trichlorobiphenyl (IUPAC #35) as a model sorbate. There was greater sorptivity for PCB-35 by BCRM than by SRM 2975. The observed differences in sorption between the two reference black carbons for PCB-35 may be ascribed to the different chemical characteristics of the black carbons. Differences in pore volume distribution at <16A pore width are less likely to be responsible for the observed differences in sorption. The elemental analysis confirmed that BCRM was a pure n-hexane soot because only C, H and O were measured. In contrast, SRM 2975 also contained N and S and a higher O% than BCRM. Compared to the low BC sediment, the two reference BCs had greater pore volume distributions, surface areas, total pore volumes and sorption. The observed nF (i.e., Freundlich exponent) values for PCB indicated greater linearity of the isotherms for the natural sediment than for the reference black carbons. For designing studies of sorption of HOCs in natural systems, in particular, when PCBs are contaminants of concern, results of this study can aid selection of the appropriate reference BCs.     

Photocatalytic oxidation of gas-phase elemental mercury by nanotitanosilicate fibers

Photocatalytic fibers were generated from the continuous evaporation of titanium tetraisopropoxide with tetraethyl orthosilicate through a flame burner. The morphology, the crystal form, and the components of the nanotitanosilicate fibers were analyzed by Raman spectroscopy, Field emission-scanning electron microscope, X-ray diffraction, and Brunauer-Emmett-Teller surface area analysis. The nanotitanosilicates prepared by three different carrier gases (air, N(2), and Ar) were tested for their photocatalytic ability to remove/oxidize gas-phase elemental mercury. Under UV black light, the Hg(0) capture efficiencies were 78%, 86%, and 85% for air, N(2), and Ar, respectively. For air, the value was close to 90%, even under household fluorescent light. The Hg(0) capture efficiency by nanotitanosilcate was measured under fluorescent light, UV black light, and sunlight.     

Oxidation of elemental mercury using atmospheric pressure non-thermal plasma

The oxidation of gas phase elemental mercury (Hg0) by atmospheric pressure non-thermal plasma has been investigated at room temperature, employing both dielectric barrier discharge (DBD) of the gas mixture of Hg0 and injection of ozone (O3) into the gas mixture of Hg0. Results have shown that the oxidative efficiencies of Hg0 by DBD and the injection of O3 are 59% and 93%, respectively, with energy consumption of 23.7 J L(-1). This combined approach has indicated that O3 plays a decisive role in the oxidation of gas phase Hg0. Also the oxidation of Hg0 by injecting O3 into the gas mixture of Hg0 proceeds with better efficiency than DBD of the gas mixture of Hg0. These results have been explained by the incorporation of the competitive reaction pathways between the formation of HgO by O3 and the decomposition of HgO back to Hg0 in the plasma environment.     

Occurrence of phthalates in sediment and biota: relationship to aquatic factors and the biota-sediment accumulation factor

Phthalate compounds in sediments and fishes were investigated in 17 Taiwan's rivers to determine the relationships between phthalate levels in sediment and aquatic factors, and biota-sediment accumulation factor (BSAF) for phthalates. Mean concentrations (range) of di(2-ethylhexyl) phthalate (DEHP), butyl benzyl phthalate (BBzP) and di-n-butyl phthalate (DBP) in sediment at low-flow season were 4.1 (<0.05-46.5), 0.22 (<0.05-3.1) and 0.14 (<0.05-1.3)mgkg(-1)dw; those at high-flow season were 1.2 (<0.05-13.1), 0.13 (<0.05-0.27) and 0.09 (<0.05-0.22)mgkg(-1)dw, respectively. Trace levels of dimethyl phthalate (DMP), diethyl phthalate (DEP) and di-n-octyl phthalate (DOP) in sediment were found in both seasons. Concentrations of DEHP in sediments were significantly affected by temperature, suspended solids, ammonia-nitrogen, and chemical oxygen demand. The highest concentration of DEHP in fish samples were found in Liza subviridis (253.9mgkg(-1)dw) and Oreochromis miloticus niloticus (129.5mgkg(-1)dw). BSAF of DEHP in L. subviridis (13.8-40.9) and O. miloticus niloticus (2.4-28.5) were higher than those in other fish species, indicating that the living habits of fish and physical-chemical properties of phthalates, like logKow, may influence the bioavailability of phthalates in fish. Our data suggested that DEHP level in river sediments were influenced by water quality parameters due to their effects on the biodegradation processes, and that the DEHP level in fish was affected by fish habitat and physiochemical properties of polluted contaminants.     

In situ iron activated persulfate oxidative fluid sparging treatment of TCE contamination--a proof of concept study

In situ chemical oxidation (ISCO) is considered a reliable technology to treat groundwater contaminated with high concentrations of organic contaminants. An ISCO oxidant, persulfate anion (S(2)O(8)(2-)) can be activated by ferrous ion (Fe(2+)) to generate sulfate radicals (E(o)=2.6 V), which are capable of destroying trichloroethylene (TCE). The property of polarity inhibits S(2)O(8)(2-) or sulfate radical (SO(4)(-)) from effectively oxidizing separate phase TCE, a dense non-aqueous phase liquid (DNAPL). Thus the oxidation primarily takes place in the aqueous phase where TCE is dissolved. A bench column study was conducted to demonstrate a conceptual remediation method by flushing either S(2)O(8)(2-) or Fe(2+) through a soil column, where the TCE DNAPL was present, and passing the dissolved mixture through either a Fe(2+) or S(2)O(8)(2-) fluid sparging curtain. Also, the effect of a solubility enhancing chemical, hydroxypropyl-beta-cyclodextrin (HPCD), was tested to evaluate its ability to increase the aqueous TCE concentration. Both flushing arrangements may result in similar TCE degradation efficiencies of 35% to 42% estimated by the ratio of TCE degraded/(TCE degraded+TCE remained in effluent) and degradation byproduct chloride generation rates of 4.9 to 7.6 mg Cl(-) per soil column pore volume. The addition of HPCD did greatly increase the aqueous TCE concentration. However, the TCE degradation efficiency decreased because the TCE degradation was a lower percentage of the relatively greater amount of dissolved TCE by HPCD. This conceptual treatment may serve as a reference for potential on-site application.     

Degradation rates of CFC-11, CFC-12 and CFC-113 in anoxic shallow aquifers of Araihazar, Bangladesh

Chlorofluorocarbons CFC-11 (CCl(3)F), CFC-12 (CCl(2)F(2)), and CFC-113 (CCl(2)F-CClF(2)) are used in hydrology as transient tracers under the assumption of conservative behavior in the unsaturated and saturated soil zones. However, laboratory and field studies have shown that these compounds are not stable under anaerobic conditions. To determine the degradation rates of CFCs in a tropical environment, atmospheric air, unsaturated zone soil gas, and anoxic groundwater samples were collected in Araihazar upazila, Bangladesh. Observed CFC concentrations in both soil gas and groundwater were significantly below those expected from atmospheric levels. The CFC deficits in the unsaturated zone can be explained by gas exchange with groundwater undersaturated in CFCs. The CFC deficits observed in (3)H/(3)He dated groundwater were used to estimate degradation rates in the saturated zone. The results show that CFCs are degraded to the point where practically no (<5%) CFC-11, CFC-12, or CFC-113 remains in groundwater with (3)H/(3)He ages above 10 yr. In groundwater sampled at our site CFC-11 and CFC-12 appear to degrade at similar rates with estimated degradation rates ranging from approximately 0.25 yr(-1) to approximately 6 yr(-1). Degradation rates increased as a function of reducing conditions. This indicates that CFC dating of groundwater in regions of humid tropical climate has to be carried out with great caution.     

Ozonation of pentachlorophenol in unsaturated soils

A heterogeneous model was developed to describe interactions between ozone and hydrophobic organic compounds, exemplified by pentachlorophenol, in highly gas-saturated vadose zones where water moisture was limited to a thin film on soil particle surfaces. The soil was assumed to be free of soil organic matter. The model included a set of transient equations considering diffusion with simultaneous chemical reaction and hydrophobic partitioning. From dimensionless analysis, it was found that the film concentrations of ozone and the hydrophobic organic component were dependent on the Damk?hler numbers. Effects of Damk?hler numbers on the film profiles of components were examined. With the interfacial flux of ozone calculated from film profiles, dimensionless governing equations of ozone transport and contaminant removal across an experimental column were established. These equations were dependent on the Stanton number. One-dimensional column experiments were conducted to test the model. The optimal time for flow rate adjustment during the process was approximated. Finally, effects of ozone velocity and ozone gas concentration on the Stanton number were evaluated.     

A comparison of the low frequency electrical signatures of iron oxide versus calcite precipitation in granular zero valent iron columns

Geophysical methods have been proposed as technologies for non-invasively monitoring geochemical alteration in permeable reactive barriers (PRBs). We conducted column experiments to investigate the effect of mineralogy on the electrical signatures resulting from iron corrosion and mineral precipitation in Fe0 columns using (a) Na2SO4, and (b) NaHCO3 plus CaCl2 mixture, solutions. At the influent interface where the reactions were most severe, a contrasting time-lapse electrical response was observed between the two columns. Solid phase analysis confirmed the formation of corrosion halos and increased mineralogical complexity in the corroded sections of the columns compared to the minimal/non-corroded sections. We attribute the contrasting time-lapse signatures to the differences in the electrical properties of the mineral phases formed within the two columns. While newly precipitated/transformed polarizable and semi-conductive iron oxides (mostly magnetite and green rust) increase the polarization and conductivity of the sulfate column, the decrease of both parameters in the bicarbonate column is attributed to the precipitation of non-polarizable and non-conductive calcite. Our results show that precipitate mineralogy is an important factor influencing the electrical properties of the corroded iron cores and must be considered if electrical geophysical methods are to be developed to monitor PRB barrier corrosion processes in situ.     

Elemental Mercury Control by Novel Oxidant and Sorbent in an Entrained-Flow System

An entrained-flow system has been designed and constructed to simulate in-flight mercury capture by sorbents in ducts of coal-fired utility plants. The test conditions of 1.5 s residence time, 140°C temperature, 4.5 ppbv inlet Hg⁰ concentration, and 0–20 lb/MMacf sorbent injection rates were chosen to simulate conditions in the ducts. Novel oxidants developed in previous fixed-bed tests and novel sorbents derived from the novel oxidants were tested for their Hg⁰ capture in the entrained-flow system to examine the possibility of using those sorbents in a full-scale system. Darco-FGD and Darco Hg-LH served as benchmark sorbents with which mercury control capability of the novel oxidants and novel sorbents could be compared. The test results showed that the novel oxidants have remarkable Hg⁰ oxidation capability, and the novel sorbents showed a better performance in Hg⁰ removal than Darco Hg-LH.