Environmental risk assessment of human pharmaceuticals in Denmark after normal therapeutic use

An environmental risk assessment is presented for the 25 most used pharmaceuticals in the primary health sector in Denmark. Predicted environmental concentrations (PECs) for the aquatic environment were calculated using conservative assumptions and all PECs exceeded 1 ng/l. Measured concentrations were in general within a factor of 2-5 of PECs and ranged from approximately 0.5 ng/l to 3 micrograms/l for nine of the pharmaceuticals reported in literature. The calculation of predicted no-effect concentration (PNEC) based on aquatic ecotoxicity data was possible for six of the pharmaceuticals. PEC/PNEC ratio exceeded one for ibuprofen, acetylsalicylic acid, and paracetamol. For estrogens the PEC/PNEC ratio approached one when non-standard test was used. The ratio was below one for estrogens (standard test), diazepam and digoxin. For the terrestrial compartment, toxicity data were not available, and no assessment was carried out. Comparisons of predicted concentrations of furosemide, ibuprofen, oxytetracycline and ciprofloxacin in sludge based on either preliminary experimental sludge-water partition coefficients (Kd), octanol-water coefficients (Kow) or acid-base constants (pKa) revealed large variations.     

Removal of BTEX vapor from waste gases by a trickle bed biofilter

The system performance of a trickle bed biofilter for treating single and mixed benzene, toluene, ethylbenzene, and o-xylene (BTEX) vapors from waste gases was investigated under different gas flow rates and influent BTEX concentrations. When a single substrate was fed, removal efficiencies of greater than 90% could be achieved for the loads below 64 g benzene/m3/hr, 110 g toluene/m3/hr, 53 g ethylbenzene/m3/hr, and 55 g o-xylene/m3/hr. When a mixed substrate was fed, removal efficiencies of each compound could be above 90% at BTEX loads below 96 g/m3/hr. The trickle bed biofilter appears to be an effective treatment process for removing both single and mixed BTEX vapors with low to high loads. Under similar substrate loads, BTEX vapors were preferentially biodegraded in the order of toluene, benzene, o-xylene, and ethylbenzene. The volumetric removal rates (elimination capacities) of BTEX vapors for a single-substrate feed were higher than those for a mixed-substrate feed under similar substrate loads; these differences were enhanced at higher substrate loads and less significant for a preferred substrate.     

The sensitivity of PM2.5 source-receptor relationships to atmospheric chemistry and transport in a three-dimensional air quality model

Air quality model simulations constitute an effective approach to developing source-receptor relationships (so-called transfer coefficients in the risk analysis framework) because a significant fraction of particulate matter (particularly PM2.5) is secondary (i.e., formed in the atmosphere) and, therefore, depends on the atmospheric chemistry of the airshed. In this study, we have used a comprehensive three-dimensional air quality model for PM2.5 (SAQM-AERO) to compare three approaches to generating episodic transfer coefficients for several source regions in the Los Angeles Basin. First, transfer coefficients were developed by conducting PM2.5 SAQM-AERO simulations with reduced emissions of one of four precursors (i.e., primary PM, sulfur dioxide (SO2), oxides of nitrogen (NOx), and volatile organic compounds) from each source region. Next, we calculated transfer coefficients using two other methods: (1) a simplified chemistry for PM2.5 formation, and (2) simplifying assumptions on transport using information limited to basin-wide emission reductions. Transfer coefficients obtained with the simplified chemistry were similar to those obtained with the comprehensive model for VOC emission changes but differed for NOx and SOz emission changes. The differences were due to the parameterization of the rates of secondary PM formation in the simplified chemistry. In 90% of the cases, transfer coefficients estimated using only basin-wide information were within a factor of two of those obtained with the explicit source-receptor simulations conducted with the comprehensive model. The best agreement was obtained for VOC emission changes; poor agreement was obtained for primary PM2.5.     

Effects of five insecticides used in apple orchards on Hyaliodes vitripennis (Say) (Hemiptera: Miridae)

Azinphos-methyl, carbaryl, dimethoate, phosmet and phosalone were used in apple orchards to manage apple aphid, apple maggot, woolly apple aphid and leaf eating caterpillars. Among the five insecticides evaluated, dimethoate, carbaryl and azinphosmethyl were the most toxic to the nymphs and adults of Hyaliodes vitripennis (Say) from two regions. Phosalone was the least toxic. Nymphs were more resistant than the adults. While the LC50 for dimethoate was 130 ppm for nymphs, it was 3 ppm for adults from St. Jean-Baptiste-de-Rouville. There were also significant differences in the level of resistance between the two regions where the H. vitripennis were collected. At St. Alexandre the LC50 for phosalone on nymphs was 19,250 ppm whereas, at St. Jean-Baptiste-de-Rouville it was 160,000 ppm.     

Dioxins: WHO's tolerable daily intake (TDI) revisited

In December 1990, the World Health Organization (WHO) established a tolerable daily intake (TDI) of 10 pg/kg b.w. (body weight) for TCDD, based on liver toxicity, reproductive effects and immunotoxicity in experimental animals, and making use of kinetic data in humans and experimental animals. Since then new epidemiological and toxicological data have emerged, in particular with respect to neurodevelopmental and endocrine effects of dioxin. Therefore, the European Centre for Environment and Health of the World Health Organization (WHO-ECEH) and the International Programme on Chemical Safety (IPCS) jointly organized a consultation on the "Assessment of the health risk of dioxins: re-evaluation of the TDI", May 1998, Geneva, Switzerland. The participants discussed the health risks for infants, cancer and non-cancer endpoints in humans and animals, mechanistic aspects, kinetic behaviour, modelling, exposure, and the applicability of the toxic equivalency (TEQ) concept. For the health risk assessment of dioxin-like compounds, the WHO Consultation focused on the most sensitive effects that are considered adverse (hormonal, reproductive and developmental effects) seen at low doses in animal studies (rats and monkeys). Human daily intakes corresponding with body burdens similar to those associated with adverse effects in animals could be estimated to be in the range of 14-37 pg/kg b.w./day. To arrive at a TDI expressed as TEQ, a composite uncertainty factor of 10 was recommended. By applying this uncertainty factor a TDI range of 1-4 pg TEQs/kg body weight was established. An extensive executive summary of the results of this WHO Consultation with all the underlying background documents will be published in Food Additives and Contaminants (in press).     

Neural network model for predicting peak photochemical pollutant levels

In this paper, an attempt is made for the 24-hr prediction of photochemical pollutant levels using a neural network model. For this purpose, a model is developed that relates peak pollutant concentrations to meteorological and emission variables and indexes. The analysis is based on measurements of O3 and NO2 from the city of Athens. The meteorological variables are selected to cover atmospheric processes that determine the fate of the airborne pollutants while special care is taken to ensure the availability of the required input data from routine observations or forecasts. The comparison between model predictions and actual observations shows a good agreement. In addition, a series of sensitivity tests is performed in order to evaluate the sensitivity of the model to the uncertainty in meteorological variables. Model forecasts are generally rather insensitive to small perturbations in most of the input meteorological data, while they are relatively more sensitive in changes in wind speed and direction.     

Microwave regeneration of activated carbon used for removal of solvents from vented air

A microwave regeneration of activated carbon used to remove organic solvents from vented air has been investigated. Methyl ethyl ketone (MEK), acetone, and tetrachloroethylene (TCE) vapors were removed from vented air through adsorption onto granular activated carbon. The saturated carbon was then regenerated in a microwave field, where the solvent was quickly desorbed and recovered from the inner pores of the carbon granules. The microwave-induced regeneration restored the original adsorption capacity and surface area of the activated carbon.     

On-road motor vehicle emissions and fuel consumption in urban driving conditions

This paper reports on the analysis of on-road vehicle speed, emission, and fuel consumption data collected by four instrumented vehicles. Time-, distance-, and fuel-based average fuel consumption, as well as CO, HC, NOx, and soot emission factors, were derived. The influences of instantaneous vehicle speed on emissions and fuel consumption were studied. It was found that the fuel-based emission factors varied much less than the time- and distance-based emission factors as instantaneous speed changed. The trends are similar to the results obtained from laboratory tests. The low driving speed contributed to a significant portion of the total emissions over a trip. Furthermore, the on-road data were analyzed using the modal approach. The four standard driving modes are acceleration, cruising, deceleration, and idling. It was found that the transient driving modes (i.e., acceleration and deceleration) were more polluting than the steady-speed driving modes (i.e., cruising and idling) in terms of g/km and g/sec. These results indicated that the on-road emission measurement is feasible in deriving vehicle emissions and fuel consumption factors in urban driving conditions.     

Impact of long-term pesticide applications on some soil biological parameters

The soil oxidative and anaerobic processes, as well as, the microbial biomass were followed during three years in a cotton farm (Tatuí) where the recommended pesticides have been used for several years, and in an experimental field (S?o Paulo) treated first time with the same pesticides. The oxidative process was monitored by the dehydrogenase (DHA)-activity using triphenyltetrazolium chloride (TTC) as substrate. The anaerobic process was followed by the iron-oxide reduction, and the microbial biomass was estimated by the substrate (glucose)-indiced respiration. Increases in DHA-activity and in the microbial biomass occurred only in the farm soil, with concomitant decreases in iron-reduction. In the experimental field soil, the increases in DHA-activity were followed only by decreases in iron-reduction. Soil characteristics were the determining factor for different biological parameters after pesticide inputs. All the pesticides produced at least one clear but transient effect.     

Persistence, degradation and leaching of coumaphos in soil

Dissipation, degradation and leaching of fresh 14C coumaphos, alkylated 14C coumaphos and aged residues of 14C coumaphos from vats were studied in alkaline sandy loam soil in soil columns in the field under subtropical conditions in Delhi for a year. Dissipation, degradation and bound residue formation was more in case of alkali treated coumaphos than fresh coumaphos. After 365 days total residues of fresh coumaphos accounted for 33.25% while that of alkali treated coumaphos was 19.12%. Bound residue formation was almost double in case of alkali treated coumaphos (18.95%) than fresh coumaphos (9.53%) after 150 days followed by release of bound residue in both the cases. The proportion of metabolites 4-methylumbelliferone, chlorferon and potasan collectively was 86.05% in fresh coumaphos extractable residues while the same was 91.74% in alkali treated coumaphos after 365 days. Aged residues from vats containing copper sulphate and buffer were found to be more persistent in soil as total residues remained were 95.58% in comparison with 83.09% total residues of aged residues from vats containing only buffer after 150 days of treatment. Copper sulphate seems to inhibit the degradatiion of coumaphos in soil by microorganisms. Chlorferon was the major metabolite in generally all the samples. Coumaphos did not leach below 10 cm in all the cases.