Formation of PCDD/Fs in the sintering process: role of the grid-Cr2O3 catalyst in the de novo synthesis

The sintering process is among the major sources of the very toxic polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans (PCDD/Fs) in the environment. At the industrial scale, it has been shown that dust collected on the grid, which supports the feed, contains PCDD/Fs amounts between the values found in the bottom of the cake and the values found on dust collected during gas sampling in the wind boxes. This fact suggests that the grid, containing 25wt.% of chromium, could have a catalytic activity in PCDD/Fs formation during the sintering process. This research tries to study this potential role. The de novo synthesis of PCDD/Fs is simulated at laboratory scale by thermal treatments of samples mixed with grid filings or Cr2O3. The thermal experiments performed with E.S.P. dust (dust collected in the electrostatic precipitator of a sintering plant) or graphite mixed with grid filings do not allow to confirm a role of the grid in PCDD/Fs formation during the industrial process. On the other hand, it has been shown that Cr2O3 can be considered as a catalyst in the de novo synthesis of PCDD/Fs. This compound takes place in the two steps of the de novo synthesis: the degradation of the carbon matrix as well as the chlorination reactions.     

Photocatalytic degradation of azo dyes by nitrogen-doped TiO2 nanocatalysts

This study examined the photocatalytic degradation of three azo dyes, acid orange 7 (AO7), procion red MX-5B (MX-5B) and reactive black 5 (RB5) using a new type of nitrogen-doped TiO2 nanocrystals. These newly developed doped titania nanocatalysts demonstrated high reactivity under visible light (lambda>390 nm), allowing more efficient usage of solar light. The doped titania were characterized by X-ray diffraction (XRD) and transmission electron microscopy (TEM). Experiments were conducted to compare the photocatalytic activities of nitrogen-doped TiO2 nanocatalysts and commercially available Degussa P25 powder using both UV illumination and solar light. It is shown that nitrogen-doped TiO2 after calcination had the highest photocatalytic activity among all three catalysts tested, with 95% of AO7 decolorized in 1 h under UV illumination. The doped TiO2 also exhibited substantial photocatalytic activity under direct sunlight irradiation, with 70% of the dye color removed in 1h and complete decolorization within 3 h. Degussa P25 did not cause detectable dye decolorization under identical experimental conditions using solar light. The decrease of total organic carbon (TOC) and evolution of inorganic sulfate (SO4(2-)) ions in dye solutions were measured to monitor the dye mineralization process.     

Monitoring and toxicity of sulfonated derivatives of benzene and naphthalene in municipal sewage treatment plants

Monitoring benzenesulfonates (BS) and naphthalenesulfonates (NS) took place in five municipal sewage treatment plants (STP). A previously optimized method based on solid phase extraction with polymeric cartridges followed by ion-pair liquid chromatography-electrospray-mass spectrometry (SPE-IPC-ESI-MS) was used. This work confirmed the little or no effect of primary settlement on total organic carbon (TOC) and monosulfonated compounds removal, whereas the main reduction is obtained at the biological stage. However, the most polar compounds, such as naphthalenedisulfonates (NDS), were not effectively removed using the biological treatment. An aromatic sulfonated compound is suggested to be used as a tracer of the origin of industrial pollutants discharged into STPs. A bioluminescence inhibition test, Microtox assay, allowed toxicity determination of the most relevant aromatic sulfonated compounds detected and toxicity comparison between primary and secondary effluents.     

Distribution and partitioning of phosphorus in solid waste and sediments from drainage canals in the industrial belt of Delhi, India

Phosphorus is an essential and often limiting nutrient in both marine and freshwater ecosystems. However, its oversupply is of great concern in many environments due to its role in eutrophication. The concentration and distribution of sediment bound phosphorus species not only record its input into the environment, but also suggest their possible sources. It is recognized that the features of phosphorus behaviour have not been extensively studied in urban environments. In this study, phosphorus in solid waste and sediments from drainage canals within the industrial belt of Delhi were fractionated into five operationally defined forms, i.e., exchangeable or loosely sorbed phosphorus (Exch-P), Fe-bound phosphorus (Fe-P), authigenic apatite, CaCO3-bound phosphorus and biogenic apatite (Acet-P), detrital apatite (Det-P) and organic-bound phosphorus (Org-P), in order to assess the potential bioavailability status in these systems.     

Long-term increases in surface water dissolved organic carbon: observations, possible causes and environmental impacts

Dissolved organic carbon (DOC) concentrations in 22 UK upland waters have increased by an average of 91% during the last 15 years. Increases have also occurred elsewhere in the UK, northern Europe and North America. A range of potential drivers of these trends are considered, including temperature, rainfall, acid deposition, land-use, nitrogen and CO2 enrichment. From examination of recent environmental changes, spatial patterns in observed trends, and analysis of time series, it is suggested that DOC may be increasing in response to a combination of declining acid deposition and rising temperatures; however it is difficult to isolate mechanisms based on monitoring data alone. Long-term DOC increases may have wide-ranging impacts on freshwater biota, drinking water quality, coastal marine ecosystems and upland carbon balances. Full understanding of the significance of these increases requires further knowledge of the extent of natural long-term variability, and of the natural "reference" state of these systems.     

The recovery of ammonia and hydrogen sulfide from ground-level area sources using dynamic isolation flux chambers: bench-scale studies

Controlled bench-scale laboratory experiments were conducted to evaluate the recovery of ammonia (NH3) and hydrogen sulfide (H2S) from dynamic isolation flux chambers. H2S (80-4000 ppb) and NH3 (5000-40,000 ppb) samples were diffused through the flux chamber to simulate ground level area source emissions while measuring the inlet and outlet flux chamber concentrations simultaneously. Results showed that the recovery of H2S during a 30-min sampling time was almost complete for concentrations >2000 ppb. At the lowest concentration of 80 ppb, 92.55% of the H2S could be recovered during the given sampling period. NH3 emissions exhibited similar behavior between concentrations of 5000-40,000 ppb. Within the 30-min sampling period, 92.62% of the 5000-ppb NH3 sample could be recovered. Complete recovery was achieved for concentrations >40,000 ppb. Predictive equations were developed for gas adsorption. From these equations, the maximum difference between chamber inlet and outlet concentrations of NH3 or H2S was predicted to be 7.5% at the lowest concentration used for either gas. In the calculation of emission factors for NH3 and H2S, no adsorption correction factor is recommended for concentrations >37,500 ppb and 2100 ppb for NH3 and H2S, respectively. The reported differences in outlet and inlet concentration above these ranges are outside the fullscale sensitivity of the gas sensing equipment. The use of 46-90 m of Teflon tubing with the flux chambers has apparently no effect on gas adsorption, because recovery was completed almost instantaneously at the beginning of the tests.     

Monitoring of the booster biocide dichlofluanid in water and marine sediment of Greek marinas

Dichlofluanid (N-dichlorofluoromethylthio-N'-dimethyl-N-phenylsulphamide) is used as booster biocide in antifouling paints. The occurrence of dichlofluanid and its metabolite DMSA (N'-dimethyl-N-phenyl-sulphamide) was monitored in seawater and marine sediment from three Greek marinas. Seawater and sediment samples were collected at three representative positions and one suspected hotspot in each marina and shipped to the laboratory for chemical analysis. As part of the project, an analytical method had been developed and validated. Furthermore, some additional experiments were carried out to investigate the potential contribution of paint particle bound dichlofluanid on the total concentration in the sediment. As expected, given its known high hydrolytic degradation rate, no detectable concentrations of dichlofluanid were measured in any of the seawater samples. DMSA was detected in seawater samples at very low concentrations varying from <3 ng l(-1) (LOD) to 36 ng l(-1). During method validation, it had already been demonstrated that dichlofluanid is unstable in sediment and can therefore only be determined as its metabolite DMSA. In a separate experiment, in which marine sediment was spiked with artificial paint particles containing dichlofluanid and then analysed according to the validated method, it was demonstrated that if there is any dichlofluanid originating from paint particles, this would be determined as DMSA. No DMSA was detected in any of the sediment samples. It could therefore be concluded that there were no significant concentrations of dichlofluanid in the sediment samples.     

Anaerobic degradation of diethyl phthalate, di-n-butyl phthalate, and di-(2-ethylhexyl) phthalate from river sediment in Taiwan

We investigated anaerobic degradation rates for three phthalate esters (PAEs), diethyl phthalate (DEP), di-n-butyl phthalate (DBP), and di-(2-ethylhexyl) phthalate (DEHP), from river sediment in Taiwan. The respective anaerobic degradation rate constants for DEP, DBP, and DEHP were observed as 0.045, 0.074, and 0.027 1/day, with respective half-lives of 15.4, 9.4, and 25.7 days under optimal conditions of 30 °C and pH 7.0. Anaerobic degradation rates were enhanced by the addition of the surfactants brij 35 and triton N101 at a concentration of 1 critical micelle concentration (CMC), and by the addition of yeast extract. Degradation rates were inhibited by the addition of acetate, pyruvate, lactate, FeCl₃, MnO₂, NaCl, heavy metals, and nonylphenol. Our results indicate that methanogen, sulfate-reducing bacteria, and eubacteria are involved in the degradation of PAEs.     

Levels of dioxin-like compounds in sewage sludge determined with a bioassay based on EROD induction in chicken embryo liver cultures

A bioassay for the detection of dioxin-like compounds was used to estimate levels in sewage sludge from Swedish sewage treatment plants (STPs). The sludge extracts were HPLC-separated into three fractions containing a) monoaromatic/aliphatic, b) diaromatic (e.g. polychlorinated biphenyls [PCBs], polychlorinated dibenzodioxins and polychlorinated dibenzofurans [PCDDs/Fs]), and c) polyaromatic compounds (e.g. polycyclic aromatic hydrocarbons [PAHs]). The bioassay, which is based on EROD (7-ethoxyresorufin O-deethylase) induction in cultured chicken embryo livers detected dioxin-like activity in all unfractionated extracts and in the di- and polyaromatic fractions of all sludge extracts, but not in the monoaromatic/aliphatic fractions. The levels ranged between 6 and 109 pg bio-TEQ/g sludge (d.w.). In sediment samples from rural lakes in Sweden, levels of about 5 pg bio-TEQ/g (d.w.) have been found. The polyaromatic fractions of the sludge samples were potent in the bioassay, probably due to various PAHs and other polyaromatics in the sludge. The levels of six PAHs that are screened for in the sludge at Swedish STPs accounted for only 3-10% of the observed EROD-induction by the polyaromatic fractions. Consequently, many other polyaromatic EROD-inducing compounds were present in the sludge. Inclusion of a biological test like the chicken embryo liver bioassay in the screening of sludge would improve the ability to detect the presence of bioactive dioxin-like compounds. A theoretical estimation of bio-TEQ concentrations in farm-soil following long-term application of sludge with bio-TEQ concentrations similar to those observed in this investigation indicated that the bio-TEQ levels in soil would increase very slowly over time. The chicken embryo liver bioassay proved useful in assessing levels of dioxin-like compounds in sewage sludge and it gives valuable complementary information to chemical analysis data.