The influence of geometry and draught shields on the performance of passive samplers

Passive samplers provide an excellent opportunity to perform indicative measurements or establish a dense network of measuring sites. A drawback compared with conventional active measuring methods is the larger spread of results. This variation can, to a large extent, be attributed to the influence of temperature, sampler geometry and wind on sampling results. A proper design of sampler geometry and optimum choice of draught shield can reduce the influence of wind velocity on a badge type sampler to less than 10%. Wire mesh screens prove to be inadequate in damping turbulence. Filters give good results. Attention should be paid to the size and isolation value of the walls of the sampler to prevent thermal updrafts occurring within the sampler. Tube type samplers are less influenced by wind, provided that turbulence is prevented from influencing diffusion within the sampler.     

Paleolimnological assessment of Grove and Plow Shop Ponds, Ayer, Massachusetts, USA--a superfund site

Three sediment cores from each of severely polluted Grove and Plow Shop Ponds, Ayer, Massachusetts, USA, were dated using (210)Pb, characterized for plant macrofossil assemblages, and analyzed for H(2)O, loss-on-ignition, stable Pb isotopes, and concentrations of As, Ca, Cd, Cr, Cu, Fe, Hg, methyl-Hg, Ni, Pb, and Zn. A core from nearby kettle Spectacle Pond, Littleton, Massachusetts, was similarly characterized (except for plant macrofossil assemblages) to assess the regional air pollution signal in sediment for comparison with the six cores. Accumulation rates for metals (mass per area per year), the anthropogenic component (mass per area per year), and total accumulation of the anthropogenic component (mass per area) indicate that As, Cd, Cr, Cu, Hg, methyl-Hg, Ni, Pb, and Zn have accumulated in sediment as a consequence of point source pollution from within the drainage basins of Grove and Plow Shop Ponds. Three distinct sources of pollution are inferred. As is entering Plow Shop Pond via groundwater in the southwest. Cd, Ni, Pb, and Zn are entering the system predominantly at the eastern end of, or upstream from, Grove Pond. Pb also comes from the northwest corner of Grove Pond, the principal source of Cr, Cu, and Hg. These results are consistent with chemistry of modern surface sediments. The history of pollution extends back more than 100 years. Intra- and inter-core variability of concentrations and accumulation rates indicate that much of the pollution was likely in particulate form with little physical redistribution. Recently, concentrations and accumulation rates have generally decreased substantially for those elements present in excessive concentrations in the past. This is a consequence of accumulation of recent, less polluted sediment. In Spectacle Pond, the nearby reference lake, accumulation rates for As, Cd, Hg, and Pb, adjusted for background values and changes in sedimentation rate, increased above background starting in the late 19th century, peaked about 1980, and declined substantially to 2000. These decreases suggest that the anthropogenic (pollution) component of atmospheric deposition of these elements declined after 1980 by at least 50%(As), 80%(Cd), 80%(Hg), and 80%(Pb).     

Development of an ombrotrophic peat bog (low ash) reference material for the determination of elemental concentrations

Given the increasing interest in using peat bogs as archives of atmospheric metal deposition, the lack of validated sample preparation methods and suitable certified reference materials has hindered not only the quality assurance of the generated analytical data but also the interpretation and comparison of peat core metal profiles from different laboratories in the international community. Reference materials play an important role in the evaluation of the accuracy of analytical results and are essential parts of good laboratory practice. An ombrotrophic peat bog reference material has been developed by 14 laboratories from nine countries in an inter-laboratory comparison between February and October 2002. The material has been characterised for both acid-extractable and total concentrations of a range of elements, including Al, As, Ca, Cd, Cr, Cu, Fe, Hg, Mg, Mn, Na, Ni, P, Pb, Ti, V and Zn. The steps involved in the production of the reference material (i.e. collection and preparation, homogeneity and stability studies, and certification) are described in detail.     

Natural mercury enrichment in a minerogenic fen--evaluation of sources and processes

Mercury (Hg) records in natural archives such as peat bogs are often used to evaluate anthropogenic or climatic influences on atmospheric Hg deposition. In this context, there is an ongoing discussion about natural sources or processes of Hg enrichment in natural archives. In the present study we estimated Hg fluxes from rock weathering, direct atmospheric deposition and from indirect atmospheric deposition in the catchment of a pristine minerogenic fen (GC2) located in the Magellanic Moorlands, southernmost Chile. The Hg record in the bog covers 11 174 cal. (14)C years and shows Hg concentrations of up to 570 [micro sign]g kg(-1) with an average of 268 [micro sign]g kg(-1). Hg was found to be enriched in the peat by a factor of 81 if compared to the mean Hg concentrations in the rocks of the catchment (3.2 [micro sign]g kg(-1)). Hg and also Pb, Fe, and As were found to be enriched predominately in goethite layers indicating high retention of these elements in the bog by iron oxyhydrates. It could also be demonstrated that the high peat decomposition rates in minerogenic bogs can increase the Hg concentrations in the minerogenic peat by a factor of approximately 2 at the same atmospheric Hg deposition rate if compared to ombrotrophic sites. This study has shown that Hg in minerogenic peat can be naturally enriched especially through the retention by autochthonous formed goethite and can be a solely internal process which does not require increased external Hg fluxes.     

High frequency monitoring of the coastal marine environment using the MAREL buoy

The MAREL Iroise data buoy provides physico-chemical measurements acquired in surface marine water in continuous and autonomous mode. The water is pumped 1.5 m from below the surface through a sampling pipe and flows through the measuring cell located in the floating structure. Technological innovations implemented inside the measuring cell atop the buoy allow a continuous cleaning of the sensor, while injection of chloride ions into the circuit prevents biological fouling. Specific sensors for temperature, salinity, oxygen and fluorescence investigated in this paper have been evaluated to guarantee measurement precision over a 3 month period. A bi-directional link under Internet TCP-IP protocols is used for data, alarms and remote-control transmissions with the land-based data centre. Herein, we present a 29 month record for 4 parameters measured using a MAREL buoy moored in a coastal environment (Iroise Sea, Brest, France). The accuracy of the data provided by the buoy is assessed by comparison with measurements of sea water weekly sampled at the same site as part of SOMLIT (Service d'Observation du Milieu LIToral), the French network for monitoring of the coastal environment. Some particular events (impact of intensive fresh water discharges, dynamics of a fast phytoplankton bloom) are also presented, demonstrating the worth of monitoring a highly variable environment with a high frequency continuous reliable system.     

Evaluation of forest nutrition based on large-scale foliar surveys: are nutrition profiles the way of the future?

This paper introduces the use of nutrition profiles as a first step in the development of a concept that is suitable for evaluating forest nutrition on the basis of large-scale foliar surveys. Nutrition profiles of a tree or stand were defined as the nutrient status, which accounts for all element concentrations, contents and interactions between two or more elements. Therefore a nutrition profile overcomes the shortcomings associated with the commonly used concepts for evaluating forest nutrition. Nutrition profiles can be calculated by means of a neural network, i.e. a self-organizing map, and an agglomerative clustering algorithm with pruning. As an example, nutrition profiles were calculated to describe the temporal variation in the mineral composition of Scots pine and Norway spruce needles in Finland between 1987 and 2000. The temporal trends in the frequency distribution of the nutrition profiles of Scots pine indicated that, between 1987 and 2000, the N, S, P, K, Ca, Mg and Al decreased, whereas the needle mass (NM) increased or remained unchanged. As there were no temporal trends in the frequency distribution of the nutrition profiles of Norway spruce, the mineral composition of the needles of Norway spruce needles subsequently did not change. Interpretation of the (lack of) temporal trends was outside the scope of this example. However, nutrition profiles prove to be a new and better concept for the evaluation of the mineral composition of large-scale surveys only when a biological interpretation of the nutrition profiles can be provided.     

Selection and Calibration of Numerical Modeling in Flow and Water Quality

Numerical modeling is frequently used in coastal engineering research and application. One possible issue associated with using this method however, is that initial outcomes might differ from expectation. Modeling manipulation addresses this issue by changing the initial parameters which in turn affects the final output results. The advancement of modeling techniques in recent years has seen a gradual but steady accruement of knowledge regarding the relationship between input parameters and possible outputs, which has resulted in improved accuracy and efficiency methods. The advancements within this field have predominantly occurred on an individual basis and as such lack standardisation. An expert numerical modeler may use this knowledge subconsciously, yet may not know how to convey it to the model users. This paper has been written to introduce a systematic intelligent coding schema designed to organise current coastal engineering modeling manipulation knowledge into a standardised format. This system is relevant to the development of appropriate strategies for improved accuracy and efficiency as well as model modification to simulate specific real phenomena in prototype application cases.     

A pilot project to detect and forecast harmful algal blooms in the northern Gulf of Mexico

More timely access to data and information on the initiation, evolution and effects of harmful algal blooms can reduce adverse impacts on valued natural resources and human health. To achieve this in the northern Gulf of Mexico, a pilot project was initiated to develop a user-driven, end-to-end (measurements to applications) observing system. A key strategy of the project is to coordinate existing state, federal and academic programs at an unprecedented level of collaboration and partnership. Resource managers charged with protection of public health and aquatic resources require immediate notice of algal events and a forecast of when, where and what adverse effects will likely occur. Further, managers require integrated analyses and interpretations, rather than raw data, to make effective decisions. Consequently, a functional observing system must collect and transform diverse measurements into usable forecasts. Data needed to support development of forecasts will include such properties as sea surface temperature, winds, currents and waves; precipitation and freshwater flows with related discharges of sediment and nutrients; salinity, dissolved oxygen, and chlorophyll concentrations (in vivo fluorescence); and remotely-sensed spatial images of sea surface chlorophyll concentrations. These data will be provided via a mixture of discrete and autonomous in situ sensing with near real-time data telemetry, and remote sensing from space (SeaWiFS), aircraft (hyperspectral imagery) or land (high-frequency radar). With calibration across these platforms, the project will ultimately provide a 4-dimensional visualization of harmful algae events in a time frame suitable to resource managers.     

Using improved neural network model to analyze RSP,NOx and NO2 levels in urban air in Mong Kok,Hong Kong

As the health impact of air pollutants existing in ambient addresses much attention in recent years, forecasting of airpollutant parameters becomes an important and popular topic inenvironmental science. Airborne pollution is a serious, and willbe a major problem in Hong Kong within the next few years. InHong Kong, Respirable Suspended Particulate (RSP) and NitrogenOxides NO_x and NO₂ are major air pollutants due to thedominant diesel fuel usage by public transportation and heavyvehicles. Hence, the investigation and prediction of the influence and the tendency of these pollutants are ofsignificance to public and the city image. The multi-layerperceptron (MLP) neural network is regarded as a reliable andcost-effective method to achieve such tasks. The works presentedhere involve developing an improved neural network model, whichcombines the principal component analysis (PCA) technique and theradial basis function (RBF) network, and forecasting thepollutant levels and tendencies based in the recorded data. Inthe study, the PCA is firstly used to reduce and orthogonalizethe original input variables (data), these treated variables arethen used as new input vectors in RBF neural network modelestablished for forecasting the pollutant tendencies. Comparingwith the general neural network models, the proposed modelpossesses simpler network architecture, faster training speed,and more satisfactory predicting performance. This improvedmodel is evaluated by using hourly time series of RSP, NO_x and NO₂ concentrations collected at Mong Kok Roadside Gaseous Monitory Station in Hong Kong during the year 2000. By comparing the predicted RSP, NO_x and NO₂ concentrationswith the actual data of these pollutants recorded at the monitorystation, the effectiveness of the proposed model has been proven.Therefore, in authors' opinion, the model presented in the paper is a potential tool in forecasting air quality parameters and hasadvantages over the traditional neural network methods.     

Trihalomethanes in Drinking Water of Greater Québec Region (Canada): Occurrence, Variations and Modelling

The levels of trihalomethanes (THMs) – the main species of by-product from water chlorination – were monitored in thedistribution systems of the five major drinking water utilitiesof the greater area of Québec City in order to investigate andmodel their occurrence on a spatial and seasonal basis. Data forTHMs and other water quality and operational parametersassociated with their formation were generated through a 16 monthsampling program involving several sites representing variablewater residence times, from the plant to the system extremity.The results demonstrate that the differences in measured THMlevels between the five utilities are mainly due to the variablequality of raw waters, the type of water treatment process beingused and the type and levels of applied disinfectant. Dependingon the utility, average THM levels were from 1.3 to 2.5 timeshigher in the system extremities than in the water leaving thetreatment plant. Also, average levels of THMs measured in summerat the distribution system extremities were, depending on theutility, from 2.5 to 5 times higher than the average levelsmeasured in winter. The seasonal differences were found to besignificantly greater than those observed by others in waterutilities in the United States and Europe and are explained inlarge part by the considerable changes, over the year, in thequality and temperature of surface waters in Southern Québec. Forthe five utilities under study, multivariate regression modelswere developed in order to predict spatial and seasonalvariations of THMs. Both residual chlorine demand and temperaturewere found to be better, statistically, as predictors for THMoccurrence. The usefulness of the developed models for routineand long term water quality management, as well as for assessmentof human exposure to THMs, are also discussed.