The Presence of Calcium Oxalate Dihydrate (Weddellite) in Street Sediments from Niterói, Brazil and Its Health Implications

Established research in first world urban environments has shown street sediments to be effective sinks for heavy metals and emphasises the health risks to children by its inhalation or ingestion. In third world countries with fewer pollution controls, contamination may be augmented by additional pollutants such as sewage discharge into urban streets and/or periodic inundation with sewage-laden run-off. This pollutant not only contains heavy metals and organic matter, but calcium oxalates that may derive directly from the sewage itself. To study this premise street sediments were collected from sites of varying industrialisation and sewage contamination within the city of Niteroi, Brazil. Calcium oxalate dihydrate (weddellite) was identified by X-ray diffraction, fourier transform infra red and scanning electron microscopy techniques and oxalate concentrations in <63m and colloidal (clay and organic matter) fractions, were determined by ion chromatography. Oxalate in colloidal fractions averaged 43601mgkg^–1 in sewage contaminated industrialised urban zones, 4519mgkg^–1 in suburban areas and 17477mgkg^–1 in suburbs with favelas (shantytowns-of Niterói). Oxalate concentrations coincide with high levels of metal ions (Fe, Mn, Zn, Pb, Ni, Cr) that stabilise calcium oxalate dihydrate and prevent its dehydration to the monohydrate (whewellite). Lower levels of oxalate were found in lichen-covered roof sediment, plaster and mortar samples. Oxalate concentration coincides with sewage contamination and street sediments appear to act as a sink for calcium oxalate dihydrate derived from sewage. Previous studies have shown that low levels of exposure can damage kidneys and the nervous system, while prolonged exposure can cause severe corneal, retinal and skin damage, cyanosis and possibly gangrene. Contact with blood serum may result in hypocalcemia, muscular stimulation, convulsions and finally collapse. The conditions described are common throughout urban areas of the developing world and may suggest a particular environmental hazard in these regions.     

Considerations on the new epidemic outbreak of human leptospirosis in greater recife, brasil, in 1975

Abstract— A brief report was presented on a new outbreak of leptospirosis among the population of Greater Recife in 1975 in the wake of the floods that struck the city and its survivors in July of that year. A total of 107 cases were recorded, of which 105 were identified by sero-agglutination and 2 by hemoculture. Once again the serotype icterohaemorrhagiae was the predominant etiological agent, having been found in 55 cases, followed by ballum in 18, grippotyphosa in 9, and pyrogenes in 8 cases.     

Genetic evidence fails to discriminate between <Emphasis Type="Italic">Macroramphosus gracilis</Emphasis> Lowe 1839 and <Emphasis Type="Italic">Macroramphosus</Emphasis><Emphasis Type="Italic">scolopax</Emphasis> Linnaeus 1758 in Portuguese waters

Fish belonging to the genus Macroramphosus are distributed throughout the Atlantic, Indian and Pacific oceans. Some authors consider this genus monotypic, Macroramphosus scolopax being the only valid species. Other authors consider (based on several morphological and ecological characters) that another species (Macroramphosus gracilis) exists and occurs frequently in sympatry with the first one. Intermediate forms are also reported in literature. In this paper, using the mitochondrial control region and the nuclear first S7 intron markers, we failed to find genetic differences between individuals considered to belong to both species as well as the intermediate forms. Our results suggest that in the northeastern Atlantic, Macroramphosus is represented by a single species, M. scolopax, with different morphotypes interbreeding in the sampling areas.     

ReefBahia, an integrated GIS approach for coral reef conservation in Bahia, Brazil

Coral reefs around the world are facing serious threats. These fragile ecosystems are in need for conservation. The coastal state of Bahia hosts the most extensive and richest area of coral reefs in the South Atlantic Ocean. Assessment, planning and management of coral reef ecosystems are particularly challenging tasks. This work shows how the creation of a GIS improves the process of management, monitoring and conservation of the Bahian reef environments The initial data input started by the vectorization of 1) bathymetric data from the Bureau of Hydrography and Navigation (DHN), 2) shoreline and mangrove areas from Landsat 7 ETM + images, 3) near surface reefs from Quickbird images, and 4) coastal and marine protected areas of federal, state and local administrations. Geological, physical, biological and social information was then included in order to create a suitable marine GIS for conservation aims. The data includes information on sediment granulometry and transport patterns, rocky substrate outcrops, sea surface temperature, wave direction, rain precipitation, major contributing river discharge, artisanal fishery, benthic cover and bleaching data. ReefBahia GIS has provided essential information for a better understanding of coral reefs of the state of Bahia geological and ecological characteristics such as mapping, representation, connectivity and biodiversity of coral reefs, geological facies, Quaternary sedimentation, numeric modeling of wave refraction and monitoring of bleaching events.     

Evolution of biodegradation of deinking by-products used as alternative cover material

Deinking by-products (DBP) have been used as alternative cover material for landfills and mine tailings. Since DBP is biodegradable because of its high cellulose and hemicellulose content, a laboratory experimental program was performed to monitor the evolution of biodegradation and changes in the physico-chemical and geotechnical properties of DBP samples submitted to accelerated biodegradation for 1460 days at 38 degrees C. The evolution of gas and leachate production was monitored in terms of both quality and quantity, which allowed for the calculation of mass loss with time. Under the conditions of the tests (no load applied), 19.6% of the mass was lost as gas, whereas 6.1% was leached out. The results show that biodegradation did not significantly alter the compaction behavior of DBP. The void ratio and water content increased significantly, while the volume of the samples slightly decreased. This seem to indicate that the porous structure of the samples was no longer the same after 1460 d of accelerated biodegradation. A slight increase in the relative density indicates that the organic/inorganic matter ratio increased. The results of permeability tests performed with samples at various stages of biodegradation and at various confining stresses show that the saturated hydraulic conductivity of recompacted biodegraded DBP decreased from 7 x 10(-7)cm/s to approximately 2 x 10(-7)cm/s, as biodegradation advanced.     

The costs and benefits of packaging waste management systems in Europe: the perspective of local authorities

Local authorities are generally in charge of household packaging waste management operations, particularly in countries with Green Dot schemes or similar extended producer responsibility systems. This leads to the need of establishing a system of financial transfers between the packaging industry and the local authorities (regarding the costs involved in selective collection and sorting). In the present study, the costs and benefits of recycling, from the perspective of local authorities, are compared for Portugal, Belgium and Italy (in Lombardia region), adopting the same economic–financial methodology. The results show that the industry is not paying the net cost of packaging waste management. If the savings attained by diverting packaging waste from other treatment operations are not considered, it seems that the industry should increase the financial support to local authorities. However, if the avoided costs with other treatments are considered as a benefit for local authorities, the costs are generally outweighed by the benefits, and the financial support could, therefore, be reduced.     

Effects of realistic concentrations of TiO<Subscript>2</Subscript> and ZnO nanoparticles in <Emphasis Type="Italic">Prochilodus lineatus</Emphasis> juvenile fish

The impact of nanoparticles on fish health is still a matter of debate, since nanotechnology is quite recent. In this study, freshwater benthonic juvenile fish Prochilodus lineatus were exposed through water to three concentrations of TiO₂ (0.1, 1, and 10 μg l^?1) and ZnO (7, 70, and 700 μg l^?1) nanoparticles, as well as to a mixture of both (TiO₂ 1 μg l^?1?+?ZnO 70 μg l^?1) for 5 and 30 days. Nanoparticle characterization revealed an increase of aggregate size in the function of concentration, but suspensions were generally stable. Fish mortality was high at subchronic exposure to 70 and 700 μg l^?1 of ZnO. Nanoparticle exposure led to decreased acetylcholinesterase activity either in the muscle or in the brain, depending on particle composition (muscle—TiO₂ 10 μg l^?1; brain—ZnO 7 and 700 μg l^?1), and protein oxidative damage increased in the brain (ZnO 70 μg l^?1) and gills (ZnO 70 μg l^?1 and mixture) but not in the liver. Exposed fish had more frequent alterations in the liver (necrosis, vascular congestion, leukocyte infiltration, and basophilic foci) and gills (hyperplasia and epithelial damages, e.g., epithelial disorganization and epithelial loss) than the control fish. Thus, predicted concentrations of TiO₂ and ZnO nanoparticles caused detectable effects on P. lineatus that may have important consequences to fish health. But, these effects are much more subtle than those usually reported in the scientific literature for high concentrations or doses of metal nanoparticles.     

Evaluation of a low-cost adsorbent for removal of toxic metal ions from wastewater of an electroplating factory

In this study, sugar cane residue or bagasse was used for removal of toxic metal ions from wastewater of an electroplating factory located in northeast Brazil. Prior acid treatment increased the adsorption efficacies in batch wise experiments. The microstructure of the material before and after the treatment was investigated by X-ray diffraction, infrared spectroscopy and scanning electron microscopy. Column operations showed that removals of Cu²⁺, Ni²⁺ and Zn²⁺ from wastewater (in the absence of cyanide) were 95.5%, 96.3.0%, and 97.1%, respectively. Regeneration of the adsorbent obtained in acid indicated that the efficiencies decreased only after the fourth cycle of re-use. Acid-treated sugar cane bagasse can be considered a viable alternative to common methods to remove toxic metal ions from aqueous effluents of electroplating industries.     

The influence of temperature on the deactivation of commercial Pd/Rh automotive catalysts

Automotive catalyst deactivation can be promoted by thermal and poisoning mechanisms. Catalyst efficiency is reduced by thermal degradation resulting in the agglomeration of precious metals and the reduction of the washcoat surface area. In this paper, the temperature influence on the commercial Pd/Rh-based automotive catalyst performance was studied. Textural and physicochemical characterisation techniques were employed, such as X-ray fluorescence (XRF), atomic absorption spectrometry (AAS), N₂ physisorption, X-ray diffraction (XRD), temperature programmed reduction (TPR) and scanning electron microscopy coupled with energy-dispersive X-ray analysis (SEM–EDX). The catalysts were evaluated for CO and propane oxidation with a stoichiometric gas mixture similar to engine exhaust gas. The results indicated the transformation of alumina into high temperature phases and the formation of new mixed oxide phases. Evidence of sintered particles and several spots of palladium agglomerates was seen by SEM–EDX analysis. The activity results showed the effects of thermal deactivation on the conversion of the pollutants. In spite of exposure to extreme temperature conditions (72 h at 1200 °C), significant activity was still observed for carbon monoxide and propane oxidation reactions.