Leaf accumulation of trace elements and polycyclic aromatic hydrocarbons (PAHs) in Quercus ilex L

Quercus ilex L. leaves were collected four times in one year at six urban sites and one remote area in order to determine trace element and PAH accumulation through concomitant analyses of unwashed and water-washed leaves. Both unwashed and washed leaves showed the highest amounts of trace elements and PAHs in the urban area. Unwashed leaves showed greater differences between urban and remote areas and among the urban sites than washed leaves for trace element and PAH concentrations. Water-washing resulted in a significant (P<0.001) decrease in leaf concentrations of Cr, Cu, Fe, Pb, V and Zn. By contrast, Cd and total PAH concentrations showed no differences between unwashed and washed leaves.     

Effect of vegetation type on throughfall deposition and seepage flux

This paper compares different vegetation types (coniferous and deciduous forest, grassed and pure heathland) in terms of input (throughfall deposition) and output (seepage flux) in a region with intermediate nitrogen load (+/-20kg Nha(-1)y(-1) via bulk precipitation) in comparable conditions in north Belgium. Coniferous forest (two plots Pinus sylvestris and two plots Pinus nigra) received significantly higher nitrogen and sulphur throughfall deposition than deciduous forest and heathland. Grassed and pure heathland had significantly highest throughfall quantities of Ca(2+) and Mg(2+), respectively. The observed differences in throughfall deposition between the different vegetation types were not univocally reflected in the ion seepage flux. Considerable seepage fluxes of NO(3)(-), SO(4)(2-), Ca(2+) and Al(III) were only found under the P. nigra plots. We discuss our hypothesis that the P. nigra forests already evolved to a situation of N saturation, while the other vegetation types did not.     

Single-source impact analysis using three-dimensional air quality models

Isolating the effects of an individual emissions source on secondary air pollutants such as ozone and some components of particulate matter must incorporate complex nonlinear processes, be sensitive to small emissions perturbations, and account for impacts that may occur hundreds of kilometers away. The ability to evaluate these impacts is becoming increasingly important for efficient air quality management. Here, as part of a recent compliance enforcement action for a violation of the Clean Air Act and as an evaluation of ozone response to single-source emissions plumes, two three-dimensional regional photochemical air quality models are used to assess the impact on ozone from approximately 2000 to 3000 excess t/month of nitrogen oxides emitted from a single power plant in Ohio. Periods in May, July, and August are evaluated. Two sensitivity methods are applied: the "brute-force" (B-F) method and the decoupled direct method (DDM). Using DDM, maximum 1-hr averaged ozone concentrations are found to increase by up to 1.8, 1.3, and 2.2 ppbv during May, July, and August episodes, respectively, and concentration increases greater than 0.5 ppbv occur in Ohio, Pennsylvania, Maryland, New York, West Virginia, Virginia, and North and South Carolina. B-F results for the August episode show a maximum 1-hr averaged ozone concentration increase of 2.3 ppbv. Significant localized decreases are also simulated, with a maximum of 3.6 ppbv in Ohio during the August episode and decreases of 0.50 ppbv and greater in Ohio, Pennsylvania, Maryland, West Virginia, and Virginia. Maximum increases are compared with maximum decreases for the August period using second-order DDM and are found, in aggregate, to be greater in magnitude by 42%. When evaluated during hours when ozone concentrations exceed 0.060 ppm, the maximum increases in ozone are higher than decreases by 82%. The spatial extent of ozone increase in both cases is about triple that of reduction.     

Long-term survey of heavy-metal pollution, biofilm contamination and diatom community structure in the Riou Mort watershed, South-West France

In a metal-polluted stream in the Riou Mort watershed in SW France, periphytic biofilm was analyzed for diatom cell densities and taxonomic composition, dry weight and metal bio-accumulation (cadmium and zinc). Periphytic diatom communities were affected by the metal but displayed induced tolerance, seen through structural impact (dominance of small, adnate species) as well as morphological abnormalities particularly in the genera Ulnaria and Fragilaria. Species assemblages were characterized by taxa known to occur in metal-polluted environments, and shifts in the community structure expressed seasonal patterns: high numbers of Eolimna minima, Nitzschia palea and Pinnularia parvulissima were recorded in Summer and Autumn, whereas the species Surirella brebissonii, Achnanthidium minutissimum, Navicula lanceolata and Surirella angusta were dominant in Winter and Spring. Commonly used indices such as the Shannon diversity index and Specific Pollution Sensitivity Index reflected the level of pollution and suggest seasonal periodicity, the lowest diversities being observed in Summer.     

Effects of repeated exposure to malathion on growth, food consumption, and locomotor performance of the western fence lizard (Sceloporus occidentalis)

Effects of repeated pollutant exposure on growth, locomotor performance, and behavior have rarely been evaluated in reptiles. We administered three doses of malathion (2.0, 20, or 100mg/kg body weight) to western fence lizards (Sceloporus occidentalis) over an 81day period. Eight and 23% mortality occurred at 20 and 100mg/kg (p=0.079) and 85% of lizards in the 100mg/kg group exhibited clinical symptoms of poisoning. Growth, food consumption, body condition index, and terrestrial locomotor performance were not significantly influenced by malathion. However, arboreal sprint velocity was significantly reduced in lizards receiving 100mg/kg. Fifty percent of lizards in the 100mg/kg group also refused to sprint in the arboreal setting (p=0.085). Based on these results, arboreal locomotor performance was the most sensitive metric of exposure we evaluated. Further study of compounds such as malathion is warranted due to highly variable application rates and exposure scenarios.     

Long term changes in atmospheric N and S throughfall deposition and effects on soil solution chemistry in a Scots pine forest in the Netherlands

In a Scots pine forest the throughfall deposition and the chemical composition of the soil solution was monitored since 1984. (Inter)national legislation measures led to a reduction of the deposition of nitrogen and sulphur. The deposition of sulphur has decreased by approximately 65%. The total mineral-nitrogen deposition has decreased by ca. 25%, which is mainly due to a reduction in ammonium-N deposition (−40%), since nitrate-N deposition has increased (+50%). The nitrogen concentration in the upper mineral soil solution at 10 cm depth has decreased, leading to an improved nutritional balance, which may result in improved tree vitality. In the drainage water at 90 cm depth the fluxes of NO₃⁻ and SO₄²⁻ have decreased, resulting in a reduced leeching of accompanying base cations, thus preserving nutrients in the ecosystem. It may take still several years, however, before this will meet the prerequisite of a sustainable ecosystem.     

Wind direction bias in generating wind roses and conducting sector-based air dispersion modeling

Certain widely used wind rose programs and air dispersion models use an overly simple data-transfer algorithm that induces a directional bias in their output products. The purpose of this paper is to provide a revised algorithm that corrects the directional bias that occurs from the aliasing that occurs when the sector widths used to report wind direction data are on the same order of magnitude, but not equal, to the sector widths used in the wind direction summaries. The directional bias issue arises when output products in 16 direction sectors (22.5 degrees each) are produced from wind direction data reported in terms of 36 sectors (10 degrees each). The result directional bias affects the results of simulations of air and surface concentrations using widely applied air dispersion models. Datasets or models with the directional bias discussed here give consistent positive biases (approximately 30%) for cardinal direction sectors (north, south, east, and west) and consistent negative biases for all of the other sectors (around -10%). Data summary and air dispersion programs providing outputs in direction sectors that do not match the observational sectors need to be checked for this bias. A revised data-transfer algorithm is provided that corrects the directional bias that can occur in transferring wind direction data between different sector widths.     

Sonochemical substrate selectivity and reaction pathway of systematically substituted azo compounds

The sonochemical degradation of the systematically substituted azo compound 2,7-dihydroxy-1-phenylazonaphthaline-3,6-disulfonic acid was investigated using a frequency of 850 kHz and an acoustic input power of 61 W. All derivatives were degraded completely within 6h by the ultrasonic treatment. Trifluoromethyl substituted azo compounds exhibited 2-3-fold higher degradation rates in comparison to the reference hydrogen substituted azo compound (k=0.54 h(-1)). In contrast to enzymatic processes (azoreductase or laccase), the ultrasonic treatment for these ortho-, meta-, and para-substituted azo compound showed 1.5-50-fold higher degradation rates. Additionally the ultrasound treatment was characterized by shorter reaction times. As a result of the detection and identification of specific intermediates using LC-MS a reaction pathway of the sonochemical degradation of the analysed azo compound is proposed indicating the formation of cyclohexadienone and naphthalene quinone derivatives.     

Spatial and temporal variations and possible sources of dichlorodiphenyltrichloroethane (DDT) and its metabolites in rivers in Tianjin, China

Water, suspended solid (SS) and sediment samples were collected from nine water courses in Tianjin, China and analyzed for dichlorodiphenyltrichloroethane (DDT) and its metabolites (DDXs, including o,p'-,p,p'-DDT, DDD and DDE). The average DDX concentrations in water, SS and sediment were 59+/-30 ng l(-1), 2690+/-1940 ng g(-1)dry wt. and 340+/-930 ng g(-1)dry wt., respectively. Due to the termination of the extensive agricultural application and industrial manufacture, DDXs in river sediment decreased by one order of magnitude since 1970's and low DDT fractions in these sediments were observed. Still, DDXs in the sediments near the outlets of the major manufacturers remained relatively high attributed to the historic input. DDXs in sediment were also positively correlated with organic matter content. Spatial distributions of DDXs in SS and water was different from that in sediment. For SS, a negative correlation between DDX concentration and SS content indicated a dilution effect in many rivers. Dissolved organic carbon content was the major factor affecting DDX concentrations in water phase. Wastewater discharged from dicofol manufacturers and likely illegal agricultural application were the primary reasons causing high DDT (DDE+DDD) ratios in SS and water.     

Fugitive emissions opacity determination using the digital opacity compliance system (DOCS)

Maintenance of Department of Defense (DoD) weapon systems, conducting battlefield training exercises as well as meeting military construction and/or demolition schedules, invariably generate fugitive air emissions, many of which are visible. Although there is no codified federal method for quantifying fugitive emissions opacity, many state and local air regulatory agencies have instituted enforceable fugitive emission opacity standards at DoD facilities. The current study focused on comparing the performance of the digital opacity compliance system (DOCS) with U.S. Environment Protection Agency Method 9 (Method 9) certified human observers in quantifying the visible opacity associated with fugitive emissions produced using a commercial fog generator. By systematically repositioning both DOCS cameras and Method 9-certified observers during field testing, differences in method performance as a function of observational locations were documented. At both the 30- and 300-ft off-set distances, opacity levels reported by the DOCS technology and Method 9-certified smoke readers were found to be statistically different at the 99% confidence level. Alternatively, at the 90- and 150-ft off-set distances, results suggested that there was an insignificant difference at the 99% confidence level between the two methods. Comparing the magnitude of the each method's standard deviation suggested that, at the 30-ft off-set distance, the DOCS technology was consistently more precise than Method 9-certified readers regardless of the observer's downwind distance. However, at the 90, 150, and 300-ft off-set distances, method precision seemed to vary as a function of both off-set and downwind distance. The primary factor affecting the consistency in opacity measurements appeared to be the impact of ground-level air turbulence on fog plume dispersion and transport. Field observations demonstrated that localized wind shear played a critical and decisive role in how and to what extent fugitive emissions opacity could be determined, regardless of the method selected.