Assessment of drinking water quality using ICP-MS and microbiological methods in the Bholakpur area,Hyderabad, India

A total of 16 people died and over 500 people were hospitalized due to diarrhoeal illness in the Bholakpur area of Hyderabad, India on 6th May 2009. A study was conducted with immediate effect to evaluate the quality of municipal tap water of the Bholakpur locality. The study consists of the determination of physico-chemical properties, trace metals, heavy metals, rare earth elements and microbiological quality of drinking water. The data showed the variation of the investigated parameters in samples as follows: pH 7.14 to 8.72, EC 455 to 769 μS/cm, TDS 303.51 to 515.23 ppm and DO 1.01 to 6.83 mg/L which are within WHO guidelines for drinking water quality. The water samples were analyzed for 27 elements (Li, Be, B, Na, Mg, Al, Si, K, Ca, V, Cr, Mn, Fe, Ni, Co, Cu, Zn, As, Se, Rb, Sr, Mo, Ag, Cd, Sb, Ba and Pb) using inductively coupled plasma-mass spectrometry (ICP-MS). The concentrations of Fe (0.12 to 1.13 mg/L), Pb (0.01 to 0.07 mg/L), Cu (0.01 to 0.19 mg/L), Ni (0.01 to 0.15 mg/L), Al (0.16 to 0.49 mg/L), and Na (38.36 to 68.69 mg/L) were obtained, which exceed the permissible limits of the World Health Organization (WHO) for drinking water quality guidelines. The remaining elements were within the permissible limits. The microbiological quality of water was tested using standard plate count, membrane filtration technique, thermotolerant coliform (TTC), and most probable number (MPN) methods. The total heterotrophic bacteria ranged from 1.0 × 10⁵ to 18 × 10⁷ cfu/ml. Total viable bacteria in all the water samples were found to be too numerable to count and total number of coliform bacteria in all water samples were found to be of order of 1,100 to >2,400 MPN index/100 ml. TTC tested positive for coliform bacteria at 44.2°C. All the water samples of the study area exceeded the permissible counts of WHO and that (zero and minimal counts) of the control site (National Geophysical Research Institute) water samples. Excessively high colony numbers indicate that the water is highly contaminated with microorganisms and is hazardous for drinking purposes. Bacteriological pollution of drinking water supplies caused diarrhoeal illness in Bholakpur, which is due to the infiltration of contaminated water (sewage) through cross connection, leakage points, and back siphoning.     

Interlaboratory evaluation of trace element determination in workplace air filter samples by inductively coupled plasma mass spectrometry

Inductively coupled plasma mass spectrometry (ICP-MS) is becoming more widely used for trace elemental analysis in the occupational hygiene field, and consequently new ICP-MS international standard procedures have been promulgated by ASTM International and ISO. However, there is a dearth of interlaboratory performance data for this analytical methodology. In an effort to fill this data void, an interlaboratory evaluation of ICP-MS for determining trace elements in workplace air samples was conducted, towards fulfillment of method validation requirements for international voluntary consensus standard test methods. The study was performed in accordance with applicable statistical procedures for investigating interlaboratory precision. The evaluation was carried out using certified 37-mm diameter mixed-cellulose ester (MCE) filters that were fortified with 21 elements of concern in occupational hygiene. Elements were spiked at levels ranging from 0.025 to 10 μg filter(-1), with three different filter loadings denoted "Low", "Medium" and "High". Participating laboratories were recruited from a pool of over fifty invitees; ultimately twenty laboratories from Europe, North America and Asia submitted results. Triplicates of each certified filter with elemental contents at three different levels, plus media blanks spiked with reagent, were conveyed to each volunteer laboratory. Each participant was also provided a copy of the test method which each participant was asked to follow; spiking levels were unknown to the participants. The laboratories were requested to prepare the filters by one of three sample preparation procedures, i.e., hotplate digestion, microwave digestion or hot block extraction, which were described in the test method. Participants were then asked to analyze aliquots of the prepared samples by ICP-MS, and to report their data in units of μg filter(-1). Most interlaboratory precision estimates were acceptable for medium- and high-level spikes (RSD <25%), but generally yielded greater uncertainties than were anticipated at the outset of the study.     

Terrain Discontinuity Effects in the Regional Flow of a Complex Karstified Aquifer

Karst aquifers are characterized by spatial heterogeneity due to the presence of highly permeable channels and conduits in low-permeable fractured rocks (matrix block). Recent studies have reported a close relationship between surface and subsurface water in karstic regions due to the water flow through a complicated network of paths formed by fracture intersections. Subsurface flow in karstified aquifers ranges between conduit flow, in large passages with relatively high flow velocities, and diffuse flow, in the matrix block where Darcy’s law is still valid. In this paper, we present the simulation of a complex karstified aquifer system in Crete, Greece, where the presence of main faults drastically affects the regional flow. A discrete fracture approach in conjunction with an equivalent porous medium approach was adopted to simulate the mixed flow in the area of interest. The simulation results have shown that the length and the orientation of the dominant faults, primarily during the rainy season, affect the flow field.     

Seagrass resource assessment using remote sensing methods in St. Joseph Sound and Clearwater Harbor,Florida, USA

In the event of a natural or anthropogenic disturbance, environmental resource managers require a reliable tool to quickly assess the spatial extent of potential damage to the seagrass resource. The temporal availability of the Landsat 5 Thematic Mapper (TM) imagery provided a suitable option to detect and assess damage of the submerged aquatic vegetation (SAV). This study examined Landsat TM imagery classification techniques to create two-class (SAV presence/absence) and three-class (SAV estimated coverage) SAV maps of the seagrass resource. The Mahalanobis Distance method achieved the highest overall accuracy (86%) and validation accuracy (68%) for delineating the seagrass resource (two-class SAV map). The Maximum Likelihood method achieved the highest overall accuracy (74%) and validation accuracy (70%) for delineating the seagrass resource three-class SAV map. The Landsat 5 TM imagery classification provided a seagrass resource map product with similar accuracy to the aerial photointerpretation maps (validation accuracy 71%). The results support the application of remote sensing methods to analyze the spatial extent of the seagrass resource.     

Assessment of metal pollution in urban road dusts from selected highways of the Greater Toronto Area in Canada

Over the last several decades, there has been increased attention on the heavy metal contamination associated with highways because of the associated health hazards and risks. Here, the results are reported of an analysis of the content of metals in roadside dust samples of selected major highways in the Greater Toronto Area of Ontario, Canada. The metals analysed are lead (Pb), zinc (Zn), cadmium (Cd), nickel (Ni), chromium (Cr), copper (Cu), manganese (Mn), calcium (Ca), potassium (K), magnesium (Mg) and iron (Fe). In the samples collected, the recorded mean concentrations (in parts per million) are as follows: Cd (0.51), Cu (162), Fe (40,052), Cr (197.9), K (9647.6), Mg (577.4), Ca (102,349), Zn (200.3), Mn (1202.2), Pb (182.8) and Ni (58.8). The mean concentrations for the analysed samples in the study area are almost all higher than the average natural background values for the corresponding metals. The geo-accumulation index of these metals in the roadside dust under study indicates that they are not contaminated with Cr, Mn and Ca; moderately contaminate with Cd and K; strongly contaminated with Fe and Mg; strongly to extremely contaminated with Ni and Pb; and extremely contaminated with Cu and Zn. The pollution load index (PLI) is used to relate pollution to highway conditions, and the results show that PLI values are slightly low at different samples collected from Highways 401 and 404 and high in many samples collected from Highway 400 and the Don Valley Parkway. Highway 400 exhibits the highest PLI values.     

Environmental assessment of trace element bioaccumulation in sipunculan from seagrass and wetland sediments

This study is the first measurement of trace elements in sipunculan and their surrounding sediments. The bioaccumulation characteristics of arsenic (As), cadmium (Cd), chromium (Cr), copper (Cu), mercury (Hg), and zinc (Zn) were analyzed and compared in two sipunculan species, Sipuncula nudus and Siphonosoma vastum, which were collected from seagrass beds and wetlands in Taiwan. The sipunculan and sediment samples were analyzed using an inductively coupled plasma mass spectrometer. Both sipunculan in the wetlands and seagrass beds had a high Cu bioaccumulation mechanism. Multivariate analysis, principle component analysis, and partial least squares for discriminant analysis of trace element levels and bioaccumulation factors were used to distinguish the element distributions that corresponded to the two habitats (seagrass beds and wetlands). Different levels of certain trace elements in these two sipunculan species may result not only from the environmental factors of various habitats but also from the accumulation characteristics of various species. The As, Cd, Cr, Cu, Hg, and Zn concentrations were markedly lower in sipunculan than in other invertebrates from the adjacent polluted regions. The public health issues regarding the consumption of sipunculan are also discussed.     

Assessment of heavy metals and their interrelationships with some physicochemical parameters in eco-efficient rivers of Himalayan region

Most precious and world famed Himalayan rivers like Ganga, Yamuna, and their tributaries are originated from Uttarakhand state of India. Over the years, increased industrial activities and urban growth along the rivers and lakes have resulted in increased load over the water bodies. In the present study, a comparison of characteristics of water quality with respect to heavy metals (Fe, Zn, Cu, and Pb) and their interrelationships with some physiological parameters during different seasons of year 2010 has been made in the water bodies flowing through the two geographical regions, namely Garhwal and Kumaon regions of the Himalayan State of India. All observed values of Pb, 02 observation of the Cu, and 59 observations of Fe are found exceed with the WHO standard for drinking water; 83 observations of Pb, 110 observations of Cu, and 59 observations of Fe are found exceed with the Bureau of Indian Standards. However, none of the observation of Zn is found exceeding with the standard limit. Cu shows the highest concentration 7.30 mg/l among all observations and also its higher concentration in Kumaon rivers. All the metals show negative correlation with dissolved oxygen and pH. Fe in river Yamuna system and Zn in Kumaon rivers show significant temporal variations at 90 % level of significance (LOS). However, no significant temporal difference of remaining metals is observed even at 95 % LOS. All metals except Fe in river Yamuna system show very significant variation in spatial distribution in different river systems at 95 % LOS.     

Biosorption of Pb(II) and Cr(III) from aqueous solutions: breakthrough curves and modeling studies

The sorption capacity parameters obtained for batch studies provide useful information about biosorption system. However, such data fail to explain the process under continuous-flow conditions. The present study is an attempt to explore the biosorption of Pb(II) and Cr(III) by straw from local wheat (Triticum aestivum). The biosorbent has been characterized by using Fourier transform infrared spectroscopy and surface area and elemental analyses and found to be porous and polyfunctional. S-shaped breakthrough curves were obtained at different column heights for the both metal ions. Various breakthrough parameters and saturation times have been determined. The column data have been successfully used to study the Bohart–Adams' bed depth service time (BDST) model and Yoon and Nelson's model. It was found that BDST model quite efficiently explained the whole column data whereas Yoon and Nelson model could explain it below 90 % breakthrough concentration. The predicted and calculated BDST parameters were in agreement with each other. Yoon and Nelson's constant decreased with an increase in the column height for both metal ions. Effect of change in flow rate on the Pb(II) biosorption has also been discussed with respect to BDST approach.     

Multivariate analysis of potentially toxic metals in sediments of a tropical coastal lagoon

Surface sediments collected from the Lagos Lagoon, Nigeria, and three adjoining rivers were analysed for their physicochemical properties and pseudo-total concentration of the potentially toxic metals (PTM) Cd, Cr, Cu, Pb and Zn. The concentration of the PTM varied seasonally and spatially. Odo-Iyaalaro was observed to be the most polluted river, with highest concentrations of 42.1 mg kg^?1, 102 mg kg^?1, 185 mg kg^?1, 154 mg kg^?1 and 1040 mg kg^?1 of Cd, Cr, Cu, Pb and Zn, respectively, while Ibeshe River was the least contaminated, apart from a site affected by Cu from the textile industry. Some of the sediments were found to be above the consensus-based probable effect concentrations and Dutch sediment guideline for metals. Overall metal concentrations were similar to those reported for other tropical lagoon and estuarine systems affected by anthropogenic inputs as a result of rapid urbanisation. Due to the large number of samples, principal component analysis was used to examine relationships within the data set. Generally, sediments collected during the dry season were observed to have higher concentration of PTM than those collected during the rainy season. This means that PTM could accumulate over a prolonged period and then be released relatively rapidly, on an annual basis, into tropical lagoon systems.     

Some considerations on the use of simple box models of contaminant fate in soils

A simple box model computing time-averaged concentrations in soil and water of contaminants such as pesticides, following a pulse emission under the assumption of constant removal rates, is presented and evaluated against a benchmark model and some lysimeter experiments representative of different soil and climate settings in Europe. The simple box model allows capturing to some extent the trends of contaminant releases observed from lysimeters or predicted by the benchmark model. This suggests that the correct order of magnitude of environmental concentrations and loads of contaminants can be described as a first approximation by a very simple back-of-the-envelope calculation. In the calculation, the time lag between contaminant application and the start of runoff or leaching should be considered. In the absence of more detailed information, repeating the calculation for the extreme cases of zero and one month lag yields a reasonably realistic range, and the geometric mean of the two is suggested as a first guess estimate. This configures a practical approach for the screening of contaminant losses especially suited for the mapping of predicted environmental concentrations (PECs) for assessment at broad scale (such as continental Europe, a country or a large catchment), where contingent determinants of contaminant fate tend to be averaged out and use of more detailed models usually promises to yield little improvement of PECs.