Ions species size distribution in particulate matter associated with VOCs and meteorological conditions over an urban region

Airborne particulate matter (PM10, PM2.5, PM1) and volatile organic compounds (benzene, toluene, m,p-xylene, o-xylene) samples were collected during winter and summer seasons of 2005 at two sites, representing an urban and a suburban region of the Greater Athens Area. Urban site traffic emissions were the major contributor to the concentration of PM2.5, PM10, toluene, and xylenes, while benzene and PM1 concentrations were presented in significant spatial variations. K+, Na+, Mg2+, Ca2+, NO3-, Cl- and SO42- ions were analyzed for the chemical characterization of the collected PM samples. The results showed that Na+ cations and SO42- anions were the dominant species, during winter and summer, respectively, in both sites. The analysis of the synoptic scale and mesoscale atmospheric circulation during the experimental periods demonstrated that the meteorological conditions play a key role, not only in the variation but also in the distribution of the ionic concentrations at the three fractions of particulates and the dominant character (alkaline/acidic/neutral) of the particulates at the two sampling sites.     

Population biology and life strategies of Chlorophthalmus agassizii Bonaparte, 1840 (Pisces: Osteichthyes) in the Mediterranean Sea

The population biology and life strategies of Chlorophthalmus agassizii were studied in the Ionian Sea (eastern–central Mediterranean) using the data collected during the experimental trawl surveys carried out from 1995 to 2000. Depth-related trends of both density and size were found. With depth the former decreased while the latter increased. A typical bigger–deeper phenomenon was detected: young-of-the-year individuals occur on the shelf during autumn–winter months and move towards bathyal bottoms as they grow. The sampled population was made up of several size–age groups. The maximum age of 8 years was identified by means of otolith readings. The Von Bertalanffy growth parameters were estimated from the age–length key (L _∞=189.04±5.401 mm; k=0.24±0.021; t _o=−1.20±0.132; φ′=3.94) and modal progression analysis (L _∞=218.33±18.397 mm; k=0.164±0.028; t _o=−1.694±0.171; φ′=3.89). Reproduction of this monoecious fish was observed during summer–early autumn. Considering the female portion of the gonad, the size at attainment of 50% maturity was 115 mm TL. The corresponding age is within the third year of life. The simultaneous occurrence of oocytes in different development stages was shown in the ovary. Both the asynchronous ovary and oocyte size distribution indicate that C. agassizii spawns more than once during a reproductive season (batch spawner). Functional fecundity (on average 3,018 hydrated oocytes) was between 37 and 69% of the absolute fecundity and increased significantly with the individual size. Since adult specimens are mostly distributed on the slope, eggs and larvae develop in epipelagic waters and migrate in-shore where juvenile forms recruit on the shelf. Juveniles migrate ontogenetically towards deeper bottoms and after 2–3 years start to reproduce annually within a life span greater than 10 years.     

Economic damages of ozone air pollution to crops using combined air quality and GIS modelling

This study aims at presenting a combined air quality and GIS modelling methodological approach in order to estimate crop damages from photochemical air pollution, depict their spatial resolution and assess the order of magnitude regarding the corresponding economic damages. The analysis is conducted within the Greater Thessaloniki Area, Greece, a Mediterranean territory which is characterised by high levels of photochemical air pollution and considerable agricultural activity. Ozone concentration fields for 2002 and for specific emission reduction scenarios for the year 2010 were estimated with the Ozone Fine Structure model in the area under consideration. Total economic damage to crops turns out to be significant and estimated to be approximately 43 M€ for the reference year. Production of cotton presents the highest economic loss, which is over 16 M€, followed by table tomato (9 M€), rice (4.2 M€), wheat (4 M€) and oilseed rape (2.8 M€) cultivations. Losses are not spread uniformly among farmers and the major losses occur in areas with valuable ozone-sensitive crops. The results are very useful for highlighting the magnitude of the total economic impacts of photochemical air pollution to the area’s agricultural sector and can potentially be used for comparison with studies worldwide. Furthermore, spatial analysis of the economic damage could be of importance for governmental authorities and decision makers since it provides an indicative insight, especially if the economic instruments such as financial incentives or state subsidies to farmers are considered.     

The probabilistic tsunami hazard assessment along Karnataka Coast from Makran Subduction Zone,west coast of India

Coastal tsunami amplitudes were calculated to identify areas susceptible to tsunami hazard at selected locations of the coast of Karnataka, west of India, due to earthquakes in the Makran Subduction Zone. This is the first time that the probabilistic tsunami hazard assessment along this study area has been attempted. A series of earthquake source scenarios with magnitudes of Mw 8.0, Mw 8.5, and a mega thrust of Mw 9.1 were modeled by using the Community Model Interface for Tsunami interface with the MOST model of Titov and Synolakis (J. Waterway, Port, Coastal and Ocean Engineering, 121(6), 308–316, 1995). As per the previous occurrences, the two least magnitudes are probable, while Mw 9.1 is a worst-case scenario as described by Heidarzadeh et al. (Ocean Engineering, 36(5), 368–376, 2009) and the same is reported by Burbidge et al. (Geoscience Australia Professional Opinion No. 2009/11) as high magnitude. These are not at all historical earthquakes or specifically from historical catalogues. The results of modeling show that all the seven coastal locations are inundated barely in our worst-case scenario with maximum water levels in the range of 100–200 cm. The first tsunami wave strikes the coast within 4–5 h of earthquake occurrence.     

Gradient ion chromatography of environmentally relevant anions in scrubbers of waste incinerators

Improved separations of a wide range of anions of environmental importance in scrubbers of waste incinerators were achieved by applying a Na₂B₄O₇/NaOH composition gradient of low electrical conductivity in combination with suppressed ion chromatography. Fluoride, Acetate, Formiate and 16 other ions including Iodide could be separated within the same run in less than 20 minutes. The selective detection of small amounts of several anions in presence of excessive amounts of Chloride and Sulfate is discussed. Furtheron various adsorbents were tested for the removal of Phenol as a potential trouble shooting source in 5 ion chromatography. Depending on the analytical task and circumstances several adsorbents reveiled promising properties.     

Large-scale green synthesis of Cu nanoparticles

This article reports a novel, eco-friendly herbal method to synthesize Cu nanoparticles in large scales. Cu nanoparticles are an alternative to Ag and Au nanoparticles and have potential applications in many industrial areas. Many synthetic routes have been documented for the preparation of copper nanoparticles, but very few routes are eco-friendly and large-scale. We report here the preparation of Cu nanoparticles from aqueous CuSO₄ using non-toxic and inexpensive materials like curd, milk, and herbal extracts such as tamarind and lemon juice as capping agents. X-ray diffraction and transmission electron microscopy show that produced particles are nanocrystalline copper 20–50 nm in size with a face-centered cubic structure. Fourier-transformed infrared spectroscopy evidences the role of organic acids in the capping process. The novelty of this work is the synthesis of Cu nanoparticles from CuSO₄ without electricity and using non-toxic, cheap capping agents.     

Measuring combined exposure to environmental pressures in urban areas: an air quality and noise pollution assessment approach

This study presents a methodological scheme developed to provide a combined air and noise pollution exposure assessment based on measurements from personal portable monitors. Provided that air and noise pollution are considered in a co-exposure approach, they represent a significant environmental hazard to public health. The methodology is demonstrated for the city of Thessaloniki, Greece. The results of an extensive field campaign are presented and the variations in personal exposure between modes of transport, routes, streets and transport microenvironments are evaluated. Air pollution and noise measurements were performed simultaneously along several commuting routes, during the morning and evening rush hours. Combined exposure to environmental pollutants is highlighted based on the Combined Exposure Factor (CEF) and Combined Dose and Exposure Factor (CDEF). The CDEF takes into account the potential relative uptake of each pollutant by considering the physical activities of each citizen. Rather than viewing environmental pollutants separately for planning and environmental sustainability considerations, the possibility of an easy-to-comprehend co-exposure approach based on these two indices is demonstrated. Furthermore, they provide for the first time a combined exposure assessment to these environmental pollutants for Thessaloniki and in this sense they could be of importance for local public authorities and decision makers. A considerable environmental burden for the citizens of Thessaloniki, especially for VOCs and noise pollution levels is observed. The material herein points out the importance of measuring public health stressors and the necessity of considering urban environmental pollution in a holistic way.     

Evaluation of airborne particulate matter and metals data in personal,indoor and outdoor environments using ED-XRF and ICP-MS and co-located duplicate samples

Factors and sources affecting measurement uncertainty associated with monitoring metals in airborne particulate matter (PM) were investigated as part of the Windsor, Ontario Exposure Assessment Study (WOEAS). The assessment was made using co-located duplicate samples and a comparison of two analytical approaches: ED-XRF and ICP-MS. Sampling variability was estimated using relative percent difference (RPD) of co-located duplicate samples. The comparison of ICP-MS and ED-XRF results yields very good correlations (R² ≥ 0.7) for elements present at concentrations that pass both ICP-MS and ED-XRF detection limits (e.g. Fe, Mn, Zn, Pb and Cu). PM concentration ranges (median, sample number) of 24-h indoor PM₁₀ and personal PM₁₀ filters, and outdoor PM_2.5 filters were determined to be 2.2–40.7 (11.0, n = 48) μg m^?3, 8.0–48.3 (11.9, n = 48) μg m^?3, and 17.1–42.3 (21.6, n = 18) μg m^?3, respectively. The gravimetric analytical results reveal that the variations in PM mass measurements for same-day sampling are insignificant compared to temporal or spatial variations: 92%, 100% and 96% of indoor, outdoor and personal duplicate samples, respectively, pass the quality criteria (RPD ≤ 20%). Uncertainties associated with ED-XRF elemental measurements of S, Ca, Mn, Fe and Zn for 24-h filter samples are low: 78%–100% of the duplicate samples passed the quality criteria. In the case of 24-h filter samples using ICP-MS, more elements passed the quality criteria due to the lower detection limits. These were: Li, Na, K, Ca, Si, Al, V, Fe, Mn, Co, Cu, Mo, Ag, Zn, Pb, As, Mg, Sb, Sn, Sr, Th, Ti, Tl, and U. Low air concentrations of metals (near or below instrumental detection limits) and/or inadvertent introduction of metal contamination are the main causes for excluding elements based on the pass/fail criteria. Uncertainty associated with elemental measurements must be assessed on an element-by-element basis.