纳米二氧化钛复合石墨烯催化剂的制备及处理染料废水

以硫酸钛为原料,采用共沉淀法,制备了一系列纳米二氧化钛复合石墨烯催化剂,采用XRD和FTIR对样品进行表征。通过紫外光照射亚甲基蓝溶液光催化降解实验,研究石墨烯的加入量对TiO2光催化性能的影响,结果表明,TiO2-GO-5具有最佳的光催化性能。在pH=6.00、TiO2-GO-5的投加量为0.070 g/50 mL、光照3 h条件下,100 mg/L亚甲基蓝溶液的脱色率达到最大值为90.52%。     

电镀污泥的热处理特性以及对金属回收的影响

焙烧-酸浸法可有效回收电镀污泥中的有价金属,而污泥的热处理特性是决定能否采用焙烧预处理的重要因素。研究了氧化焙烧和还原焙烧对污泥成分和金属浸出性的影响,并对焙烧前后的污泥进行了金属形态分析和X射线衍射(XRD)分析。结果表明,焙烧预处理实现了污泥减量和金属富集;ES1经氧化焙烧后金属浸出率接近原泥,Cu的浸出率达99%;ES2的还原焙烧效果优于氧化焙烧,特别是Cu的浸出率超过97%,XRD分析发现,还原焙烧过程中金属Cu被还原为铁铜合金;2种焙烧均造成了ES3中目标金属Ni的浸出率的降低;金属浸出性的下降与残渣态的形成有关。     

Biodegradation of beta-cypermethrin by a novel Azoarcus indigens strain HZ5

A novel strain HZ5 was isolated from the activated sludge of a pesticide manufacturer in Hangzhou, which was capable of degrading beta-cypermethrin (beta-CP). Based on its physiological characteristics and analysis of 16S rDNA gene, strain HZ5 was identified as Azoarcus indigens, which was a new genus that can degrade beta-CP effectively. Strain HZ5 could degrade beta-CP over a wide range of temperature (20 to 40°C) and pH (5.5 to 9.0), and the optimal temperature and pH were 30°C and 7.0. The highest degradation rate was approximately 70% of 50 mg/L beta-CP within 144 h at pH 7.0 and 30°C in MSM. An additional carbon source could enhance the biodegradation of beta-CP. Studies on biodegradation of the beta-CP showed no significant enantioselectivity. During the process, two main intermediate metabolites were produced by strain HZ5 and determined as 3-phenoxybenzaldehyde and 3-phenoxybenzoic acid by gas chromatography-mass spectrometry (GC-MS) analysis. The results indicated that strain HZ5 may have potential application in bioremediation of beta-CP polluted environment.     

Influences of adding easily degradable organic waste on the minimization and humification of organic matter during straw composting

To find a better composting process with low greenhouse gas emission and high humus production, the effect of adding kitchen waste on reduction and humification of organic matter during straw composting was studied. Three processes were compared, consisting of different ratios of straw and kitchen waste (1:2, 1:1, and 2:1). At four time points over a 62-d incubation, the reduction and humification of compost was evaluated by measuring the total mass, carbon content, and humic material content of the compost. Treatment 1 (straw/kitchen waste ratio of 1:2) reduced the total mass of compost the most. Treatment 2 (straw/kitchen waste ratio of 1:1) reduced the total carbon content the most, reflecting the highest emission of greenhouse gas. Treatment 3 produced the most humic acid material and released the lowest amount of carbon. Hence, from the point of view of reducing greenhouse gas emissions and increasing stable organic matter such as humus and humic acid during composting, treatment #3 was optimal. The three treatments resulted in significant differences in microbial biomass and enzyme activity during composting. The highest amount of active microbial biomass was associated with the largest reduction in compost mass (treatment 1). Higher proportions of straw (treatments 2 and 3), which contains more lignin, were associated with greater β-glycosidase activity, which may generate more humus that can improve soil quality. Dehydrogenase activity seemed to be the most important microbial factor in organic carbon catabolism or humification.     

The Reuse of Biosludge as an Adsorbent from a Petrochemical Wastewater Treatment Plant

Abstract

Biosludge was obtained from a petrochemical industry’s biological wastewater treatment plant. Zinc chloride (ZnCl₂) was used as a sludge activation agent during the pyrolytic process. Scanning electron microscope (SEM) image photographs, element composition, surface functional group, and pore structure were analyzed for the sludge adsorbent characteristics. Results indicated the proper ZnCl₂-immersed concentration, pyrolytic temperature, and time could produce adsorbent from the bio-sludge. The optimal conditions for a larger surface area adsorbent were 3 M ZnCl₂-immersed sludge pyrolyzed at 600 °C for 30 min and washed with 3 N hydrochloric acid (HCl) solution and distilled water. The predominant pore size of the sludge adsorbent was the mesopore.     

Decomposition of SF6 in an RF Plasma Environment

Abstract

Sulfur hexafluoride (SF₆)-contained gas is a common pollutant emitted during the etching process used in the semiconductor industry. This study demonstrated the application of radio-frequency (RF) plasma in the decomposition of SF₆. The decomposition fraction of SF₆ [η_SF6 (C_in–C_out)/C_in x 100%] and the mole fraction profile of the products were investigated as functions of input power and feed O₂/SF₆ ratio in an SiO₂ reactor. The species detected in both SF₆/Ar and SF₆/O₂/Ar RF plasmas were SiF₄, SO₂, F₂, SO₂F₂, SOF₂, SOF₄, S₂F₁₀, S₂OF₁₀, S₂O₂F₁₀, and SF₄. The results revealed that at 40 W, η_SF6 exceeded 99%, and the reaction products were almost all converted into stable compounds such as SiF₄, SO₂, and F₂ with or without the addition of oxygen. Sulfur oxyfluorides such as SO₂F₂, SOF₂, SOF₄, S₂OF₁₀, and S₂O₂F₁₀ were produced only below 40 W. The results of this work can be used to design a plasma/chemical system for online use in a series of a manufacturing process to treat SF₆-containing exhaust gases.     

Hydrothermal treatment for inactivating some hygienic microbial indicators from food waste–amended animal feed

To achieve the hygienic safety of food waste used as animal feed, a hydrothermal treatment process of 60–110 °C for 10–60 min was applied on the separated food waste from a university canteen. Based on the microbial analysis of raw waste, the inactivation of hygienic indicators of Staphylococcus aureus (SA), total coliform (TC), total aerobic plate counts (TPC), and molds and yeast (MY) were analyzed during the hydrothermal process. Results showed that indicators' concentrations were substantially reduced after hydrothermal treatment, with a greater reduction observed when the waste was treated with a higher temperature and pressure and a longer ramping time. The 110 °C hydrothermal treatment for 60 min was sufficient to disinfect food waste as animal feed from the viewpoint of hygienic safety. Results obtained so far indicate that hydrothermal treatment can significantly decrease microbial indicators' concentrations but does not lead to complete sterilization, because MY survived even after 60 min treatment at 110 °C. The information from the present study will contribute to the microbial risk control of food waste–amended animal feed, to cope with legislation on food or feed safety.

Implications: Reduction of microbial indicators at ramping time and holding time during the hydrothermal process showed that hydrothermal treatment is an effective method to achieve hygienic feed from food waste to a certain extent, but the conditions researched in this study were not enough for the complete sterilization of food waste, because of the different heat resistance of bacteria and spores.     

Cornmeal-induced resistance to ciprofloxacin and erythromycin in enterococci

Triclosan is used as an antibacterial agent in household items and personal care products. Since this compound is found in maternal milk of humans and bodies of wild animals, there is growing concern among some consumer groups and scientific community that triclosan is adverse for humans and wild animals. In order to estimate adverse actions of triclosan, the effects of triclosan on intracellular Zn²⁺ concentration and cellular thiol content were studied in rat thymocytes by the use of flow cytometer with appropriate fluorescent probes. Triclosan at 1-3 μM (sublethal concentrations) increased the intensity of FluoZin-3 fluorescence (intracellular Zn²⁺ concentration) and decreased the intensity of 5-chloromethylfluorescein (5-CMF) fluorescence (cellular thiol content). Negative correlation (r = −0.985) between triclosan-induced changes in FluoZin-3 and 5-CMF fluorescences was found. Removal of external Zn²⁺ did not significantly affect the triclosan-induced augmentation of FluoZin-3 fluorescence, suggesting an intracellular Zn²⁺ release by triclosan. These actions of triclosan were similar to those of H₂O₂ and triclosan significantly potentiated the cytotoxicity of H₂O₂. Therefore, the results may suggest that triclosan at sublethal concentrations induces oxidative stress that decreases cellular thiol content, resulting in an increase in intracellular Zn²⁺ concentration by Zn²⁺ release from intracellular store(s). Since recent studies show many physiological roles of intracellular Zn²⁺ in cellular functions, the triclosan-induced disturbance of cellular Zn²⁺ homeostasis may induce adverse actions on the cells.     

Historical change of mercury pollution in remote Yongle archipelago, South China Sea

We collected three ornithogenic coral sand sedimentary profiles from Jinyin Island, Jinqing Island and Guangjin Island of Yongle archipelago, South China Sea and reconstructed the deposition flux of anthropogenic Hg over the past 700 years in the study area. On the whole, the anthropogenic Hg flux is relatively low; it remained at a low level before the Industrial Revolution with a small peak at about 1450-1550 AD, which may record the enhanced metallurgy activity in Ming Dynasty of China. During the 20th century, the deposition flux of anthropogenic Hg increased rapidly, but two troughs occurred during the periods around 1940s and 1970s, corresponding to the economic depression caused by World War II, Civil War in China (1945-1949), and the Culture Revolution (1966-1976) in China. Since the 1970s the deposition flux of anthropogenic Hg has been persistently increasing, apparently the result of fast economic development in East and Southeast Asia countries around South China Sea.