Feasibility of Applying a Stable Isotopic Tracer for Direct Determination of Dry Particulate Deposition to Soybean Plants

ABSTRACT

A stable rare-earth isotopic tracer was used to measure the deposition of KNO₃ particles on soybean leaves by direct measurement of the tracer on the plant surfaces by thermal-ionization mass spectrometry. Submicrometer particles, made from a solution containing 3 |mg mL^-1 neodymium isotope (¹⁴⁸Nd, 87.9%) and 1,000 mg mL^-1 KNO₃, were dispersed with a two-fluid nozzle and released upwind of a soybean field. Total suspended- and size-fractionated-aerosol particles were collected on an open-face filter and in a micro-orifice impactor, respectively, at a distance of 40 m from the release point. Soybean leaves exposed to the plume were collected at distances ranging from 25 to 100 m. As little as 5.5 pg of the tracer (i.e., excess ¹⁴⁸Nd) was detected in soybean leaves at signal-to-noise ratios ranging from 7,500 to 240,000, in the presence of 200 to 2,700 pg of naturally occurring Nd. The dry-particle deposition velocity, determined from the ratio of the aerial concentration and directly deposited aerosol (geometric mass mean diameter, 0.20 mm) flux, and its corresponding analytical uncertainty were 0.30 cm sec^-1 and 2.5%, respectively.     

The Relationship between the Quantity of Heavy Metal and PAHs in Fly Ash

ABSTRACT

Heavy metal and polycyclic aromatic hydrocarbons (PAHs) in flue gas have received considerable attention in recent years due to their mutagenic or carcinogenic properties. The present study is carried out to investigate the influence of the quantity of heavy metals on PAHs formation in fly ash.

A fluidized bed incinerator was used in this experiment to obtain fly ash of chemical similarity by incinerating various compositions of waste. The obtained fly ash, both with and without heavy metal, were used to adsorb the PAHs in the flue gas and to investigate the formation of PAHs in fly ash. The results indicate that carbon and heavy metals most greatly influence the formation of PAHs in the fly ash. Carbon is absorptive; heavy metals encourage not only absorption of PAHs but also catalyze PAHs formation.     

Removal of sulfamethoxazole and sulfapyridine by carbon nanotubes in fixed-bed columns

Sulfamethoxazole (SMX) and sulfapyridine (SPY), two representative sulfonamide antibiotics, have gained increasing attention because of the ecological risks these substances pose to plants, animals, and humans. This work systematically investigated the removal of SMX and SPY by carbon nanotubes (CNTs) in fixed-bed columns under a broad range of conditions including: CNT incorporation method, solution pH, bed depth, adsorbent dosage, adsorbate initial concentration, and flow rate. Fixed-bed experiments showed that pH is a key factor that affects the adsorption capacity of antibiotics to CNTs. The Bed Depth Service Time model describes well the relationship between service time and bed depth and can be used to design appropriate column parameters. During fixed-bed regeneration, small amounts of SMX (3%) and SPY (9%) were irreversibly bonded to the CNT/sand porous media, thus reducing the column capacity for subsequent reuse from 67.9 to 50.4 mg g^?1 for SMX and from 91.9 to 72.9 mg g^?1 for SPY. The reduced column capacity resulted from the decrease in available adsorption sites and resulting repulsion (i.e., blocking) of incoming antibiotics from those previously adsorbed. Findings from this study demonstrate that fixed-bed columns packed with CNTs can be efficiently used and regenerated to remove antibiotics from water.     

Hydrothermal treatment for inactivating some hygienic microbial indicators from food waste–amended animal feed

To achieve the hygienic safety of food waste used as animal feed, a hydrothermal treatment process of 60–110 °C for 10–60 min was applied on the separated food waste from a university canteen. Based on the microbial analysis of raw waste, the inactivation of hygienic indicators of Staphylococcus aureus (SA), total coliform (TC), total aerobic plate counts (TPC), and molds and yeast (MY) were analyzed during the hydrothermal process. Results showed that indicators' concentrations were substantially reduced after hydrothermal treatment, with a greater reduction observed when the waste was treated with a higher temperature and pressure and a longer ramping time. The 110 °C hydrothermal treatment for 60 min was sufficient to disinfect food waste as animal feed from the viewpoint of hygienic safety. Results obtained so far indicate that hydrothermal treatment can significantly decrease microbial indicators' concentrations but does not lead to complete sterilization, because MY survived even after 60 min treatment at 110 °C. The information from the present study will contribute to the microbial risk control of food waste–amended animal feed, to cope with legislation on food or feed safety.

Implications: Reduction of microbial indicators at ramping time and holding time during the hydrothermal process showed that hydrothermal treatment is an effective method to achieve hygienic feed from food waste to a certain extent, but the conditions researched in this study were not enough for the complete sterilization of food waste, because of the different heat resistance of bacteria and spores.     

Effect of copper(II) on biodegradation of benzo[a]pyrene by Stenotrophomonas maltophilia

Benzo[a]pyrene (BaP) biodegradation by Stenotrophomonas maltophilia was studied under the influence of co-existed Cu(II) ions. About 45% degradation was achieved within 3 d when dealing with 1 mg L^?1 BaP under initial natural pH at 30 °C; degradation reached 48% in 2 d at 35 °C. Efficacy of BaP biodegradation reached the highest point at pH 4. In the presence of 10 mg L^?1 Cu(II) ions, the BaP removal ratio was 45% on 7th day, and maintained stable from 7 to 14 d at 30 °C under natural pH. The favorable temperature and pH for BaP removal was 25 °C and 6.0 respectively, when Cu(II) ions coexisted in the solutions. Experiments on cometabolism indicated that S. maltophilia performed best when sucrose was used as an additional carbon source. GC–MS analysis revealed that the five rings of BaP opened, producing compounds with one or two rings which were more bioavailable.     

Remediation of DDTs contaminated soil in a novel Fenton-like system with zero-valent iron

Application of a novel Fenton-like system with zero-valent iron, EDTA and Air (ZVI/EDTA/Air) was investigated to degrade dichlorodiphenyltrichloroethane (DDT), dichlorodiphenyldichloroethane, and dichlorodiphenyldichloroethylene (DDE) in the actual contaminated soil from an organochlorine pesticide site. It was found DDTs in the soil were effectively degraded by the system at room temperature, ambient atmosphere pressure and near neutral pH. The dosages of EDTA and ZVI were the dominant factors influencing the removal of contaminants. An increase of EDTA from 0.05 to 0.2 mM and ZVI from 1 to 5 g L^?1 improved the removal of the contaminants significantly. However, excessive amount of EDTA led to a negative effect on the degradation process. Meanwhile, EDTA was simultaneously degraded so as to avoid the secondary pollution risk on soil remediation. Only a small amount of 4,4′-DDE and 2,2-bis(4-chlorophenyl)-1-chloroethylene (4,4′-DDMU) generated as the intermediates of DDT degradation during the process. Our investigation suggests that the Fenton-like system is a promising alternative for remediation of organochlorine pesticides contaminated soils.     

上海室内外灰尘中多氯联苯及其人体暴露评估

2008年11月~2009年6月以气象学分4个季度测定了上海地区居民家庭室内外灰尘中多氯联苯(PCBs)的浓度.研究表明,春季和冬季室内灰尘中PCBs平均含量高于夏季和秋季,而室外灰尘中PCBs含量表现相反特征.单个室内样品∑PCBs浓度范围为1.0×103~1.97×106pg/g,室外为n.d.~1.96×106pg/g.此外,通过生理学的体外实验模拟人体胃肠消化过程,并利用响应面法研究影响PCBs生物有效性的因素,发现胆汁浓度相对于消化时间、液固比和污染物浓度对PCBs生物有效性影响最大.依据室内外灰尘中PCBs年平均浓度、生物有效性及灰尘摄入量计算得出,上海地区儿童和成人通过摄入灰尘人均PCBs的日暴露量分别为2.657×102~1.078×104pg/d和1.328×102~ 5.392×103pg/d.     

A General Model for Analyzing Data from Mark-recapture Experiments with an Application to the Pacific Halibut

A general model is developed to examine the patterns of the regional movement of tagged and released fish from mark-recapture experiments. It is a stochastic model that incorporates fishing mortality, natural mortality, fish movement, tag-shedding, and different rates of reporting. A likelihood function is constructed for estimating its parameters. We used this model to analyze data on the Pacific halibut from mark-recapture experiments conducted by the International Pacific Halibut Commission (IPHC), with a total of 36,058 releases from 1982 to 1986 and 5,826 recoveries from 1982 to 2000. We estimated their rates of movement among IPHC management areas, along with their instantaneous rates of natural and fishing mortalities. Our analysis revealed that fish movement was not significant among areas, with a resident probability of > 0.92. This lends support to the IPHC catch-at-age stock assessment model (which has no built-in movement components). The estimated instantaneous rate of natural mortality (0.198 year⁻¹) lies between that assumed in all IPHC stock assessments before 1998 (0.20 year⁻¹) and that from 1999 onwards (0.15 year⁻¹). The estimates of the instantaneous rates of fishing mortality were consistent with those from the IPHC stock assessment model. Received: April 2003 / Revised: May 2005     

Anthropogenic nitrogen sources and exports in a village-scale catchment in Southeast China

An experimental village-scale catchment was selected for investigation of nitrogen (N) sources and exports. The mean N application rate over the catchment was 350.2 kg N ha⁻¹, but this rate varied spatially and temporally. The N leaching loss rate varied from 8.1 to 52.7 kg N ha⁻¹ under different land use regimes. The average N leaching loss rate was 13.4 kg N ha⁻¹ over the whole catchment, representing about 3.8% of the total N inputs. The N export rate through stormflows was 28.8 kg N ha⁻¹, about 8.2% of the total N inputs. Seasonal patterns showed that 95% of N exports through stormflows occurred during July to September in 2002. Overall, the maximum riverine N exports were 12.1% of total N inputs and 15.5% of the inorganic fertilizer N applied. Understanding N sources and exports in a village-scale catchment can provide a knowledge base for amelioration of diffuse agricultural pollution.     

Heavy metals associated with reduced sulfur in sediments from different deposition environments in the Pearl River estuary, China

Distribution of acid volatile sulfur (AVS) and the simultaneously extracted metals (SEM: Cu, Pb, Zn, Cd, Ni) in sediment profiles has been studied at five sites in Pearl River estuary, China. Of the five sampling locations, Nos.1 and 2 are in the middle shoal, Nos.3 and 4 in the west shoal and No. 5 locates to the south of the estuary. The AVS content in the sediments of the middle shoal varies in a small range (0.25–4.06 μmol g⁻¹), while that of west shoal increases with depth from 0 to ultimately 26.09 μmol g⁻¹. The SEM concentration in the sediment profiles at location Nos. 1, 2 and 5 is generally in the range of 0.95±0.2 μmol g⁻¹ with a slight upward increase, while that in the sediment of west shallows are much higher (1.43–2.42 μmol g⁻¹) with a significant upward increase, especially in the upper layer of ca. 15 cm. The observed upward increase of SEM content at all the sites implies that heavy metal contamination of sediment in the Pearl River estuary is increasing. Calculations of the excess heavy metal content which is defined by SEM-AVS molar difference suggests that the upper sediment in the Pearl River estuary, especially on the west shallows, could be a source of heavy metal contaminants and may cause toxicity to the benthos. The site-specific distribution patterns in the AVS and SEM profiles were interpreted according to the hydrogeochemistry of deposition environments.