乳状液膜法处理煤制兰炭废水

以磷酸三丁酯(TBP)为载体、煤油为膜溶剂、NaOH水溶液为内水相,采用乳状液膜法处理兰炭废水。实验结果表明:当TBP体积分数为4%、表面活性剂质量分数为4%、内水相NaOH质量分数为12%、油内比(乳状液的油相与内水相的体积比)为3∶2、乳水比为1∶5、萃取时间为15min时,废水中的酚类(以苯酚计)去除率达到85%以上,COD去除率达83%以上。     

H(+)/phenanthrene symporter and aquaglyceroporin are implicated in phenanthrene uptake by wheat (Triticum aestivum L.) roots

Polycyclic aromatic hydrocarbons (PAHs) are ubiquitous organic pollutants that are toxic to human and nonhuman organisms. Dietary intake of PAHs is a dominant route of exposure for the general population because food crops are a major source of dietary PAHs. The mechanism for crop root uptake of PAHs remains unclear. Here we reveal that wheat root uptake of PAHs involves active and passive processes. The passive uptake is mercury and glycerol dependent. Mercury and glycerol inhibit uptake, indicating that aquaglyceroporins sensitive to mercury contribute to passive uptake. Active uptake is mediated by a phenanthrene/H symporter. The electrical response of wheat roots triggered by phenanthrene consists of two sequential phases: depolarization followed by repolarization. The depolarization is phenanthrene concentration dependent, with saturation kinetics that have an apparent of K(m) 10.8 μmol L(-1). As uptake proceeds, external solution pH increase is noticed. Lower pH favors the uptake. Vanadate and 2,4-dinitrophenol suppress the electrical response to phenanthrene and phenanthrene uptake, suggesting that plasma membrane H(+)-ATPase is involved in the establishment of an electrochemical proton gradient acting as a driving force for active uptake. Therefore, it is suggested that aquaglyceroporin and phenanthrene/H symporter are implicated in phenanthrene uptake. Our results provide insight into PAH uptake mechanism in wheat roots that is relevant to strategies for reducing PAH accumulation in wheat for food safety, improving phytoremediation of PAH-contaminated soils or water by agronomic practices and genetic modification to target remedial plants for higher PAH uptake capacity.     

Assessing benzene-induced toxicity on wild type Euglena gracilis Z and its mutant strain SMZ

Benzene is a representative member of volatile organic compounds and has been widely used as an industrial solvent. Groundwater contamination of benzene may pose risks to human health and ecosystems. Detection of benzene in the groundwater using chemical analysis is expensive and time consuming. In addition, biological responses to environmental exposures are uninformative using such analysis. Therefore, the aim of this study was to employ a microorganism, Euglena gracilis (E. gracilis) as a putative model to monitor the contamination of benzene in groundwater. To this end, we examined the wild type of E. gracilis Z and its mutant form, SMZ in their growth rate, morphology, chlorophyll content, formation of reactive oxygen species (ROS) and DNA damage in response to benzene exposure. The results showed that benzene inhibited cell growth in a dose response manner up to 48 h of exposure. SMZ showed a greater sensitivity compared to Z in response to benzene exposure. The difference was more evident at lower concentrations of benzene (0.005–5 μM) where growth inhibition occurred in SMZ but not in Z cells. We found that benzene induced morphological changes, formation of lipofuscin, and decreased chlorophyll content in Z strain in a dose response manner. No significant differences were found between the two strains in ROS formation and DNA damage by benzene at concentrations affecting cell growth. Based on these results, we conclude that E. gracilis cells were sensitive to benzene-induced toxicities for certain endpoints such as cell growth rate, morphological change, depletion of chlorophyll. Therefore, it is a potentially suitable model for monitoring the contamination of benzene and its effects in the groundwater.     

脱硫石膏粒径分布与脱水性能实验研究

脱硫石膏粒径分布是影响脱硫石膏浆液脱水性能的重要因素之一,以干法、湿法筛分和研磨破碎获得不同粒径分布的脱硫石膏,在相同的过滤条件下,对不同粒径分布脱硫石膏浆液脱水性能进行了研究,实验结果表明,当脱硫石膏粒径d50大于50μm且（d90-d10）小于100μm,真空过滤最大真空度不低于0．098MPa,过滤时间不少于2．5min,滤饼厚度不超过20mm时,石膏滤饼含水率可以降低到12％以下（最低可达10％）;d50在17μm为脱硫石膏在相同的过滤条件下能够实现真空脱水干燥的转折点;d50和（d90-d10）共同影响石膏脱水性能,d50小于20μm时,仅表现为d50的影响。     

一种湿度计的校准方法——测量不确定度分析校准法

本文提出了校准湿度计的一种新方法一测量不确定度分析校准法,以利用5121湿度发生器校准可输出（0-5）V的湿度传感器的基本误差为例,介绍了其校准方法确定了该方法校准湿度计的置信度和准确葭：     

湿度传感器在防护性能检测中动态湿度的测量方法

1引言 防护装备在核、生、化环境下起着防放射性灰尘、防生物细菌和防化学毒剂的作用。防护装备的防护性能检测准确与否。直接影响着防护装备产品的质量乃至使用者的生命安全。防护装备的防护性能受湿度的影响很大,以前,在防护装备的防护性能检测过程中是利用干、湿球温度计来检测测试管路中的湿度。     

Application of MSWI fly ash on acid soil and its effect on the environment

This study evaluated the feasibility of using municipal solid waste incinerator (MSWI) fly ash as acid soil amendment. In particular, changes in soil physicochemical properties and the potential environmental problems caused by the application of MSWI fly ash were investigated. The results showed that application of MSWI fly ash to the acid soil could raise the soil pH. The contents of rapidly available P and K, and slowly available K in the amended soil had a linear relationship with the addition ratio of MSWI fly ash. An addition of less than 20% of MSWI could raise the soil respiratory intensity after incubation for 3-5 days. Application of MSWI fly ash to the soil increased its content of water soluble salts and heavy metals, which could cause phytotoxicity in the plants. Therefore, the addition of MSWI fly ash to the soil should not be excessive, and less than 5-10% is an advisable addition level depending on the acidity of the soil and the plants growing on it.     

Numerical simulation of hydrogen–air detonation for damage assessment in realistic accident scenarios

An accidental hydrogen release within an equipment enclosure may result in the presence of detonable mixture in a confined environment. From a safety standpoint, it is then useful to assess the potential for damage. In that context, numerical simulation of the sequence of events subsequent to detonative ignition provides a useful tool, although with obvious limitations. This article describes the procedure, summarizes two case studies, and reviews the limitations. First, a hydrogen dispersion pattern is obtained from numerical simulation of dispersion, using a commercial package designed primarily for incompressible flow. This dispersion cloud is then used as the initial condition in an inviscid, compressible, reactive flow simulation. To force detonative ignition, a sufficiently large amount of energy is deposited in a small region that corresponds to the ignition location. Chemistry is modeled using a single step Arrhenius model. Because the wave thickness is small compared with the computational domain, a fine mesh is needed, limiting the practicality of the process to two-dimensional geometries. This is the most significant limitation; it is conservative. The two cases described in the paper include an electrolyzer, in which a small release occurs, leading potentially to some damage to the enclosure, and a reformer, in which the consequences are potentially more serious.