Development of IC-ELISA for detection of organophosphorus pesticides in water

Diethyl (carboxymethyl) phosphonate (DECP) was used as the hapten to develop an indirect competitive enzyme-linked immunosorbent assay (IC-ELISA) for detecting organophosphorus pesticides (OPs). Conjugator of DECP with bovin serum albumin (BSA) was used as the immunogen for producing the polyclonal antibodies (PcAbs). Three antisera were obtained after the immune procedure. Characterization studies of the PcAbs indicated that the titer of antiserum-1 was highest in 3 antisera, and antiserum-1 had high affinity and specificity to the parathion, dichlorvos and pirimiphos. The IC-ELISA showed an IC₅₀ of 0.428 μ g/mL with a detection limit of 0.0125 μ g/mL to parathion. The assay also indicated that the IC₅₀ values of pirimiphos and dichlorvos were 0.331 μ g/mL and 1.25 μ g/mL respectively, and the detection limits of pirimiphos and dichlorvos were 0.0116 μ g/mL and 0.048 μ g/mL respectively. Recoveries of parathion, pirimiphos and dichlorvos spiked into water samples ranged from 90% to 160%. The results indicated that the ELISA could be a convenient and supplemental analytical tool for monitoring OPs residues in environmental water samples.     

Influence of particle location on the number of charges per charged nanoparticle at the outlet of a needle charger

This study has investigated numerically the influence of particle location on the number of charges per charged particle in the 10–40 nm size range at the outlet of a needle charger by simulating flow field, electric field, particle charging, and particle trajectory at various conditions. The results show that the total (i.e., diffusion + field charging) number of charges per particle increase with decreasing ratio values of radial location at the outlet of the charger due to the particle position close to the needle tip. It has also been shown that in the outlet region of the charger there is a critical radial location at which the number of charges per particle is a maximum; this critical radial location represents the point at which the charged particle trajectory becomes closest to the needle electrode. The maximum value of number of charges increases with increasing Reynolds number and slightly increases with decreasing applied voltage for particle diameter larger than 20 nm. The maximum number of charges per charged nanoparticle increases with increasing particle diameter. In addition, the minimum ratio value of radial particle location decreases with increasing Reynolds number for various particle diameters.

Implications: In this work, the influence of particle location on the number of charges per charged nanoparticle at the outlet of a needle charger has been investigated using numerical models under different conditions. The results demonstrate that the radial location affects the number of charges per particle at the outlet of the charger. The maximum number of charges increases with increasing particle diameter, and the minimum ratio value of radial particle location decreases with increasing Reynolds number. The numerical models explain and quantify the number of charges on the charged particle in the 10–40 nm size range from the outlet of the needle charger at various conditions.     

利用污泥熟肥作为高含水率污泥堆肥调理剂

采用静态强制通风好氧堆肥的方法,以木屑作为对比,考察了利用污泥熟肥作为调理剂对污泥堆肥过程的影响。结果表明,与以木屑作为调理剂的污泥堆体(对照组)相比,以污泥熟肥作为调理剂的污泥堆体(实验组)升温快,高温阶段(>50℃)持续时间长达10 d,满足粪便无害化卫生标准的要求,而对照组仅持续了2 d;实验组腐熟的堆肥含水率从60%降到39%,下降了21%,pH维持在7.5～8.5范围内,微生物活性较强,而对照组含水率仅下降15%,pH始终低于7.5;实验组种子发芽指数(GI)在第14天就回升到80%以上,基本上去除了植物毒性,而对照组GI在第22天才回升到50%。总体而言,污泥熟肥能显著改善堆肥中微生物的微环境,促进有机物的降解,缩短堆肥腐熟时间,是一种优质的调理剂。     

青萍(Lemna minor L.)对氮磷的吸收特征

以西部地区优势浮萍品种青萍为实验对象,研究了青萍对不同浓度硝态氮和磷酸盐的吸收特征。结果表明,硝态氮浓度在1～10 mg/L范围内,青萍对硝态氮有较好的吸收效果,M-M方程可以较好地描述硝态氮浓度与青萍对硝态氮的吸收速率之间的关系,通过M-M方程拟合得到青萍对硝态氮的最大吸收速率为0.1167 mg/(g FW.h),亲和力常数为6.9274。磷酸盐浓度在0.1～1.0 mg/L范围内,青萍对磷酸盐也有较好的吸收效果,二次多项式回归可以较好地描述青萍吸收速率与磷酸盐浓度的关系,回归方程得到青萍对磷酸盐的最大吸收速率为0.0193 mg/(g FW.h),对应磷酸盐浓度为0.6 mg/L。     

耐低温贫营养好氧反硝化菌群脱氮特性及安全性

针对微污染水体强化原位生物脱氮技术同时面临低温、贫营养及好氧问题,对实验室已分离筛选的贫营养好氧反硝化菌和耐低温好氧反硝化菌进行菌源重组,构建出高效耐低温贫营养好氧脱氮功能菌群T1(Y3+F3+H8)和T2(Y3+F4)。研究不同投菌量条件下菌群的脱氮特性,结果表明,投菌量对T1脱氮效果有一定影响,0.1、0.2和1.0 mg/L投量对NO3--N去除率为71%、91%和100%,总氮去除率为56%、34%和52%;T2菌群,当投量为0.2 mg/L时,对NO3--N、总氮去除率最大可达66%和59.48%。对菌群T1、T2进行生物安全性分析,采用次氯酸钠进行消毒,其生物灭活率均达到99.9%以上。     

氧化物催化剂对非热等离子体催化降解甲苯的影响

考察了在干燥气氛下不同氧化物催化剂对非热等离子体催化降解甲苯的影响。从甲苯降解率、碳平衡、CO2选择性和O3去除4个方面,对比了氧化物催化剂的介电性能、表面供氧能力和比表面积与多孔结构对反应产生影响的强弱。结果表明,催化剂的介电性能有利于甲苯降解率、碳平衡和O3产量的提高,但对CO2选择性和O3去除的影响极小;一定能量密度下,催化剂比表面积与多孔结构对CO2选择性和O3去除所产生的影响要强于介电性能;催化剂表面供氧能力可明显促进反应的进行,其对反应所产生的影响要强于比表面积与多孔结构。     

变压吸附技术的应用及其发展简述

文章分析了变压吸附技术存在的问题,并提出解决措施。通过对变压吸附技术应用现状的总结,对该技术未来的发展方向进行预测与评价。指出变压吸附技术能够经济高效地实现物质的分离,有望成为分离技术未来的发展方向,为环保和工业生产做出更大贡献。     

微生物法处理海上钻井废钻井液

微生物法适用于海上钻井含油废弃物的处理。通过多次对菌株采集、分离、纯化和培养驯化,选育得到了3株对石油烃类有很好降解效果的石油类降解菌;确定了石油类降解菌适宜的生化处理条件:最佳生长及原油降解温度为50℃、最佳生长及原油降解酸碱性环境为pH=6.0、最佳菌株接种量2%、最佳原油初始浓度为500mg/L。处理后的含油废弃钻井液含油量基本稳定在2mg/L以下,降解率达98%以上。     

回收与降解聚驱采出水的工艺探讨

含聚污水的处理是困扰石油行业的难题之一。基于聚驱采出水的特点,围绕聚合物的回收利用和降解理论及技术,探讨国内外含聚污水处理技术的研究与应用现状,对比分析现有处理技术存在的问题及适应性,提出采用化学混凝、气浮和水质改性等技术来回收利用PAM(聚丙烯酰胺)的新思路,打破了降解PAM的传统思维,同时分析含聚污水处理与利用技术的可行性与应用前景,有望实现含聚污水的循环利用。     

单标多点校正组合英蓝超滤测定地表水中多种阴离子

建立了利用组合单标多点校正和英蓝超滤单元的离子色谱法测定地表水中F-、C1-、NO3-、S0424—4-种离子的方法,方法操作简便,灵敏度高,线性范围广,抗干扰能力强,可同时快速测定不同数量级浓度的离子,降低了配置标准品和样品前处理的复杂性,减少了因前处理带来的干扰。