Ultrafine particles at three different sampling locations in Taiwan

Atmospheric ultrafine particles (UPs or PM_0.1) were investigated at the roadside of Syuefu road in Hsinchu city, in the Syueshan highway tunnel in Taipei and in the NTU Experimental Forest in Nantou, Taiwan. A SMPS (TSI 3936) and three MOUDIs (MSP 110) were collocated to determine the number and mass concentrations of the PM_0.1 simultaneously. The filter samples were further analyzed for organic carbon (OC), element carbon (EC), water-soluble ions and trace elements. Taking into account the OC artifact of PM_0.1, good chemical mass closure (ratio of the reconstructed chemical mass to the gravimetrical mass of PMs) was obtained with an unknown percentage of 10.6, 26.2 and 37.2% at the roadside, tunnel and forest, respectively. The unexplained mass was attributed to aerosol water in this study. The artifact at the roadside, tunnel and the forest PM_0.1 mass was found to be as high as 51.6 ± 10.7%, 20.0 ± 5.4% and 85.6 ± 18.4%, respectively. Finally, the effective density of the roadside, tunnel and forest PM_0.1 was calculated based on the results of chemical speciation and found to be 1.45, 1.29 and 1.22 g cm^?3, respectively, which was in good agreement with that obtained by using the method of Spencer et al. (2007). Based on these results, it is foreseeable that the number concentration of the SMPS can be converted using the effective density determined by Spencer et al. (2007) for the real time measurement of the PM_0.1 concentration.     

Surface ozonation of polyvinyl chloride for its separation from waste plastic mixture by froth floatation

Selective surface modification of polyvinyl chloride (PVC) by ozonation was evaluated to facilitate the separation of PVC from other heavy plastics with almost the same density as PVC, especially polyethylene terephthalate (PET), by the froth flotation process. The optimum froth flotation conditions were investigated, and it was found that at 40°C, 90% of PVC and PET plastics floated. The bubble size became larger and the area covered with bubbles on the plastic surface was reduced with increasing temperature. Optimum PVC separation was achieved with the flotation solution at 40°C and mixing at 180–200 rpm, even for sheet samples 10 mm in size. Combined treatment by ozonation and froth flotation is a simple, effective, and inexpensive method for PVC separation from waste plastics.     

A pilot study for determining the optimal operation condition for simultaneously controlling the emissions of PCDD/Fs and PAHs from the iron ore sintering process

In this study, the cost-benefit analysis technique was developed and incorporated into the Taguchi experimental design to determine the optimal operation combination for the purpose of providing a technique solution for controlling both emissions of PCDD/Fs and PAHs, and increasing both the sinter productivity (SP) and sinter strength (SS) simultaneously. Four operating parameters, including the water content, suction pressure, bed height, and type of hearth layer, were selected and all experimental campaigns were conducted on a pilot-scale sinter pot to simulate various sintering operating conditions of a real-scale sinter plant. The resultant optimal combination could reduce the total carcinogenic emissions arising from both emissions of PCDD/Fs and PAHs by 49.8%, and increase the sinter benefit associated with the increase in both SP and SS by 10.1%, as in comparison with the operation condition currently used in the real plant. The ANOVA results indicate that the suction pressure was the most dominant parameter in determining the optimal operation combination. The above result was theoretically plausible since the higher suction pressure provided more oxygen contents leading to the decrease in both PCDD/F and PAH emissions. But it should be noted that the results obtained from the present study were based on pilot scale experiments, conducting confirmation tests in a real scale plant are still necessary in the future.     

Combining bioaccumulation and coping mechanism to enhance long-term site-specific risk assessment for zinc susceptibility of bivalves

The purpose of this study is to conduct a long-term site-specific risk assessment for zinc (Zn) susceptibility of bivalves, green mussel Perna viridis and hard clam Ruditapes philippinarum, based on published experimental data by linking the biologically-based damage assessment model with the subcellular partitioning concept. A comprehensive risk modeling framework was developed to predict susceptibility probability of two bivalve species exposed to waterborne Zn. The results indicated that P. viridis accumulates more Zn toxicity, whereas both toxic potency and the recovery rate of Zn are higher for R. philippinarum. We found that negative linear correlations exist in elimination-recovery and elimination-detoxification relationships, whereas a positive linear correlation was observed in recovery-detoxification relationships for bivalves exposed to waterborne Zn. Simulation results showed that the spatial differences of susceptibility primarily resulted from the variation of waterborne Zn concentration under field conditions. We found that R. philippinarum is more susceptible of Zn than P. viridis under the same exposure condition. Results also suggested that Zn posed no significant susceptibility risk to two bivalve species in Taiwan. We suggested that these two species can be used to biomonitor the water quality on Taiwan coastal areas.     

Photocatalytic degradation of methyl orange by a multi-layer rotating disk reactor

Introduction

Solar wastewater treatment based on photocatalytic reactions is a green process that utilizes renewable energy resources and minimizes secondary pollution. Reactor design plays an important role in promoting treatment efficiency and throughput density (based on unit volume of the reactor).

Experimental

A rotating disk reactor that significantly increases the process efficiency has been designed and evaluated for application to photocatalytic decomposition of dye pollutants in aqueous solutions. In this process, a novel multi-layer rotating disk reactor (MLRDR) was presented. Photocatalyst (TiO₂) particles are immobilized on the surfaces of disks. Within each layer of the reactor, methyl orange aqueous solution is allowed to flow from the center of the disk in a radial direction along the surface of the disk, which is rotating at high speed and is irradiated with UV lamps. The effluent is then directed to the center of another layer that lies underneath. Up to four stacked layers have been tested in this study, and the effects due to the number of the layers and volumetric flow rate on reaction conversion are investigated.

Results and discussion

The efficiency of this photocatalytic reactor exhibits complex dependence on these parameters. With selected operating conditions, conversions greater than 95% can be achieved within seconds of residence time. Design equations of the reactor have been derived based on fluid dynamics and kinetic models, and the simulation results show promising scale-up potential of the reactor.     

Characteristics of Road Dust from Different Sampling Sites in Northern Taiwan

Abstract

Road dust contributes a large percentage of the atmosphere’s suspended particles in Taiwan. Three road dust samples were collected from downtown, electrical park, and freeway tunnel areas. A mechanical sieve separated the road dust in the initial stage. Particles >100 μm were 75%, 70%, and 60% (wt/wt), respectively, of the samples. Those particles <37 μm were resuspended in another mixing chamber and then collected by a Moudi particle sampler. The largest mass fraction of resuspended road dust was in the range of 1–10 μm. Ultrafine particles (<1 μm) composed 33.7, 17, and 7.4% of the particle samples (downtown, electrical park, and freeway tunnel, respectively). The road dust compositions were analyzed by inductively coupled plasma (ICP)-atomic emissions spectroscopy and ICP-mass spectrometry. The highest concentration fraction contained more aluminum (Al), iron (Fe), calcium (Ca), and potassium than other elements in the road dust particle samples. Additionally, the sulfur (S) content in the road dust from the electrical park and freeway tunnel areas was 2.1 and 3.4 times the downtown area sample, respectively. The sulfur originated from the vehicle and boiler oil combustion and industrial manufacturing processes. Furthermore, zinc (Zn) concentration in the tunnel dust was 2.6 times that of the downtown and electrical park samples, which can be attributed to vehicle tire wear and tear. Resuspended road dusts (<10 μm) from the downtown and freeway tunnel areas were principally 2.5–10 μm Al, barium (Ba), Ca, copper (Cu), Fe, magnesium (Mg), sodium (Na), antimony (Sb), and Zn, whereas arsenic (As), chromium (Cr), and nickel (Ni) were predominant in the ultrafine particle samples (<1 μm). Al, Ba, and Ca are the typical soil elements in coarse particles; and As, and Cr and Ni are the typical fingerprint of oil combustion and vehicle engine abrasion in ultrafine particles. There was a special characteristic of resuspension road dust at electrical park, that is, many elements, including As, Ba, Ca, cadmium, Cr, Cu, Fe, manganese (Mn), Ni, lead (Pb), S, vanadium (V), and Zn, were major in ultrafine particles. These elements should be attributed to the special manufacturing processes of electric products.     

The association between maternal nonylphenol exposure and parity on neonatal birth weight: A cohort study in Taiwan

Background

The aim of this study was to explore the association between NP exposure and parity and their effect on neonatal birth weight.

Methods

A cohort of pregnant women was established in a medical center in North Taiwan. Urinary NP concentration was determined by high-performance liquid chromatography coupled with fluorescent detection and adjusted using creatinine. A multivariable regression model was fit to determine the association between the maternal NP level in each trimester and neonatal birth weight. The odds ratios (ORs) of infant birth weight below the 10th, 25th, and 50th percentiles, comparing pregnant women with the different NP exposure levels, was estimated using a logistic regression.

Results

Of the 162 pregnant women in the study, 99 were multiparas and 63 were primiparas. After adjusting for other covariates, the NP level in the second trimester had a significant association with birth weight in the primiparas (β = −182.49 g, p value = 0.02). The OR of low infant birth weight, comparing pregnant women with different NP levels, was increased by decreasing the cutoff percentile for birth weight (OR = 1.18 for the 50th percentile, 2.12 for the 25th percentile, and 7.81 for the 10th percentile). The odds of primiparas with high NP level having a low neonatal birth weight increased to 3.87, 11.77, and 9.40 for the three different percentiles (p value < 0.05).

Conclusion

Maternal NP exposure level is associated with an increased risk of low neonatal weight. Primiparas are especially at risk, and the second trimester of pregnancy may be the critical stage of exposure.     

Will unit‐pricing enhance recycling?

Unit pricing is a program in solid waste management that integrates market instruments to encourage households to reduce waste generation and increase recycling. Many studies have shown that unit pricing is effective, especially when the evaluation is based on comparing outcomes before and after implementation. In this paper, we use the so-called difference-in-differences approach to evaluate unit pricing. This approach can provide a less-biased estimation, and can help to examine whether a unit pricing program generates less waste and higher recycling or results in illegal dumping in neighboring regions. Using the fee-per-bag program implemented in Taipei City, Taiwan, as a case study, we found that unit pricing does reduce the amount of garbage but its impact on recycling is not as significant as the current literature suggests. Moreover, the program causes a serious negative externality: more than 60%?of the garbage reduction in the city is due to increased dumping of waste in neighboring regions. As the impact of unit‐pricing on recycling is limited, policy-makers cannot rely solely on this program to enhance recycling in the management of municipal solid waste.     

Effects of emulsified asphalt on the mechanical properties of granulation of calcium fluoride sludge

Journal of Material Cycles and Waste Management - To reduce the landfill volume of waste CaF2 sludge, artificial fluorite bulk (AFB) is granulated by blending CaF2 sludge and emulsified asphalt...