西北干旱区中小城市水价探析

为了促进西北干旱区中小城市的快速、稳定的发展,解决该地区中小城市的水资源短缺问题,以水价作为出发点,充分利用水价格的经济杠杆作用,制定出该地区中小城市的水价。以西北干旱区中具有代表性的城市石河子为例,通过实地调研,得到石河子居民、居民生活用水情况、现行水价、居民家庭节水情况、居民的心理承受水价以及平时生活的节水意识等情况,通过分析,得出居民的心理承受偏低,现行水价仍有一定的上调空间,调价范围为1.58~2.31元/m3,最高可调至4.11元/m3。结合石河子的水价,为西北干旱区的中小城镇的水价改革、提高水资源的利用率等提出一些切实可行的建议。     

电渗析法再生CO_2电还原电解液的研究

探索了电渗析法再生CO2电还原电解液的可行性。以HCOOK溶液作为CO2电还原反应后的模拟液,采用单室电渗析装置对其进行再生,考察了电流、时间、温度等操作条件对电流效率和再生率的影响,研究结果表明:在常温条件下,操作电流低于极限电流时,采用电渗析法再生CO2电还原电解液具有高的电流效率和再生率。     

一体化接触氧化反应器处理景区生活污水

常州某旅游景区采用一体化生活污水处理装置处理该区生活污水,通过试验确定反应器的最佳工艺参数,研究表明采用接触氧化反应器处理农村污水,在反应器内溶解氧维持在2.0~4.0 mg/L,水力负荷为3.53 m3/(m3.d)的运行条件下,对COD、NH3-N及TN去除率分别达80.82%、69.12%、63.16%,出水可稳定达GB18918-2002《城镇污水处理厂污染物排放标准》一级标准。     

微电解-生化法处理大蒜废水工程实例

针对大蒜废水特点,采用了铁屑微电解-UASB-接触氧化工艺进行处理.运行结果表明:在设计进水水质、水量范围内,COD、BOD5、氨氮和ss去除率分别为98%、99%、70%和98%,出水各项指标均达到GB 8978--1996<污水综合排放标准>中的一级排放标准,系统运行费用为1.19元/m3.     

无机-有机复合絮凝剂PST处理印染废水效果研究

以模拟印染废水和实际印染废水为实验对象,检验了一种新合成有机-无机复合絮凝剂(PST)的絮凝效果。结果表明,PST具有良好的絮凝性能。在受试条件下,絮凝效果与絮凝剂投加量、染料浓度有较大相关性。废水的pH值应用范围较宽;搅拌时间对COD去除率和脱色率没有显著影响。采用PST处理广东省高明市某印染厂的印染废水后,COD去除率为75.16%,脱色率为76.18%,处理效果良好,处理成本明显低于目前市场上普遍使用的聚铝等絮凝剂。     

A~2/O工艺厌氧池有机物降解动力学模型对比研究

试验考察了东阿县污水处理厂一期A2/O工艺厌氧池去除有机污染物效能,当进水ρ(COD)为548.3 mg/L时,厌氧池平均去除率达78.7%。同时探讨了几种常见数学模型模拟厌氧池去除有机物规律情况,根据实际工程监测数据确定有机底物降解动力学常数,得出Grau模型、Stover-kincannon模型和改进的Monod模型较适合模拟厌氧池去除有机物的规律,并对模型进行了检验。     

低温水解酸化-A~2/O（PACT）-混凝沉淀处理印染废水

低温条件下对水解酸化-A2/O（PACT）-混凝沉淀组合工艺处理印染废水进行了中试研究。考察印染废水中COD和色度去除效果,结果表明：低温对工艺负面影响较大,未加粉末活性炭时好氧段COD和色度的去除率分别为42.6%和58.9%;投加粉末活性炭后,去除率分别达55.8%和65.4%,提高了13.2%和6.5%,显示出低...     

Competition of bloom-forming marine phytoplankton at low nutrient concentrations

Competition of three bloom-forming marine phytoplankton (diatom Skeletonema costatum, and dinoflagellates Prorocentrum minimum and Alexandrium tamarense) was studied through a series of multispecies cultures with di erent nitrate (NaNO3) and phosphate (NaH2PO4) levels and excess silicate to interpret red tide algae succession. S. costatum outgrew the other two dinoflagellates in nitrate and phosphate replete cultures with 10 mol/L Na2SiO3. Under nitrate limited (8.82 mol/L NaNO3) conditions, the growth of S. costatum was also dominant when phosphate concentrations were from 3.6 to 108 mol/L. Cell density of the two dinoflagellates only increased slightly, to less than 400 and 600 cells/mL, respectively. Cell density of S. costatum decreased with time before day 12, and then increased to 4000 cells/mL (1.5 mg/L dry biomass) at NaNO3 concentrations between 88.2 and 882 mol/L with limited phosphate (0.36 mol/L NaH2PO4) levels. In addition, P. minimum grew well with a maximal cell density of 1690–2100 cells/mL (0.5–0.6 mg/L dry biomass). Although S. costatum initially grew fast, its cell density decreased quickly with time later in the growth phase and the two dinoflagellates were dominant under the nitrate-limited and high nitrate conditions with limited phosphate. These results indicated that the diatom was a poor competitor compared to the two dinoflagellates under limited phosphate; however, it grew well under limited nitrate when growth of the dinoflagellates was near detection limits.     

Removal of copper ions from aqueous solution by calcium alginate immobilized kaolin

Kaolin has been widely used as an adsorbent to remove heavy metal ions from aqueous solutions. However, the lower heavy metal adsorption capacity of kaolin limits its practical application. A novel environmental friendly material, calcium alginate immobilized kaolin (kaolin/CA), was prepared using a sol-gel method. The e ects of contact time, pH, adsorbent dose, and temperature on Cu2+ adsorption by kaolin/CA were investigated. The Langmuir isotherm was used to describe the experimental adsorption, the maximum Cu2+ adsorption capacity of the kaolin/CA reached up to 53.63 mg/g. The thermodynamic studies showed that the adsorption reaction was a spontaneous and endothermic process.     

Removal of phosphate by Fe-coordinated amino-functionalized 3D mesoporous silicates hybrid materials

Phosphate removal from aqueous waste streams is an important approach to control the eutrophication downstream bodies of water. A Fe(III) coordinated amino-functionalized silicate adsorbent for phosphate adsorption was synthesized by a post-grafting and metal cation incorporation process. The surface structure of the adsorbent was characterized by X-ray di raction, N2 adsoropion/desoprotion technique, and Fourier transform infrared spectroscopy. The experimental results showed that the adsorption equilibrium data were well fitted to the Langmuir equation. The maximum adsorption capacity of the modified silicate material was 51.8 mg/g. The kinetic data from the adsorption of phosphate were fitted to pseudo second-order model. The phosphate adsorption was highly pH dependent and the relatively high removal of phosphate fell within the pH range 3.0–6.0. The coexistence of other anions in solutions has an adverse e ect on phosphate adsorption; a decrease in adsorption capacity followed the order of exogenous anions: F?? > SO2?? 4 > NO??3 > Cl??. In addition, the adsorbed phosphate could be desorbed by NaOH solutions. This silicate adsorbent with a large adsorption capacity and relatively high selectivity could be utilized for the removal of phosphate from aqueous waste streams or in aquatic environment.