Pollution levels and characteristics of phthalate esters in indoor air in hospitals

The concentrations of phthalate esters(PAEs) in Chinese hospitals were investigated by simultaneously determining concentrations of gas- and particle-phase PAEs. PAEs were detected in two third-class first-grade hospitals, two second-class first-grade hospitals, and a community health service center. Hospital drugstores had the highest concentration(24.19 μg/m3), which was 1.54 times that of newly decorated houses. The second highest concentration was found in the transfusion rooms, averaging 21.89 μg/m3; this was followed by the concentrations of PAEs in the nurse's workstations, the wards, and the doctor's offices, with mean concentrations of 20.66, 20.0, and 16.92 μg/m3, respectively. The lowest concentrations were found in the hallways(16.30 μg/m3). Of the six different kinds of PAEs found, major pollutants included diethyl phthalates, dibutyl phthalates, butylbenzyl phthalates and di(2-ethylhexyl) phthalates, comprising more than 80% of all PAEs present.Meanwhile, a comparison between different wards showed that PAE concentrations in the maternity wards were 1.63 times higher than in the main wards. Based on known health hazards, our results suggest that the PAEs seriously influence the health of the pregnant women and babies; therefore, it is of great importance to take the phthalate concentrations in hospitals into consideration. In addition, hospital indoor air was more seriously contaminated than the air of newly decorated houses.     

运动对急性暴露于2,3,7,8-四氯二苯并二恶英大鼠肝组织酶活性的影响

为了研究运动对2,3,7,8-四氯二苯并二恶英(2,3,7,8-TCDD)急性暴露大鼠肝组织酶活性的影响,将40只雄性Wistar大鼠随机分为正常对照组(NC)、染毒组(NT)、运动对照组(EC)、运动染毒组(ET)。染毒组(NT组与ET组)腹腔注射10μg·kg-1(以单位体重计)的TCDD,对照组(NC组与EC组)腹腔注射等量的玉米油;NT、NC组静养4周,ET、EC组运动(尾部负重5%游泳30分钟)4周。4周后,称重并宰杀大鼠,分离肝组织,称重后-80℃保存待测7-乙氧基异吩恶唑酮脱乙基酶(EROD)、7-乙氧基香豆素-O-脱乙基酶(ECOD)及芳香烃羟化酶(AHH)的活性。将数据进行多因素方差分析(MAVONA)处理,结果表明,染毒可降低大鼠体重,增加肝湿重和肝相对重量、增加EROD、ECOD活性;运动可增加大鼠肝相对重量、增加AHH的活性;染毒后运动可降低EROD、ECOD的活性。结论:急性10μg·kg-1(以单位体重计)TCDD染毒后4周可增加大鼠肝相对重量;4周的运动能有效降低TCDD对EROD、ECOD活性的激活作用。     

To roll or not to roll: nyctinastic behavior in young leaves of sacred lotus,Nelumbo nucifera

The Science of Nature -     

利用FOCMEC和CAP方法反演2021年大丰海域M5.0及天宁M4.2地震震源机制解∗

利用 FOCMEC 和 CAP 方法分别对大丰海域 M5.0 地震、天宁 M4.2 地震震源机制解进行反演,分析两种方法所得结果的差异。大丰海域 M5.0 地震 FOCMEC 方法与 CAP 方法计算震源机制解结果存在细微差异,CAP 方法所得结果与其它机构结果较为统一。天宁 M4.2 地震 FOCMEC 方法与 CAP 方法计算震源机制解结果基本一致。 通过研究发现 CAP 方法对台站分布要求不高,但需要地震震级较大,波形信噪比高,震相拟合度较好;FOCMEC 方法对地震震级要求不高,但需要震中位置被台站包围较好,且震中附近台站密度较高,P 波初动清晰。     

Diversity of methanotrophs in a simulated modified biocover reactor

A simulated landfill biocover microcosm consisting of a modifying ceramsite material and compost were investigated. Results show that the mixture can improve the material porosity and achieve a stable and highly efficient (100%) methane oxidation over an extended operating period. The diversity of the methanotrophic community in the microcosm was assessed. Type I methanotrophs were enhanced in the microcosm due to the increased air diffusion and distribution, whereas the microbial diversity and population density of type II methanotrophs were not significantly affected. Moreover, the type I methanotrophic community structure significantly varied with the reactor height, whereas that of type II methanotrophic communities did not exhibit a spatial variation. Phylogenetic analysis showed that type I methanotroph-based nested polymerase chain reaction-denaturing gradient gel electrophoresis (PCR-DGGE) resulted in the detection of eight different populations, most of which are related to Methylobacter sp., whereas that of type II resulted in the detection of nine different populations, most of which are related to Methylocystaceae. Methanotrophic community analysis also indicated that a number of new methanotrophic genera not closely related to any known methanotrophic populations were present.     

Evaluation of the emission characteristics of PCDD/Fs from electric arc furnaces

Distribution of PCDD/F (polychlorinated dibenzo-p-dioxin and polychlorinated dibenzofuran) congeners at two electric arc furnaces (EAFs) in Taiwan is evaluated via intensive stack sampling and analysis. Two kinds of exhaust system in EAFs including stack system and shutter system are selected for measuring dioxin emissions. In addition, dioxin emissions during oxidation and reduction stages at EAF-A were characterized. Results indicate that the PCDD/F concentration of stack gas in EAF-A was 4.39 ng/N m³ while total Toxic Equivalent Quantity (TEQ) concentration was 0.35 ng I-TEQ/N m³. The PCDD/F concentration of stack gas in EAF-B was 2.20 ng/N m³ and the TEQ concentration was 0.14 ng I-TEQ/N m³. 1,2,3,4,6,7,8-H_pCDF, OCDD and OCDF are the major contributors of the dioxin concentrations for two EAFs investigated and the percentage of PCDD/F in particulate phase increases as the chlorination level of the PCDD/F congener increases. The results obtained on gas/particulate partitioning of PCDD/Fs in flue gases prior to the APCD in EAFs indicate that more than 90% exists in particulate phase. In EAF-A, the PCDD/F concentration during oxidation stage is slightly higher than that measured during reduction stage, including the sampling points of CO converter outlet, prior to bag filter and stack. Majority of PCDD/Fs emitted from steel-making processes exists in particulate-phase (about 60–70%) at both EAFs investigated.     

Partitioning and removal of dioxin-like congeners in flue gases treated with activated carbon adsorption

Activated carbon adsorption is commonly used to control dioxin-like congener (PCDD/Fs and PCBs) emissions. Partitioning of PCDD/Fs and PCBs between vapor and solid phases and their removal efficiencies achieved with existing air pollution control devices (APCDs) at a large-scale municipal waste incinerator (MWI) and an industrial waste incinerator (IWI) are evaluated via intensive stack sampling and analysis. Those two facilities investigated are equipped with activated carbon injection (ACI) with bag filter (BF) and fixed activated carbon bed (FACB) as major PCDD/F control devices, respectively. Average PCDD/F and PCB concentrations of stack gas with ACI+BF as APCDs are 0.031 and 0.006ng-TEQ/Nm(3), and that achieved with FACB are 1.74 and 0.19ng-TEQ/Nm(3) in MWI and IWI, respectively. The results show that FACB could reduce vapor-phase PCDD/Fs and PCBs concentrations in flue gas, while the ACI+BF can effectively adsorb the vapor-phase dioxin-like congener and collect the solid-phase PCDD/Fs and PCBs in the meantime. Additionally, the results of the pilot-scale adsorption system (PAS) experimentation indicate that each gram activated carbon adsorbs 105-115ng-PCDD/Fs and each surface area (m(2)) of activated carbon adsorbs 10-25ng-PCDD/Fs. Based on the results of PAS experimentation, this study confirms that the surface area of mesopore+macropore (20-200A) of the activated carbon is a critical factor affecting PCDD/F adsorption capacity.     

Thermal hazard accident investigation of hydrogen peroxide mixing with propanone employing calorimetric approaches

Hydrogen peroxide (H₂O₂), historically, due to its broad applications in the chemical industries, has caused many serious fires and explosions around the world. Its thermal hazards may also be incurred by an incompatible reaction with other chemicals, and a runaway reaction may be induced in the last stage. This study applied thermal analytical methods to explore the H₂O₂ leading to these accidents by incompatibility and to discuss what might be formed by the upset situations. Thermal hazard analysis contained a solvent, propanone (CH₃COCH₃, so-called acetone), which was deliberately selected to mix with H₂O₂ for investigating the degree of thermal hazard. Differential scanning calorimetry (DSC) and vent sizing package 2 (VSP2) were employed to evaluate the thermal hazard of H₂O₂. The results indicated that H₂O₂ is highly hazardous while mixed with propanone, as a potential contaminant. The time to maximum rate (TMR) was used as emergency response time in the chemical industries. Therefore, TMR of H₂O₂ was calculated to be 70 min for runaway reaction (after T₀) and TMR of H₂O₂/propanone was discovered to be 27 min only. Fire and explosion hazards could be successfully lessened if the safety-related data are properly imbedded into manufacturing processes.