Laboratory and field evaluation of crystallized DOW 704 oil on the performance of the Well Impactor Ninety-Six fFine particulate matter fractionator

Subsequent to the 1997 promulgation of the Federal Reference Method (FRM) for monitoring fine particulate matter (PM2.5) in ambient air, U.S. Environmental Protection Agency (EPA) received reports that the DOW 704 diffusion oil used in the method's Well Impactor Ninety-Six (WINS) fractionator would occasionally crystallize during field use, particularly under wintertime conditions. Although the frequency of occurrence on a nationwide basis was low, uncertainties existed as to whether crystallization of the DOW 704 oil may adversely affect a sampling event's data quality. In response to these concerns, EPA and the State of Connecticut Department of Environmental Protection jointly conducted a series of specialized tests to determine whether crystallized oil adversely affected the performance of the WINS fractionator. In the laboratory, an experimental setup used dry ice to artificially induce crystallization of the diffusion oil under controlled conditions. Using primary polystyrene latex calibration aerosols, standard size-selective performance tests of the WINS fractionator showed that neither the position nor the shape of the WINS particle size fractionation curve was substantially influenced by the crystallization of the DOW 704 oil. No large particle bounce from the crystallized impaction surface was observed. During wintertime field tests, crystallization of the DOW 704 oil did not adversely affect measured PM2.5 concentrations. Regression of measurements with crystallized DOW 704 versus liquid dioctyl sebacate (DOS) oil produced slope, intercept, and R2 values of 0.98, 0.1, and 0.997 microg/m3, respectively. Additional field tests validated the use of DOS as an effective impaction substrate. As a result of these laboratory and field tests, DOS oil has been approved by EPA as a substitute for DOW 704 oil. Since the field deployment of DOS oil in 2001, users of this alternative oil have not reported any operational problems associated with its use in the PM2.5 FRM. Limited field evaluation of the BGI very sharp cut cyclone indicates that it provides a viable alternative to the WINS fractionator.     

Source apportionment of fine particulate matter in the southeastern United States

Particulate matter (PM) less than 2.5 microm in size (PM2.5) source apportionment by chemical mass balance receptor modeling was performed to enhance regional characterization of source impacts in the southeastern United States. Secondary particles, such as NH4HSO4, (NH4)2SO4, NH4NO3, and secondary organic carbon (OC) (SOC), formed by atmospheric photochemical reactions, contribute the majority (>50%) of ambient PM2.5 with strong seasonality. Source apportionment results indicate that motor vehicle and biomass burning are the two main primary sources in the southeast, showing relatively more motor vehicle source impacts rather than biomass burning source impacts in populated urban areas and vice versa in less urbanized areas. Spatial distributions of primary source impacts show that each primary source has distinctively different spatial source impacts. Results also find impacts from shipping activities along the coast. Spatiotemporal correlations indicate that secondary particles are more regionally distributed, as are biomass burning and dust, whereas impacts of other primary sources are more local.     

Identification and interpretation of representative ozone distributions in association with the sea breeze from different synoptic winds over the coastal urban area in Korea

To aid the studies of long-term impact assessment of cumulative ozone (O3) exposures, the representative 8-hr O3 pollution patterns have been identified over the Greater Seoul Area (GSA) in Korea. Principal component analysis and two-stage clustering techniques were used to identify the representative O3 patterns, and numerical and observational analyses were also used to interpret the identified horizontal distribution patterns. The results yielded three major O3 distribution patterns, and each of the three patterns was found to have strong correlations with local and synoptic meteorological conditions over the GSA. For example, pattern 1, accounting for 46% of O3 concentration distributions, mostly occurred under relatively weak westerly synoptic winds. The predominant features of this pattern were infrequent high O3 levels but a distinct gradient of O3 concentration from the western coastal area to the eastern inland area that was mainly induced by the local sea breeze. Pattern 2, accounting for 31% of O3 concentration distributions, was found with higher O3 levels in the western coastal area but lower in the eastern inland area. This is due to the modified sea breeze under the relatively stronger easterly opposing synoptic wind, affecting the high O3 occurrence in the western coastal area only. However, pattern 3, accounting for 21% of O3 concentration distributions, showed significantly higher O3 concentrations over the whole GSA mainly due to the retarded and slow-moving sea-breeze front under the weak opposing synoptic flow. Modeling study also indicated that local and synoptic meteorological processes play a major role in determining the high O3 concentration distribution patterns over the GSA.     

Phosphorus Load Reduction Goals for Feitsui Reservoir Watershed, Taiwan

The present paper describes an effort for developing the total maximum daily load (TMDL) for phosphorus and a load reduction strategy for the Feitsui Reservoir in Northern Taiwan. BASINS model was employed to estimate watershed pollutant loads from nonpoint sources (NPS) in the Feitsui Reservoir watershed. The BASINS model was calibrated using field data collected during a 2-year sampling period and then used to compute watershed pollutant loadings into the Feitsui Reservoir. The simulated results indicate that the average annual total phosphorus (TP) loading into the reservoir is 18,910 kg/year, which consists of non-point source loading of 16,003 kg/year, and point source loading of 2,907 kg/year. The Vollenweider mass balance model was used next to determine the degree of eutrophication under current pollutant loading and the load reduction needed to keep the reservoir from being eutrophic. It was estimated that Feitsui Reservoir can becoming of the oligotrophic state if the average annual TP loading is reduced by 37% or more. The results provide the basis on which an integrated control action plan for both point and nonpoint sources of pollution in the watershed can be developed.     

Percentile estimation using variable censored data

Much progress has been made in recent years to address the estimation of summary statistics, using data that are subject to censoring of results that fall below the limit of detection (LOD) for the measuring instrument. Truncated data methods (e.g., Tobit regression) and multiple-imputation are two approaches for analyzing data results that are below the LOD. To apply these methods requires an assumption about the underlying distribution of the data. Because the log-normal distribution has been shown to fit many data sets obtained from environmental measurements, the common practice is to assume that measurements of environmental factors can be described by log-normal distributions. This article describes methods for obtaining estimates of percentiles and their associated confidence intervals when the results are log-normal and a fraction of the results are below the LOD. We present limited simulations to demonstrate the bias of the proposed estimates and the coverage probability of their associated confidence intervals. Estimation methods are used to generate summary statistics for 2,3,7,8-tetrachloro dibenzo-p-dioxin (2,3,7,8-TCDD) using data from a 2001 background exposure study in which PCDDs/PCDFs/cPCBs in human blood serum were measured in a Louisiana population. Because the congener measurements used in this study were subject to variable LODs, we also present simulation results to demonstrate the effect of variable LODs on the multiple-imputation process.     

Partitioning of hydrogen peroxide between the gas and liquid phases in the presence of surfactant

Gas-liquid phase partitioning is a key physical property that can predict the environmental fate of a compound between two phases. Several environmental factors have been known to affect the gas-liquid phase partitioning. We investigated the influence of surfactant on the gas-liquid phase partitioning of hydrogen peroxide (H(2)O(2)). The surfactant used was ammonium perfluorooctanoate (APFO). H(2)O(2) solution containing the surfactant was equilibrated in a closed system and gas phase H(2)O(2) concentration was measured by the peroxyoxalate chemiluminescence (PO-CL) method. Gas phase H(2)O(2) concentrations remained constant below the critical micelle concentration (CMC) and increased linearly with surfactant concentration above the CMC, which indicated that surfactant micelles influenced the gas-liquid phase partitioning of H(2)O(2). This result showed that H(2)O(2)-micelle interactions are less favorable than H(2)O(2)-H(2)O interactions. Surfactant monomers did not affect the gas-liquid phase partitioning of H(2)O(2) due to the absence of micelles. Solvent (methanol) effect was also investigated and showed that gas phase H(2)O(2) concentrations increased with the addition of solvent. This indicated the unfavorable interaction of H(2)O(2) with hydrophobic medium compared to hydrophilic one. It is consistent with the result that H(2)O(2)-micelles has a weaker interaction than H(2)O(2)-water because surfactant micelles are hydrocarbon-like organic phase rather than aqueous phase.     

Polychlorinated biphenyl contamination trends in Lake Hartwell, South Carolina (USA): sediment recovery profiles spanning two decades

To assess the ca. 20-year polychlorinated biphenyl (PCB) contamination trends in Lake Hartwell, SC, sediment cores from the Twelve Mile Creek arm were collected in July 2004 at two sites (G30 and G33) first sampled in the mid-1980s. Congener-specific PCB data as a function of depth from the sediment-water interface for the 2004 sediment samples were compared to data obtained from 1987 and 1998 samples taken from the same locations. Despite modest decreases in total PCB levels near the G30 sediment-water interface, historical increases in average degrees of chlorination may elevate the overall toxic risk at this site. Unlike G30, the more rapid recovery in the near-surface sediment of G33 suggests that the effectiveness of the U.S. EPA natural attenuation record of decision is site-specific and is unlikely to result in uniform surface sediment recovery throughout the most contaminated regions of Lake Hartwell.     

Phosphorus supply influences heathland responses to atmospheric nitrogen deposition

On an upland moor dominated by pioneer Calluna vulgaris and with an understorey of mosses and lichens, experimental plots were treated with factorial combinations of nitrogen (N) at +0 and +20kg Nha(-1)yr(-1), and phosphorus (P) at +0 and +5kg Pha(-1)yr(-1). Over the 4-year duration of the experiment, the cover of the Calluna canopy increased in density over time as part of normal phenological development. Moss cover increased initially in response to N addition but then remained static; increases in cover in response to P addition became stronger over time, eventually causing reductions in the cover of the dominant Calluna canopy. Lichen cover virtually disappeared within 4 years in plots receiving +20kg Nha(-1)yr(-1) and also in separate plots receiving +10kg Nha(-1)yr(-1), but this effect was reversed by the addition of P.     

Use of inert C&D materials for seawall foundation: quality control measures

The technical viability of using inert construction and demolition (C&D) materials for the construction of seawall and breakwater foundations has been established by laboratory testing of the materials, numerical analysis of foundation stability, and a pilot field-scale engineering performance evaluation. However, quality control measures are still required so that only suitable materials are used for seawall and breakwater foundation construction. The development of different quality control measures for different site conditions is presented in this paper. The rationale, practicality, and implementation of these quality control measures are also discussed.