Effects of open burning of rice straw on concentrations of atmospheric polycyclic aromatic hydrocarbons in central Taiwan

The sizes and concentrations of 21 atmospheric polycyclic aromatic hydrocarbons (PAHs) were measured at Jhu-Shan (a rural site) and Sin-Gang (a town site) in central Taiwan in October and December 2005. Air samples were collected using semi-volatile sampling trains (PS-1 sampler) over 16 days for rice-straw burning and nonburning periods. These samples were then analyzed using a gas chromatograph with a flame-ionization detector (GC/FID). Particle-size distributions in the particulate phase show a bimode, peaking at 0.32-0.56 microm and 3.2-5.6 microm at the two sites during the nonburning period. During the burning period, peaks also appeared at 0.32-0.56 microm and 3.2-5.6 microm at Jhu-Shan, with the accumulation mode (particle size between 0.1 and 3.2 microm) accounting for approximately 74.1% of total particle mass. The peaks at 0.18-0.32 microm and 1.8-3.2 microm at Shin-Gang had an accumulation mode accounting for approximately 70.1% of total particle mass. The mass median diameter (MMD) of 3.99-4.35 microm in the particulate phase suggested that rice-straw burning generated increased numbers of coarse particles. The concentrations of total PAHs (sum of 21 gases + particles) at the Jhu-Shan site (Sin-Gang site) were 522.9 +/- 111.4 ng/ml (572.0 +/- 91.0 ng/ml) and 330.1 +/- 17.0 ng/ml (or 427.5 +/- 108.0 ng/ml) during burning and nonburning periods, respectively, accounting for a roughly 58% (or 34%) increase in the concentrations of total PAHs due to rice-straw burning. On average, low-weight PAHs (about 87.0%) represent the largest proportion of total PAHs, followed by medium-weight PAHs (7.1%), and high-weight PAHs (5.9%). Combustion-related PAHs during burning periods were 1.54-2.57 times higher than those during nonburning periods. The results of principal component analysis (PCA)/absolute principal component scores (APCS) suggest that the primary pollution sources at the two sites are similar and include vehicle exhaust, coal/wood combustion, incense burning, and incineration emissions. Open burning of rice straw was estimated to contribute approximately 5.0-33.5% to the total atmospheric PAHs at the two sites.     

Inter-simple sequence repeat markers reveal strong genetic differentiation among populations of the endangered mollusc Patella ferruginea (Gastropoda: Patellidae) from two Sardinian marine protected areas

The giant Mediterranean limpet Patella ferruginea Gmelin, 1791 is an endangered marine gastropod, whose range has progressively shrinked to few, restricted areas, due to intense human exploitation. We have studied the genetic structure of the species, in order to (1) gather information about the levels of genetic variability within and between natural populations of P. ferruginea collected in two Sardinian marine protected areas (MPAs) (Penisola del Sinis—Isola di Mal di Ventre and Isola dell’ Asinara), and (2) make an attempt to find relationships between ecological and biological attributes of the species and the genetic differentiation of the populations studied. The genetic study was carried out by means of the analysis of ten inter-simple sequence repeat (ISSR) primers on a total of 40 individuals collected at four localities. Genetic analysis evidenced (1) medium to high levels of within-population genetic variability, (2) a pattern of genetic structuring that varied with spatial scales, and (3) a strong genetic differentiation between the two MPAs. Although preliminary, these results suggest that gene flow may be present only at very small geographic scale, raising concerns on the future of the conservation of the species.     

Comprehensive analysis of the carbon impacts of vehicle intelligent speed control

In recent years sophisticated technologies have been developed to control vehicle speed based on the type of road the vehicle is driven on using Global Positioning Systems and in-car technology that can alter the speed of the vehicle. While reducing the speed of road vehicles is primarily of interest from a safety perspective, vehicle speed is also an important determinant of vehicle emissions and thus these technologies can be expected to have impacts on a range of exhaust emissions. This work analyses the results from a very large, comprehensive field trial that used 20 instrumented vehicles with and without speed control driven almost 500,000 km measuring vehicle speed at 10 Hz. We develop individual vehicle modal emissions models for CO₂ for 30 Euro III and Euro IV cars at a 1-Hz time resolution. Generalized Additive Models were used to describe how emissions from individual vehicles vary depending on their driving conditions, taking account of variable interactions and time-lag effects. We quantify the impact that vehicle speed control has on-vehicle emissions of CO₂ by road type, fuel type and driver behaviour. Savings in CO₂ of ≈6% were found on average for motorway-type roads when mandatory speed control was used compared with base case conditions. For most other types of road, speed control has very little effect on emissions of CO₂ and in some cases can result in increased emissions for low-speed limit urban roads. We also find that there is on average a 20% difference in CO₂ emission between the lowest and highest emitting driver, which highlights the importance of driver behaviour in general as a means of reducing emissions of CO₂.     

Simple model for estimating dry deposition velocity of ozone and its destruction in a polluted nocturnal boundary layer

Determining the destructions of both ozone and odd oxygen, O_x, in the nocturnal boundary layer (NBL) is important to evaluate the regional ozone budget and overnight ozone accumulation. This work develops a simple method to determine the dry deposition velocity of ozone and its destruction at a polluted nocturnal boundary layer. The destruction of O_x can also be determined simultaneously. The method is based on O₃ and NO₂ profiles and their surface measurements. Linkages between the dry deposition velocities of O₃ and NO₂ and between the dry deposition loss of O_x and its chemical loss are constructed and used. Field measurements are made at an agricultural site to demonstrate the application of the model. The model estimated nocturnal O₃ dry deposition velocities from 0.13 to 0.19 cm s^?1, very close to those previously obtained for similar land types. Additionally, dry deposition and chemical reactions account for 60 and 40% of the overall nocturnal ozone loss, respectively; ozone dry deposition accounts for 50% of the overall nocturnal loss of O_x, dry deposition of NO₂ accounts for another 20%, and chemical reactions account for the remaining 30%. The proposed method enables the use of measurements made in typical ozone field studies to evaluate various nocturnal destructions of O₃ and O_x in a polluted environment.     

Effect of air-drying and oven-drying treatment on Cr(VI) content and Cr bond forms in soil

Air-drying and oven-drying are pretreatment processes often used before testing and analyzing various soil characteristics in the laboratory. This study selected three kinds of soil, including red soil, entisol, and alluvial soil, and examined the variation of the Cr(VI) content and Cr bond forms in these soils during air-drying and oven-drying. The results show that when the soil is air-dried in natural environment, the Cr(VI) content decreases with air-drying time. On day 10 of air-drying, the Cr(VI) content in these soils is 22.8～47.9 % of the initial value. When the soil is oven-dried, the Cr(VI) concentration decays faster; on day 8, the Cr(VI) is no longer detected in these soil samples. When the Cr(VI)-contaminated soil is treated by air-drying and oven-drying, the Cr bond form converts into a more stable form. After oven-drying, the Cr mainly exists in Fe–Mn oxide form, organic bond form, and residual form. The air-drying and oven-drying pretreatment processes of soil reduce the Cr(VI) content and stabilize the Cr bond form. If the laboratory analytic results are applied to risk analysis or remediation strategy planning for chromium-contaminated soil, the toxicity, bioavailability, and mobility of Cr in soil may be underrated.     

An isolated AC module for photovoltaic energy conversion

In this paper, an isolated ac module with pseudo dc-link and galvanic isolation is proposed for photovoltaic energy conversion. The studied grid-tie ac module can individually extract the maximum solar power from each photovoltaic panel and transfer to ac utility system. It consists of an interleaved active-clamping single-ended primary-inductive circuit (SEPIC) with a secondary voltage doubler, a full-bridge polarity selector operating under line frequency to achieve high efficiency. For the studied topology, key features such as reduced input current ripple, zero-voltage switching (ZVS) of primary switches, low reverse-recovery current of the output diodes, and lower switch voltage stress are obtained. Also, to reduce input current ripple, an interleaved control strategy is adopted. A simple control strategy is proposed to generate a rectified sinusoidal waveform voltage at the pseudo dc-link capacitors and achieve the high maximum power point tracking (MPPT) accuracy. The operation principles and design considerations of the studied ac module are analyzed and discussed. A prototype with 25–60 V dc input, 110 V/60 Hz ac output and 150 W power rating has been constructed for verifying the feasibility of the proposed ac module.     

Spatial distribution of ciguateric fish in the Republic of Kiribati

Ciguatera is food poisoning caused by human consumption of reef fish contaminated with ciguatoxins (CTXs). The expanding international trade of tropical fish species from ciguatera-endemic regions has resulted in increased global incidence of ciguatera, and more than 50 000 people are estimated to suffer from ciguatera each year worldwide. The Republic of Kiribati is located in the Pacific Ocean; two of its islands, Marakei and Tarawa, have been suggested as high-risk areas for ciguatera. The toxicities of coral reef fish collected from these islands, including herbivorous, omnivorous and carnivorous fish (24% [n = 41], 8% [n = 13] and 68% [n = 117], respectively), were analyzed using the mouse neuroblastoma assay (MNA) after CTX extraction. The MNA results indicated that 156 fish specimens, or 91% of the fish samples, were ciguatoxic (CTX levels >0.01 ng g⁻¹). Groupers and moray eels were generally more toxic by an order of magnitude than other fish species. All of the collected individuals of eight species (n = 3-19) were toxic. Toxicity varied within species and among locations by up to 10 000-fold. Cephalapholis argus and Gymnothorax spp. collected from Tarawa Island were significantly less toxic than those from Marakei Island, although all individuals were toxic based on the 0.01 ng g⁻¹ threshold. CTX concentrations in the livers of individuals of two moray eel species (Gymnothorax spp., n = 6) were nine times greater than those in muscle, and toxicity in liver and muscle showed a strong positive correlation with body weight. The present study provides quantitative information on the ciguatoxicity and distribution of toxicity in fish for use in fisheries management and public health.     

Review of the progress in preparing nano Ti02： An important environmental engineering material

TiO2 nanomaterial is promising with its high potential and outstanding performance in photocatalytic environmental applications, such as CO2 conversion, water treatment, and air quality control. For many of these applications, the particle size, crystal structure and phase, porosity, and surface area influence the activity of TiO2 dramatically. TiO2 nanomaterials with special structures and morphologies, such as nanospheres, nanowires, nanotubes, nanorods, and nanoflowers are thus synthesized due to their desired characteristics. With an emphasis on the different morphologies of TiO2 and the influence factors in the synthesis, this review summarizes fourteen TiO2 preparation methods, such as the sol-gel method, solvothermal method, and reverse micelle method. The TiO2 formation mechanisms, the advantages and disadvantages of the preparation methods, and the photocatalytic environmental application examples are proposed as well.     

节能型虹吸式滗水器的设计与应用

详细介绍了虹吸式滗水器的构成、特点及工作原理,结合理论和实践经验给出了虹吸式滗水器的设计、计算方法及关键设计参数,提出了常规使用方法,整套设备的设计全面而简单明了。     

用代处置手段加强危险废物的管理

代处置是危险废物管理的强制手段，是行政代执行的具体表现形式之一。行政代执行作为一项间接强制措施，在国外立法中已被广泛采用。本文从危险废物代处置的概念、条件、要求、程序等方面进行了分析，为环保部门运用代处置措施进行危险废物管理提供参考。