Charge reduction on polypropylene granules and suppression of incendiary electrostatic discharges by using a novel AC electrostatic ionizer

As a method to prevent or mitigate electrostatic charge and/or discharges, we have developed a novel AC electrostatic ionizer. In this study, we evaluated experimentally the practical version of the novel AC electrostatic ionizer with a modeling test system and a pneumatic powder transport facility. In addition, electrostatic discharges generated inside a silo while loading polypropylene (PP, 3 mm) granules were observed visually with/without the novel AC ionizer. The specific charge was clearly decreased with the novel AC electrostatic ionizer. The specific charge obtained with the four arranged AC electrostatic ionizers used was approximately one eighth of that without the AC ionizer. The incendiary bulk surface discharges completely died out inside the silo by using the four arranged ionizers.     

Properties of alkali-activated systems with stone powder sludge

This article investigates the effects of stone powder sludge on the microstructure and strength development of alkali-activated fly ash and blast furnace slag mixes. Stone powder sludge produced from a crushed aggregate factory was used to replace fly ash and granulated blast furnace slag at replacement ratios of 0%, 10%, 20%, and 30% by mass. The unit weight and compressive strength of the samples were measured, and scanning electron microscopy/energy dispersive spectroscopy and X-ray diffraction (XRD) analyses were performed. The test results indicated that the compressive strength of alkali-activated blast furnace slag mixes using stone powder sludge was higher than that of the alkali-activated blast furnace slag control mix, but the compressive strength of alkali-activated fly ash mixes decreased with increasing replacement ratio of stone powder sludge. Microscopy results indicated that for alkaliactivated blast furnace slag samples, broken surfaces were more evident than for the alkali-activated fly ash samples. For all XRD diagrams, broad and diffuse peaks were observed around 2θ = 35° (d = 2.96–3.03 Å), implying amorphous or short-ordering structure phases.     

Changes in air saturation and air-water interfacial area during surfactant-enhanced air sparging in saturated sand

Reduction in the surface tension of groundwater, prior to air sparging for removal of volatile organic contaminant from aquifer, can greatly enhance the air content and the extent of influence when air sparging is implemented. However, detailed information on the functional relationship between water saturation, air-water contact area induced by air sparging and the surface tension of water has not been available. In this study, the influence of adding water-soluble anionic surfactant (sodium dodecyl benzene sulfonate) into groundwater before air sparging on the air-water interfacial area and water saturation was investigated using a laboratory-scale sand packed column. It was found that water saturation decreases with decreasing surface tension of water until it reaches a point where this trend is reversed so that water saturation increases with further decrease in the surface tension. The lowest water saturation of 0.58 was achieved at a surface tension of 45.4 dyn/cm, which is considered as the optimum surface tension for maximum de-saturation for the initially water-saturated sand used in this study. The air-water contact area generated in the sand column due to air sparging was measured using a gaseous interfacial tracer, n-decane, and was found to monotonically increase with decreasing water saturation. The results of this study provide useful design information for surfactant-enhanced air sparging removal of volatile contaminants from aquifers.     

Effects of in-situ ozonation on indigenous microorganisms in diesel contaminated soil: survival and regrowth

Soil column experiments were conducted to investigate the effects of chemical oxidation on the survival of indigenous microbes (i.e., heterotrophic microbes, phenanthrene-degrading microbes, and alkane-degrading microbes) for field soil contaminated with diesel fuel. Rapid decreases of total petroleum hydrocarbons (TPH) and aromatics of diesel fuel were observed within the first 60 min of ozone injection; after 60 min, TPH and aromatics decreased asymptotically with ozonation time. The three types of indigenous microbes treated were very sensitive to ozone in the soil column experiment, hence the microbial population decreased exponentially with ozonation time. The numbers of heterotrophic, alkane-degrading, and phenanthrene-degrading bacteria were reduced from 10(8) to 10(4), 10(7) to 10(3), and 10(6) CFU g soil(-1) to below detection limit after 900 min of ozonation, respectively. Except for the soil sample ozonated for 900 min, incubation of ozone-treated soil samples that were not limited by oxygen diffusion showed further removal of TPH. The soil samples that were ozonated for 180 min exhibited the lowest concentration of TPH and the highest regrowth rate of the heterotrophic and alkane-degrading populations after the 9 weeks of incubation.     

Health risk assessment and source apportionment of PM2.5-bound toxic elements in the industrial city of Siheung,Korea

Environmental Science and Pollution Research - The emission sources and their health risks of fine particulate matter (PM2.5) in Siheung, Republic of Korea, were investigated as a middle-sized...     

Characteristics of biotic and abiotic removals of dissolved organic carbon in wastewater effluents using soil batch reactors.

Biodegradable dissolved organic carbon (BDOC) analyses and abiotic adsorption of dissolved organic carbon (DOC) from different wastewater effluent were conducted to evaluate biotic and abiotic removal mechanisms as a function of the initial DOC concentration and source of DOC using soil batch reactors. To obtain high DOC concentrations, a laboratory-scale reverse osmosis unit was used. It was found that BDOC fraction was independent of the initial DOC concentration and was dependent on the source of wastewater and/or the types of wastewater treatment. The BDOC fractions varied from 9 to 73%. Trickling filter effluent (Tucson, Arizona) showed the highest BDOC, ranging from 65 to 73% biodegradable, while wastewater treated by the soil aquifer treatment (SAT) (NW-4) was found to be most refractory, with DOC removals of 9 to 14%. For nitrified/denitrified tertiary effluent (Mesa, Arizona) and secondary effluent (Scottsdale, Arizona), 36 to 42% removal of DOC was observed during the BDOC test. The amount of BDOC in the wastewater depended not on the concentration of DOC, but on the effectiveness of pretreatment. Abiotic adsorption capacity of wastewater effluent varied from 6 to 18%. Molecular weight distribution analyses showed that more than 50% of DOC in the Scottsdale concentrate had a molecular weight of less than 1000 Da, and no significant change in distribution profiles occurred after approximately 12% abiotic adsorption with both soils with acclimated microorganisms (SAT soil) and soils without acclimated microorganisms (non-SAT soils). Hence, preferential adsorption was not observed and the presence of acclimated microbes did not influence adsorption.     

Upgrading food wastes by means of bromelain and papain to enhance growth and immunity of grass carp (<Emphasis Type="Italic">Ctenopharyngodon idella</Emphasis>)

The fast growing of global aquaculture industry accompanied with increasing pressure on the supply and price of traditional feed materials (e.g., fish meal and soy bean meal). This circumstance has urged the need to search alternative sources of feed stuff. Food waste was used as feed stuff in rearing fish which possess substantial protein and lipid. Grass carp are major species reared in Hong Kong with lower nutritional requirements; it is also an ideal species for investigating the feasibility of using food waste as fish feeds for local aquaculture industry. The growth and immunity, reflected by total protein, total immunologlobulin (IgI), and nitroblue tetrazolium (NBT) activity of grass carp blood, were depressed when feeding with food waste feeds without enzymes. However, the supplementation of bromelain and papain in fish feed enhanced the efficient use of food waste by grass carp, which in turn improved the fish immunity. The present results indicated that the addition of those enzymes could enhance the feed utilization by fish and hematological parameters of grass carp, and the improvement on growth and immunity superior to the control (commercial feed) was observed with the addition of bromelain and papain supplement. Addition of 1 and 2 % mixture of bromelain and papain could significantly enhance the lipid utilization in grass carp.     

Gliding arc plasma processing for decomposition of chloroform

The decomposition of chloroform (CHCl₃) diluted in air was studied. The experiment was carried out by using a gliding arc plasma. Different values of initial concentrations of chloroform, total gas flow rates, and input power frequencies have been used to investigate this effects on the conversion reaction products both qualitatively and quantitatively. Experimental results indicate that the maximum conversion of chloroform was 97% at a total gas flow rate of 180?L?h^?1 containing 1% chloroform. Using air as carrier gas, decomposition of CHCl₃ produces CCl₄, CO₂, CO, and Cl₂ as the main products. Small amounts of HCl and COCl₂ are also detected. Liquid products were also produced.     

Space-time stick-breaking processes for small area disease cluster estimation

We propose a space-time stick-breaking process for the disease cluster estimation. The dependencies for spatial and temporal effects are introduced by using space-time covariate dependent kernel stick-breaking processes. We compared this model with the space-time standard random effect model by checking each model’s ability in terms of cluster detection of various shapes and sizes. This comparison was made for simulated data where the true risks were known. For the simulated data, we have observed that space-time stick-breaking process performs better in detecting medium- and high-risk clusters. For the real data, county specific low birth weight incidences for the state of South Carolina for the years 1997–2007, we have illustrated how the proposed model can be used to find grouping of counties of higher incidence rate.     

Photocatalytic bacterial inactivation by polyoxometalates

The photocatalytic inactivation (PCI) of Escherichia coli (Gram-negative) and Bacillus subtilis (Gram-positive) was performed using polyoxometalate (POM) as a homogeneous photocatalyst and compared with that of heterogeneous TiO₂ photocatalyst. Aqueous suspensions of the microorganisms (10⁷–10⁸ cfu ml⁻¹) and POM (or TiO₂) were irradiated with black light lamps. The POM-PCI was faster than (or comparable to) TiO₂-PCI under the experimental conditions employed in this study. The relative efficiency of POM-PCI was species-dependent. Among three POMs (H₃PW₁₂O₄₀, H₃PMo₁₂O₄₀, and H₄SiW₁₂O₄₀) tested in this study, the inactivation of E. coli was fastest with H₄SiW₁₂O₄₀ while that of B. subtilis was the most efficient with H₃PW₁₂O₄₀. Although the biocidal action of TiO₂ photocatalyst has been commonly ascribed to the role of photogenerated reactive oxygen species such as hydroxyl radicals and superoxides, the cell death mechanism with POM seems to be different from TiO₂-PCI. While TiO₂ caused the cell membrane disruption, POM did not induce the cell lysis. When methanol was added to the POM solution, not only the PCI of E. coli was enhanced (contrary to the case of TiO₂-PCI) but also the dark inactivation was observed. This was ascribed to the in situ production of formaldehyde from the oxidation of methanol. The interesting biocidal property of POM photocatalyst might be utilized as a potential disinfectant technology.