Remediation of contaminated soil by a solvent/surfactant system

This study investigates a new approach using a solvent/surfactant-aided soil-washing process to improve the performance of conventional surfactant-aided soil remediation. Three surfactants (Brij 35, Tween 80, and SDS) and three organic solvents (acetone, triethylamine, and squalane) were used to evaluate the desorption performances of 4,4'-dichlorobiphenyl (DCB) out of three soils with different sorption characteristics. The performance improvement is likely due to better dissolution of the hydrophobic contaminants from the soil assisted by the solvent, and the formation of solvent-incorporated surfactant micelles, which increases both the size (i.e. capacity) and affinity of micelles for more effective contaminant extraction. The foc of soils were found to be important in determining the performance of a solvent/surfactant-aided soil-washing process. Judging from the experimental data and as verified by the two constants in the proposed soil-washing model, as the organic solvent is coexisting with the surfactant micelles, both the marginal soil-washing performance (right after the use of a very small amount of solvent compared to that of none) and the final soil-washing capacity are increased compared to those of a pure surfactant-aided washing process.     

河源夏季臭氧污染特征及其成因

2015年9月至2016年8月,在广东河源城区内采用在线连续观测,分析该地区近地面臭氧(O_3)及其前体物的变化规律和相关性,重点探讨了夏季O_3污染特征及成因。结果表明,河源市城区O_3总超标天数为10 d,主要集中在7—9月。O_3浓度变化呈现明显的春、冬季低,夏、秋季高的季节变化。O_3浓度日变化呈典型单峰特征,前体物主要呈双峰变化。O_3小时浓度和CO无明显的相关性,与NO2浓度呈现较高的负相关关系;气象及HYSPLIT-4模型计算综合分析结果表明,夏季污染时段河源高空、低空气团大部来自西南方向,夏季O_3污染主要来源于珠三角区域传输和本地源排放。     

油墨油脂废水生物接触氧化法研究

本文通过试验研究了油墨油脂废水用生物接触氧化处理的可行性,指出微生物必须要经过驯化过程,使其对该种废水有很好的适应性,才能保证处理稳定。     

阿卡波糖生产废水的光催化降解工艺研究

在实验室用溶胶-凝胶法合成一种复合光催化剂,以难生化降解的阿卡波糖废水作为降解对象,研究经光催化降解后的废水,对后续生化装置的影响。     

Short-term prediction of urban PM2.5 based on a hybrid modified variational mode decomposition and support vector regression model

Environmental Science and Pollution Research - PM2.5 (particulate matter with a size/diameter ≤ 2.5 μm) is an important air pollutant that affects human health, especially...     

Violence‐prevention climate,exposure to violence and aggression,and prevention behavior: A mediation model

This study explored mechanisms underlying employees' behaviors targeted at preventing workplace physical violence and verbal aggression. Poor psychological violence‐prevention climate perceptions and previous exposure to violence and aggression represent stressors that were associated with increased strains and reduced motivation. Strains and motivation, in turn, were related to prevention behaviors. We collected data from employee and coworker dyads, and structural equation modeling results supported that clear organizational policies, prompt management responses to assaults, and putting safety as a priority contributed positively to prevention behaviors through reduced strains and increased motivation. On the other hand, prior experiences of being attacked were related to more strains and lower motivation, which were related to lower prevention compliance. Our results inform future interventions for violence prevention. Copyright © 2011 John Wiley & Sons, Ltd.     

Feasibility study on high-temperature sorption of hydrogen sulfide by natural soils

In this study, seven natural soils were tested for the sorption of hydrogen sulfide from coal gasification gas at high temperature. Results indicate that the LP natural soil has the best performance and the highest sulfur sorption capacity. After extracting free iron oxides, most natural soils have no sorption efficiency. The free iron oxides, therefore, proved to be the major components that react with hydrogen sulfide to form iron sulfides. The sulfur sorption capacity, either determined by EA or breakthrough time, is very close to the theoretical value based on the stoichiometric calculation with the content of free iron oxides. Moreover, the presence of CO is a positive effect while H2 is a negative effect. This can be explained via the water-shift reaction. On the basis of the results of temperature-programmed sulfidation (TPS), the starting temperature for the sorption of hydrogen sulfide is between 623-673 K. From the analyses of temperature-programmed oxidation (TPO) and XPS, the iron polysulfides are the major products and approximately 90% regeneration efficiency can be theoretically achieved while the temperature is controlled higher than 813 K. In the regeneration tests, the results show that the LP natural soil can be regenerated and thus reused after the oxidation process. No significant degeneration occurs on the LP natural soil after five sorption/regeneration cycles. The sulfur sorption capacity of the tenth regenerated soil can be achieved at least 80% compared to the fresh one. The experimental analyzed SO2 concentration from the regeneration process is almost identical to the theoretical calculated equilibrium concentration of the process. Maghemite is the main product after the regeneration process.     

Instabilities in non-rotating and rotating shallow shear flows

Numerical simulations for the wave radiation effect on the linear and nonlinear instabilities of rotating and non-rotating shallow flows are conducted using shallow-water equations. At a low convective Froude number, the results of the instabilities is a string of eddies. The coalescence between the neighbouring eddies decides the transverse mixing of the shallow shear flow. At a higher convective Froude number, the development of the shear flow is characterized by wave radiation and the production of shocklets. The radiation of waves in the non-rotating shallow flow is a phenomenon analogous to the radiation of sound in gas dynamics. In the rotating flow on the other hand, the shallow-flow instabilities are intensified due to rotational interference within a window of instability over a narrow range of Rossby numbers.     

Health risk of aerosols and toxic metals from incense and joss paper burning

We report for the first time the distribution and hazard potential of aerosol and metals resulting from joss paper burning. Burning joss paper and incense is a traditional custom in many Oriental countries. Large amounts of air pollutants, including particles, polycyclic aromatic hydrocarbons, toxic metals and other gaseous pollutants, are released into the environment during the burning stage. Many investigations have reported on the emission of pollutants from the incense burning. However, no work has been reported until now on the analysis of the released pollutants apart from polycyclic aromatic hydrocarbons. In this study, a micro-orifice uniform-deposit impactor and inductively coupled plasma optical emission spectrometry were, respectively, used to collect aerosols and characterize the toxic metals from joss paper burning. We studied two types of particulate matter (PM): PM_2.5 that are particles with a diameter smaller than 2.5 μm and PM₁₀ that are particles with a diameter smaller than 10 μm. PM_2.5 are the most potentially toxic particles. Our results showed that PM_2.5 are the major component of the pollutants and that the PM_2.5 to PM₁₀ ratio ranged from 62 to 99%. The metals Na, Ca, Mg, Al and K were the main species in the aerosol and in the bottom ash.     

Hygroscopicity of particles generated from photooxidation of α-pinene under different oxidation conditions in the presence of sulfate seed aerosols

Smog chamber experiments were conducted to investigate the hygroscopicity of particles generated from photooxidation of α-pinene/NOx with different sulfate seed aerosols or oxidation conditions. Hygroscopicity of particles was measured by a tandem differential mobility analyzer （TDMA） in terms of hygroscopic growth factor （Gf）, with a relative humidity of 85%. With sulfate seed aerosols present, Gf of the aerosols decreased very fast before notable secondary organic aerosols （SOA） formation was observed, indicating a heterogeneous process between inorganic seeds and organic products might take place as soon as oxidation begins, rather than only happening after gas-aerosol partition of organic products starts. The final SOA-coated sulfate particles had similar or lower Gf than seed-free SOA. The hygroscopicity of the final particles was not dependent on the thickness but on the hygroscopicity properties of the SOA, which were influenced by the initial sulfate seed particles. In the two designed aging processes, Gf of the particles increased more significantly with introduction of OH radical than with ozone. However, the hygroscopicity of SOA was very low even after a long time of aging, implying that either SOA aging in the chamber was very slow or the Gf of SOA did not change significantly in aging. Using an aerosol composition speciation monitor （ACSM） and matrix factorization （PMF） method, two factors for the components of SOA were identified, but the correlation between SOA hygroscopicity and the proportion of the more highly oxidized factor could be either positive or negative depending on the speciation of seed aerosols present.