Honeybees (<Emphasis Type="Italic">Apis mellifera</Emphasis>) as a biological barrier for contamination of honey by environmental toxic metals

The aim of the study was to investigate the transfer of toxic metals from honeybee workers (Apis mellifera L.) to bee honey in relation to the ecological state of the environment. The materials of the study consisted of samples of honeybee bodies and varietal honeys taken from the same apiary located in three areas: R1—urbanized (16), R2—ecologically clean (16) and R3—industrialized (15) of south-eastern Poland. The contents of 14 elements in all tested samples, including toxic metals (Cd, Pb, Hg, Al, Ni, Tl) as well as bioelements (K, Mg, Ca, Mn, Fe, Zn, Cu, Se), were analysed by the ICP-OES method with prior microwave mineralization. The concentrations of the majority of the studied elements, excluding aluminum and lead, were significantly higher in bee bodies than in honey samples (P?<?0.05). The pollution of bee bodies by toxic metals was dependent on the environmental cleanliness, and the most pollution was observed in the industrialized area. The bee body was the most effective barrier for Cd and Tl transfer to the honey, while the level of Ni was similar in both tested materials. The Al concentration was significantly higher in honey than bee bodies (14.81?±?24.69 and 6.51?±?5.83 mg kg^?1, respectively), which suggests the possibility of secondary contamination of honey. The greatest sensitivity to heavy metal pollution was observed in honeydew honey compared to nectar honeys (P?<?0.05). It was proved for the first time that bees work as biofilters for toxic metals and prevent honey contamination.     

Silver near municipal wastewater discharges into western Lake Ontario,Canada

Because of the widespread use of silver nanoparticles in commercial products, discharges of municipal wastewater may be a point source of silver in the aquatic environment. We monitored two sites in western Lake Ontario impacted by discharges from wastewater treatment plants serving the City of Toronto. Concentrations of silver were elevated in bottom sediments and suspended sediments collected at the two sites. We also deployed two types of passive samplers in the water column at the two sites, the newly developed Carbon Nanotube Integrative Samplers for monitoring “CNIS-labile” silver and Diffusive Gradient in Thin Film samplers for monitoring “DGT-labile” silver. Results from these passive samplers indicated that the concentrations of silver at the two sites were either below detection limits or were in the ng/L range. In laboratory experiments where the sediments were re-suspended in Milli-Q water, a small proportion of the silver (i.e., <?25%) was labile and partitioned as colloidal or dissolved silver into the liquid phase after agitation. Nanoparticles tentatively identified as silver nanoparticles were detected by single-particle ICP-MS in suspension after agitation of both suspended and bottom sediments. Therefore, there is a need to assess whether silver species, including silver nanoparticles are transported from wastewater treatment plants into sediments in the aquatic environment. This study is unique in focusing on the in situ distribution of silver in natural waters and in sediments that are potentially impacted by urban sources of nanoparticles.     

Water quality index for agricultural systems in Northwest Uruguay

Agricultural systems have experienced rapid expansion and intensification in the last several decades. In Uruguay, since the beginning of 2000, the most common cropping systems have included soybeans. Currently, this crop is expanding towards lowlands traditionally occupied by rice in rotation with pastures. However, the environmental effects of agricultural intensification and diversification are not well known. Thus, some indices have been proposed to quantify the changes in agricultural production systems and assess water quality. The main goal of this study was to develop a water quality index (WQI) to assess the impacts of the diversification of rice production systems in northwest Uruguay. The study was carried out in an agricultural basin where other summer crops have been incorporated in the rice-pasture sequence. Agriculture intensification and crop diversification indices were calculated using information provided by farmers. Water samples were collected downstream of the production area before crop sowing and after crop harvest (2008–2009 to 2010–2011 and 2016–2017 to 2017–2018). Biochemical oxygen demand, nitrates, total phosphorus, fecal coliforms, and total suspended solids were the variables that mainly explained the effects of the agricultural activities on water quality. The proposed water quality index included these unweighted variables, which allowed for the pre-sowing and post-harvest to be differentiated, as well as the degree of diversification. Therefore, the proposed WQI constitutes a tool that can be used to evaluate the water quality in an agricultural basin. Likewise, it can be used to select agricultural sequences that generate the least possible impacts on the associated water resources.     

Urban tracer dispersion experiments during the second DAPPLE field campaign in London 2004

As part of the DAPPLE programme two large scale urban tracer experiments using multiple simultaneous releases of cyclic perfluoroalkanes from fixed location point sources was performed. The receptor concentrations along with relevant meteorological parameters measured are compared with a three screening dispersion models in order to best predict the decay of pollution sources with respect to distance. It is shown here that the simple dispersion models tested here can provide a reasonable upper bound estimate of the maximum concentrations measured with an empirical model derived from field observations and wind tunnel studies providing the best estimate. An indoor receptor was also used to assess indoor concentrations and their pertinence to commonly used evacuation procedures.     

Verification of diffusive and pumped samplers for volatile organic compounds using a controlled atmosphere test facility

There is a requirement to verify the performance of sorbent-based passive or active samplers and to extend their use, where possible, to monitor volatile organic compounds (VOCs) that are known to be photochemical ozone pre-cursors or are relevant to the activities of the petrochemical industry. We report measurements of the 14-day diffusive uptake rates for the VOCs: i-butane (2-methyl propane), n-butane, i-pentane (2-methyl butane), n-pentane, n-hexane, benzene, toluene, and m-xylene (at environmental level concentrations) for industry standard axial samplers (Perkin–Elmer-type samplers) containing the sorbents Carbopack-X, -Z, -B or Tenax-TA. We also present data on back-diffusion, blank levels, and storage for the above sorbents, and describe the simultaneous use of the sorbent Carbopack-X for pumped sampling of certain VOCs. The results were obtained by dosing samplers in a controlled atmosphere test facility (CATFAC) operating under well-defined conditions of concentration, nominal temperature of 20 °C, wind speed of 0.5 m s^?1, and relative humidities of 0% and 80%. Field measurements were also obtained to provide supplementary data to support the laboratory study. Results are compared to existing published data, where these are available.     

Seasonal monoterpene and sesquiterpene emissions from Pinus taeda and Pinus virginiana

Seasonal volatile organic compound emission data from loblolly pine (Pinus taeda) and Virginia pine (Pinus virginiana) were collected using branch enclosure techniques in Central North Carolina, USA. P. taeda monoterpene emission rates were at least ten times higher than oxygenated monoterpene and sesquiterpene emissions in all seasons. α-pinene and β-pinene were the most abundant emissions, while β-caryophyllene had the highest sesquiterpene emission rate from this species. β-phellandrene was the dominant compound emitted from P. virginiana, followed by the sesquiterpene β-caryophyllene. Sesquiterpene emissions from P. virginiana have not been reported in the literature previously. Summer sesquiterpene emissions from P. virginiana were nearly as high as monoterpene emissions, but were 4–12 times lower than monoterpene emissions in the other seasons. Oxygenated monoterpenes and 2-methyl-3-buten-2-ol were emitted at higher rates from P. taeda than from P. virginiana. Temperature response of the pinenes from P. taeda is similar to previously reported values used in emission models, while that for other compounds falls at the lower end of the previously reported range. Temperature response of all compounds from P. virginiana is in reasonable agreement with previously reported values from other pine species. There is evidence of light dependence of sesquiterpene emission after accounting for temperature response from both species. This effect is somewhat stronger in P. taeda. Bud break, needle expansion, and needle fall (and therefore wind events) seemed to increase monoterpene emission during non-summer seasons. In some instances springtime monoterpene emissions were higher than summertime emissions despite cooler temperatures. Emissions of individual compounds within monoterpene, oxygenated monoterpene, and sesquiterpene classes were highly correlated with each other. Compounds from different classes were much less correlated within each species. This is due to a varying temporal emission patterns for each BVOC class and suggests different production, storage, and emission controls for each. Analysis of enclosure blanks and diurnal patterns indicates that, despite precautions, disturbance due to the enclosure technique may still impact monoterpene emission rate estimates. This did not appear to affect sesquiterpene emissions.     

Comparison of summer and winter California central valley aerosol distributions from lidar and MODIS measurements

Aerosol distributions from two aircraft lidar campaigns conducted in the California Central Valley are compared in order to identify seasonal variations. Aircraft lidar flights were conducted in June 2003 and February 2007. While the ground PM_2.5 (particulate matter with diameter ≤ 2.5 μm) concentration was highest in the winter, the aerosol optical depth (AOD) measured from the MODIS and lidar instruments was highest in the summer. A multiyear seasonal comparison shows that PM_2.5 in the winter can exceed summer PM_2.5 by 68%, while summer AOD from MODIS exceeds winter AOD by 29%. Warmer temperatures and wildfires in the summer produce elevated aerosol layers that are detected by satellite measurements, but not necessarily by surface particulate matter monitors. Temperature inversions, especially during the winter, contribute to higher PM_2.5 measurements at the surface. Measurements of the mixing layer height from lidar instruments provide valuable information needed to understand the correlation between satellite measurements of AOD and in situ measurements of PM_2.5. Lidar measurements also reflect the ammonium nitrate chemistry observed in the San Joaquin Valley, which may explain the discrepancy between the MODIS AOD and PM_2.5 measurements.     

Study on ambient concentrations of PM10, PM10–2.5, PM2.5 and gaseous pollutants. Trace elements and chemical speciation of atmospheric particulates

This study provides the first comprehensive report on mass concentrations of particulate matter of various sizes, inorganic and organic gas concentrations monitored at three sampling sites in the city of Palermo (Sicily, Italy). It also provides information on the water-soluble species and trace elements. A total of 2054 PM₁₀ (1333) and PM_2.5 (721) daily measurements were collected from November 2006 to February 2008. The highest mass concentrations were observed at the urban stations, average values being about two times higher than those at the suburban (control) site. Time variations in PM₁₀ and also PM_10–2.5 were observed at the urban stations, the highest concentrations being measured in autumn and winter. CO, NOx, NO₂, benzene, toluene and o-xylene concentrations peaked in autumn and winter, a pattern similar to those recorded for PM₁₀ and PM_10–2.5 mass levels, indicating the importance of traffic emissions in urban air pollution. 91% and 51% of the benzene measurements exceeded the limit of 5 μg m^?3 at the two urban monitoring sites. Trace elements (As, Ba, Cr, Cu, Mo, Pb, Sb) suspected of being introduced into the atmosphere mainly by anthropogenic activities, were highly enriched with respect to local soil. Results indicate that a large fraction of PM₁₀ (31–47% in weight) and PM_2.5 (29% in weight) is made up of water-soluble ions. Ammonium sulphate and nitrate particles accounted for 14–29 wt% of particulate matter mass concentrations. Crustal and marine components, combined, account for 41% and 49% in PM_2.5 and PM₁₀, respectively. The calculated deficits in Cl^- and NH₄⁺ ions suggest that a proportion of these ions are lost, via the formation of gaseous NH₄Cl or HCl and NH₃.     

Estimation of economic costs of particulate air pollution from road transport in China

Valuation of health effects of air pollution is becoming a critical component of the performance of cost–benefit analysis of pollution control measures, which provides a basis for setting priorities for action. Beijing has focused on control of transport emission as vehicular emissions have recently become an important source of air pollution, particularly during Olympic games and Post-games. In this paper, we conducted an estimation of health effects and economic cost caused by road transport-related air pollution using an integrated assessment approach which utilizes air quality model, engineering, epidemiology, and economics. The results show that the total economic cost of health impacts due to air pollution contributed from transport in Beijing during 2004–2008 was 272, 297, 310, 323, 298 million US$ (mean value), respectively. The economic costs of road transport accounted for 0.52, 0.57, 0.60, 0.62, and 0.58% of annual Beijing GDP from 2004 to 2008. Average cost per vehicle and per ton of PM₁₀ emission from road transport can also be estimated as 106 US $/number and 3584 US $ t^?1, respectively. These findings illustrate that the impact of road transport contributed particulate air pollution on human health could be substantial in Beijing, whether in physical and economic terms. Therefore, some control measures to reduce transport emissions could lead to considerable economic benefit.     

Bioaccumulation and biological effects in the earthworm Eisenia fetida exposed to natural and depleted uranium

The accumulations of both natural (U) and depleted (DU) uranium in the earthworms (Eisenia fetida) were studied to evaluate corresponding biological effects. Concentrations of metals in the experimental soil ranged from 1.86 to 600 mg kg⁻¹. Five biological endpoints: mortality, animals’ weight increasing, lysosomal membrane stability by measuring the neutral red retention time (the NRRT), histological changes and genetic effects (Comet assay) were used to evaluate biological effects in the earthworms after 7 and 28 days of exposure. No effects have been observed in terms of mortality or weight reduction. Cytotoxic and genetic effects were identified at quite low U concentrations. For some of these endpoints, in particular for genetic effects, the dose (U concentration)-effect relationships have been found to be non-linear. The results have also shown a statistically significant higher level of impact on the earthworms exposed to natural U compared to depleted U.