Pesticide burden on some insects of economic importance in Lucknow (India)

Some insects of economic importance from Lucknow (India) have been investigated for their pesticide burden. Chlorinated pesticide residues of DDT, BHC and aldrin along with their metabolites and isomers have been detected in crop pollinating insects, honeybees (Apis indica) and butterflies (Danais chrysippus and Eurema sp.) and predators, dragonfly (Platythemis sp.) and wasps (Polistes herebreus). DDT and their metabolites were present in concentrations which varied from 231–796 ng g^–1, followed by BHC (10–60 ng g^–1), and aldrin (0.26–6.68 ng g^–1). This finding is likely to stimulate newer interest in the area of pesticide research and start meaningful investigation to find if bioaccumulated pesticides would have adverse impact on otherwise beneficial potentials of such insects in our ecosystems.     

Effect of Humic Acid on the Bioavailability of γ-Hexachlorocyclohexane in Marsilea Minuta (L.)

Effect of various concentrations of humic acid (0.2 to 1%) on thebioavailability of -HCH in vegetative clones of theaquatic fern Marsilea minuta was studied in a staticexperimental bioassay system on different photoperiods. Additionof humic acid showed the reduction in the bioavailability of-HCH in all the photoperiods (72 hr light to 144 hrlight) at the interval of 16 hr light (L) and 8 hr dark (D) inboth aerial and submerged portion as compared to controlindicating its protective role in toxicity.     

The influence of geometry and draught shields on the performance of passive samplers

Passive samplers provide an excellent opportunity to perform indicative measurements or establish a dense network of measuring sites. A drawback compared with conventional active measuring methods is the larger spread of results. This variation can, to a large extent, be attributed to the influence of temperature, sampler geometry and wind on sampling results. A proper design of sampler geometry and optimum choice of draught shield can reduce the influence of wind velocity on a badge type sampler to less than 10%. Wire mesh screens prove to be inadequate in damping turbulence. Filters give good results. Attention should be paid to the size and isolation value of the walls of the sampler to prevent thermal updrafts occurring within the sampler. Tube type samplers are less influenced by wind, provided that turbulence is prevented from influencing diffusion within the sampler.     

Effects of Roadway Crossings on Leaf Litter Processing and Invertebrate Assemblages in Small Streams

The effects of the Maine Turnpike (Interstate 95) on leaf litter processing were examined in five first- and second-order coastal plain streams in southern Maine, U.S.A. Invertebrate assemblages and red maple leaf softening and loss rates were compared at 53 stations arrayed upstream and downstream of the turnpike. Litter softening rate was not affected by the roadway. Litter loss rate was significantly faster at downstream stations (-0.0024 degree-day(-1)) than at upstream stations or at stations nearest the roadway, which were not different from each other (-0.0022 degree-day(-1)). Litter softening and loss rates were more strongly related to physical and chemical habitat variables than to shredder assemblage characteristics. Significant among-stream differences were observed in most community structural metrics and in biomass of important shredder taxa, but effects of the roadway were rarely consistent among streams. This is attributed in part to habitat variation, which was greater among streams than within streams. This study suggests that while the presence of the Maine Turnpike may influence stream water quality and habitat structure, the relatively subtle effects of roadway runoff and associated habitat modifications on stream ecosystem processes are masked by within- and among-stream variability in litter processing and leaf pack invertebrate assemblage structure.     

Development of an ombrotrophic peat bog (low ash) reference material for the determination of elemental concentrations

Given the increasing interest in using peat bogs as archives of atmospheric metal deposition, the lack of validated sample preparation methods and suitable certified reference materials has hindered not only the quality assurance of the generated analytical data but also the interpretation and comparison of peat core metal profiles from different laboratories in the international community. Reference materials play an important role in the evaluation of the accuracy of analytical results and are essential parts of good laboratory practice. An ombrotrophic peat bog reference material has been developed by 14 laboratories from nine countries in an inter-laboratory comparison between February and October 2002. The material has been characterised for both acid-extractable and total concentrations of a range of elements, including Al, As, Ca, Cd, Cr, Cu, Fe, Hg, Mg, Mn, Na, Ni, P, Pb, Ti, V and Zn. The steps involved in the production of the reference material (i.e. collection and preparation, homogeneity and stability studies, and certification) are described in detail.     

High frequency monitoring of the coastal marine environment using the MAREL buoy

The MAREL Iroise data buoy provides physico-chemical measurements acquired in surface marine water in continuous and autonomous mode. The water is pumped 1.5 m from below the surface through a sampling pipe and flows through the measuring cell located in the floating structure. Technological innovations implemented inside the measuring cell atop the buoy allow a continuous cleaning of the sensor, while injection of chloride ions into the circuit prevents biological fouling. Specific sensors for temperature, salinity, oxygen and fluorescence investigated in this paper have been evaluated to guarantee measurement precision over a 3 month period. A bi-directional link under Internet TCP-IP protocols is used for data, alarms and remote-control transmissions with the land-based data centre. Herein, we present a 29 month record for 4 parameters measured using a MAREL buoy moored in a coastal environment (Iroise Sea, Brest, France). The accuracy of the data provided by the buoy is assessed by comparison with measurements of sea water weekly sampled at the same site as part of SOMLIT (Service d'Observation du Milieu LIToral), the French network for monitoring of the coastal environment. Some particular events (impact of intensive fresh water discharges, dynamics of a fast phytoplankton bloom) are also presented, demonstrating the worth of monitoring a highly variable environment with a high frequency continuous reliable system.     

Organochlorine Pesticide Residues in Wheat and Drinking Water Samples from Jaipur, Rajasthan, India

The organochlorine pesticide contamination in dietary sources has caused serious threat to the human progeny. The present study was therefore conducted to evaluate the pesticide contamination in wheat flour and drinking water from Jaipur City, Rajasthan, India using Gas Chromatograph. All the wheat and water samples were found to be contaminated with various organochlorine pesticide residues of DDT and its metabolites, HCH and its isomers, heptachlor and its expoxide and aldrin. The amount of pesticide detected in wheat flour was higher than the permissible limits prescribed by WHO/FAO. In drinking water only a few pesticides exceeded the permissible limits. Seasonal variations of pesticides residues were also observed during the study period.     

A pilot project to detect and forecast harmful algal blooms in the northern Gulf of Mexico

More timely access to data and information on the initiation, evolution and effects of harmful algal blooms can reduce adverse impacts on valued natural resources and human health. To achieve this in the northern Gulf of Mexico, a pilot project was initiated to develop a user-driven, end-to-end (measurements to applications) observing system. A key strategy of the project is to coordinate existing state, federal and academic programs at an unprecedented level of collaboration and partnership. Resource managers charged with protection of public health and aquatic resources require immediate notice of algal events and a forecast of when, where and what adverse effects will likely occur. Further, managers require integrated analyses and interpretations, rather than raw data, to make effective decisions. Consequently, a functional observing system must collect and transform diverse measurements into usable forecasts. Data needed to support development of forecasts will include such properties as sea surface temperature, winds, currents and waves; precipitation and freshwater flows with related discharges of sediment and nutrients; salinity, dissolved oxygen, and chlorophyll concentrations (in vivo fluorescence); and remotely-sensed spatial images of sea surface chlorophyll concentrations. These data will be provided via a mixture of discrete and autonomous in situ sensing with near real-time data telemetry, and remote sensing from space (SeaWiFS), aircraft (hyperspectral imagery) or land (high-frequency radar). With calibration across these platforms, the project will ultimately provide a 4-dimensional visualization of harmful algae events in a time frame suitable to resource managers.