城市垃圾焚烧渗沥液中Ca2+对厌氧EGSB处理效果的影响简

研究了城市生活垃圾焚烧厂渗沥液中Ca²⁺对厌氧颗粒污泥膨胀床反应器（EGSB）处理效果的影响,并采用静态实验方法考察了Ca²⁺对厌氧颗粒污泥产甲烷活性的影响。实验结果表明,进水COD为17 000 mg/L的条件下,当Ca²⁺浓度低于6 000 mg/L时,EGSB对COD去除率达93%以上;当Ca²⁺浓度高于6 000 mg/L时,COD去除率随运行时间明显下降,并在污泥中形成大量沉淀。静态实验结果表明,废水中低浓度Ca²⁺促进了厌氧颗粒污泥的产甲烷活性,但高浓度Ca²⁺明显抑制了其产甲烷活性,这是导致高Ca²⁺浓度条件下EGSB对COD去除率降低的主要原因。研究表明,颗粒污泥产甲烷活性恢复程度随Ca²⁺浓度增加而减弱。     

Toxicity of imidazolium salt with anion bromide to a phytoplankton Selenastrum capricornutum: effect of alkyl-chain length

Room-temperature ionic liquids are regarded as environmentally benign alternatives to volatile organic solvents. However, the product designs for this promising group of compounds should take account, not only the technological needs, but also the eco-toxicological hazards. Therefore, this study aimed to evaluate the toxicity of some important ionic liquids on the growth of the freshwater alga, Selenastrum capricornutum. The ionic liquids examined in this study included 1-propyl-3-methylimidazolium [PMIM], 1-butyl-3-methylimidazolium [BMIM], 1-hexyl-3-methylimidazolium [HMIM] and 1-octyl-3-methylimidazolium [OMIM] with a bromide anion. The susceptibility of alga to ionic liquids was strongly dependent on the alkyl-chain length. According to our results, a longer alkyl-chain resulted in stronger inhibition of algal growth. In general, the toxicity could be summarized as decreasing in the following order: [OMIM]>[HMIM]>[BMIM]>or=[PMIM]. Among the ionic liquids examined, [OMIM] [Br] was found to be most toxic to S. capricornutum, with EC(50) values ranging from 26.3 microM to 54.9 microM after an incubating time of 96 h. Although [BMIM] [Br] and [PMIM] [Br] was relatively less toxic than [OMIM] and [HMIM], their toxicity increased as increasing the incubation time from 48 h to 96 h. This fact indicates that these kinds of ionic liquids may become more toxic after being released and contacted to freshwater ecosystem.     

Optimizing the performance of phase-change materials in personal protective clothing systems.

Phase-change materials (PCM) can be used to reduce thermal stress and improve thermal comfort for workers wearing protective clothing. The aim of this study was to investigate the effect of PCM in protective clothing used in simulated work situations. We hypothesized that it would be possible to optimize cooling performance with a design that focuses on careful positioning of PCM, minimizing total insulation and facilitating moisture transport. Thermal stress and thermal comfort were estimated through measurement of body heat production, body temperatures, sweat production, relative humidity in clothing and subjective ratings of thermal comfort, thermal sensitivity and perception of wetness. Experiments were carried out using 2 types of PCM, the crystalline dehydrate of sodium sulphate and microcapsules in fabrics. The results of 1 field and 2 laboratory experimental series were conclusive in that reduced thermal stress and improved thermal comfort were related to the amount and distribution of PCM, reduced sweat production and adequate transport of moisture.     

Arsenic in groundwater and sediment in the Mekong River delta, Vietnam

A study of groundwater and sediment during 2007-2008 in the Mekong River delta in Vietnam (MDVN) revealed that 26%, 74%, and 50% of groundwater samples were above the US EPA drinking water guidelines for As (10 μg/L), Mn (0.05 mg/L), and Fe (0.3 mg/L). The range of As, Fe, and Mn concentrations in the MDVN were <0.1-1351 μg/L, <0.01-38 mg/L, and <0.01−14 mg/L, respectively. Elevated levels of As were found in groundwater at sampling sites close to the Mekong River and in wells less than 60−70 m deep. An inverse relationship was found between As and Mn concentrations in groundwater. Sediment samples from An Giang and Dong Thap had the highest As concentrations (18 mg/kg and 38 mg/kg, respectively). Arsenic sediment occurred mainly in the poorly crystalline Fe oxide phases. Reductive dissolution of the Fe oxide phase is not necessarily the dominant mechanism of As release to groundwater.     

Mercury in air in an area impacted by strong industrial activities

The concentrations of total gaseous mercury (TGM) and its relevant environmental parameters were measured at a highly industrialized area in the Ban Wall industrial complex (BWIC) in An San city, Korea from March to May 2005. The mean concentrations of Hg measured during the entire study period were computed to be 6.32 ± 8.56 ng m⁻³ (range of 2.32–181 ng m⁻³; N = 1160). Due to the effects of strong man-made activities, the significantly high Hg concentration levels (e.g., at or above 10 ng m⁻³) comprised about 7.5% of all data with the mean of 21.8 ± 26.3 ng m⁻³ (N = 87). By separating the data into daytime and nighttime periods, the Hg values exhibited a notable daytime enhancement possibly due to strong man-made activities during working hours. The results of the correlation analysis indicated the possible relationship between the Hg concentration and the temperature as well as several pollutant species (e.g., NO₂ and NO_x). Evaluation of the Hg data in relation with the air mass transport pattern confirms that the Hg concentration levels in this industrial area are affected most eminently by local, rather than distant, pollution sources.     

Unusual arsenic speciation in sea anemones

Nine species of sea anemones (Anthopleura asiatica, Actinia equina, Actinodendron arboreum, Phymanthus loligo, Entacmaea actinostoloides, Stichodactyla gigantea, S. haddoni, S. mertensii and Metridium senile) contained arsenic in the range of 1.6-7.0microg As g(-1) (wet mass basis). Irrespective of the species, water-soluble arsenic compounds accounted for more than 80% of the total arsenic. Analysis of water-soluble arsenic compounds by LC/ESI-MS revealed that four arsenicals, arsenobetaine (AB), trimethylarsoniopropionate, arsenocholine (AC) and tetramethylarsonium ion (TEMA), are contained in most species but arsenate, methylarsonic acid, dimethylarsinic acid and trimethylarsine oxide are absent in all species. Interestingly, compositional patterns of the four arsenicals greatly differed from species to species. Only three species (S. gigantea, S. haddoni and M. senile) contained AB at the highest proportions, similar to the majority of marine animals. However, the remaining six species showed unusual compositional patterns of arsenic compounds; AC was most predominant in A. arboreum and P. loligo and TEMA in A. asiatica, A. equina, E. actinostoloides and S. mertensii. On the whole, high proportions (24.6-87.1% of the water-soluble arsenic) of TEMA appear to be a peculiar characteristic of many species of sea anemones. Thus, sea anemones are an important animal group in the arsenic cycling, especially in that they may be donors of TEMA to predators.     

Response surface method for modeling the removal of carbon dioxide from a simulated gas using water absorption enhanced with a liquid-film-forming device

This paper presents the results from using a physical absorption process to absorb gaseous CO_2mixed with N_2using water by producing tiny bubbles via a liquid-film-forming device(LFFD)that improves the solubility of CO_2in water.The influence of various parameters—pressure,initial CO_2concentration,gas-to-liquid ratios,and temperature—on the CO_2removal efficiency and its absorption rate in water were investigated and estimated thoroughly by statistical polynomial models obtained by the utilization of the response surface method(RSM)with a central composite design(CCD).Based on the analysis,a high efficiency of CO_2capture can be reached in conditions such as low pressure,high CO_2concentration at the inlet,low gas/liquid ratio,and low temperature.For instance,the highest removal efficiency in the RSM–CCD experimental matrix of nearly 80%occurred for run number 20,which was conducted at 0.30 MPa,CO_2concentration of 35%,gas/liquid ratio of 0.71,and temperature of 15°C.Furthermore,the coefficients of determination,R~2,were 0.996 for the removal rate and 0.982 for the absorption rate,implying that the predicted values computed by the constructed models correlate strongly and fit well with the experimental values.The results obtained provide essential information for implementing this method properly and effectively and contribute a promising approach to the problem of CO_2capture in air pollution treatment.     

降解多环芳烃的微生物的分离、鉴定方法及应用

阐述了降解多环芳烃的微生物的分离和鉴定方法;介绍了多环芳烃降解微生物的驯化方式;综述了多环芳烃降解菌的应用研究情况;对消除环境中多环芳烃污染问题的相关研究进行了展望并指出了将实验室筛选分离到的多环芳烃高效降解菌应用到实际环境中需解决的主要问题。     

Statistical analysis of regulatory ecotoxicity tests.

ANOVA-type data analysis, i.e.. determination of lowest-observed-effect concentrations (LOECs), and no-observed-effect concentrations (NOECs), has been widely used for statistical analysis of chronic ecotoxicity data. However, it is more and more criticised for several reasons, among which the most important is probably the fact that the NOEC depends on the choice of test concentrations and number of replications and rewards poor experiments, i.e., high variability, with high NOEC values. Thus, a recent OECD workshop concluded that the use of the NOEC should be phased out and that a regression-based estimation procedure should be used. Following this workshop, a working group was established at the French level between government, academia and industry representatives. Twenty-seven sets of chronic data (algae, daphnia, fish) were collected and analysed by ANOVA and regression procedures. Several regression models were compared and relations between NOECs and ECx, for different values of x, were established in order to find an alternative summary parameter to the NOEC. Biological arguments are scarce to help in defining a negligible level of effect x for the ECx. With regard to their use in the risk assessment procedures, a convenient methodology would be to choose x so that ECx are on average similar to the present NOEC. This would lead to no major change in the risk assessment procedure. However, experimental data show that the ECx depend on the regression models and that their accuracy decreases in the low effect zone. This disadvantage could probably be reduced by adapting existing experimental protocols but it could mean more experimental effort and higher cost. ECx (derived with existing test guidelines, e.g., regarding the number of replicates) whose lowest bounds of the confidence interval are on average similar to present NOEC would improve this approach by a priori encouraging more precise experiments. However, narrow confidence intervals are not only linked to good experimental practices, but also depend on the distance between the best model fit and experimental data. At least, these approaches still use the NOEC as a reference although this reference is statistically not correct. On the contrary, EC50 are the most precise values to estimate on a concentration response curve, but they are clearly different from the NOEC and their use would require a modification of existing assessment factors.