Comprehensive investigation of various re-refining technologies of used lubricating oil: a review

Journal of Material Cycles and Waste Management - Waste lubricating oil is considered to be a hazardous waste and has tremendous impact on human health and environment. The present review...     

Electroosmotic dewatering of dredged sediments: bench-scale investigation

The Indiana Harbor (Indiana, USA) has not been dredged since 1972 due to lack of a suitable disposal site for dredged sediment. As a result of this, over a million cubic yards of highly contaminated sediment has accumulated in the harbor. Recently, the United States Army Corps of Engineers (USACE) has selected a site for the confined disposal facility (CDF) and is in the process of designing it. Although dredging can be accomplished rapidly, the disposal in the CDF has to be done slowly to allow adequate time for consolidation to occur. The sediment possesses very high moisture content and very low hydraulic conductivity, which cause consolidation to occur slowly. Consolidation of the sediment is essential in order to achieve adequate shear strength of sediments and also to provide enough air space to accommodate the large amount of sediment that requires disposal. Currently, it has been estimated that if a one 3-foot (0.9-m) thick layer of sediment was disposed of at the CDF annually, it would take approximately 10 years to dispose of all the sediment that is to be dredged from the Indiana Harbor. This study investigated the feasibility of using an electroosmotic dewatering technology to accelerate dewatering and consolidation of sediment, thereby allowing more rapid disposal of sediment into the CDF. Electroosmotic dewatering essentially involves applying a small electric potential across the sediment layer, thereby inducing rapid flow as a result of physico-chemical and electrochemical processes. A series of bench-scale electrokinetic experiments were conducted on actual dredged sediment samples from the Indiana Harbor to investigate dewatering rates caused by gravity alone, dewatering rates caused by gravity and electric potential, and the effects of the addition of polymer flocculants on dewatering of the sediments. The results showed that electroosmotic dewatering under an applied electric potential of 1.0VDC/cm could increase the rate of dewatering and consolidation by an order of magnitude as compared to gravity drainage alone. Amending the sediment with polymers at low concentrations (0.5-1% by dry weight) will enhance this dewatering process; however, the optimal polymer concentration and the cost-effectiveness of using polymers should be investigated further.     

Metal Fractionation Studies in Surfacial and Core Sediments in the Achankovil River Basin in India

The Fractionation of Fe, Zn, Cu, Pb, Mn and Cd in the sediments of the Achankovil River, Western Ghats, India using a sequential extraction method was carried out to understand the metal availability in the basin for biotic and abiotic activities. Spatial distribution of heavy metals has been studied. Sediment grain size has significant control over the heavy metal distribution. The fluctuations in their concentration partly depend upon the lithology of the river basin and partly the anthropogenic activities. The sediments are dominated by sand and are moderately to strongly positively skewed and are very leptokurtotic in nature. The quartzite and feldspars are abundant minerals along with significant amount of mica with low clay content. The core sediments show increasing trend of heavy metal concentration with depth due to the recent addition of anthropogenic sources and post-diagenic activities. Significant amount of Cd (18%) was found in carbonate fraction, which may pose environmental problems due to its toxic nature. Small concentrations of metals, except Cd and Cu, are in exchangeable fraction, which indicate low bio-availability. Enrichment Factor (EF) for individual metals shows the contribution from terrregious and in part from anthropogenic sources. Selective Sequential Extraction (SSE) study shows the variation in specific metal distribution pattern, their distribution in different phases and their bio-availability. Maximum amount of the metals were bound to the non-residual fractions (mainly Fe-oxides). Overall, bio-availability of these micronutrients from sediments seems to be very less. Non-residual phase is the most important phase for majority of heavy metals studied. Among the non-residual fraction, maximum amount of the heavy metals bound to Fe-oxides. The study high lights the need for in-depth study of heavy metals distribution and fractionation in the smaller river basins to get precise information on the behavior and transport of heavy metals in the fluvial environment and their contribution to the world ocean.     

Mammalian cell-line based toxicological evaluation of paper mill black liquor treated in a soil microcosm by indigenous alkalo-tolerant Bacillus sp

Organic pollutants present in the soil of a microcosm containing pulp and paper mill black liquor were extracted with hexane/acetone (1:1 v/v) to study the biodegradation and detoxification potential of a Bacillus sp. gas chromatography-mass spectroscopic (GC-MS) analysis performed after biodegradation showed formation of simpler compounds like p-hydroxyhydrocinnamic acid (retention time [RT] 19.3 min), homovanillic acid methyl ester (RT 21.6 min) and 3,5-dimethoxy-p-coumaric alcohol (RT 24.7 min). The methyltetrazolium (MTT) assay for cytotoxicity, 7-ethoxyresorufin-O-deethylase (EROD) assay for dioxin-like behavior and alkaline comet assay for genotoxicity were carried out in the human hepatocarcinoma cell line HuH-7 before and after bacterial treatment. Bioremediation for 15 days reduced toxicity, as shown by a 139-fold increase in black liquor’s LC₅₀ value, a 343-fold reduction in benzo(a)pyrene equivalent value and a 5-fold reduction in olive tail moment. The EROD assay positively correlated with both the MTT and comet assays in post biodegradation toxicity evaluation.     

Potential use of Caulerpa fastigiata biomass for removal of lead: kinetics, isotherms, thermodynamic, and characterization studies

The present study attempts to analyze the biosorption trend of biosorbent Caulerpa fastigiata (macroalgae) biomass for removal of toxic heavy metal ion Pb (II) from solution as a function of initial metal ion concentration, pH, temperature, sorbent dosage, and biomass particle size. The sorption data fitted with various isotherm models and Freundlich model was the best one with correlation coefficient of 0.999. Kinetic study results revealed that the sorption data on Pb (II) with correlation coefficient of 0.999 can best be represented by pseudo-second-order. The biosorption capacity (q _e ) of Pb (II) is 16.11?±?0.32 mg g^?1 on C. fastigiata biomass. Thermodynamic studies showed that the process is exothermic (ΔH° negative). Free energy change (ΔG°) with negative sign reflected the feasibility and spontaneous nature of the process. The SEM studies showed Pb (II) biosorption on selective grains of the biosorbent. The FTIR spectra indicated bands corresponding to –OH, COO^?, –CH, C?=?C, C?=?S, and –C–C– groups were involved in the biosorption process. The XRD pattern of the C. fastigiata was found to be mostly amorphous in nature.     

Social cost of environmental pollution and application of counter measures through clean development mechanism: in the context of developing countries

The developing countries i.e., the non-Annex-I countries (parties to the Kyoto Protocol but not responsible to any reduction target yet) in the Kyoto Protocol whose economies are in transition are also allowed to reduce GHG emissions. Among these, the countries that have accepted the Kyoto Protocol may be benefited from CDM projects to promote sustainable development. The developed countries i.e., the Annex-I countries (that have signed the Kyoto Protocol & are responsible to have specific GHG emission reduction target) or the investing countries, in return, have privilege to purchase CER credits (in units equivalent to one tonne of CO₂ gas emission reduction) to meet the emission target as specified in the Kyoto Protocol. The key step in understanding about CDM is to grasp the concept of “baseline” and “additionality”. The “Baseline” is the emissions level that would have existed if a CDM project had not happened. The feature of an approved CDM project is that the planned reductions would not occur without the additional incentive provided by emission reduction credits; this concept is known as “Additionality”. According to environmental additionality concept, baseline emission minus project emission is equal to emissions reduction. “Investment Additionality,” ultimately rejected during negotiation of the “Marrakech Accords” and “Financial Additionality,” are the two important concepts. The concept of trading of CER matches to the idea of Pigovian tax (equal to the negative externality and which is considered one of the “traditional” means of bringing a modicum of market forces) in Economics, making pollution more costly to the polluter, as the polluters have negative cost since they save money by polluting; hence, there are supposed negative externalities associated with the market activity. Economic theory predicts that in an economy where the cost of reaching mutual agreement between parties is high and where pollution is diffuse, Pigovian tax will be an efficient way to promote the public interest and will lead to an improvement of the quality of life measured by the Genuine Progress Indicator and other human economic indicators, as well as higher gross domestic product growth. We can seek a level of pollution such that the marginal savings (MS) to one polluting unit from pollution (−MC) is equal to marginal damage (MD) from pollution over the entire population, since pollution is a public bad i.e., MS (x*) = ∑MD_i (x*) where ∑D_i (x) is the total damage. Though the responsibility of reduction in emission does not lie on the non-Annex-I countries, still effort of maintaining global emission balance can be expected equally from developed and developing countries. The responsibilities of Kyoto Protocol are (a) to reduce global GHG emissions, (b) to bring about sustainable development in the developing countries lie on above two groups since its effect on February 16, 2005. Different polluters have different costs of pollution control. The least costly way of controlling pollution from various sources that reflects different costs of pollution control making the set of environmental regulations to achieve the emission target at the lowest cost makes the regulation cost-effective. Though efficiency is not attainable for many regulations, cost-effectiveness is attainable.     

Nitrous oxide and methane emission from a flooded rice field as influenced by separate and combined application of herbicides bensulfuron methyl and pretilachlor

Combination of divergent active principles to achieve broad-spectrum control is gaining popularity to manage the weed menace in intensive agriculture. However, such application could have non-target impacts on the soil processes affecting soil ecology and environmental interactions. A field experiment was conducted to investigate the impact of separate and combined applications of herbicides bensulfuron methyl and pretilachlor on the emission of N₂O and CH₄, and related soil and microbial parameters in a flooded alluvial field planted to rice cv Lalat. Single application of the herbicide bensulfuron methyl or pretilachlor resulted in a significant reduction of N₂O and CH₄ emissions while the combination of these two herbicides distinctly increased N₂O and CH₄ emissions. Cumulative N₂O emissions (kg N₂O-N) followed the order of bensulfuron methyl (0.35 kg ha⁻¹) < pretilachlor (0.36 kg ha⁻¹) < control (0.45 kg ha⁻¹) < bensulfuron methyl 0.6% + pretilachlor 6.0% single dose (0.49 kg ha⁻¹) < bensulfuron methyl 0.6% + pretilachlor 6.0% double dose (0.54 kg ha⁻¹). Cumulative CH₄ emissions (kg CH₄), on the other hand, followed the order of bensulfuron methyl (47.89 kg ha⁻¹) < pretilachlor (73.17 kg ha⁻¹) < bensulfuron methyl 0.6% + pretilachlor 6.0% single dose (93.50 kg ha⁻¹) < control (106.54 kg ha⁻¹) < bensulfuron methyl 0.6% + pretilachlor 6.0% double dose (124.67 kg ha⁻¹). The inhibitory effect of separate application of herbicides bensulfuron methyl 0.6% and pretilachlor 6.0% on N₂O emission was linked to lower mineral N, lower denitrifying and nitrifying activity and low denitrifier and nitrifier populations. Inhibitory effect on CH₄ emission, on the contrary, was linked to prevention in the drop of redox potential, lower readily mineralizable carbon (RMC) and microbial biomass carbon (MBC) contents as well as lower methanogenic and higher methanotrophic bacterial population. Admittedly, stimulatory effect of combined application of herbicides bensulfuron methyl 0.6% and pretilachlor 6.0% at double dose on N₂O and CH₄ emission was related to reversal of the identified indicators of inhibition. Results indicate that while individual application of herbicides bensulfuron methyl 0.6% or pretilachlor 6.0% can reduce N₂O and CH₄ emission from flooded soil planted to rice, their combined application at normal dose can keep the emission at a comparatively lower level with significantly higher grain yield as compared to the herbicides applied alone.     

Reduction of selenite to red elemental selenium by moderately halotolerant Bacillus megaterium strains isolated from Bhitarkanika mangrove soil and characterization of reduced product

Two Gram (+) bacterial strains, BSB6 and BSB12, showing resistance and potential for Se(IV) reduction among 26 moderately halotolerant isolates from the Bhitarkanika mangrove soil were characterized by biochemical and 16S rDNA sequence analyses. Both of them were strictly aerobic and able to grow in a wide range of pH (4-11), temperature (4-40 °C) and salt concentration (4-12%) having an optimum growth at 37 °C, pH ∼7.5 and 7% salt (NaCl). The biochemical characteristics and 16S rDNA sequence analysis of BSB6 and BSB12 showed the closest phylogenetic similarity with the species Bacillus megaterium. Both the strains effectively reduced Se(IV) and complete reduction of selenite (up to 0.25 mM) was achieved within 40 h. SEM with energy dispersive X-ray and TEM analyses revealed the formation of nano size spherical selenium particles in and around the bacterial cells which were also supported by the confocal micrograph study. The UV-Vis diffuse reflectance spectra and XRD of selenium precipitates revealed that the selenium particles are in the nanometric range and crystalline in nature. These bacterial strains may be exploited further for bioremediation process of Se(IV) at relatively high salt concentrations and green synthesis of selenium nanoparticles.