A Water Quality Monitoring Network Design Methodology for the Selection of Critical Sampling Points: Part I

The principal instrument to temporally and spatially manage water resources is a water quality monitoring network. However, to date in most cases, there is a clear absence of a concise strategy or methodology for designing monitoring networks, especially when deciding upon the placement of sampling stations. Since water quality monitoring networks can be quite costly, it is very important to properly design the monitoring network so that maximum information extraction can be accomplished, which in turn is vital when informing decision-makers. This paper presents the development of a methodology for identifying the critical sampling locations within a watershed. Hence, it embodies the spatial component in the design of a water quality monitoring network by designating the critical stream locations that should ideally be sampled. For illustration purposes, the methodology focuses on a single contaminant, namely total phosphorus, and is applicable to small, upland, predominantly agricultural-forested watersheds. It takes a number of hydrologic, topographic, soils, vegetative, and land use factors into account. In addition, it includes an economic as well as logistical component in order to approximate the number of sampling points required for a given budget and to only consider the logistically accessible stream reaches in the analysis, respectively. The methodology utilizes a geographic information system (GIS), hydrologic simulation model, and fuzzy logic.     

Response of plant species to coal-mine soil materials

A two-year experiment was conducted on the Black Mesa Coal Mine near Kayenta, Arizona to investigate the growth and establishment of seven plant species in unmined soil (undisturbed soil) and coal-mine soil (spoils). Natural rainfall (20 cm/yr) and natural rainfull plus sprinkler irrigation (50 cm/yr) were the irrigation treatments applied to each soil material. Plant species grew better in unmined soil than in coal-mine soil. Supplemental irrigation water resulted in more plant growth than did natural rainfall alone in both soil materials; however, there were highly significant differences among species. Alfalfa (Medicago sativa L.) and all of the annual perennial grasses used, excluding Indian ricegrass (Oryzopsis hymenoides Ricker), produced effective ground cover on both soil materials when they received supplemental irrigation water. Fourwing saltbush (Atriplex canescens Pursh.) had low germination (emergence), seedling establishment, and stem production during the first year of growth; however, in the second year of growth, this species produced a dense ground cover on coal-mine soil with natural rainfall plus irrigation. In revegetating the Black Mesa Coal Mine, Harlan II barley (Hordeum vulgare L.) and Super X wheat (Triticum aestivum L.) provided initial protective cover until adapted perennial species could be established for permanent stabilisation. The Black Mesa Research Study indicated that irrigation water during seedling establishment was essential for the effective stabilisation of coal-mine soils in a semiarid environment.     

Use of hold-gro erosion control fabric in the establishment of plant species on coal mine soil

Experiments were conducted on the Black Mesa Coal Mine, Kayenta, Arizona in 1977 and 1978 to study the effectiveness of Hold-Gro Erosion Control Fabric (a product from the Gulf States Paper Corporation, Tuscaloosa, Alabama) in the establishment of plants on coal mine soil following the surface mining of coal. Four plant species were planted: (1) spring barley (Horduem vulgare L.), an annual grass (2) crested wheatgrass (Agropyron cristatum L.), a perennial grass (3) alfalfa (lucerne) (Medicago sativa L.), a perennial legume and (4) fourwing saltbush (Atriplex canescens Pursh.), a perennial shrub. Seeds of each plant species were planted in reclaimed coal mine soil in the spring of the year by both broadcast seeding (conventional culture) and the incorporation of seeds in Hold-Gro Erosion Control Fabric. Average numbers of seedlings established and percent ground cover for all species studied were higher in areas where conventional culture was used than they were in areas where seeds were incorporated in Hold-Gro Erosion Control Fabric. The incorporation of seeds in Hold-Gro Erosion Control Fabric in the establishment of plant species on coal mine soil was not an effective cultural practice in the southwestern United States. The authors gratefully acknowledge the assistance of M.A. Norem with portions of the research involving this contribution. The authors also express their appreciation to the Gulf States Paper Corporation in Tuscaloosa. Alabama for providing the Hold-Gro Erosion Control Fabrie used in this research. Contribution from the Arizona Agr. Exp. Stn., University of Arizona, Tucson, Arizona 85721. Approved for publication as Arizona Agr. Exp. Stn. Research Contribution No. 3767.     

Australia's first Environment Statement

Summary Australia's first National Environment Statement focuses on the substantial ecologic and economic impacts of land degradation, primarily in the significant agricultural mega-region of the Murray-Darling Basin. But the Statement only summarises existing policies to show a A$500 million spending programme on the environment. Inescapable, is the conclusion that economic growth as present and projected, and environmental sustainability, cannot co-exist in the long term. Levels of awareness of Australia's diverse environmental concerns were measured but no targets or future achievements were chartered — so how is effective management to be attained? The proposed significant and rapid devolution of power for action to local government, catchment management groups and community associations is a welcome development but this must be supported by adequate technical information and guidance by government.Dr Diana G. Day is an environmental policy analyst with major interests in water planning. She is currently setting up a new Centre for Environmental Management at Newcastle University, and is Director of the National Land and Water Resources Research and Development Corporation in Australia.     

How changing regulations determine biotreatment options for petroleum wastes

Remediation of refinery wastes is regulated by three major federal environmental statutes: the Clean Air Act, the Clean Water Act, and the Resource Conservation and Recovery Act (RCRA); other statutes apply, but to a lesser degree. During the past two years, RCRA's rules have effectively outlawed the passive biological treatment of primary refinery waste sludges in waste ponds and lagoons, even though the law recommends active biological treatment as the second stage in the waste treatment train. RCRA's land disposal restrictions may also outlaw land farming treatment for the bottom sludges involved in crude oil storage. Since 1980, when the U.S. Environmental Protection Agency listed an initial group of five waste streams as hazardous, the agency has listed two more waste streams and twenty-five organic constituents, several found in petroleum wastes. Now it is about to list fourteen more petroleum refining wastes and is studying the addition of fifteen more waste streams. Treatment standards and restrictions have also been promulgated. This article explores the biotreatment techniques and technologies that are still available to petroleum and environmental engineers.     

Regression modeling of streamflow, baseflow, and runoff using geographic information systems

Regression models for predicting total streamflow (TSF), baseflow (TBF), and storm runoff (TRO) are needed for water resource planning and management. This study used 54 streams with >20 years of streamflow gaging station records during the period October 1971 to September 2001 in Pennsylvania and partitioned TSF into TBF and TRO. TBF was considered a surrogate of groundwater recharge for basins. Regression models for predicting basin-wide TSF, TBF, and TRO were developed under three scenarios that varied in regression variables used for model development. Regression variables representing basin geomorphological, geological, soil, and climatic characteristics were estimated using geographic information systems. All regression models for TSF, TBF, and TRO had R(2) values >0.94 and reasonable prediction errors. The two best TSF models developed under scenarios 1 and 2 had similar absolute prediction errors. The same was true for the two best TBF models. Therefore, any one of the two best TSF and TBF models could be used for respective flow prediction depending on variable availability. The TRO model developed under scenario 1 had smaller absolute prediction errors than that developed under scenario 2. Simplified Area-alone models developed under scenario 3 might be used when variables for using best models are not available, but had lower R(2) values and higher or more variable prediction errors than the best models.     

The use of tree-rings and foliage as an archive of volcanogenic cation deposition

Tree cores (Pinus nigra ssp. laricio) and leaves (Castanea sativa) from the flanks of Mount Etna, Sicily were analysed by ICP-MS to investigate whether volcanogenic cations within plant material provide an archive of a volcano's temporal and spatial depositional influence. There is significant compositional variability both within and between trees, but no systematic dendrochemical correlation with periods of effusive, explosive or increased degassing activity. Dendrochemistry does not provide a record of persistent but fluctuating volcanic activity. Foliar levels of bioaccumulated cations correspond to modelled plume transport patterns, and map short-term volcanic fumigation. Around the flanks of the volcano foliar variation is greater for volatile cations (Cs, Cd, Pb) than for lithophilic cations (Ba, Sr), consistent with trace-metal supply from volcanic aerosol during quiescent periods.     

A free,open-source tool for identifying urban agglomerations using polygon data

This paper describes the function of a software tool for identifying urban agglomerations in low-information settings using free, open data. The framework outlined here is designed to work using polygon data. This paper describes the advantages and disadvantages of using polygon-based geographies in regional analysis, discusses the practical and ethical challenges of distinguishing urban from rural regions, and discusses the relevance of this tool in the analysis of global city regions. It also describes the logical structure of our polygon-based software tool and directs interested readers to the source code. We finally examine the agglomeration results for Sri Lanka and compare them with published urbanization figures. We conclude that there are very large disparities between our model’s outputs and the urbanization estimates from the United Nations and that our tools can be used as a less discretionary way to identify actual levels of urbanization. We hope that other analysts will continue to refine the progression toward a less discretionary model of identifying urban regions.     

Conceptual frameworks and key questions for assessing the contribution of marine protected areas to shark and ray conservation

Marine protected areas (MPAs) are key tools in addressing the global decline of sharks and rays, and marine parks and shark sanctuaries of various configurations have been established to conserve shark populations. However, assessments of their efficacy are compromised by inconsistent terminology, lack of standardized approaches to assess how MPAs contribute to shark and ray conservation, and ambiguity about how to integrate movement data in assessment processes. We devised a conceptual framework to standardize key terms (e.g., protection, contribution, potential impact, risk, threat) and used the concept of portfolio risk to identify key attributes of sharks and rays (assets), the threats they face (portfolio risk), and the specific role of MPAs in risk mitigation (insurance). Movement data can be integrated into the process by informing risk exposure and mitigation through MPAs. The framework is operationalized by posing 8 key questions that prompt practitioners to consider the assessment scope, MPA type and purpose, range of existing and potential threats, species biology and ecology, and management and operational contexts. Ultimately, MPA contributions to shark and ray conservation differ according to a complex set of human and natural factors and interactions that should be carefully considered in MPA design, implementation, and evaluation.