Decentralized Groundwater Recharge Systems Using Roofwater and Stormwater Runoff1

Stephens, Daniel B., Mark Miller, Stephanie J. Moore, Todd Umstot, and Deborah J. Salvato, 2011. Decentralized Groundwater Recharge Systems Using Roofwater and Stormwater Runoff. Journal of the American Water Resources Association (JAWRA) 48(1): 134‐144. DOI: 10.1111/j.1752‐1688.2011.00600.x Abstract: Stormwater capture for groundwater recharge in urban areas is usually conducted at the regional level by water agencies. Field and modeling studies in New Mexico indicate that stormwater diverted to retention basins may recharge about 50% of precipitation that falls on the developed area, even in dry climates. Comparable volumes of recharge may be expected at homes, subdivisions, or commercial properties with low‐impact development (LID) technologies for stormwater control that promote recharge over evapotranspiration. Groundwater quality has not been significantly impacted at sites that have been recharging stormwater to aquifers for decades. Distributed recharge systems may be a good alternative to centralized regional facilities where there is limited land for constructing spreading basins or little funding for new infrastructure. LID technologies borrowed from stormwater managers are important tools for groundwater managers to consider to enhance recharge.     

Optimizing line intercept sampling and estimation for feral swine damage levels in ecologically sensitive wetland plant communities

Ecological sampling can be labor intensive, and logistically impractical in certain environments. We optimize line intercept sampling and compare estimation methods for assessing feral swine damage within fragile wetland ecosystems in Florida. Sensitive wetland sites, and the swine damage within them, were mapped using GPS technology. Evenly spaced parallel transect lines were simulated across a digital map of each site. The length of each transect and total swine damage under each transect were measured and percent swine damage within each site was estimated by two methods. The total length method (TLM) combined all transects as a single long transect, dividing the sum of all damage lengths across all transects by the combined length of all transect lines. The equal weight method (EWM) calculated the damage proportion for each transect line and averaged these proportions across all transects. Estimation was evaluated using transect spacings of 1, 3, 5, 10, 15, and 20 m. Based on relative root mean squared error and relative bias measures, the TLM produced higher quality estimates than EWM at all transect spacings. Estimation quality decreased as transect spacing increased, especially for TLM. Estimation quality also increased as the true proportion of swine damage increased. Diminishing improvements in estimation quality as transect spacings decreased suggested 5 m as an optimal tradeoff between estimation quality and labor. An inter-transect spacing of 5 m with TLM estimation appeared an optimal starting point when designing a plan for estimating swine damage, with practical, logistical, economic considerations determining final design details.     

Risk factors for increased BTEX exposure in four Australian cities

Benzene, toluene, ethylbenzene and xylenes (BTEX) are common volatile organic compounds (VOCs) found in urban airsheds. Elevated levels of VOCs have been reported in many airsheds at many locations, particularly those associated with industrial activity, wood heater use and heavy traffic. Exposure to some VOCs has been associated with health risks. There have been limited investigations into community exposures to BTEX using personal monitoring to elucidate the concentrations to which members of the community may be exposed and the main contributors to that exposure. In this cross sectional study we investigated BTEX exposure of 204 non-smoking, non-occupationally exposed people from four Australian cities. Each participant wore a passive BTEX sampler over 24h on five consecutive days in both winter and summer and completed an exposure source questionnaire for each season and a diary for each day of monitoring. The geometric mean (GM) and range of daily BTEX concentrations recorded for the study population were benzene 0.80 (0.04-23.8 ppb); toluene 2.83 (0.03-2120 ppb); ethylbenzene 0.49 (0.03-119 ppb); and xylenes 2.36 (0.04-697 ppb). A generalised linear model was used to investigate significant risk factors for increased BTEX exposure. Activities and locations found to increase personal exposure included vehicle repair and machinery use, refuelling of motor vehicles, being in an enclosed car park and time spent undertaking arts and crafts. A highly significant difference was found between the mean exposures in each of the four cities, which may be explained by differences in fuel composition, differences in the mix and density of industry, density of motor vehicles and air pollution meteorology.     

Codependencies of reactive air toxic and criteria pollutants on emission reductions

It is important to understand the effects of emission controls on concentrations of ozone, fine particulate matter (PM2.5), and hazardous air pollutants (HAPs) simultaneously, to evaluate the full range of health, ecosystem, and economic effects. Until recently, the capability to simultaneously evaluate interrelated atmospheric pollutants ("one atmosphere" analysis) was unavailable to air quality managers. In this work, we use an air quality model to examine the potential effect of three emission reductions on concentrations of ozone, PM2.5, and four important HAPs (formaldehyde, acetaldehyde, acrolein, and benzene) over a domain centered on Philadelphia for 12-day episodes in July and January 2001. Although NO(x) controls are predicted to benefit PM2.5 concentrations and sometimes benefit ozone, they have only a small effect on formaldehyde, slightly increase acetaldehyde and acrolein, and have no effect on benzene in the July episode. Concentrations of all pollutants except benzene increase slightly with NO(x) controls in the January simulation. Volatile organic compound controls alone are found to have a small effect on ozone and PM2.5, a less than linear effect on decreasing aldehydes, and an approximately linear effect on acrolein and benzene in summer, but a slightly larger than linear effect on aldehydes and acrolein in winter. These simulations indicate the difficulty in assessing how toxic air pollutants might respond to emission reductions aimed at decreasing criteria pollutants such as ozone and PM2.5.     

Advanced multivariate analysis to assess remediation of hydrocarbons in soils

Accurate monitoring of degradation levels in soils is essential in order to understand and achieve complete degradation of petroleum hydrocarbons in contaminated soils. We aimed to develop the use of multivariate methods for the monitoring of biodegradation of diesel in soils and to determine if diesel contaminated soils could be remediated to a chemical composition similar to that of an uncontaminated soil. An incubation experiment was set up with three contrasting soil types. Each soil was exposed to diesel at varying stages of degradation and then analysed for key hydrocarbons throughout 161 days of incubation. Hydrocarbon distributions were analysed by Principal Coordinate Analysis and similar samples grouped by cluster analysis. Variation and differences between samples were determined using permutational multivariate analysis of variance. It was found that all soils followed trajectories approaching the chemical composition of the unpolluted soil. Some contaminated soils were no longer significantly different to that of uncontaminated soil after 161 days of incubation. The use of cluster analysis allows the assignment of a percentage chemical similarity of a diesel contaminated soil to an uncontaminated soil sample. This will aid in the monitoring of hydrocarbon contaminated sites and the establishment of potential endpoints for successful remediation.     

How contaminated with ammunition-derived lead is meat from European small game animals? Assessing and reducing risks to human health

Small game animals are generally hunted with lead gunshot which often fragments causing elevated lead concentrations in meat and presenting health risks to frequent consumers and vulnerable groups. We reviewed three decades of European data on lead concentrations in the meat of gamebirds, rabbits and hares across countries with various restrictions on lead gunshot use. Mean meat lead concentrations decreased to a low level in Denmark, the only country in the study with a total ban on lead gunshot use. In contrast, elsewhere in Europe meat lead concentrations increased over time, an unexplained and previously undescribed finding. The only regulatory restriction associated with a decrease in meat lead concentrations was the Danish total ban on lead gunshot use. We calculated an arithmetic mean lead concentration in small game meat of 5.205 ppm w.w. (2011–2021) from across Europe. EU and UK regulators are considering banning lead ammunition for all hunting to protect human and wildlife health. The mean value we found for small game meat (2011–2021) was fourteen times higher than that used in a recent EU-wide risk assessment.Supplementary InformationThe online version contains supplementary material available at 10.1007/s13280-022-01737-9.     

Brood production and lineage discrimination in the red harvester ant (Pogonomyrmex barbatus)

In contrast to the system of caste determination in most social insects, reproductive caste determination in some populations of Pogonomyrmex barbatus has a genetic basis. Populations that exhibit genetic caste determination are segregated into two distinct, genetic lineages. Same-lineage matings result in female reproductives, while inter-lineage matings result in workers. To investigate whether founding P. barbatus queens lay eggs of reproductive genotype, and to determine the fate of those eggs, we genotyped eggs, larvae, and pupae produced by naturally inseminated, laboratory-raised queens. We show that founding dependent lineage queens do lay eggs of reproductive genotype, and that the proportion of reproductive genotypes decreases over the course of development from eggs to larvae to pupae. Because queens must mate with a male of each lineage to produce both workers and female reproductives, it would benefit queens to be able to distinguish males of the two lineages. Here we show that P. barbatus males from the two genetic lineages differ in their cuticular hydrocarbon profiles. Queens could use male cuticular hydrocarbons as cues to assess the lineage of males at the mating aggregation, and possibly keep mating until they have mated with males of both lineages.     

A second look at the Palmes' diffusive sampler

The Palmes' tube, the first diffusive sampler incorporating a fixed path length, has received wide usage for the sampling of a large number of gaseous pollutants. But despite numerous previous studies, questions remain regarding the accuracy of these inexpensive, simple-to-construct, open-ended samplers. Here the mass transfer resistance in a Palmes' diffusive sampler was measured using the loss of cyclohexane from a Palmes' tube containing liquid cyclohexane at its base. The average loss rates, at factorial combinations of five air incidence angles evenly spaced from 270 degrees to 90 degrees, and five air speeds from 0.5 m/sec to 2.5 m/sec ranged from 46% to 121% higher than rates calculated from the physical dimensions of the sampler, proving the need to calibrate these samplers rather than relying on a theoretical calculation. The mass transfer resistance was nearly constant when the airflow was perpendicular to the sampler and sufficiently high to avoid stagnation, a finding that may explain the widespread acceptance of the results obtained using this sampler.     

Effects of wind‐energy facilities on breeding grassland bird distributions

The contribution of renewable energy to meet worldwide demand continues to grow. Wind energy is one of the fastest growing renewable sectors, but new wind facilities are often placed in prime wildlife habitat. Long‐term studies that incorporate a rigorous statistical design to evaluate the effects of wind facilities on wildlife are rare. We conducted a before‐after‐control‐impact (BACI) assessment to determine if wind facilities placed in native mixed‐grass prairies displaced breeding grassland birds. During 2003–2012, we monitored changes in bird density in 3 study areas in North Dakota and South Dakota (U.S.A.). We examined whether displacement or attraction occurred 1 year after construction (immediate effect) and the average displacement or attraction 2–5 years after construction (delayed effect). We tested for these effects overall and within distance bands of 100, 200, 300, and >300 m from turbines. We observed displacement for 7 of 9 species. One species was unaffected by wind facilities and one species exhibited attraction. Displacement and attraction generally occurred within 100 m and often extended up to 300 m. In a few instances, displacement extended beyond 300 m. Displacement and attraction occurred 1 year after construction and persisted at least 5 years. Our research provides a framework for applying a BACI design to displacement studies and highlights the erroneous conclusions that can be made without the benefit of adopting such a design. More broadly, species‐specific behaviors can be used to inform management decisions about turbine placement and the potential impact to individual species. Additionally, the avoidance distance metrics we estimated can facilitate future development of models evaluating impacts of wind facilities under differing land‐use scenarios.