基于部分湿式氧化法的污泥资源化研究

介绍了部分湿式氧化法的基本原理,指出COD去除率是判断是否部分湿式氧化的重要指标。用高压反应釜进行污泥处理,在一定的温度、压力和适合氧气量的条件下,考察了COD去除率、有机物降解率、pH值、过滤性能等随反应时间的变化。试验结果表明,通过控制反应时间,可以实现污泥的部分湿式氧化。考察了污泥经过部分湿式氧化后产物的性质,包括颗粒分布、有机物含量、养分含量和重金属等项目,分析结果表明,产物具有良好的资源化前景。     

硫酸系统水平衡分析计算和生产实践

在硫酸系统中,通过水平衡分析计算烟气带入净化工序的SO2体积分数和含水量,确定净化工序的能力,控制干燥塔进口烟气温度,使干吸工序生产出合格产品;通过计算,烟气带入净化工序的水量小于产品带出的水量,制酸净化污水经过污水处理工序处理后返回到净化工序重复使用,实现净化污水零排放,消除对环境的污染.     

Removal of copper ions from aqueous solution by calcium alginate immobilized kaolin

Kaolin has been widely used as an adsorbent to remove heavy metal ions from aqueous solutions. However, the lower heavy metal adsorption capacity of kaolin limits its practical application. A novel environmental friendly material, calcium alginate immobilized kaolin (kaolin/CA), was prepared using a sol-gel method. The e ects of contact time, pH, adsorbent dose, and temperature on Cu2+ adsorption by kaolin/CA were investigated. The Langmuir isotherm was used to describe the experimental adsorption, the maximum Cu2+ adsorption capacity of the kaolin/CA reached up to 53.63 mg/g. The thermodynamic studies showed that the adsorption reaction was a spontaneous and endothermic process.     

Mobilities and leachabilities of heavy metals in sludge with humus soil

Chemical forms of Zn, Ni, Cu, and Pb in municipal sewage sludge were investigated by adding humus soil to sludge and by performing sequential extraction procedures. In the final sludge mixtures, Zn and Ni were mainly found in Fe/Mn oxide-bound (F3) and organic matter/sulfide-bound (F4) forms. For Zn, exchangeable (F1), carbonate-bound (F2), and F3 forms were transformed to F4 and residual forms (F5). For Ni, F1 and F2 forms were transformed to F1, F2, and F3 forms. Both Cu and Pb were strongly associated with the stable forms F4 and F5. For Cu, F2 and F3 forms were major contributors, while for Pb, F3 and F4 forms were major contributors to F5. Humus soil dosage and pH conditions in the sludge were strongly correlated with the forms of heavy metals. Five forms were used to evaluate metal mobilities in the initial and final sludge mixtures. The mobilities of the four heavy metals studied decreased after 28 days. The metal mobilities in the final sludge mixtures were ranked in the following order: Ni > Zn > Cu = Pb. Leaching tests showed that the mobilities of Zn and Ni in lower pH conditions (pH 4) were higher than those in higher pH conditions (pH 8).     

Adsorptive property of Cu^2＋-loaded montmorillonite clays for Escherichia coli K_（88） in vitro

The Cu²⁺-loaded montmorillonite clays (MMT-Cu) may be a good material for the adsorbed and eliminated pathogenic bacteria from aqueous solution.     

Effect of C/N ratio, aeration rate and moisture content on ammonia and greenhouse gas emission during the composting

Gaseous emission (N₂O, CH₄ and NH₃) from composting can be an important source of anthropogenic greenhouse gas and air pollution. A laboratory scale orthogonal experiment was conducted to estimate the effects of C/N ratio, aeration rate and initial moisture content on gaseous emission during the composting of pig faeces from Chinese Ganqinfen system. The results showed that about 23.9% to 45.6% of total organic carbon (TOC) was lost in the form of CO₂ and 0.8% to 7.5% of TOC emitted as CH₄. Most of the nitrogen was lost in the form of NH₃, which account for 9.6% to 32.4% of initial nitrogen. N₂O was also an important way of nitrogen losses and 1.5% to 7.3% of initial total nitrogen was lost as it. Statistic analysis showed that the aeration rate is the most important factor which could affect the NH₃ (p = 0.0189), CH₄ (p = 0.0113) and N₂O (p = 0.0493) emissions significantly. Higher aeration rates reduce the CH₄ emission but increase the NH₃ and N₂O losses. C/N ratio could affect the NH₃ (p = 0.0442) and CH₄ (p = 0.0246) emissions significantly, but not the N₂O. Lower C/N ratio caused higher NH₃ and CH₄ emissions. The initial moisture content can not influence the gaseous emission significantly. Most treatments were matured after 37 days, except a trial with high moisture content and a low C/N ratio.     

Structural and electrochemical properties of annealed La1-xYxNi3.55Mno.4Alo.3Coo.75 hydrogen storage alloys

The effects of the annealing and partial substitution of Y for La on the structural and electrochemical properties of La_1-xY_xNi_3.55Mn_o.4Al_o.3Cr_o.75 (x = 0, 0.1 and 0.2) alloys were reported in the present work. The single-phased CaCu₅-type structure was retained after La was partially substituted by Y. However, the increase of Y content leads to decrease of the lattice parameters and the unit-cell volume. The annealed La_o.9Y_o.1Ni_3.55Mn_o.4Al_o.3Co_o.75 alloys shows typical isometric microstructure, indicating that the composition segregation is improved by annealing. Y substitution for La in the alloys is effective to improve the electrochemical properties at both room temperature and high temperature. A critical substitution content of Y is found at x = 0.1.     

间甲酚对斑马鱼胚胎的影响

采用静态实验方法,研究了不同浓度的间甲酚(m-cresol)对斑马鱼胚胎的急性毒性.结果表明,当m-cresol浓度超过一定数值时,伴随着时间的延长可使暴露胚胎的畸形数增加,暴露胚胎孵化出的仔鱼也出现畸形现象,mcresol的毒性呈现出剂量-效应关系.当m-cresol质量浓度不小于13 mg/L时,暴露12 h的胚胎开始出现畸形;质量浓度为25 mg/L时,暴露24 h的胚胎全部畸形.m-cresol对胚胎24 h眼点发育及20 s主动活动、48 h黑色素和72 h各类畸形的EC50分别为33.609,8.882和5.652 mg/L.可见,一定浓度的m-cresol可对斑马鱼胚胎及其孵化仔鱼产生毒性作用.     

Catalytic bubble-free hydrogenation reduction of azo dye by porous membranes loaded with palladium nanoparticles

Catalytic bubble-free hydrogenation reduction of azo dye by porous membranes loaded with palladium （Pd） nanoparticles was studied for the first time. The effects of Pd loading, dye concentration and reuse repetitions of membranes were investigated. In reduction, the dye concentration decreased whereas the pH rose gradually. An optimal Pd loading was found. The catalytic membranes were able to be reused more than 3 times.     

Biosorption mechanisms involved in immobilization of soil Pb by Bacillus subtilis DBM in a multimetal-contaminated soil

Mechanisms of soil Pb immobilization by Bacillus subtilis DBM, a bacterial strain isolated from a heavy-metal-contaminated soil, were investigated. Adsorption and desorption experiments with living bacterial cells as well as dead cells revealed that both extracellular adsorption and intracellular accumulation were involved in the Pb2＋removal from the liquid phase. Of the sequestered Pb（II）, 8.5% was held by physical entrapment within the cell wall, 43.3% was held by ion-exchange, 9.7% was complexed with cell surface functional groups or precipitated on the cell surface, and 38.5% was intracellularly accumulated.Complexation of Pb2＋with carboxyl, hydroxyl, carbonyl, amido, and phosphate groups was demonstrated by Fourier transform infrared spectroscopic analysis. Precipitates of Pb5（PO4）3OH, Pb5（PO4）3Cl and Pb10（PO4）6（OH）2that formed on the cell surface during the biosorption process were identified by X-ray diffraction analysis. Transmission electron microscopy–energy dispersive spectroscopic analysis confirmed the presence of the Pb（II）precipitates and that Pb（II） could be sequestered both extracellularly and intracellularly.Incubation with B. subtilis DBM significantly decreased the amount of the weak-acid-soluble Pb fraction in a heavy-metal-contaminated soil, resulting in a reduction in Pb bioavailability, but increased the amount of its organic-matter-bound fraction by 71%. The ability of B.subtilis DBM to reduce the bioavailability of soil Pb makes it potentially useful for bacteria-assisted phytostabilization of multi-heavy-metal-contaminated soil.