Volatile Organic Compounds from Coal Tar and Soil Vapor Samples at MGP Sites

This study characterized organic compounds found in New York State manufactured gas plant (MGP) coal tar vapors using controlled laboratory experiments from four separate MGP sites. In addition, a limited number of deep (0.3–1.2 m above coal tar) and shallow (1.2–2.4 m above coal tar) soil vapor samples were collected above the in situ coal tar source at three of these sites. A total of 29 compounds were consistently detected in the laboratory-generated coal tar vapors at 50°C, whereas 24 compounds were detected at 10°C. The compounds detected in the field sample results were inconsistent with the compounds found in the laboratory-generated samples. Concentrations of compounds in the shallow soil vapor sample were either non-detectable or substantially lower than those found in deeper samples, suggesting attenuation in the vadose zone. Laboratory-generated data at 50°C compared the (% non-aromatic)/(% aromatic) ratio and indicated that this ratio may provide good discrimination between coal tar vapor and common petroleum distillates.     

Controlled Exposures of Volunteers to Respirable Carbon and Sulf uric Acid Aerosols

Respirable carbon or fly ash particles are suspected to increase the respiratory toxicity of coexisting acidic air pollutants, by concentrating acid on their surfaces and so delivering it efficiently to the lower respiratory tract. To investigate this issue, we exposed 15 healthy and 15 asthmatic volunteers in a controlled- environment chamber (21°C, 50 percent relative humidity) to four test atmospheres: (i) clean air; (ii) 0.5-μm H2SO4 aerosol at =100 μg/m³, generated from water solution; (iii) 0,5-μm carbon aerosol at =250 μg/m³, generated from highly pure carbon black with specific surface area comparable to ambient pollution particles; and (iv) carbon as in (iii) plus =100 μg/m³ of ultrafine H2SO4 aerosol generated from fuming sulfuric acid. Electron microscopy showed that nearly all acid in (iv) became attached to carbon particle surfaces, and that most particles remained in the sub-μm size range. Exposures were performed double-blind, 1 week apart. They lasted 1 hr each, with alternate 10-min periods of heavy exercise (ventilation =50 L/min) and rest. Subjects gargled citrus juice before exposure to suppress airway ammonia. Lung function and symptoms were measured pre-exposure, after initial exercise, and at endexposure. Bronchial reactivity to methacholine was measured after exposure. Statistical analyses tested for effects of H₂SO₄ or carbon, separate or interactive, on health measures. Group data showed no more than small equivocal effects of any exposure on any health measure. One individual's responses were consistent with a clinically significant excess airway constriction from H₂SO₄ plus carbon, and 2-3 others showed slight excess responses to the combined pollutants, but all these observations might have reflected chance variations. We conclude that coexisting carbon aerosol did not increase respiratory irritancy of H₂SO₄, in most healthy and asthmatic subjects exposed for 1 hr under simulated "worst-case" ambient conditions.     

Recovering CO2 From Large− and Medium-Size Stationary Combustors

This paper summarizes the results of research conducted at Ar-gonne National Laboratory (ANL) to develop and design a novel method for the recovery of CO₂ from flue gases. The basic process concept Involves the combustion of a hydrocarbon fuel using a mixture of oxygen and carbon dioxide (or CO₂ and H₂0) rather than air as the oxidant, which results In a product stream that contains primarily CO₂ and H₂O. This stream Is then dried and conditioned to meet the specifications of the end user, A slip stream of CO₂ (or CO₂, and H₂0) is used as a diluent in the combustion chamberto maintain a flame temperature equivalent to the temperature that would otherwise be obtained using air as an oxidant. The cost-effectiveness of the process in recovering C0₂ is dependent on the scale of the operation, the type of fuel used, the cost of oxygen, and the cost of capital. The sensitivity of the cost of the recovered C0₂ to these variables Is discussed, and a model for estimating the cost of CO₂ recovered using the ANL process Is presented.     

Pilot-Scale Demonstration of an Innovative Treatment for Vapor Emissions

ABSTRACT

Researchers from the National Renewable Energy Laboratory recently conducted a pilot-scale study at McClellan Air Force Base (AFB) in Sacramento, CA. The objective of the test was to determine the effectiveness of an ambient-temperature, solar-powered photocatalytic oxidation treatment unit for destroying emissions of chlorinated organic compounds from an air stripper. This paper reports test results and discusses applications and limitations of the technology.

A 10-standard-cubic-foot-per-minute (SCFM) (28.3 L/min) slip stream of air from an air stripper at Operative Unit 29-31 at McClellan AFB was passed through a reactor that contained a lightweight, perforated, inert support coated with photoactive titanium dioxide. The reactor faced south and was tilted at a 45° angle from vertical so that the light-activated catalyst received most of the available sunlight. An online portable gas chro-matograph with two identical columns simultaneously analyzed the volatile organic compounds contained in the reactor inlet and outlet air streams. Summa canister grab samples of the inlet and outlet were also collected and sent to a certified laboratory for U.S. Environmental

Protection Agency Method TO-14 analysis and verification of our field analyses. Three weeks of testing demonstrated that the treatment system's destruction and removal efficiencies (DREs) are greater than 95% at 10 SCFM with UV intensities at or greater than 1.5 milliwatts/square centimeter (mW/cm²). DREs greater than 95% at 20 SCFM were obtained under conditions where UV irradiation measured at or greater than 2 mW/cm². In Sacramento, this provided 6 hours of operation per clear or nearly clear day in April. A solar tracking system could extend operating time. The air stream also contained trace amounts of benzene. We observed no loss of system performance during testing.     

Evaluation of best management practice products in preventing discharge of metals: a laboratory evaluation

Heavy metal accumulation in soil poses serious environmental and health risks, as metals are carried with eroded soils. In this study, 17 different soil erosion and sediment control products were investigated for their effectiveness in controlling transport of particulate heavy metals (Cu, Zn, Pb, Cd). Among the treatments investigated, wood mulch and tackifiers were found to be the most effective in reducing total suspended solids (TSS) and total heavy metal losses. They reduced TSS to an undetectable level during short-term simulation tests. Paper mulch was the only treatment that had no significant reduction in both total metal loss and TSS. Fiber rolls, silt fences, and gravel bags were effective in reducing sediment loss. Although the netting/blanket treatments were not effective in reducing total metal discharge, they significantly reduced sediment loss compared with the control.     

South Pole Antarctica observations and modeling results: New insights on HOx radical and sulfur chemistry

Measurements of OH, H₂SO₄, and MSA at South Pole (SP) Antarctica were recorded as a part of the 2003 Antarctic Chemistry Investigation (ANTCI 2003). The time period 22 November, 2003–2 January, 2004 provided a unique opportunity to observe atmospheric chemistry at SP under both natural conditions as well as those uniquely defined by a solar eclipse event. Results under natural solar conditions generally confirmed those reported previously in the year 2000. In both years the major chemical driver leading to large scale fluctuations in OH was shifts in the concentration levels of NO. Like in 2000, however, the 2003 observational data were systematically lower than model predictions. This can be interpreted as indicating that the model mechanism is still missing a significant HO_x sink reaction(s); or, alternatively, that the OH calibration source may have problems. Still a final possibility could involve the integrity of the OH sampling scheme which involved a fixed building site. As expected, during the peak in the solar eclipse both NO and OH showed large decreases in their respective concentrations. Interestingly, the observational OH profile could only be approximated by the model mechanism upon adding an additional HO_x radical source in the form of snow emissions of CH₂O and/or H₂O₂. This would lead one to think that either CH₂O and/or H₂O₂ snow emissions represent a significant HO_x radical source under summertime conditions at SP. Observations of H₂SO₄ and MSA revealed both species to be present at very low concentrations (e.g., 5 × 10⁵ and 1 × 10⁵ molec cm^?3, respectively), but similar to those reported in 2000. The first measurements of SO₂ at SP demonstrated a close coupling with the oxidation product H₂SO₄. The observed low concentrations of MSA appear to be counter to the most recent thinking by glacio-chemists who have suggested that the plateau's lower atmosphere should have elevated levels of MSA. We speculate here that the absence of MSA may reflect efficient atmospheric removal mechanisms for this species involving either dynamical and/or chemical processes.     

Verification of diffusive and pumped samplers for volatile organic compounds using a controlled atmosphere test facility

There is a requirement to verify the performance of sorbent-based passive or active samplers and to extend their use, where possible, to monitor volatile organic compounds (VOCs) that are known to be photochemical ozone pre-cursors or are relevant to the activities of the petrochemical industry. We report measurements of the 14-day diffusive uptake rates for the VOCs: i-butane (2-methyl propane), n-butane, i-pentane (2-methyl butane), n-pentane, n-hexane, benzene, toluene, and m-xylene (at environmental level concentrations) for industry standard axial samplers (Perkin–Elmer-type samplers) containing the sorbents Carbopack-X, -Z, -B or Tenax-TA. We also present data on back-diffusion, blank levels, and storage for the above sorbents, and describe the simultaneous use of the sorbent Carbopack-X for pumped sampling of certain VOCs. The results were obtained by dosing samplers in a controlled atmosphere test facility (CATFAC) operating under well-defined conditions of concentration, nominal temperature of 20 °C, wind speed of 0.5 m s^?1, and relative humidities of 0% and 80%. Field measurements were also obtained to provide supplementary data to support the laboratory study. Results are compared to existing published data, where these are available.     

Fuel Oil Additives for Controlling Air Contaminant Emissions

An addition of additives to fuel oils prior to combustion is one way of reducing combustible contaminant emissions to the outer air. Reported test results show that some additives improve, moderately, the combustive properties of fuel oils. Combustion is also improved but to a lesser degree, in boiler systems that are deficient in operation and design. Being combustible, polynuclear hydrocarbons emissions would be reduced by use of additives. Other types of additives to reduce slagging and inhibit corrosion from combustion of fuel oils are also available. The cost of using additives is low. Improved additives are required, especially ones to better combustion in the deficient boiler systems. These can be found by research and literature surveys. Their effectiveness and nontoxicity would be confirmed by laboratory and field testing.