Treatment technology for remediation of wood preserving sites: Overview

This is the first in a series of five articles describing the applicability, performance, and cost of technologies for the remediation of contaminated soil and water at wood preserving sites. Site‐specific treatability studies conducted under the supervision of the United States Environmental Protection Agency (US EPA), National Risk Management Research Laboratory (NRMRL), from 1995 through 1997 constitute much of the basis for the evaluations presented, although data from other treatability studies, literature sources, and actual site remediations have also been included to provide a more comprehensive evaluation of remediation technologies. This article provides an overview of the wood preserving sites studied, including contaminant levels, and a summary of the performance of the technologies evaluated. The subsequent articles discuss the performance of each technology in more detail. Three articles discuss technologies for the treatment of soils, including solidification/stabilization, biological treatment, solvent extraction and soil washing. One article discusses technologies for the treatment of liquids, water and nonaqueous phase liquids (NAPLS), including biological treatment, carbon adsorption, photolytic oxidation, and hydraulic containment. The reader should be aware that other technologies including, but not limited to, incineration, thermal desorption, and base catalyzed dehalogenation, also have application for treating contaminants on wood preserving sites. They are not discussed in these five articles since the focus was to evaluate lesser known and hopefully lower cost approaches. However, the reader should include consideration of these other technologies as part of any evaluation or screening of technologies applicable to remediation of wood preserving sites.     

Solidification/stabilization for remediation of wood preserving sites: Treatment for dioxins,PCP, creosote,and metals

This article discusses the use of solidification/stabilization (S/S) to treat soils contaminated with organic and inorganic chemicals at wood preserving sites. Solidification is defined for this article as making a material into a freestanding solid. Stabilization is defined as making the contaminants of concern nonmobile as determined from a leaching test. S/S then combines both properties. For more information on S/S in general the reader should refer to other publications (Connors, J.R. [1990]). Chemical fixation and solidification of hazardous wastes. New York: Van Nostrand Reinhold; US Environmental Protection Agency. [1993a]. Engineering bulletin solidification/stabilization of organics and inorganics (EPA/540/S‐92/015); Wiles, C.C. [1989]. Solidification and stabilization technology. In H.M. Freeman [Ed.], Standard handbook of hazardous waste treatment and disposal. New York: McGraw Hill) as this article addresses only wood preserving sites and assumes basic knowledge of S/S processes. For a more general discussion of wood preserving sites and some other remedial options, the reader may wish to refer to a previous EPA publication (US Environmental Protection Agency. [1992a]. Contaminants and remedial options at wood preserving sites [EPA/600/R‐92/182]). This article includes data from the successful remediation of a site with mixed organic/inorganic contaminants, remediation of a site with organic contaminants, and detailed treatability study results from four sites for which successful formulations were developed. Included are pre‐ and post‐treatment soil characterization data, site vaines. ileizdot‐ names (in some cases), treatment formulas used (generic aridproprietary), costs, recommendations, and citatioiis to inore detailed refer‐ en ces. The data presen ted iiidica te that dioxins, pentachlorophepi 01 (PCP), creosote, polycyclic aromatic hydrocarbom (PAHsI, and metals can be treated at moderate cost by the use of S/S techuologp.     

Flow and transport in fractured tuff at Yucca Mountain: numerical experiments on fast preferential flow mechanisms

Recent discovery of bomb-related ³⁶Cl at depth in fractured tuff in the unsaturated zone at the Yucca Mountain candidate high-level waste (HLW) repository site has called into question the usual modeling assumptions based on the equivalent continuum model (ECM). A dual continuum model (DCM) for simulating transient flow and transport at Yucca Mountain is developed. In order to ensure properly converged flow solutions, which are used in the transport simulation, a new flow solution convergence criteria is derived. An extensive series of simulation studies is presented which indicates that rapid movement of solute through the fractures will not occur unless there are intense episodic infiltration events. Movement of solute in the environs of the repository is enhanced if the properties of the tuff layer at the repository horizon are modified from current best-estimate values. Due to a large advective–dispersive coupling between the matrix and fractures, the matrix acts as a major buffer which inhibits rapid transport along the fractures. Consequently, fast movement of solutes through the fractures to the repository depth can only be explained if the matrix–fracture coupling term is significantly reduced from a value that would be calculated on the basis of data currently available.     

Numerical simulation of a fine-grained denitrification layer for removing septic system nitrate from shallow groundwater

One of the most common methods to dispose of domestic wastewater involves the release of septic effluent from drains located in the unsaturated zone. Nitrogen from such systems is currently of concern because of nitrate contamination of drinking water supplies and eutrophication of coastal waters. It has been proposed that adding labile carbon sources to septic distribution fields could enhance heterotrophic denitrification and thus reduce nitrate concentrations in shallow groundwater. In this study, a numerical model which solves for variably saturated flow and reactive transport of multiple species is employed to investigate the performance of a drain field design that incorporates a fine-grained denitrification layer. The hydrogeological scenario simulated is an unconfined sand aquifer. The model results suggest that the denitrification layer, supplemented with labile organic carbon, may be an effective means to eliminate nitrogen loading to shallow groundwater. It is also shown that in noncalcareous aquifers, the denitrification reaction may provide sufficient buffering capacity to maintain near neutral pH conditions beneath and down gradient of the drain field. Leaching of excess dissolved organic carbon (DOC) from the denitrification layer is problematic, and causes an anaerobic plume to develop in simulations where the water table is less than 5-6 m below ground surface; this anaerobic plume may lead to other down gradient changes in groundwater quality. A drain field and denitrification layer of smaller dimensions is shown to be just as effective for reducing nitrate, but has the benefit of reducing the excess DOC leached from the layer. This configuration will minimize the impact of wastewater disposal in areas where the water table is as shallow as 3.5 m.     

Environmental Pollution Challenges and Associated Planning and Management Issues Facing Offshore Oil and Gas Field Development in the UK

Reducing the environmental impact of offshore operations is one of the most pressing challenges facing the oil and gas industry in Europe today. A study was conducted to review the issues by literature search, and consultation with stakeholders and experts. It was clear from the literature search that considerable research had been dedicated to: protecting the marine environment; achieving compliance with legislative controls; assessing the technical and economic feasibility of platform disposal options; and ecological surveying. By comparison, considerably less research had been carried out in other important areas such as: assessing the impacts wastes returned to shore for disposal; identifying sustainable strategies for operations; and assessing and mitigating against adverse impacts from atmospheric emissions. It is clear that the environmental regulatory regime offshore will become tougher and have an increasing influence on offshore oil and gas field environmental planning and management. Future regulatory developments include: a streamlining of the offshore oil and gas environmental regulatory regime; the introduction of the Habitats Directive into the licensing system; and the Offshore Combustion Installations (Prevention and Control of Pollution) Regulations 1999. In addition, post Kyoto regulatory developments and societal concern over atmospheric pollution, will increasingly focus efforts on reducing the emission of global warming gases. These changes, coupled with the uncertainty over how resilient the environment is to perturbation, present a need to clearly manage environmental information.     

A 10-year survey, 1980–1990, of prenatally diagnosed small supernumerary marker chromosomes,identified by fish analysis. Outcome and follow-up of 14 cases diagnosed in a series of 12 699 prenatal samples

A cytogenetic survey and follow-up studies were made of 14 cases with supernumerary marker chromosomes, identified among 12 699 prenatal samples, investigated at our institution over a 10-year period from 1980 to 1990. FISH (fluorescence in situ hybridization) techniques were employed to identify the chromosomal origin of the marker chromosomes. Five cases were familial, all derived from acrocentric chromosomes, and all without apparent phenotypic effects in the children. Nine cases represented de novo aberrations. In two cases (one with a marker from chromosome 14 or 22, the other with a ring-like marker derived from chromosome 17), the pregnancies continued and apparently normal babies were delivered at term, but the child with a marker derived from chromosome 17 showed slight psychomotor retardation at 2 years of age. All other pregnancies with de novo markers were terminated. In three cases, significant abnormalities were found at autopsy. One of these had an isochromosome 12p and the phenotype was consistent with Pallister-Killian syndrome. In conclusion, marker chromosome identification, as well as clinical follow-up, is essential for the purpose of improving genetic counselling.     

The ultrasonic detection of an isolated craniosynostosis

The prenatal detection of scaphocephaly, an isolated form of craniosynostosis, is presented. The diagnosis was made at 34 weeks of gestation in a woman with polyhydramnios. The ultrasound appearance and postnatal follow-up are presented.     

Expediting remedial designs and assessments

A successful air-based remediation system, now frequently chosen for sites contaminated with VOCs, demands a thorough understanding of the nature and distribution of the VOCs and the soil air permeabilities. Considering likely remediation methods during the site investigation allows collection of all data needed for method selection and design within a single, highly efficient site visit. A case history illustrates how to integrate several data collection and testing activities into a single site visit.     

Recovery of the Kakerori: An Endangered Forest Bird of the Cook Islands

The Kakerori, or Rarotonga Flycatcher (Pomarea dimidiata) , is an endangered monarch flycatcher endemic to the island of Rarotonga, Cook Islands. This bird was reported to be common until the middle of the nineteenth century, but it declined before 1885 and was thought to be extinct early this century. A small population persisted in the rugged interior of Rarotonga; in 1987 the population stood at 38 birds but was in decline. We determined that introduced predators, especially ship rats (Rattus rattus) , were affecting breeding success. Through a program of experimental management, aimed mainly at rodent control, the population increased from a low of 29 birds in Spring 1989 to 60 birds in Spring 1993. The recovery can be attributed to both improved breeding success and increased adult survivorship.